间歇浸取对废物水泥窑共处置产品中Cr和As释放的影响

研究间歇浸取条件下废物水泥窑共处置产品中重金属Cr、As的释放,对水泥产品在实际应用中的环境安全性评价有重要意义.通过模拟煅烧实验制取含Cr和As的水泥熟料,并制取混凝土样品,采用pH影响实验和扩散浸出实验,研究了混凝土中Cr和As的溶解特性及其间歇浸取对混凝土中Cr和As释放的影响.结果表明,浸取方式对浸取液pH有较...     

水力条件对复合人工湿地处理城市受污染河水效果的影响

通过对水力负荷、水力停留时间等水力条件的控制,观察其对复合垂直上行流人工湿地处理城市受污染河水效果的影响.一年多来的运行结果表明:水力条件对复合垂直上行流人工湿地去除其他污染物的影响显著,但对总氮去除的影响不大.水力停留时间的延长可提高总磷、氨氮、COD的去除效果;随着水力负荷的增加,总磷、氨氮、COD去除率都有所增加...     

O3-BAC组合工艺深度净化MBR出水的中试研究

采用臭氧-生物活性炭(O3-BAC)组合工艺对某工业园区再生水厂MBR出水进行了深度净化的中试研究,主要考察了组合工艺各节点对常规指标的处理效果.结果表明,臭氧投加量约3 mg/L(H2O)、臭氧接触塔接触时间为30min、活性炭滤池空床接触时间(BECT)为15 min时,O3-BAC组合工艺能有效去除水中色度、浊度...     

再生水厂原水水质在线预警系统研究与应用

再生水原水水质在线预警系统能够为再生水工艺安全、稳定的运行提供保障.以中国北方T市某再生水厂为例,分析再生水厂进水主要污染指标的变化规律,根据再生水厂的MBR处理工艺特征及要求,确定6项预警指标为pH、COD、TN、NH3-N、TP和SS.在原水水质在线监测系统的基础上,建立了基于神经网络的水质预测方法.结合实际运行情...     

日本城市污水再生利用方面的经验分析

日本开展污水再生利用工作已经有30年的历史,经过多年的积累,在综合管理、技术开发应用等方面取得了一定的成果.对日本在再生水政策标准、生产模式、处理技术和技术经济性、安全输配和水质安全性等方面的概况进行了汇总分析,并对缺水地区--福冈、东京都和横滨的再生水生产利用实例进行了介绍,以期对我国城市污水再生利用具有一定的借鉴.     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中,出现白色颗粒状物质,且随着负荷的提高,其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成,结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为,该白色颗粒的主要成分为长链羧酸钙盐,具体为硬脂酸钙。同时,对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Recycling of organic materials and solder from waste printed circuit boards by vacuum pyrolysis-centrifugation coupling technology

Here, we focused on the recycling of waste printed circuit boards (WPCBs) using vacuum pyrolysis-centrifugation coupling technology (VPCT) aiming to obtain valuable feedstock and resolve environmental pollution. The two types of WPCBs were pyrolysed at 600°C for 30 min under vacuum condition. During the pyrolysis process, the solder of WPCBs was separated and recovered when the temperature range was 400-600°C, and the rotating drum was rotated at 1000 rpm for 10 min. The type-A of WPCBs pyrolysed to form an average of 67.91 wt.% residue, 27.84 wt.% oil, and 4.25 wt.% gas; and pyrolysis of the type-B of WPCBs led to an average mass balance of 72.22 wt.% residue, 21.57 wt.% oil, and 6.21 wt.% gas. The GC-MS and FT-IR analyses showed that the two pyrolysis oils consisted mainly of phenols and substituted phenols. The pyrolysis oil can be used for fuel or chemical feedstock for further processing. The recovered solder can be recycled directly and it can also be a good resource of lead and tin for refining. The pyrolysis residues contained various metals, glass fibers and other inorganic materials, which could be recovered after further treatment. The pyrolysis gases consisted mainly of CO, CO(2), CH(4), and H(2), which could be collected and recycled.     

Bioconversion of dairy manure by black soldier fly (Diptera: Stratiomyidae) for biodiesel and sugar production

Modern dairies cause the accumulation of considerable quantity of dairy manure which is a potential hazard to the environment. Dairy manure can also act as a principal larval resource for many insects such as the black soldier fly, Hermetia illucens. The black soldier fly larvae (BSFL) are considered as a new biotechnology to convert dairy manure into biodiesel and sugar. BSFL are a common colonizer of large variety of decomposing organic material in temperate and tropical areas. Adults do not need to be fed, except to take water, and acquired enough nutrition during larval development for reproduction. Dairy manure treated by BSFL is an economical way in animal facilities. Grease could be extracted from BSFL by petroleum ether, and then be treated with a two-step method to produce biodiesel. The digested dairy manure was hydrolyzed into sugar. In this study, approximately 1248.6 g fresh dairy manure was converted into 273.4 g dry residue by 1200 BSFL in 21 days. Approximately 15.8 g of biodiesel was gained from 70.8 g dry BSFL, and 96.2 g sugar was obtained from the digested dairy manure. The residual dry BSFL after grease extraction can be used as protein feedstuff.     

Distribution and bioaccumulation of steroidal and phenolic endocrine disrupting chemicals in wild fish species from Dianchi Lake, China

The distribution and bioaccumulation of steroidal and phenolic endocrine disrupting chemicals (EDCs) were studied in various tissues of wild fish species from Dianchi Lake, China. In muscle tissue, 4-tert-octylphenol, 4-cumylphenol, 4-nonlyphenol and bisphenol A were detected in fish from each sampling site, with maximal concentrations of 4.6, 4.4, 18.9 and 83.5 ng/g dry weight (dw), respectively. Steroids (estrone, 17β-estradiol 17α-ethynylestradiol and estriol) were found at lower levels (<11.3 ng/g dw) and less frequently in muscle samples. The highest concentrations of steroids and phenols were found in liver, followed by those in gill and the lowest concentration was found in muscle. The field bioconcentration factors (BCFs) of phenols were calculated in fish species ranged from 18 to 97. Moreover, the measured tissue concentrations were utilized in order to estimate water concentration of steroids (4.4-18.0 ng/L). These results showed that steroidal and phenolic EDCs were likely ubiquitous contaminants in wild fish.