日本城市污水再生利用方面的经验分析

日本开展污水再生利用工作已经有30年的历史,经过多年的积累,在综合管理、技术开发应用等方面取得了一定的成果.对日本在再生水政策标准、生产模式、处理技术和技术经济性、安全输配和水质安全性等方面的概况进行了汇总分析,并对缺水地区--福冈、东京都和横滨的再生水生产利用实例进行了介绍,以期对我国城市污水再生利用具有一定的借鉴.     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中,出现白色颗粒状物质,且随着负荷的提高,其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成,结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为,该白色颗粒的主要成分为长链羧酸钙盐,具体为硬脂酸钙。同时,对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Recycling of organic materials and solder from waste printed circuit boards by vacuum pyrolysis-centrifugation coupling technology

Here, we focused on the recycling of waste printed circuit boards (WPCBs) using vacuum pyrolysis-centrifugation coupling technology (VPCT) aiming to obtain valuable feedstock and resolve environmental pollution. The two types of WPCBs were pyrolysed at 600°C for 30 min under vacuum condition. During the pyrolysis process, the solder of WPCBs was separated and recovered when the temperature range was 400-600°C, and the rotating drum was rotated at 1000 rpm for 10 min. The type-A of WPCBs pyrolysed to form an average of 67.91 wt.% residue, 27.84 wt.% oil, and 4.25 wt.% gas; and pyrolysis of the type-B of WPCBs led to an average mass balance of 72.22 wt.% residue, 21.57 wt.% oil, and 6.21 wt.% gas. The GC-MS and FT-IR analyses showed that the two pyrolysis oils consisted mainly of phenols and substituted phenols. The pyrolysis oil can be used for fuel or chemical feedstock for further processing. The recovered solder can be recycled directly and it can also be a good resource of lead and tin for refining. The pyrolysis residues contained various metals, glass fibers and other inorganic materials, which could be recovered after further treatment. The pyrolysis gases consisted mainly of CO, CO(2), CH(4), and H(2), which could be collected and recycled.     

Bioconversion of dairy manure by black soldier fly (Diptera: Stratiomyidae) for biodiesel and sugar production

Modern dairies cause the accumulation of considerable quantity of dairy manure which is a potential hazard to the environment. Dairy manure can also act as a principal larval resource for many insects such as the black soldier fly, Hermetia illucens. The black soldier fly larvae (BSFL) are considered as a new biotechnology to convert dairy manure into biodiesel and sugar. BSFL are a common colonizer of large variety of decomposing organic material in temperate and tropical areas. Adults do not need to be fed, except to take water, and acquired enough nutrition during larval development for reproduction. Dairy manure treated by BSFL is an economical way in animal facilities. Grease could be extracted from BSFL by petroleum ether, and then be treated with a two-step method to produce biodiesel. The digested dairy manure was hydrolyzed into sugar. In this study, approximately 1248.6 g fresh dairy manure was converted into 273.4 g dry residue by 1200 BSFL in 21 days. Approximately 15.8 g of biodiesel was gained from 70.8 g dry BSFL, and 96.2 g sugar was obtained from the digested dairy manure. The residual dry BSFL after grease extraction can be used as protein feedstuff.     

竹炭对废水中Cu2+的吸附

探讨了竹炭粒径、加入量、溶液 pH、吸附时间、Cu2+初始质量浓度等因素对竹炭吸附 Cu2+效果的影响.实验结果表明:竹炭对废水中Cu2+有很好的吸附效果,当竹炭粒径小于0.15 mm、加入量为 16 g/L、溶液 pH 为 6.0、Cu2+初始质量浓度 25 mg/L、吸附时间为 1.5 h 时,竹炭对 Cu2+的去...     

催化湿式氧化预处理造纸黑液

采用连续式固定床反应器,利用自制稀土类复合金属氧化物催化剂对草浆造纸黑液进行了催化湿式氧化(CWAO)预处理研究.通过正交实验确定了最佳工艺条件为:进水COD 40 800 mg/L,空速0.8h-1,反应温度260℃,反应压力6.5 MPa.在此最佳条件下进行实验,COD去除率达90％.经CWAO工艺处理后,草浆造纸...     

A study on legislative and policy tools for promoting the circular economic model for waste management in China

The circular economy has been developing rapidly in recent years in China. A legislative system has been created to provide legal protection for the development of a circular economy, including a series of price and tax measures in the waste management area. These measures form the basic foundation for promoting better waste management under the circular economic model. Many challenges, however, remain. For instance, the legal system needs to incorporate more sophisticated science, and China lacks key waste treatment technology that could support the further development of a circular economy. There is also a need to educate the public about the concept of the circular economy and its benefits. Specific suggestions are made for the development and implementation of the circular economic model.     

Abundance and removal of antibiotic resistance genes (ARGs) in the rearing environments of intensive shrimp aquaculture in South China

Although research regarding antibiotic resistance genes (ARGs) in aquaculture environments has gained increasing scientific interest, further studies are required to understand the abundances and removal mechanisms of ARGs during the entire rearing period of shrimp aquaculture. Thus, in this study, abundances, distributions and removal rates of ARGs in different environmental compartments of intensive shrimp farms in South China were investigated during the entire rearing period. The results indicated that sul1 and cmlA were the predominant ARGs in the water and sediment samples. Additionally, the total abundance of ARGs was higher in shrimp pond water than in the source water and farm effluent. Moreover, sediment samples indicated significantly higher ARG abundances than water samples from the shrimp ponds (P?<?0.05). Environmental factors were found to significantly affect the distribution of ARGs in shrimp rearing environments. Furthermore, stable ponds aided the removal of ARGs from shrimp pond water. This study accounted for temporal variations in ARG abundances as well as removal of ARGs in different environmental compartments during the entire shrimp rearing period. However, additional research is required to optimize the water treatment process for removal of ARGs from the aquaculture.     

Analysis of metabolic changes in Trichoderma asperellum TJ01 at different fermentation time-points by LC-QQQ-MS

Trichoderma spp. are among the most widely recognized biocontrol fungi used to inhibit pathogens and promote plant growth. These functions are related to primary and secondary metabolites. This study investigated the different metabolites in Trichoderma asperellum TJ01 cultured for 24 and 72?h using liquid chromatography with triple-quadrupole mass spectrometry. Compared to the 24?h culture of T. asperellum TJ01, the 72?h culture with amino acid metabolism tended to decrease while sugar and lipid metabolisms tended to increase. Furthermore, the 72?h culture had a higher proportion of upregulated flavonoids, in combination with a higher proportion of downregulated alkaloids, and equal proportions of upregulated and downregulated polyphenols and hormones. This study also identified a few valuable medicinal substances such as trigonelline and 5-hydroxytryptophan in T. asperellum TJ01 fermentation cultures.