Direct measurements of the drag force over aligned arrays of cubes exposed to boundary-layer flows

Wind tunnel measurements of the total drag force for aligned arrays of cubes exposed to two different boundary-layer flows at three flow velocities are discussed. The drag force for eight different building packing densities λ _p (from 0.028 to 1) is measured with a standard load cell generating a novel dataset. Different λ _p are reproduced by increasing the number of buildings on the same lot area; this represents a real situation that an urban planner is faced with when a lot area of a given (fixed) size is allocated to the development of new built areas. It is assumed that the surrounding terrain is uniform and there is a transition from a given roughness (smooth) to a new roughness (rough). The approaching flow will adjust itself over the new surface within a distance that in general may be larger than the horizontal length covered by the array. We investigate the region where the flow adjustment occurs. The wide range of packing densities allowed us to analyse in detail the evolution of the drag force. The drag force increases with increasing packing densities until it reaches a maximum at an intermediate packing density (λ _p  = 0.25 in our case) followed by a slight decrease at larger packing densities. The value of the drag force depends on the flow adjustment along the array which is evaluated by introducing the parameter “drag area” to retrieve information about the drag distribution at different λ _p . Results clearly suggest a change of the distribution of the drag force, which is found to be relatively uniform at low packing densities, while most of the force acts on first rows of the arrays at large packing densities. The drag area constitutes the basis for the formulation of a new adjustment length scale defined as the ratio between the volume of the air within the array and the drag area. The proposed adjustment length scale automatically takes into account the change in drag distribution along the array for a better parameterization of urban effects in dispersion models.     

The impact of infield biomass burning on PM levels and its chemical composition

In the South of Italy, it is common for farmers to burn pruning waste from olive trees in spring. In order to evaluate the impact of the biomass burning source on the physical and chemical characteristics of the particulate matter (PM) emitted by these fires, a PM monitoring campaign was carried out in an olive grove. Daily PM10 samples were collected for 1 week, when there were no open fires, and when biomass was being burned, and at two different distances from the fires. Moreover, an optical particle counter and a polycyclic aromatic hydrocarbon (PAH) analyzer were used to measure the high time-resolved dimensional distribution of particles emitted and total PAHs concentrations, respectively. Chemical analysis of PM10 samples identified organic and inorganic components such as PAHs, ions, elements, and carbonaceous fractions (OC, EC). Analysis of the collected data showed the usefulness of organic and inorganic tracer species and of PAH diagnostic ratios for interpreting the impact of biomass fires on PM levels and on its chemical composition. Finally, high time-resolved monitoring of particle numbers and PAH concentrations was performed before, during, and after biomass burning, and these concentrations were seen to be very dependent on factors such as weather conditions, combustion efficiency, and temperature (smoldering versus flaming conditions), and moisture content of the wood burned.     

Cleaning painted surfaces: evaluation of leaching phenomenon induced by solvents applied for the removal of gel residues

Cleaning is one of the most important, delicate, and at the same time controversial processes in the conservation treatment of paintings. Although a strict definition of cleaning would be the removal of dirt, grime, or other accretions (surface cleaning), in the conservation field, cleaning is used in the broader meaning to include thinning/removing altered or “unwanted layers” of materials without damaging or altering the physicochemical properties of the surfaces to be preserved. The cleaning of unvarnished paintings is one of the most critical issues that are currently discussed. Several studies exist regarding different cleaning tools, such as gels, soaps, enzymes, ionic liquids, and foams, as well as various dry methods and lasers, but only a few have been performed on the risk associated with the use of water and organic solvents for the cleaning treatments in relation to the original paint binder. The aim of the study is to verify analytically the behavior of water gelling agents during cleaning treatments and the interaction of the following elements: water or organic solvents applied for the removal of gel residues with the original lipid paint binder. For this purpose, the study was conducted on a fragment of canvas painting (sixteenth to seventeenth century) of Soprintendenza per i Beni Storici, Artistici ed Etnoantropologici del Friuli Venezia Giulia (Superintendence for the Historical, Artistic and Ethno-anthropological Heritage of Friuli Venezia Giulia), Udine by means of Fourier transform infrared spectroscopy, gas chromatography/mass spectrometry, and scanning electron microscopy.     

强化垂直流可渗透反应墙处理渗滤液污染物

针对垃圾渗滤液污染物组分多、处理难度大、可生化性差的特点,基于可渗透反应墙(PRB)被动修复技术,通过多种填料的组合构建三重垂直流PRB强化的砂箱模型,对垃圾渗滤液进行连续动态处理研究。实验结果表明,填料的组合顺序对强化PRB系统净化能力有较大的影响,由无烟煤、沸石、钢渣依次组成的强化垂直流PRB系统(2#砂箱)对NH+4-N、NO-3-N、NO-2-N、COD、PO3-4-P的平均去除率分别为96.12%、30.36%、75.24%、39.03%和30.47%,处理效果明显好于相同条件下依次由无烟煤、钢渣、沸石组成的强化垂直流PRB系统(1#砂箱)。与常规PRB处理系统相比,强化垂直流可渗透反应墙系统可实现垃圾渗滤液中多种污染物同步有效去除,是极具发展潜力的新型技术。     

拟开发场地的土壤重金属污染调查与评价实践

土壤污染调查乃"土壤修复"的前期。在某市郊拟开发建设的场地,按8个点分三层采集了24个土壤样品,用原子吸收光谱法测定样品中汞、铅、镉、铜、锌、镍、铬等7种重金属元素的含量,汞呈现对数正态分布,其他元素为正态分布,各元素在土壤层水平分布状态和垂直分布水平的差异性不显著,锌含量水平现状值在《土壤环境质量标准》GB15618-1995二级标准的指标限值内,汞、铅、镉、铜、镍、铬含量水平现状值均在土壤环境质量一级标准的指标限值内,且各元素浓度水平现状值均与场地所在区域土壤背景值一致。由此,本调查的场地土壤环境现状没有受到铅、汞、镉、铜、锌、镍、铬金属元素污染。     

Genotoxicity of sediment extracts of the Berre lagoon (France)

To evaluate the genotoxic risk that contaminated sediment could constitute for benthic organisms, three contaminated (VA, VC and VN) and one uncontaminated (RN) sediment samples were collected in the Berre lagoon (France). Potentially bioavailable contaminants in sediments were obtained using sediment extraction with synthetic seawater adjusted to pH 4 or pH 6, simulating the range of pH prevailing in the digestive tract of benthic organisms. The genotoxic activities of these extracts were evaluated by three short-term bioassays: the Salmonella mutagenicity test using the Salmonella typhimurium strain TA102, the alkaline comet assay and the micronucleus assay on the Chinese Hamster Ovary cells CHO-K1. Results of the Salmonella mutagenicity assay detected a mutagenic response for RN extract at pH 6, and for VA extract at pH 4. Results of the comet and micronucleus assays detected low genotoxic/clastogenic activities for VA and VC extracts at pH 6 and higher activities for RN, VA and VC extracts at pH 4. To identify if metals (Al, Fe, Mn, As, Cd, Co, Cr, Cu, Hg, Ni, Pb and Zn) were involved in these genotoxic activities, their concentrations were determined in the extracts, and their speciation was assessed by thermodynamic calculations. Results showed that extracts from sites VA, VC and VN generally presented the highest trace metal contents for both extractants, while the site RN presented lower trace metal contents but the highest Fe and Mn contents. Thermodynamic calculations indicated that Fe, Mn, As and in a lower extend Co, Ni and Zn were mainly present under free forms in extracts, and were consequently, more likely able to induce a genotoxic effect. Results globally showed no correspondence between free metal contents and genotoxic activities. They suggested that these positive results could be due to uncharacterized compounds, acting as direct genotoxic agents or enhancing the genotoxic properties of analyzed metals.     

Cosorption of organic chemicals with different properties: their shared and different sorption sites

Complementary sorption of different chemicals was expected and investigating the relationship between the sorption inhibition of primary sorbate (ΔQ(pri)) and sorption of secondary sorbate (Q(sec)) could provide a new angle to understand coadsorption of different chemicals. This study used bisphenol A (BPA) as the primary adsorbate, sulfamethoxazole (SMX) as the competitor, and carbon nanotubes as model adsorbents to study their complementary and competitive adsorption. At low BPA concentrations, the sorption of SMX (Q(sec)) exceeded BPA sorption inhibition (ΔQ(pri)), indicating that these two chemicals complementarily adsorbed on their respectively preferred sorption sites. At high BPA concentrations, higher ΔQ(pri) was observed in comparison to Q(sec), which may be resulted from different packing efficiencies of the adsorbed SMX and BPA. This study emphasized that both competitive and complementary sorption should be discussed in binary sorption system.     

City breathability and its link to pollutant concentration distribution within urban-like geometries

This paper is devoted to the study of pollutant concentration distribution within urban-like geometries. By applying efficiency concepts originally developed for indoor environments, the term ventilation is used as a measure of city “breathability”. It can be applied to analyse pollutant removal within a city in operational contexts. This implies the evaluation of the bulk flow balance over the city and of the mean age of air. The influence of building packing density on flow and pollutant removal is, therefore, evaluated using those quantities. Idealized cities of regular cubical buildings were created with packing density ranging from 6.25% to 69% to represent configurations from urban sprawl to compact cities. The relative simplicity of these arrangements allowed us to apply the Computational Fluid Dynamics (CFD) flow and dispersion simulations using the standard k–? turbulence model. Results show that city breathability within the urban canopy layer is strongly dependent from the building packing density. At the lower packing densities, the city responds to the wind as an agglomeration of obstacles, at larger densities (from about 44%) the city itself responds as a single obstacle. With the exception of the lowest packing density, airflow enters the array through lateral sides and leaves throughout the street top and flow out downstream. The air entering through lateral sides increases with increasing packing density.At the street top of the windward side of compact building configurations, a large upward flow is observed. This vertical transport reduces over short distance to turn into a downward flow further downstream of the building array. These findings suggest a practical way of identifying city breathability. Even though the application of these results to real scenarios require further analyses the paper illustrates a practical framework to be adopted in the assessment of the optimum neighbourhood building layout to minimize pollution levels.     

乌江梯级电站开发对大型底栖无脊椎动物群落结构和多样性的影响

为了解乌江贵州段的底栖动物资源现状以及梯级电站开发对底栖动物群落结构和多样性的影响,对18个断面的底栖动物进行了调查。底栖动物多样性通过Shannon Wiener多样性指数进行计算。结果显示：自然河段中,底栖动物物种丰富,以节肢动物占优势,物种丰富度和密度均以思南断面最高,生物多样性则以沿河二桥断面最高;群落类型复杂,环节动物 软体动物 节肢动物为优势群落,软体动物为群落中的优势类群。梯级水库的修建使底质环境差异变小,底栖动物物种丰度、密度和生物多样性降低,群落类型趋于简单,优势类群表现不明显,并且水库建成的年代越久,底栖动物的丰度、密度就越低,群落的组成类群就越少,物种组成以寡毛类和摇蚊类为主。研究表明,梯级电站的修建对底栖动物的物种组成、密度分布、多样性、群落类型等都造成了负面影响。〖     

Effects of nitrogen application rate and a nitrification inhibitor dicyandiamide on methanotroph abundance and methane uptake in a grazed pasture soil

Methane-oxidizing bacteria (methanotrophs) in the soil are a unique group of methylotrophic bacteria that utilize methane (CH₄) as their sole source of carbon and energy which limit the flux of methane to the atmosphere from soils and consume atmospheric methane. A field experiment was conducted to determine the effect of nitrogen application rates and the nitrification inhibitor dicyandiamide (DCD) on the abundance of methanotrophs and on methane flux in a grazed pasture soil. Nitrogen (N) was applied at four different rates, with urea applied at 50 and 100 kg N ha^?1 and animal urine at 300 and 600 kg N ha^?1. DCD was applied at 10 kg ha^?1. The results showed that both the DNA and selected mRNA copy numbers of the methanotroph pmoA gene were not affected by the application of urea, urine or DCD. The methanotroph DNA and mRNA pmoA gene copy numbers were low in this soil, below 7.13?×?10³ g^?1 soil and 3.75?×?10³ μg^?1 RNA, respectively. Daily CH₄ flux varied slightly among different treatments during the experimental period, ranging from ?12.89 g CH₄ ha^?1 day^?1 to ?0.83 g CH₄ ha^?1 day^?1, but no significant treatment effect was found. This study suggests that the application of urea fertilizer, animal urine returns and the use of the nitrification inhibitor DCD do not significantly affect soil methanotroph abundance or daily CH₄ fluxes in grazed grassland soils.