带有耗能连梁的钢筋混凝土剪力墙结构地震损伤评估

为了评估目前广泛研究的新型带有耗能连梁的剪力墙结构损伤程度,提出了一种适用于该结构的损伤模型,并通过低周反复试验结果对损伤模型进行验证。提出了该结构的地震性能等级及相应的损伤指数范围,并通过地震作用的增量动力分析得到该结构的易损性曲线,对该结构进行地震损伤评估。结果表明:提出的损伤模型能较好描述带有耗能连梁的钢筋混凝土剪力墙结构的损伤发展,地震性能等级及相应的损伤指数范围能较好反映该种结构的破坏等级,得到的易损性曲线能较为有效评估该种结构的损伤程度,为基于性能的新型带有耗能连梁的剪力墙结构的抗震设计及损伤评估提供了参考。     

钢铁渣粉在混凝土中的应用研究

为提高钢铁渣综合利用率,考察了钢铁渣粉作混凝土掺合料对混凝土抗压强度、工作性及对大体积混凝土温升的影响,并介绍了应用钢铁渣粉的工程项目。试验及工程应用表明,钢铁渣粉作混凝土掺合料,在相同胶凝材料用量下可显著提高混凝土抗压强度,在保证设计强度要求下可降低胶凝材料用量。此外,钢铁渣粉作混凝土掺合料能提高混凝土的工作性及施工性能,并可能降低混凝土内部温升,是一种新型的混凝土掺合料。     

A straightforward green synthesis of N-(tert-butylsulfinyl)imines

A straightforward and environment-friendly protocol for the synthesis of valuable chiral N-(tert-butylsulfinyl)imines has been developed. Different from traditional process with benzaldehydes as substrates, arylmethyl alcohols, benzylthiol, dibenzyl ether, thioether, and disulfide are used as alternative substrates to react with tert-butanesulfinamide in the presence of KO^tBu under air for the synthesis of chiral N-(tert-butylsulfinyl)imines. This is a transition metal-free, mild, cost-effective, and simple process.     

为我国粮食安全构建高质量的生态屏障

粮食作为重要的战略物资,事关国家的经济安全和社会安定。而加快林业生态建设,构建高质量的生态屏障是林业部门应做的贡献。本文认为,良好的生态条件是我国粮食安全体系的重要组成部分。     

城市污水深度处理中有机物的去除

以城市污水地下水回灌为回用目的 ,研究不同的污水深度处理工艺及对二级生物处理出水中有机物的去除 .研究结果表明 ,原水若未经深度处理 ,直接由土壤含水层处理的出水不能满足推荐的回灌水水质要求 .对原水分别采用混凝沉淀、过滤、臭氧氧化、粉末活性炭和粒状活性炭吸附等处理单元及组合工艺进行深度处理效果的对比 ,最终选用由混凝沉淀 ,砂滤 ,粒状活性炭过滤与土壤含水层处理相结合的工艺流程 .城市污水处理厂的二级出水经该工艺处理后 ,出水中的 DOC可降至 3mg/L以下 ,且活性炭柱的产水床体积可达 350 0 BV.     

珠江口和邻近海域沉积有机质的来源及其沉积通量的时空变化

分析了珠江口和邻近海域沉积有机质(OM)的总有机碳(TOC)、总氮(TN)及稳定碳同位素组成〔δ(13C)〕等地球化学参数,并对有机质的来源和沉积通量进行了研究. 结果表明,珠江口沉积有机质来自大陆(52%)和水生(48%)混合来源;而邻近海域沉积有机质主要为水生来源(93%). 珠江口陆源有机质含量〔w(T－OC)为5.4 　mg/g〕远远高于邻近海域(0.49 　mg/g),近年来珠江口TOC和陆源有机质(T-OC)的平均沉积通量分别为5.57和2.2～3.6 mg/(cm2·a),说明珠江河口接受了大量的陆源有机物的输入,这是由于自20世纪后期的几十年以来,华南地区经济快速增长造成大量土地开垦,以及工农业生产和生活污水的排放所致. 珠江口和邻近海域的水生有机质沉积通量在近年均呈增加趋势,在珠江口达到最大值3.6 mg/(cm2·a),说明大量的营养物质导致水体的富营养化,从而促使水域初级生产力的增长.      

Adsorption of microcystins by carbon nanotubes

The production of cyanobacterial toxins microcystins (MCs) by cyanobacterial bloom which may promote the growth of tumor in human liver is a growing environmental problem worldwide. In this paper, the adsorption of MC-RR and LR, which were extracted from cyanobacterial cells in Dianchi Lake in China, by carbon nanotubes (CNTs), wood-based activated carbon (ACs) and clays were investigated. Compared with ACs and clay materials of sepiolite, kaolinite and talc tested, CNTs were found to have a strong ability in the adsorption of MCs. At the concentrations of 21.5 mg l(-1) MC-RR and 9.6 mg l(-1) MC-LR in 50 mmol phosphate buffer solution (pH 7.0), the adsorption amounts of MCs by CNTs with the range of outside diameter from 2 to 10nm were 14.8 and 5.9 mg g(-1), which were about four times higher than those by other adsorbents tested. It was shown that with the decrease of CNTs outside diameters from 60 to 2 nm, the adsorption amount of MCs was apparently increased, however the size of CNTs particles formed in solution declined. This result implies that the size of CNTs tube pore that is fit for the molecular dimension of MCs plays a dominant role. Furthermore the specific surface area of CNTs was also found to be a factor in the adsorption of MCs. The results suggested that the selection of suitable size of CNTs as a kind of adsorbent is very important in the efficient eliminating MCs from drinking water in future.     

Polycyclic aromatic hydrocarbons and organochlorine pesticides in rice hull from a typical e-waste recycling area in southeast China: temporal trend, source, and exposure assessment

The residue levels of 16 US EPA priority polycyclic aromatic hydrocarbons (PAHs) and 16 selected organochlorine pesticides (OCPs) in rice and rice hull collected from a typical e-waste recycling area in southeast China were investigated from 2005 to 2007. PAHs and OCPs also were measured in ten mollusk species (soft tissues) collected in an adjacent bay in 2007. Individual PAHs were frequently found in the entire sample set (including the rice, hull, and mollusk samples) with a detection rate of 73 %. The total concentrations of 16 PAHs (ΣPAHs) and 16 OCPs (ΣOCPs) were in the range of 40.8–432 ng/g dry weight (mean: 171 ng/g) and 2.35–925 ng/g (122 ng/g), respectively, which were comparable or higher than those reported in some polluted areas. Statistical comparisons suggested that the concentrations of contaminants in hull gradually decreased from 2005 to 2007 and the residue levels were generally in the order of mollusk, hull, and rice, on a dry weight basis. Principal component analysis in combination with diagnostic ratios implied that combustion of coal, wood, and plastic wastes that are closely associated with crude e-waste recycling activities is the main source of PAHs. The finding of decreasing trend of concentrations of PAHs in this area is consistent with the efforts of local authorities to strengthen regulations on illegal e-waste recycling activities. Composition analysis suggested that there is a recent usage or discharge of hexachlorocyclohexane and dichlorodiphenyltrichloroethane into the tested area. The estimated daily intake (EDI) of ΣPAHs and ΣOCPs (calculated from mean concentrations) through rice and mollusk consumption was 0.411 and 0.921 μg/kg body weight (bw)/day, respectively.     

Catalytic ozonation performance and surface property of supported Fe3O4 catalysts dispersions

Fe₃O₄ was supported on mesoporous Al₂O₃ or SiO₂ (50 wt.%) using an incipient wetness impregnation method, and Fe₃O₄/Al₂O₃ exhibited higher catalytic efficiency for the degradation of 2,4-dichlorophenoxyacetic acid and para-chlorobenzoic acid aqueous solution with ozone. The effect and morphology of supported Fe₃O₄ on catalytic ozonation performance were investigated based on the characterization results of X-ray diffraction, X-ray photoelectron spectroscopy, BET analysis and Fourier transform infrared spectroscopy. The results indicated that the physical and chemical properties of the catalyst supports especially their Lewis acid sites had a significant influence on the catalytic activity. In comparison with SiO₂, more Lewis acid sites existed on the surface of Al₂O₃, resulting in higher catalytic ozonation activity. During the reaction process, no significant Fe ions release was observed. Moreover, Fe₃O₄/Al₂O₃ exhibited stable structure and activity after successive cyclic experiments. The results indicated that the catalyst is a promising ozonation catalyst with magnetic separation in drinking water treatment.     

CuO/zeolite catalyzed oxidation of gaseous toluene under microwave heating

The development of a combined process of catalytic oxidation and microwave heating for treatment of toluene waste gas was described in this work. Toluene, a typical toxic volatile organic compound, was oxidized through a fixed bed reaction chamber containing zeolite-supported copper oxide (CuO/zeolite) catalyst mixed with silicon carbide (SiC), an excellent microwave-absorbing material. The target compound was efficiently degraded on the surface of the catalyst at high reaction temperature achieved by microwave-heated SiC. A set of experimental parameters, such as microwave power, air flow and the loading size of CuO etc., were investigated, respectively. The study demonstrated these parameters had critical impact on toluene degradation. Under optimal condition, 92% toluene was removed by this combined process, corresponding to an 80%–90% TOC removal rate. Furthermore, the catalyst was highly stable even after eight consecutive 6-h runs. At last, a hypothetical degradation pathway of toluene was proposed based on the experimental data obtained from gas chromatography-mass spectrum and Fourier transform infrared spectroscopy analyses.