不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

响应面分析法优化稀土废水MAP沉淀法脱氮

经过预处理后的稀土生产废水,其氨氮浓度大幅降低,但并未达到中华人民共和国《稀土工业污染物排放标准》（GB26451-2011）中氨氮浓度限值。实验通过响应面分析法中的Box-Behnken实验设计（BBD）,取pH、n（Mg）：n（N）、n（P）：n（N）3因素,采用Design-Expert 8.0.6,建立合适的剩余氨氮浓度及剩余总磷浓度模型,得到回归方程,并分析模型各项指标,各因素及其相互作用对剩余氨氮浓度及剩余总磷浓度的影响。利用预测模型预测最佳实验条件,在最佳实验条件下验证预测结果,并对沉淀物进行X射线衍射（XRD）分析。结果显示,二次响应模型适用于剩余氨氮浓度及剩余总磷浓度,2个模型均拥有较好的拟合程度、可信度及精密度,最优反应条件为：pH=9.88、n（Mg）：n（N）=1.50：1、n（P）：n（N）=1.38：1时,剩余氨氮浓度为46.58 mg/L,剩余总磷浓度为7.85 mg/L。在最优条件下所得到的沉淀物并非纯净的MgNH₄PO₄·6H₂O,还有Mg₃（PO₄）₂·22H₂O生成。     

The life cycle assessment of an e-waste treatment enterprise in China

Electrical and electronic waste (e-waste) has become one of the fastest growing waste streams in the world, and many countries have established e-waste treatment enterprises to solve their e-waste problems. In this study, a life cycle assessment (LCA) was undertaken to quantitatively investigate the environmental impacts of an e-waste treatment enterprise in China. The LCA is constructed by SimaPro software version 7.2 and expressed with the Eco-indicator 99 life cycle impact assessment method. For a sensitivity analysis of the overall LCA results, the so-called CML method is used in order to estimate the influence of the choice of the assessment method on the result. According to the survey data, discarded TV sets accounted for the highest proportion of e-waste treated in the enterprise in 2010. The e-waste treatment had little environmental impact, and at the same time large environmental benefits can be achieved mainly due to the recycled resources and reuse of some components. Based on the research results, it can be seen that recycled metal, especially copper, would be of more importance for environmental benefits. Relevant results and data from this study could provide decision support to enterprise managers and government sectors.     

Functional groups of marine ciliated protozoa and their relationships to water quality

Ciliated protozoa (ciliates) play important ecological roles in coastal waters, especially regarding their interaction with environmental parameters. In order to increase our knowledge and understanding on the functional structure of ciliate communities and their relationships to environmental conditions in marine ecosystems, a 12-month study was carried out in a semi-enclosed bay in northern China. Samples were collected biweekly at five sampling stations with differing levels of pollution/eutrophication, giving a total of 120 samples. Thirteen functional groups of ciliates (A–M) were defined based on their specific spatio-temporal distribution and relationships to physico-chemical parameters. Six of these groups (H–M) were the primary contributors to the ciliate communities in the polluted/eutrophic areas, whereas the other seven groups (A–G) dominated the communities in less polluted areas. Six groups (A, D, G, H, I and K) dominated during the warm seasons (summer and autumn), with the other seven (B, C, E, F, J, L and M) dominating in the cold seasons (spring and winter). Of these, groups B (mainly aloricate ciliates), I (aloricate ciliates) and L (mainly loricate tintinnids) were the primary contributors to the communities. It was also shown that aloricate ciliates and tintinnids represented different roles in structuring and functioning of the communities. The results suggest that the ciliate communities may be constructed by several functional groups in response to the environmental conditions. Thus, we conclude that these functional groups might be potentially useful bioindicators for bioassessment and conservation in marine habitats.     

Phosphine in paddy fields and the effects of environmental factors

Ambient levels of phosphine (PH₃) in the air, phosphine emission fluxes from paddy fields and rice plants, and the distribution of matrix-bound phosphine (MBP) in paddy soils were investigated throughout the growing stages of rice. The relationships between MBP and environmental factors were analyzed to identify the principal factors determining the distribution of MBP. The phosphine ambient levels ranged from 2.368 ± 0.6060 ng m⁻³ to 24.83 ± 6.529 ng m⁻³ and averaged 14.25 ± 4.547 ng m⁻³. The highest phosphine emission flux was 22.54 ± 3.897 ng (m² h)⁻¹, the lowest flux was 7.64 ± 4.83 ng (m² h)⁻¹, and the average flux was 14.17 ± 4.977 ng (m² h)⁻¹. Rice plants transport a significant portion of the phosphine emitted from the paddy fields. The highest contribution rate of rice plants to the phosphine emission fluxes reached 73.73% and the average contribution was 43.00%. The average MBP content of 111.6 ng kg⁻¹fluctuated significantly in different stages of rice growth and initially increased then decreased with increasing depth. The peak MBP content in each growth stage occurred approximately 10 cm under the surface of paddy soils. Pearson correlation analyses and stepwise multiple regression analysis showed that soil temperature (Ts), acid phosphatase (ACP) and total phosphorus (TP) were the principal environmental factors, with correlative rankings of Ts > ACP > TP.     

金属负载型催化剂对烟气脱硫性能的影响

介绍了国内外烟气脱硫催化剂的研究现状,研究了金属氧化物负载型催化剂对烟气脱硫性能的影响。以活性炭(AC)为载体,选用8种不同的金属硝酸盐作为浸渍液,采用等体积浸渍法制备金属氧化物负载型催化剂。以脱硫效果较好的Fe2O3/AC为例,研究了不同焙烧温度、金属负载量以及焙烧时间对催化剂脱硫性能的影响。实验结果表明,Fe2O3/AC催化剂脱硫率随着金属负载量的增加呈递增趋势,最优金属负载量为10.0%(质量分数);脱硫率随着焙烧温度的增加显著提高,最优焙烧温度为350℃;脱硫率随着焙烧时间的增加而提高,最优焙烧时间为3.0h。     

添加剂对炭黑颗粒润湿和沉降性能的影响

为提高湿式除尘装置对炭黑颗粒物的去除效率,通过向吸收液中添加复配表面活性剂以提高吸收液对炭黑的润湿性,投加絮凝剂使进入吸收液的炭黑颗粒发生凝聚和沉降,从而使吸收液得以循环利用。其中表面活性剂的复配以非离子表面活性剂月桂醇聚氧乙烯（9）醚（AEO-9）为主,与十二烷基苯磺酸钠（SDBS）、十六烷基三甲基溴化胺（CTAB）和壬酚基聚氧乙烯醚（TX-10）分别复配,筛选出复配效果最好的一组复配液;然后投加絮凝剂,探讨絮凝剂的加入对吸收液中炭黑颗粒物絮凝沉降的影响。结果表明,在AEO-9浓度为0．05mmol／L,TX-10浓度为0．09mmol／L时,吸收液的表面张力最小,为36．75mN／m;投加无机絮凝剂聚合氯化铝（PAC）浓度为100mg／L时,经15min沉降,炭黑的沉降率可达88．1％,上清液中悬浮颗粒的平均粒径为6．36μm。     

有害物质环境测试组合舱的研制及性能评价

研制了一种新型有害物质环境测试组合舱,该测试舱由舱体系（内舱和外舱）、恒温恒湿空气处理系统、空气循环装置和信号控制与处理软件组成。该测试舱具有可分别使用内舱和外舱对样品进行测试的特点,并采用美国FLUNT公司开发的air pack软件包对内舱和外舱的气流进行模拟与计算,并划分出内舱的层流区域,同时也对舱体系的性能进行了测试与评价。结果表明,有害物质环境测试组合舱的温湿度的相对标准偏差分别为0.04℃和0.7%,混合性达到90.7%。因此,该有害物质环境测试组合舱对温湿度控制精准,气流稳定,混合性能良好,能为室内空气污染研究提供条件稳定的室内仿真环境。     

改性膨润土作为垃圾渗透液防渗层的实验研究

本文以天然钠基膨润土为原料,采用水溶液聚合法,在室温条件下,通过改性聚丙烯酰胺对膨润土进行直接插层改性,制备了一种新型聚丙烯酰胺改性膨润土防渗材料。以此防渗材料作为防渗层,选用沈阳大辛填埋场的垃圾渗透液为处理对象,在动态实验下,就其对实际垃圾渗滤液中主要污染物去除的有效性和控制垃圾渗滤液渗透的可行性进行研究。抗渗性能测试结果表明,改性膨润土防渗性能较好,渗透系数为1．0×10^-7cm/s,达到固体废物填埋场的防渗材料国家标准1．0×10^-7cm／s的使用要求。改性膨润土防渗层对COD、氨氮、重金属离子去除效果较好,吸附作用较强,COD和氨氮最大去除率分别达到81％和91％,TFe、Zn^2＋和TCr的最大去除率分别达到71％、58％和73％。实验结果验证了本研究所制备的改性膨润土防渗材料具有优良的抗渗、截污性能。     

农村生活污水治理措施

介绍了适合于国内农村生活污水治理的一些技术与措施。沼气技术是当前处理农村生活污水的较佳选择。