Use of chemical coagulants to control fouling potential for wastewater membrane bioreactor processes.

Chemical coagulation with ferric chloride, alum, and an organic polymer were used to control the fouling potential of mixed liquors for submerged membrane bioreactor (MBR) processes in treating municipal wastewater. Their filterability was evaluated using a submerged hollow fiber ultrafiltration apparatus operated in constant permeate flux mode. The collected transmembrane pressures over filtration time were used to calculate the membrane fouling rates. The results showed that coagulation pretreatment can reduce fouling rates when MBRs were operated above the critical flux. Even though coagulation with the organic polymer formed larger mixed liquor suspended solids particles and had shorter time-to-filtration than those with ferric chloride and alum, the filterability for membrane filtration were similar, indicating that the membrane fouling in MBR systems was mainly controlled by the concentration of smaller colloidal particles.     

静电布袋复合式除尘器及其应用

介绍了静电布袋复合式除尘器的结构、材料及除尘原理;布袋除尘器在不同工况下的除尘效率、附加脱硫率、阻力和排放浓度等参数的测试结果;利用布袋除尘器改造静电除尘器时的改造方案、运行中应注意的问题.     

Decolorization of cationic red X-GRL by wet air oxidation: performance optimization and degradation mechanism

The decolorization of a strong colored azo dye solution of cationic red X-GRL was investigated by wet air oxidation under relatively mild conditions (60-180 degrees C, PO2 = 0-1.2 MPa). Mono-factor experiments were carried out to investigate the effect of the operation factors and the relatively important parameters were selected for optimization using response surface methodology to explore the interactions of these relatively important parameters. Model regeneration analysis and the check experiments showed that the data of the general linear model agreed with the experiment results well. With multistage Monte-Carlo optimization, the best region of these variables could be predicted to dye color removal. At typical operational conditions, the intermediates of dye degradation were detected and confirmed by GC/MS system. Considering the intermediates and the structure analysis with the help of Gaussian 03W (version 6.0) and the theory of dye color, a possible degradation mechanism for the wet air oxidation of cationic red X-GRL was discussed and the probable degradation pathway was deduced.     

涡凹气浮(CAF)/SBR法在高寒地区屠宰废水中的应用

采用涡凹气浮(CAF)和序批式活性污泥(SBR)法处理高寒地区屠宰废水,在冬季室温15℃以上培养的活性污泥完全适应该工艺的要求.经该工艺处理后,出水水质可达到国家《污水综合排放标准》(GB 8978-1996)一级标准,COD、BOD5、SS、氨氮和TN去除率分别达到95.3%、96.7%、87.1%、63.3%和60.9%.     

k-C*模型的人工湿地模拟研究

采用自由表面流人工湿地,对广东省中山市某小区对应段的河涌进行生态修复改造。基于k-C*模型的计算结果表明,在对现有河涌的面积的利用下,TP和NH4+-N的去除效果受到限制。采用多因素正交实验对模型的计算结果进行实验验证和分析,研究了4种植物、4种基质,分别在2、4、6和8 d水力停留时间(HRT)下对TP和NH4+-N的去除效果,得到影响TP和NH4+-N去除效果的因素主次顺序分别为基质→植物→HRT和基质→HRT→植物;各因素的最佳水平条件分别为:风车草、颗粒活性炭、4 d(HRT)。在最佳水平条件下进行实验,结果表明,TP和NH4+-N的浓度均可达到出水排放标准浓度指标。k-C*模型的计算值总是比实验值偏高,但两者之间的误差在一个数量级范围内。     

改性CMC聚合物吸附酸法地浸废水中的铀

在温度为70～80℃、单体质量浓度为30%～35%、羧甲基纤维素∶丙烯酸(质量比)为10∶2.5、反应时间为3.5～4 h条件下对CMC进行改性,接枝率可达68%以上。以改性前后的CMC为吸附剂,对模拟酸法地浸含铀废水进行了对比吸附实验研究。结果表明:改性CMC对铀吸附效果最佳的实验条件为:改性CMC质量浓度为0.10 g/L,温度为25℃,pH为5.0,吸附时间100 min,此时铀去除率达到了97.1%,比CMC改性后对铀的吸附率平均提高了近21%。影响吸附效果程度由强到弱的顺序为:改性CMC投加量、pH、吸附时间、温度。     

响应面法优化超临界水氧化处理农药废水

在间歇式超临界水氧化系统中对草甘膦农药废水进行降解实验。选取温度、反应时间、过氧量3个量为因素量,总有机碳(TOC)去除率为响应量进行中心组合设计（CCD）。在实验的基础上,利用响应面分析法（RSM）对实验结果进行分析及参数优化：建立了TOC去除率与各个因素关系的二次多项式数学模型;分析了各个因素单独的及相互作用对TOC去除率的影响;优化结果表明,在温度483℃、反应时间29.2 min、过氧量148.4%的条件下,达到了最佳效果,此时TOC的去除率为100%。     

活性艳橙K-7R分子印迹聚合物微球的制备及结合特性研究

以微米级聚苯乙烯微球为种球,活性艳橙K-7R为模板分子,甲基丙烯酸为功能单体,乙二醇二甲基丙烯酸酯为交联剂,采用单步溶胀聚合法在水相中制得了分子印迹聚合物微球(MIPs),并用平衡吸附实验研究了其吸附性能。通过Scatchard分析,结果表明,MIPs在识别K-7R过程中存在两类结合位点,高亲和力结合位点的平衡离解常数Kd1=14.855μmol/L,最大结合量Qmax1=1.282μmol/g;低亲和力结合位点的平衡离解常数Kd2=70.939μmol/L,最大结合量Qmax2=3.930μmol/g。该MIPs对K-7R有较高的亲和性和选择性。     

铁及铁铜氧化物对臭氧氧化酸性红B的催化效能

采用自蔓延溶胶凝胶法分别制备了铁氧化物和铁铜复合氧化物催化剂,以酸性红B为降解对象,对比了单独臭氧氧化、铁氧化物和铁铜复合氧化物催化臭氧氧化对酸性红B的降解效果,考察了磁力搅拌速度(500～1 640 r/min)、溶液pH(3～11)、臭氧投加速率(3.55～28.4 mg/min)对铁铜复合氧化物催化性能的影响。结果表明,与单独臭氧氧化比较,铁氧化物和铁铜复合氧化物均能加速酸性红B的降解,促进色度和COD的去除,结合催化剂的表征结果,推断催化剂表面羟基促进臭氧分解产生.OH是其氧化性能较好的主要原因,另外,催化剂的吸附能力对催化性能也有一定影响。随着磁力搅拌速度、溶液pH、臭氧投加速率的增大,铁铜复合氧化物催化臭氧氧化酸性红B的效果越好。     

Fe3O4/SDS磁性纳米颗粒吸附水体中的Cd2+和Zn2+

一种新型纳米固相萃取吸附剂,由阴离子表面活性剂十二烷基磺酸钠(SDS)包裹在Fe3O4磁性纳米颗粒表面形成,用于吸附水溶液中的重金属离子。研究了吸附过程的主要影响因素(如SDS浓度、溶液pH等)以及解吸过程的最佳条件,并对其机理进行了初步的探讨。研究结果表明,共沉淀法制备的Fe3O4颗粒粒径分布均匀,平均粒径约为54 nm;SDS浓度为300 mg/L时,Fe3O4/SDS磁性纳米颗粒吸附Cd2+和Zn2+的能力最强;在一定浓度范围内,Fe3O4/SDS体系对Cd2+和Zn2+的吸附平衡数据符合Langmuir吸附等温方程,饱和吸附量分别为22.42 mg/g和13.95 mg/g。最终结果表明,Fe3O4/SDS磁性纳米颗粒具有较强磁分离能力和较好的吸附效果。