天津市生物医学垃圾管理与处置方法研究

生物医学垃圾是一类成分复杂并有特殊危害的废物。本文在调查研究了天津市和国内其它部分地区生物医学垃圾产生、处置管理和管理现状的前提下，针对天津市的一些情况的特点，提出了一些生物医学垃圾处置管理和对策建议。     

环境影响评价中的危害分析及其实例应用——中河化工厂罐区扩建工程的危害分析

环境中有毒、易燃、易爆等物质的泄漏将会在不同程度上对人体和周围环境造成伤害。为此建设项目（特别是化工行业）在进行环境影响评价时，必需对这些潜在的危害物质及其可能发生的事故进行危害分析。本文通过对天津中河化工厂罐区扩建工程的危害分析，给出了危害分析的基本过程及其分析的理论方法，以便为今后化工行业建设项目的危害分析提供一个理论参考。     

Fenton法降解废弃聚乙烯醇面料的实验研究

采用Fenton法降解废弃聚乙烯醇(PVA)面料,以反应温度、初始pH、Fe~(2+)/COD质量比和H_2O_2/Fe~(2+)摩尔比为考察因素,得到最佳降解条件。结果表明,Fenton法的最佳降解条件为:反应温度60℃,pH=4,Fe~(2+)/COD质量比0.3,H_2O_2/Fe~(2+)摩尔比11。此时,降解质量浓度为50g/L的PVA面料废水,降解率超过90%,降解后黏均分子量下降了99.63%,COD去除率为61.57%,BOD/COD为0.46,吨水处理的经济成本为13 069.71元。     

催化湿法氧化处理垃圾渗滤液中Co/Bi催化剂的回收与再生

利用硝酸盐熔融法制备Co/Bi催化剂,用于催化湿法氧化(CWAO)处理垃圾渗滤液。对一次利用后的 Co/Bi催化剂进行回收和再生,在反应温度260 ℃、催化剂用量 2 g、氧分压 0. 5 MPa条件下,催化剂的回收率可达到(97. 09±0. 74)%。利用XRD、BET分析方法对新鲜制备、一次回收、一次再生、二次回收的催化剂进行表征,根据表征结果可知催化剂的活性为:新鲜制备>一次再生>二次回收>一次回收。利用上述催化剂在不同温度条件下降解垃圾渗滤液,在 280 ℃、300 ℃条件下,催化剂的活性为新鲜制备≈一次再生>一次回收,而在220 ℃、240 ℃、260 ℃条件下,则是新鲜制备>一次再生≈一次回收,表明低温条件下,一次再生的催化剂和一次回收的催化剂出现失活现象,并分析了催化剂失活的原因。     

Effects of humic substances on photodegradation of bensulfuron-methyl on dry soil surfaces

The photodegradation of the herbicide bensulfuron-methyl on dry soil surfaces in the presence and absence of humic substances was investigated under Xe lamp irradiation. A rapid rate of disappearance occurs in the humus-removed soil. The presence of humic acid (HA) and fulvic acid (FA) reduces degradation rates and has a quenching effect on the photodecomposition of bensulfuron-methyl. The quenching effect increases with increasing HA and FA concentration in soil. HA has a slightly greater ability to quenching the photolysis compared to FA. In addition, co-effects of HA and FA on quenching the photolysis are stronger than single effects of HA or FA.     

Designing monitoring networks to represent outdoor human exposure

Measurements of outdoor human exposure to suspended particulate matter (PM) are always constrained by available resources. An effective network design requires tradeoffs between variables measured, the number of sampling locations, sample duration, and sampling frequency. Sampling sites are needed to represent neighborhood and urban spatial scales with minimal influences from nearby sources. Although most PM measurements for determining compliance with standards are taken over 24-h periods every third to sixth day, outdoor human exposure assessment requires measurements taken continuously throughout the day, preferably over durations of 1 h or less. More detailed particle size and chemistry data are also desirable, as smaller size fractions and specific chemicals may be better indicators of adverse health effects than total mass samples.     

Method development for determination of fluroxypyr in soil

Four methods were developed for the analysis of fluroxypyr in soil samples from oil palm plantations. The first method involved the extraction of the herbicide with 0.05 M NaOH in methanol followed by purification using acid base partition. The concentrated material was subjected to derivatization and then cleaning process using a florisil column and finally analyzed by gas chromatography (GC) equipped with electron capture detector (ECD). By this method, the recovery of fluroxypyr from the spiked soil ranged from 70 to 104% with the minimum detection limit at 5 microg/kg. The second method involved solid liquid extraction of fluroxypyr using a horizontal shaker followed by quantification using high performance liquid chromatography (HPLC) equipped with UV detector. The recovery of fluroxypyr using this method, ranged from 80 to 120% when the soil was spiked with fluroxypyr at 0.1-0.2 microg/g soil. In the third method, the recovery of fluroxypyr was determined by solid liquid extraction using an ultrasonic bath. The recovery of fluroxypyr at spiking levels of 4-50 microg/L ranged from 88 to 98% with relative standard deviations of 3.0-5.8% with a minimum detection limit of 4 microg/kg. In the fourth method, fluroxypyr was extracted using the solid liquid extraction method followed by the cleaning up step with OASIS HLB (polyvinyl dibenzene). The recovery of fluroxypyr was between 91 and 95% with relative standard deviations of 4.2-6.2%, respectively. The limit of detection in method 4 was further improved to 1 pg/kg. When the weight of soil used was increased 4 fold, the recovery of fluroxypyr at spiking level of 1-50 microg/kg ranged from 82-107% with relative standard deviations of 0.5-4.7%.     

菌丝体表面分子印迹壳聚糖吸附剂对Cr3+的吸附性能研究

菌丝体表面分子印迹吸附剂所保留的印迹对过渡金属离子有着良好的吸附作用,以Cr3 作为吸附离子,系统研究了该吸附剂的吸附特性和影响因素.结果表明:吸附剂对Cr3 的饱和吸附容量可达60 mg/g;其吸附行为满足Langmuir方程式.初始浓度为200 mg/L时,最佳吸附pH在3～4,吸附容量可达到50 mg/g左右,离子强度对吸附没有影响,用0.5 mol/L硝酸或硫酸解吸Cr3 ,解吸率在90%以上.     

二氧化氯销毁氰化物的应用研究

在弱碱性条件下，二氧化氯消毒剂将氰化物氧化成无毒的氰酸盐（OCN）、二氧化碳和氮气。研究了影响二氧化氯销毁氰化物的几种因素：pH在8—11的范围内，不影响二氧化氯对氰化物的销毁率；在所试验的反应温度（0-40℃）内，温度对反应速率表现出有限的影响；二氧化氯与氰离子的最佳质量比为2：1；当氰离子最高使用浓度小于0．5g／L时，废水中氰离子浓度达一级以上的排放标准。     

SBR法处理高浓度氯霉素废水的实验研究

采用常规活性污泥法、间歇曝气活性污泥法和SBR法对高浓度氯霉素废水进行了对比处理试验。结果表明 ,SBR法优于其他两种方法。当进水COD浓度为 4 910mg L ,COD容积负荷为 9.8kg m3·d ,去除率可达 91.6 %。当废水中NH+4约为 4 5 5mg L时 ,脱氮率可达 6 0 %左右。污泥指数稳定在 88左右。