有害物质环境测试组合舱的研制及性能评价

研制了一种新型有害物质环境测试组合舱,该测试舱由舱体系（内舱和外舱）、恒温恒湿空气处理系统、空气循环装置和信号控制与处理软件组成。该测试舱具有可分别使用内舱和外舱对样品进行测试的特点,并采用美国FLUNT公司开发的air pack软件包对内舱和外舱的气流进行模拟与计算,并划分出内舱的层流区域,同时也对舱体系的性能进行了测试与评价。结果表明,有害物质环境测试组合舱的温湿度的相对标准偏差分别为0.04℃和0.7%,混合性达到90.7%。因此,该有害物质环境测试组合舱对温湿度控制精准,气流稳定,混合性能良好,能为室内空气污染研究提供条件稳定的室内仿真环境。     

矿化垃圾床＋三维电极／电Fenton法处理老龄垃圾渗滤液

提出以二级矿化垃圾床为预处理单元,串联三维电极／电Fenton处理老龄垃圾渗滤液的组合工艺。矿化垃圾床处理后渗滤液中COD、氨氮、总磷、色度的去除率分别为80．55％、88．47％、98．32％和87．53％。通过单因素实验和正交实验,确定了三维电极／电Fenton法最佳工艺条件。经该组合工艺后,渗滤液中COD、氨氮、总磷和色度的最高去除率分别可达97．08％、95．24％、99．55％和96．92％,其中COD、总磷、色度这3个指标低于《生活垃圾填埋场污染控制标准》（GB16889．2008）表2规定的排放标准,为该组合工艺在实际中的应用提供重要理论依据。     

添加氮损失抑制剂对蓝藻泥堆肥质量的影响

对脱水蓝藻进行大型生产性堆肥实验。研究堆肥过程中,氮损失抑制剂过磷酸钙的添加对堆肥物料各类理化性质的影响。研究结果表明,过磷酸钙加入的处理组与未加过磷酸钙的对照组堆制37 d后堆肥物料均可腐熟,且堆肥肥效均符合NY525-2002的相关要求。添加过磷酸钙处理组有机质含量为490 g/kg,全N、全P和全K含量分别为20.75、10.02和11.32 g/kg,总养分含量达到9.77%,堆肥品质明显优于对照处理。同时,在微生物的作用下,对照组中微囊藻毒素MC-RR与微囊藻毒素MC-LR去除率分别达到89.8%与78.3%。值得一提的是,添加过磷酸钙后,MC-RR和MC-LR的去除率得到进一步提高,分别达到了92.96%和100%,较好地保证了蓝藻堆肥农用的安全性,为脱水蓝藻好氧堆肥化提供了可行性依据。     

次氯酸钠处理终冷水中氰化物硫化物的研究

以次氯酸钠为氧化剂,用正交实验研究了次氯酸钠处理终冷水中氰化物和硫化物,得出正交实验中各因素的主次关系及对除氰除硫的影响。研究结果表明,反应体系的pH是影响脱氰脱硫的重要因素。在最佳处理条件,即pH为10．0,反应温度为25℃,投氯量系数为1．4,反应时间为45min．能使氰化物的质量浓度降至0．267mg／L,脱氰率高达99．8％,硫化物的质量浓度降到0．387mg／L,脱硫率达92．0％,达到≤0．5mg／L的国家排放标准。文章还对工业化提出了一些设想。     

Distribution of elements in needles of Pinus massoniana (Lamb.) was uneven and affected by needle age

Macronutrients (P, S, K, Na, Mg, Ca), heavy metals (Fe, Zn, Mn, Cu, Pb, Cr, Ni, Cd,) and Al concentrations as well as values of Ca/Al in the tip, middle and base sections, and sheaths of current year and previous year needles of Pinus massoniana from Xiqiao Mountain were analyzed and the distribution patterns of those elements were compared. The results indicated that many elements were unevenly distributed among the different components of needles. Possible deficiency of P, K, Ca, Mn and Al toxicity occurred in needles under air pollution. Heavy metals may threaten the health of Masson pine. Needle sheaths were good places to look for particulate pollutants, in this case including Fe, Cu, Zn, Pb, Cr, Cd and Al.     

Reliable evidences that the removal mechanism of hexavalent chromium by natural biomaterials is adsorption-coupled reduction

For the last few decades, over 200 papers have been published in the Cr(VI) biosorption research field. Most early studies have claimed that Cr(VI) was removed from aqueous phase through an anionic adsorption, but this approach has been lost old original position. It has been newly explained that these findings were misinterpreted due to errors in measuring the concentrations of different chromium species in the aqueous phase, insufficient contact time required for equilibrium and the lack of information about the oxidation state of the chromium bound to biomaterials. Although 'adsorption-coupled reduction' is now widely accepted as the mechanism of Cr(VI) biosorption by natural biomaterials, a number of researchers still believe that Cr(VI) is removed by anionic adsorption onto the biomaterials. Therefore, the objective of this study was to show reliable evidences that the removal mechanism of Cr(VI) by natural biomaterials is 'adsorption-coupled reduction'. Sixteen natural biomaterials were used to study the Cr(VI) biosorption. Not only Cr(VI) but also total Cr in the aqueous phase were analyzed. X-ray photoelectron spectroscope was also used to verify the oxidation state of the chromium bound to the biomaterials. Finally, the removal behavior of Cr(VI) by each biomaterial was described by a kinetic model based on a redox reaction.     

Use of chemical coagulants to control fouling potential for wastewater membrane bioreactor processes.

Chemical coagulation with ferric chloride, alum, and an organic polymer were used to control the fouling potential of mixed liquors for submerged membrane bioreactor (MBR) processes in treating municipal wastewater. Their filterability was evaluated using a submerged hollow fiber ultrafiltration apparatus operated in constant permeate flux mode. The collected transmembrane pressures over filtration time were used to calculate the membrane fouling rates. The results showed that coagulation pretreatment can reduce fouling rates when MBRs were operated above the critical flux. Even though coagulation with the organic polymer formed larger mixed liquor suspended solids particles and had shorter time-to-filtration than those with ferric chloride and alum, the filterability for membrane filtration were similar, indicating that the membrane fouling in MBR systems was mainly controlled by the concentration of smaller colloidal particles.     

制备方法对MgAl水滑石衍生氧化物负载钯催化剂丙烷完全氧化活性的影响

以沉积沉淀法(DP)、浸渍法(IM)和共沉淀法(CP)制备MgAl水滑石衍生氧化物负载钯催化剂,用ICP、XRD、SEM、TEM、EDS、TPR以及比表面测定等手段对催化剂进行了表征.ICP和XRD数据表明用上述3种方法均可成功制备水滑石为前体载钯催化剂.SEM、TEM、EDS数据表明不同方法制备的样品具有不同的形貌以及钯在其中的分散度.综合各类表征数据可知Pd在催化剂中暴露的活性位是影响其活性的主要因素.     

猪粪堆肥发酵菌种的分离筛选及特性研究

从多种样品材料中分离筛选出8株能以猪粪为基质生长的菌种,对其中4株菌(8B、8C、8E、2B)进行了初步分类鉴定,并对它们发酵猪粪培养基的特性作了研究.结果表明,这4株菌均属于芽孢杆菌属,其中8C、2B菌种生长最好,8B次之,而8E菌种则不适合作为发酵菌种;对培养基采取完全灭菌对菌种生长繁殖是有利的,间歇灭菌和不灭菌效果相对较差,甚至会对菌种产生不利影响;pH值的变化在一定程度上反映出微生物生长繁殖能力的强弱;较低的pH值不利于微生物菌种生长.     

石英砂负载氧化铁吸附除磷的热动力学研究

通过吸附动力学实验及等温吸附实验,考察了在10～40℃的温度条件下石英砂负载氧化铁(IOCS)吸附磷的热动力学性质.结果表明:准二级反应动力学模型及Langmuir等温吸附模型可分别较好地描述IOCS对磷的吸附动力学及吸附等温线实验结果(R2≥0.98);吸附速率及吸附容量随温度的增加而增加.吸附速率k从0.0095增加到0.0173,吸附容量从0.06 mg/g增加到0.08 mg/g.根据标准吉布斯自由能变(△G0＜0)和标准反应焓变(△H0＞0)值判断,IOCS对磷的吸附是自发的、吸热的化学吸附反应.