不同曝气方式下SBR亚硝化的实现及NO2--N积累效果

研究不同曝气方式下亚硝化的实现以及基质浓度、曝气频率和温度对NO-2-N积累效果的影响。以实际污泥脱水液为研究对象,控制进水NH+4-N浓度在50~80 mg/L范围内,温度为27℃,pH值为7.8~8.2,DO浓度为0.5~1.0mg/L,分别采用连续曝气和间歇曝气2种方式启动SBR亚硝化反应器,并考察了在不同基质浓度、曝气频率和温度条件下NO-2-N累积情况。实验研究结果表明,经过40 d左右的运行,在2种不同曝气方式下SBR均成功实现了亚硝化,稳定运行阶段,NO-2-N积累率分别达到95%和85%。经SEM扫描电镜观察发现,在驯化成熟的活性污泥中,亚硝化细菌多呈球状和杆状,大小不同,外形饱满。当进水氨氮浓度小于200 mg/L,曝气频率为曝气15 min/停曝15 min,温度为27℃时,NO-2-N积累效果最佳,平均积累率可达90%以上。间歇曝气可以有效促进亚硝化细菌富集,有利于实现较高浓度的NO-2-N积累。基质浓度、曝气频率和温度对NO-2-N积累效果的影响显著。     

Estimation and characterization of unintentionally produced persistent organic pollutant emission from converter steelmaking processes

Unintentionally produced persistent organic pollutants (UP-POPs) including polychlorinated dibenzo-p-dioxins, and dibenzofurans (PCDD/Fs), polychlorinated biphenyls (PCBs), and polychlorinated naphthalenes (PCNs) were characterized and quantified in stack gas and fly ash from the second ventilation systems in five typical converters in five different steelmaking plants. The 2378-substituted PCDD/Fs (2378-PCDD/Fs) and dioxin-like PCB (dl-PCBs) toxic equivalents (TEQs) were 1.84–10.3 pg WHO-TEQ Nm^?3 in the stack gas and 5.59–87.6 pg WHO-TEQ g^?1 in the fly ash, and the PCN TEQs were 0.06–0.56 pg TEQ Nm^?3 in the stack gas and 0.03–0.08 pg TEQ g^?1 in the fly ash. The concentrations of UP-POPs in the present study were generally lower than those in other metallurgical processes, such as electric arc furnaces, iron ore sintering, and secondary metallurgical processes. Adding scrap metal might increase UP-POP emissions, indicating that raw material composition was a key influence on emissions. HxCDF, HpCDF, OCDF, HpCDD, and OCDD were the dominant PCDD/Fs in the stack gas and fly ash. TeCB and PeCB were dominant in the stack gas, but HxCB provided more to the total PCB concentrations in the fly ash. The lower chlorinated PCNs were dominant in all of the samples. The 2378-PCDD/F, dl-PCB, and PCN emission factors in stack gases from the steelmaking converter processes (per ton of steel produced) were 1.88–2.89, 0.14–0.76_, and 229–759 μg t^?1, respectively.     

Comparative quantification of oxygen release by wetland plants: electrode technique and oxygen consumption model

Understanding oxygen release by plants is important to the design of constructed wetlands for wastewater treatment. Lab-scale systems planted with Phragmites australis were studied to evaluate the amount of oxygen release by plants using electrode techniques and oxygen consumption model. Oxygen release rate (0.14 g O₂/m²/day) measured using electrode techniques was much lower than that (3.94–25.20 gO₂/m²/day) calculated using the oxygen consumption model. The results revealed that oxygen release by plants was significantly influenced by the oxygen demand for the degradation of pollutants, and the oxygen release rate increased with the rising of the concentration of degradable materials in the solution. The summary of the methods in qualifying oxygen release by wetland plants demonstrated that variations existed among different measuring methods and even in the same measuring approach. The results would be helpful for understanding the contribution of plants in constructed wetlands toward actual wastewater treatment.     

Geochemical processes of mercury in Wujiangdu and Dongfeng reservoirs, Guizhou, China

The geochemical processes of mercury in Dongfeng (DF) and Wujiangdu (WJD) reservoirs, which were constructed in 1992 and 1979, respectively in Wujiang River, which is the upper branch of Yangtze River were investigated. One sampling site was chosen upriver of 1 km from the dam for each reservoir. Three sampling campaigns were conducted at these sampling sites in December 2003, April 2004 and July 2004, respectively. The distributions of different mercury species in the water column, sediment, and sediment pore water were studied. We found that the sediment is the net source of both inorganic and MeHg to the water column for both reservoirs. The MeHg diffusion fluxes in WJD reservoir at all sampling campaigns were significantly higher than those in DF reservoir. Our study demonstrated that the high primary productivity in the reservoir produced elevated organic matter content that would favor the methylmercury production in sediment.     

表面活性剂加强动电技术去除污泥中铜和镉

以实际城市污泥为研究对象,通过采用表面活性剂作为阴极液,并考虑阴极液pH值、表面活性剂类型和电压3种因素对动电技术去除污泥中重金属(铜和镉)的影响,选用正交试验确定最佳试验条件.结果表明,采用表明活性剂作为阴极液加强动电技术去除污泥中重金属足可行的,铜和镉的去除率分别达到11.1%～52.6%和9.1%～46.7%.通过对正交试验结果进行极差和方差分析,试验的最佳条件为:电压为20 V,阴极液加入十六烷基三甲基氯化铵并控制pH值为4～6.表面活性剂的类型对动电技术去除镉具有显著影响.其中,表面活性剂类型对动电过程的影响最大,阴极液pH值次之,电压影响最小.     

海河干流、大沽排污河沉积物中有机氯农药的残留状况

调查了海河干流和大沽排污河沉积物中持久性有机氯杀虫剂(OCPs)的残留状况.在所选取的16个断面沉积物样品中均有大量HCHs、DDTs检出,表明海河和大沽排污河的DDT和HCH污染相当严重.海河沉积物中HCHs和DDTs总质量浓度分别为3.30～75.96、1.57～221.57 ng/g.大沽排污河沉积物中HCHs和DDTs的残留量分别为2.30～124.61、11.28～237.30ng/g.与国内外部分河流表层沉积物中HCHs、DDTs的含量相比,海河和大沽排污河沉积物中有机氯农药含量较高.最后根据两条河流沉积物中的OCPs的残留量,分析了其可能的污染源.     

利用填埋层内生物代谢控制生活垃圾填埋场渗滤液污染

讨论了目前国内卫生填埋场运行中存在的渗滤液问题 ,分析了不同填埋结构中生物代谢环境和主要污染物的代谢途径 ,探讨了不同填埋结构中利用渗滤液回灌来控制渗滤液污染的“生物反应器型”填埋技术。     

公路两侧土壤中铅和镉污染以及存在形态分布的分析

测定了土壤中铅、镉总量,并采用五级连续浸提法和石墨炉原子吸收分光光度法对北京市3条典型公路两侧的土壤样品中铅和镉的存在形态分布进行了测定.结果表明,所选3条公路出京方向右侧的土壤铅和镉污染严重,其铅、镉总量分别是北京地区土壤铅和镉含量背景值的1.62～6.69、5.97～18.74倍.土壤中铅主要以铁锰氧化物结合态、碳酸盐结合态、有机结合态和残渣态等形式存在,镉主要以铁锰氧化物结合态和残渣态形式存在,而活性强的离子交换态浓度均较低.不容忽视的是,铅和镉的碳酸盐结合态在碱性条件下稳定,但是具有遇酸释放的隐患.     

苏州市工业用地地表径流污染特性研究

对苏州新区枫桥工业园湘江路段的10场有效降雨事件的地表径流污染特性进行了研究.研究表明.地表径流水质参数COD、SS、NH3-N、TN、TP均服从对数正态分布,在95%置信水平下,SS与COD、TP、TN之问存在线性相关性(R=0.45～0.72).统计了污染物事件平均浓度(EMC),COD、SS、NH3-N、TN、TP的EMC中值分别为213、491、2.65、5.19、1.07 mg/L,相对应的单位面积污染物负荷分别为1 898、4 375、24、46、10 kg/(hm2·a).与韩国Chongju工业区和上海市相比,SS负荷高是苏州新区枫桥工业园地表径流水质的主要特点,削减SS负荷对控制其非点源污染具有重要意义.     

Baseline soil levels of PCDD/Fs established prior to the construction of municipal solid waste incinerators in China

In order to determine the baseline contamination by polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) in different areas in China, prior to the construction of municipal solid waste incinerators (MSWIs), a total of 32 representative soil samples was collected near 16 incinerators and analyzed for their PCDD/F concentrations. The PCDD/F baseline concentrations in the soil samples ranged from 0.32 to 11.4 ng I-TEQ kg⁻¹ (dry matter), with average and median value of 2.73 and 2.24 ng I-TEQ kg⁻¹ (dry matter), respectively, and a span between maximum and minimum recorded value of 36. The PCDD homologues predominated in 26 out of 32 soil samples, with the ratio (PCDDs)/(PCDFs) ranging from 1.1 to 164; however in the other 6 samples, PCDF homologues were larger, with the same ratio varying from 0.04 to 0.8. Principal component analysis (PCA) and hierarchical cluster analysis (HCA) were used to examine PCDD/F amount and profile in these soil samples, and their possible associations with known emission sources: in this process 6 really distinct isomer fingerprints were identified. Background PCDD/F levels and profiles were comparable to those found in soils from China and other countries and indicate a rather low baseline PCDD/F contamination of soils. The present data provide the tools for future assessment of a possible impact of these MSWIs.