EDTA滴定法测定高锰水体总硬度的干扰和消除

测定水质总硬度最常用的是EDTA 滴定法,该法易受到多种因素的影响,而锰是重要影响因素之一。分析了锰对EDTA滴定法的影响,对比了两种掩蔽剂对不同浓度锰的掩蔽效果和对检测结果的影响。对实验结果进行了总结分析,为EDTA滴定法测定高锰水体总硬度过程中不同掩蔽剂的选择提供一定的依据。     

pH对铝盐絮凝剂形态分布与混凝除氟性能的影响

对比研究了AlC13和3种不同碱化度的聚合氯化铝(PACl)在不同pH与投量下除氟效果,并对不同形态铝盐除氟机理进行了初步探讨.结果表明,pH对絮凝剂水解后铝形态分布及其除氟效果有重要影响.pH 5 ～6时,Al3+和Al2、Al3等低聚态铝为AlCl3主要形态,且AlCl3更易水解生成可将溶解态氟转化为颗粒态氟的Al(OH)3,从而较PACl具有更佳除氟效果.pH ＞7时,PACl较AlCl3具有更佳除氟效果,且增大PACl碱化度可促进氟的去除,这主要是由于具有较高Al13含量的PACl更容易与电负性F-结合所致;且絮凝剂混凝除氟絮体ζ电位越高,越利于F-在絮体表面吸附.     

呼吸器标准中的泄漏率与实验室呼吸防护水平

结合国内外呼吸器最新标准中有关泄漏率与实验室呼吸防护水平的测试条件和方法,从基本概念和评价方法入手对比剖析了不同标准之间内容的差异.文中涉及的国内外标准主要有美国职业安全与健康研究所指定的系列化生放核呼吸器标准、欧洲EN 13274 - 1:2001、日本JIST8159:2006、中国GB 2626 - 2006和GB 2890 - 2009以及ISO/DIN 16900-1.2草案.通过对比分析不同标准之间在评价方法中采用的气溶胶种类、受试者人数、模拟动作种类及持续时间、采样方法、测试结果评价方法等具体内容,指出了我国呼吸器标准中泄漏率测试方法及相关标准发展中应注意的问题.     

The abatement of major pollutants in air and water by environmental catalysis

This review reports the research progress in the abatement of major pollutants in air and water by environmental catalysis. For air pollution control, the selective catalytic reduction of NO _x (SCR) by ammonia and hydrocarbons on metal oxide and zeolite catalysts are reviewed and discussed, as is the removal of Hg from flue gas by catalysis. The oxidation of Volatile organic compounds (VOCs) by photo- and thermal-catalysis for indoor air quality improvement is reviewed. For wastewater treatment, the catalytic elimination of inorganic and organic pollutants in wastewater is presented. In addition, the mechanism for the procedure of abatement of air and water pollutants by catalysis is discussed in this review. Finally, a research orientation on environment catalysis for the treatment of air pollutants and wastewater is proposed.     

Nitrogen removal from landfill leachate via ex situ nitrification and sequential in situ denitrification

Ex situ nitrification and sequential in situ denitrification represents a novel approach to nitrogen management at landfills. Simultaneous ammonia and organics removal was achieved in a continuous stirred tank reactor (CSTR). The results showed that the maximum nitrogen loading rate (NLR) and the maximum organic loading rate (OLR) was 0.65 g N l^?1 d^?1 and 3.84 g COD l^?1 d^?1, respectively. The ammonia and chemical oxygen demand (COD) removal was over 99% and 57%, respectively. In the run of the CSTR, free ammonia (FA) inhibition and low dissolved oxygen (DO) were found to be key factors affecting nitrite accumulation. In situ denitrification was studied in a municipal solid waste (MSW) column by recalculating nitrified leachate from CSTR. The decomposition of MSW was accelerated by the recirculation of nitrified leachate. Complete reduction of total oxidized nitrogen (TON) was obtained with maximum TON loading of 28.6 g N t^?1 TS d^?1 and denitrification was the main reaction responsible. Additionally, methanogenesis inhibition was observed while TON loading was over 11.4 g N t^?1 TS d^?1 and the inhibition was enhanced with the increase of TON loading.     

Physiological mechanisms of a wetland plant (Echinodorus osiris Rataj) to cadmium detoxification

Environmental Science and Pollution Research - Physiological responses of Echinodorus osiris Rataj plant under cadmium (Cd) stress (5 and 15 mg L?1) were studied by...     

纳米Al_2O_3固定化红平红球菌菌球的制备及其对苯酚的降解

以海藻酸铝为主要包埋材料、纳米Al_2O_3为添加剂,包埋固定红平红球菌,制得纳米Al_2O_3固定化红平红球菌菌球,并将其用于苯酚的降解。表征结果显示:菌球内部包含丰富的菌丝体;内部孔径以中孔居多。实验结果表明:菌球的最优制备方案为0.05 g纳米Al_2O_3加入3 m L海藻酸钠溶液中、海藻酸钠质量分数6%、微生物包埋量0.5 m L/m L(以海藻酸钠溶液计)、Al_2(SO_4)_3质量分数3%;在初始苯酚质量浓度为400 mg/L、反应时间为24h、菌球加入量为8 g/L、反应p H为8.0、反应温度为30℃的条件下,菌球首次使用时可使苯酚完全降解,使用5次后的苯酚降解率仍达93%以上,具有良好的循环使用性。     

分光光度法测定染色废水的色度

为消除测定染色废水色度的主观误差，采用分光光度法测定染色废水的色度，与稀释倍数法相比，具有精确，重现性好，适用范围广等特点，ＰＨ值对色度的测定有明显影响，控制ＰＨ值为７．６０，测定色度具有可比性。     

进出料频率对牛粪两相厌氧发酵特性的影响

以牛粪为发酵原料,在中温(35±2)℃的条件下,采用自行设计的两相厌氧发酵中试装置,在水力停留时间确定的前提下,酸化原料分别以每天、间隔1 d和间隔2 d 3种不同进出料频率加入产甲烷罐,观察挥发性固体(VS)产气率和甲烷含量的变化情况。实验结果表明:保持产酸相与产甲烷相水力停留时间(HRT)分别为3 d和17 d,每天进出料产气效果最佳,原料VS产气率和甲烷含量最大值分别为0.29 m3/(kg·VS)和58.36%。     

环境水中污染物亚硝酸根的现场快速测定研究

通过研制一种环境保护试纸从而能简便快速地现场半定量测定环境水中污染物亚硝酸根,便于野外水环境普查,应用它可使测定时间由标准法的3h左右短到5min,使分析成本大为降低。