漆酶对活性黑KN-B和直接大红染料的脱色性能

利用白腐真菌漆酶对活性黑KN-B和直接大红2种偶氮染料进行脱色实验。考察反应时间、加酶量、pH值、染料浓度、温度对脱色率的影响,研究了ABTS介体以及金属离子存在下的脱色效果,并分析了漆酶脱色的动力学性能以及其对偶氮染料的降解规律。结果表明,活性黑KN-B和直接大红脱色适宜条件为：反应时间为30 min,加酶量8 U/mL,pH=7,染料浓度分别为50 mg/L和80 mg/L,温度40~45℃。ABTS介体对酶促偶氮染料脱色没有明显促进作用。Fe²⁺对漆酶脱色有较强的抑制作用;Cu²⁺对漆酶催化活性黑KN-B促进作用较大,对直接大红影响较小。漆酶对2种染料的脱色反应符合米氏方程,其催化活性黑KN-B和直接大红染料的K_m值分别为114.81 mg/L,317.5 mg/L,v_max值分别为6.57 mg/（L·min）和26.0 mg/（L·min）。     

Degradation of bisphenol A in aqueous solution by persulfate activated with ferrous ion

Degradation of bisphenol A (BPA) in aqueous solution was studied with high-efficiency sulfate radical (SO₄ ^?·), which was generated by the activation of persulfate (S₂O₈ ^2?) with ferrous ion (Fe²⁺). S₂O₈ ^2? was activated by Fe²⁺ to produce SO₄ ^?·, and iron powder (Fe⁰) was used as a slow-releasing source of dissolved Fe²⁺. The major oxidation products of BPA were determined by liquid chromatography-mass spectrometer. The mineralization efficiency of BPA was monitored by total organic carbon (TOC) analyzer. BPA removal efficiency was improved by the increase of initial S₂O₈ ^2? or Fe²⁺ concentrations and then decreased with excess Fe²⁺ concentration. The adding mode of Fe²⁺ had significant impact on BPA degradation and mineralization. BPA removal rates increased from 49 to 97 % with sequential addition of Fe²⁺, while complete degradation was observed with continuous diffusion of Fe²⁺, and the latter achieved higher TOC removal rate. When Fe⁰ was employed as a slow-releasing source of dissolved Fe²⁺, 100 % of BPA degradation efficiency was achieved, and the highest removal rate of TOC (85 %) was obtained within 2 h. In the Fe⁰–S₂O₈ ^2? system, Fe⁰ as the activator of S₂O₈ ^2? could offer sustainable oxidation for BPA, and higher TOC removal rate was achieved. It was proved that Fe⁰–S₂O₈ ^2? system has perspective for future works.     

Photo-dissociation of dimethylamine by KrBr excilamp

A study of dimethylamine photo-dissociation in the gas phase has been conducted using UV radiation delivered from a KrBr^* excilamp, driven by a sinusoidal electronic control gear with maximum emission at wavelength of 207 nm. The electrical input power and radiant power of the lamp were measured to determine their effects on the degradation. The influence of flow velocity and initial concentration of dimethylamine were also examined. In order to evaluate the photo-dissociation process comprehensively, several parameters were investigated, including removal efficiency, energy yield, carbon balance and CO₂ selectivity. It is shown that the removal efficiency increases with enhanced input power and decreased gas flow rate. A high removal efficiency of 68% is achieved for lamp power 102 W and flow velocity 15 m³ h⁻¹. The optimum dimethylamine initial concentration is around 3520 mg m⁻³, for which the energy yield reaches up to 442 g kW h⁻¹ when the input power is 65 W. In addition, two chain compounds (1,3-bis-dimethylamino-2-propanol; 3-penten-2-one, 4-amino) and three ring organic matters (1-azetidinecarboxaldehyde, 2,2,4,4-tetramethyl; N-m-tolyl-succinamic acid; p-acetoacetanisidide), were identified by GC–MS as secondary products, in order to demonstrate the pathways of the dimethylamine degradation.     

曝气沉砂池除砂机理分析

针对曝气沉砂池小试装置模型,通过配砂实验对沉砂池除砂率进行统计分析,研究曝气强度与HRT对沉砂池除砂率的影响。实验结果表明,不同曝气强度下,随着HRT变化,除砂率逐渐上升,并最终趋于平衡状态;不同HRT下,曝气强度与除砂率近似呈现一定的线性关系,且随着曝气强度的增大,除砂率降低;在HRT小于1min时,砂粒的运行路径和沉降时间缩短,不利于砂粒的去除;在HRT大于1min时,其中1、3和4min,随着气水比的增加除砂率降低幅度相对较小,曝气所引起的横向环流在一定程度上有利于砂粒的沉降,而HRT为2min时,除砂率降幅却很大,这与砂粒在曝气沉砂池池体断面分布有关,即断面处旋转流速和水平流速的大小变化将影响砂粒的运动;相比曝气强度,HRT对除砂率的影响较大。     

Different reaction mechanisms of diphenylether and 4-bromodiphenylether with nitrous acid in the 355 nm laser flash photolysis of mixed aqueous solution

The microscopic reaction mechanisms of diphenylether (DPE) and 4-bromodiphenylether (4-BrDPE) with nitrous acid (HNO(2)) in the absence of O(2) have been explored by the 355nm laser flash photolysis. It was proposed that OH radical, from the photolysis of HNO(2), added to DPE forms the C(12)H(10)O-OH adduct while added to 4-BrDPE forms the 4-BrDPE-OH and 4-BrOH-DPE adducts. The first-order decay rate constants of the C(12)H(10)O-OH adduct, 4-BrDPE-OH adduct and 4-BrOH-DPE adduct were measured to be (1.86+/-0.14)x10(5)s(-1), (2.19+/-0.04)x10(5)s(-1) and (1.56+/-0.03)x10(5)s(-1), respectively. The final photolysis products of DPE and HNO(2) identified by GC/MS analysis were phenol, o-hydroxydiphenylether, p-hydroxydiphenylether and p-nitrodiphenylether, while the final photolysis product of 4-BrDPE and HNO(2) identified by LC/MS analysis was mainly the dimer.     

冬季自然通风对住宅室内空气品质的改善性能评价

为获得理想的自然通风方式,以改善寒冷地区住宅冬季室内空气品质、营造舒适的室内环境,采用现场实测和理论分析相结合的方法,对冬季自然通风中的室内外环境参数进行了测试,得到了室外环境参数、人工调节方式对室内环境参数及空气品质的影响特征; 针对舒适与健康的双重要求是寒冷地区住宅冬季通风的主要矛盾这一特点,分别采用临界温度、热舒适性、排污效率、人工调节便捷性等指标对不同方案的通风性能进行了评价.结果表明,采用18 ℃的临界温度可保证采暖所需的热能最低值,同时也有利于抑制甲醛、氨等的释放及挥发速率; 各房间的热舒适性均满足相关规范要求,即本文所列举的这4种方案在执行过程中并没有牺牲房间的热舒适性,只是稍微有些偏凉.方案6的排污效率最高,为88%,方案8次之,方案3最低.这与方案6中两进风口关于回风口对称布置,室内平均空气龄最短有关; 4种方案具有相同的人工调节便捷性.综合各方面因素,方案6为本文最佳通风方案.     

离子化有机污染物在沉积物和水相间的平衡分配计算

本文从热力学平衡原理出发,推导出离子化有机污染物在沉积物／水相间分配系数的理论计算模型,并以苯酚,邻氯酚,２,４－二氯酚、五氯酚和苯胺的吸附实验数据为例,计算了它们在中性分子和带电荷的离子形态下的分配系数Ｋｄ和Ｋｄｉ。以及总体分配系数Ｋｄｏ研究结果表明,离子化有机污染物在沉积物和分配行为不仅与该化学物的ｐＫａ和存在形态有关。而且还取决于环境介质的ｐＨ。     

近岸海域水质自动监测系统站位的布设

水质自动监测将是近岸海域环境监测的一个发展趋势。通过分析现有近岸海域自动监测站在站点布设过程中的经验,对近岸海域自动监测系统站位的设置原则、技术要求、基本条件及注意事项等进行阐述,为后续近岸海域自动监测系统的建设提供参考依据。     

气相色谱-质谱法测定饮用水中消毒副产物卤代腈

采用顶空加盐气相色谱-质谱法检测饮用水中的消毒副产物氯乙腈、二氯乙腈和三氯乙腈,并对样品前处理方法及GC/MS仪器条件进行优化,使得3种卤代腈在5．00μg/L ～80．0μg/L 范围内线性良好,方法检出限分别为2．52μg/L、1．02μg/L和1．57μg/L。空白水样的加标回收率为75．9％～94．1％, RSD为3．6％～6．2％。     

贵州省部分地区土壤中酞酸酯类污染现状调查

对贵州省部分地区表层土壤中酞酸酯类的污染状况进行了调查。分别在遵义地区、黔南地区、黔东南地区和毕节地区采集483个土壤样品分析,结果表明,样品中酞酸酯总质量比(ΣPAEs)为未检出~8.22 mg/kg,均值为0.63 mg/kg。其中DEHP和DBP为主要污染物,均值分别为0.32 mg/kg和0.24 mg/kg,检出率分别为90.89%和97.10%。