铬(Ⅵ)-碘化钾-甲基紫-聚乙烯醇体系分光光度法测定废水中痕量铬

研究了铬(Ⅵ)-碘化钾-甲基紫-聚乙烯醇高灵敏显色体系测定铬(Ⅵ)的新方法。实验结果表明:在最大吸收波长540 nm处,铬(Ⅵ)质量浓度在0～0.8 mg/L范围内符合朗伯-比耳定律,表观摩尔吸光系数为6.59×10~4L/(mol·cm);采用该法测定铬(Ⅵ)标准试样与镀铬废水,测定结果与国家标准分析方法的结果相吻合,加标回收率为94.0%～103.0%;测定11次0.4 mg/L铬(Ⅵ),相对标准偏差为2.1%。     

Pollution sources and occurrences of selected persistent organic pollutants (POPs) in sediments of the Mekong River delta, South Vietnam

The Mekong River delta is one of the largest agricultural land in the Southeast Asia. It plays a very important role for agriculture and fisheries in South Vietnam. However, comprehensive studies on the environmental pollution of persistent organic pollutants (POPs) in Mekong River delta have not been carried out in recent years. In this study, we collected sediment samples from the Mekong River to evaluate the contamination and ecological risks caused by several POPs. The contamination pattern of POPs was DDT>PCBs>CHLs>HCHs>HCB. DDTs are the most abundant pollutants, their concentration ranging from 0.01 to 110 ng/g dry wt, followed by PCBs (0.039-9.2 ng/g dry wt). DDTs and PCBs concentrations were higher in sediment from adjacent to urban areas than those from rural and agricultural sites, suggesting urban areas as important point sources of DDTs and PCBs to the river. Ratio of p,p'-DDT/p,p'-DDE was lower compared to those previously reported. However, some samples still had the ratio higher than 0.5, indicating recent input of DDT into the aquatic environments. This result shows that although the magnitude of contamination decreased over time, recent inputs of DDTs to the river still occur. Some sediment samples had concentrations of DDT compounds higher than the standards from the Canadian Environmental Quality Guideline, suggesting continuous monitoring for POPs contamination in the Mekong River is necessary.     

Speciation and assessment of heavy metals in surface sediments of Jinjiang River tidal reach, southeast of China

The concentration and speciation of heavy metals (Cr, Ni, Cu, Zn, Cd, Pb) in surface sediments (??≤ 63 μm) of Jinjiang River tidal reach are determined to evaluate the metal behavior. A modified BCR three-step sequential extraction procedure is carried out, and the residual fraction is undertaken by microwave-assisted acid digestion. The index of geo-accumulation indicates that Cd appeared highest among all these heavy metals in surface sediments, Cr, Cu, Zn lower, and Ni, Pb the least. The percentage of Zn, Cd is comparatively higher in the acid soluble fraction, Pb and Cu higher in the reductive fraction, indicating larger potential danger to the environment. So it is essential for developing the future remediation plans and pollution control strategies.     

Linear alkylbenzene sulfonate (LAS) in water of Lake Dianchi—spatial and seasonal variation, and kinetics of biodegradation

Agroforesty systems, which are recommended as a management option to lower the shallow groundwater level and to reuse saline subsurface drainage waters from the tile-drained croplands in the drainage-impacted areas of Jan Joaquin Valley of California, have resulted in excessive boron buildup in the soil root zone. To assess the efficacy of the long-term impacts of soil boron buildup in agroforesty systems, a mathematical model was developed to simulate non-conservative boron transport. The developed dynamic two-dimensional finite element model simulates water flow and boron transport in saturated–unsaturated soil system, including boron sorption and boron uptake by root-water extraction processes. The simulation of two different observed field data sets by the developed model is satisfactory, with mean absolute error of 1.5 mg/L and relative error of 6.5%. Application of the model to three different soils shows that boron adsorption is higher in silt loam soil than that in sandy loam and clay loam soils. This result agrees with the laboratory experimental observations. The results of the sensitivity analysis indicate that boron uptake by root-water extraction process influences the boron concentration distribution along the root zone. Also, absorption coefficient and maximum adsorptive capacity of a soil for boron are found to be sensitive parameters.     

Energy-efficient HVAC system through chillers’ capacity sizing for a library building

Heating, ventilating, and air-conditioning (HVAC) systems in commercial buildings consume the largest amount of energy. Recent surge in energy cost necessitates constant re-evaluation of HVAC system for most of the buildings. The objective of this study is to present the strategic approach on energy saving analysis of the HVAC system and chiller sizing optimization for a library building. Energy modeling code (eQUEST) for buildings simulation has been applied to verify and predict the long-term energy consumption of HVAC systems. To improve the accuracy of simulation results, the actual performance curves of the chillers and pumps were the inputs of curve fitting data from on-site field measurements data. Energy consumption data acquisition from the building energy management system (BEMS) for one year has been conducted comprehensively to calibrate energy modeling and to quantify energy saving results. The results revealed good agreement between energy modeling and BEMS data with the error of less than 10%. Besides, energy savings through the chillers’ sizing based on cooling load profile could be achieved satisfactorily by utilizing energy modeling by using the actual chiller performance curve. The energy saving for HVAC system can be obtained satisfactorily at the saving of 110,362 kWh per year. It is expected that the study will stimulate a more robust investigation of energy-efficient and cost-effective HVAC system specific for library buildings.     

Combined effects of deltamethrin, temperature and salinity on oxidative stress biomarkers and acetylcholinesterase activity in the black tiger shrimp (Penaeus monodon)

This study aimed to investigate the interactions of two abiotic factors (temperature and salinity) and deltamethrin (pyrethroid pesticide) exposure on some oxidative stress biomarkers as well as on acetylcholinesterase activity (AChE) in hepatopancreas, gills and muscle of black tiger shrimp (Penaeus monodon). A combination of three temperatures (24, 29 and 34 °C), two salinities (15 and 25 ppt), and the absence or presence of 0.1 μg L⁻¹ deltamethrin was applied on shrimp during 4 d under laboratory conditions. Lipid peroxidation level (LPO) and glutathione S-transferase activity (GST) were not affected by combined effect of temperature, salinity and deltamethrin in any of the studied tissues. Deltamethrin impaired other tested oxidative stress biomarkers, i.e. total glutathione (tGSH), catalase (CAT), glutathione peroxidase (GPx). tGSH level significantly increased in hepatopancreas due to deltamethrin exposure mainly at 34 °C, while pesticide effects on tGSH and CAT activity in gills were influenced by both temperature and salinity. In addition, GPx activity in hepatopancreas decreased after deltamethrin treatment mainly at 24 °C. Finally, AChE in muscle was strongly inhibited by deltamethrin at all tested temperatures and salinities. These novel findings demonstrate that interactions between abiotic factors and a commonly used pesticide exposure should be taken into account when analyzing some widespread biomarkers in black tiger shrimp.     

Isolation, identification and characterization of Bacillus amyloliquefaciens BZ-6, a bacterial isolate for enhancing oil recovery from oily sludge

Over 100 biosurfactant-producing microorganisms were isolated from oily sludge and petroleum-contaminated soil from Shengli oil field in north China. Sixteen of the bacterial isolates produced biosurfactants and reduced the surface tension of the growth medium from 71 to <30 mN m⁻¹ after 72 h of growth. These bacteria were used to treat oily sludge and the recovery efficiencies of oil from oily sludge were determined. The oil recovery efficiencies of different isolates ranged from 39% to 88%. Bacterial isolate BZ-6 was found to be the most efficient strain and the three phases (oil, water and sediment) were separated automatically after the sludge was treated with the culture medium of BZ-6. Based on morphological, physiological characteristics and molecular identification, isolate BZ-6 was identified as Bacillus amyloliquefaciens. The biosurfactant produced by isolate BZ-6 was purified and analyzed by high performance liquid chromatography-electrospray ionization tandem mass spectrometry. There were four ion peaks representing four different fengycin A homologues.     

Influence of amendments on soil arsenic fractionation and phytoavailability by Pteris vittata L

Increasing availability of soil arsenic is of significance for accelerating phytoremediation efficiency of As-polluted sites. The effects of seven amendments, i.e., citrate, oxalate, EDTA, sodium polyacrylate (SPA), phosphate rock (PR), single superphosphate (SSP), and compost on fractionation and phytoavailability of soil As were investigated in lab culture experiment. The results showed that the addition of PR, SPA, EDTA or compost to soils significantly increased the concentration of NaHCO₃-extractable As over a 120 d incubation period compared with the control (amendment-free) soil. Then, the four amendments were selected to add to As-contaminated soil growing Pteris vittata. It was concluded that As accumulation by the fern increased significantly under the treatments of PR and SPA by 25% and 31%, respectively. For As fractionation in soil, SPA increased Fe-As significantly by 51% and PR increased Ca-As significantly by 18%, while both the two amendments reduced occluded-As by 16% and 19%, respectively. Adding PR and SPA in soil increased the activities of urease and neutral phosphatase resulting from the improvement the fertility and physical structure of the soil, which benefits plant growth and As absorption of P. vittata. The results of the research revealed that both PR and SPA were effective amendments for improving phytoremediation of As-contaminated sites by P. vittata.     

Mercury capture into biogenic amorphous selenium nanospheres produced by mercury resistant Shewanella putrefaciens 200

Shewanella putrefaciens 200, resistant to high concentration of Hg(II), was selected for co-removal of mercury and selenium from aqueous medium. Biogenic Hg(0) reduced from Hg(II) by S. putrefaciens 200 was captured into extracellular amorphous selenium nanospheres, resulting in the formation of stable HgSe nanoparticles. This bacterial reduction could be a new strategy for mercury removal from aquatic environments without secondary pollution of mercury methylation or Hg(0) volatilization.     

Photocatalytic degradation of gaseous toluene by using immobilized titania/silica on aluminum sheets

Purpose

The aim of this study was to prepare a highly active immobilized titania/silica photocatalyst and to test its performance in situ toward degradation of toluene as one of the major toxic indoor contaminants.

Methods

In this work, two different titania layers immobilized on Al sheets were synthesized via low temperature sol?Cgel method employing presynthesized highly active titania powders (Degussa P25 and Millennium PC500, mass ratio 1:1): (a) with a silica/titania binder and a protective layer and (b) without the binder. The photocatalysts were characterized by X-ray diffraction, nitrogen sorption measurements, scanning electron microscopy (SEM), infrared spectroscopy, and UV?Cvis diffuse reflectance spectroscopy (DRS). The in situ photocatalytic degradation of gaseous toluene was selected as a probe reaction to test photocatalytic activity and to verify the potential application of these materials for air remediation.

Results

Results show that nontransparent highly photocatalytically active coatings based on the silica/titania binder and homogeneously dispersed TiO₂ powders were obtained on the Al sheets. The crystalline structure of titania was not altered upon addition of the binder, which also prevented inhomogeneous agglomeration of particles on the photocatalyst surface. The photoactivity results indicate that the adsorption properties and photocatalytic activity of immobilized photocatalysts with the silica/titania binder and an underlying protective layer were very effective and additionally, they exhibited considerably improved adhesion and uniformity.

Conclusion

We present a new highly photocatalytically active immobilized catalyst on a convenient metallic support, which has a potential application in an air cleaning device.