小城镇地震数字仿真与应急调度系统的研究

以地理信息系统为平台进行地震灾害研究,建立具有强大空间分析功能的信息系统,将发挥快速、准确的辅助决策作用.本文剖析了小城镇地震应急反应模式存在的弊端,明确了灾害空间的概念,并提出小城镇空间数据库的建库及三维可视化的技术方案.在基础信息数字化和可视化的基础上,开发了小城镇地震数字仿真与应急调度系统,实现了基于地震数字仿真结果,在相关数据库支持下进行地震应急调度决策.实践证明:该系统的运行,有利于小城镇抗震减灾的迅速决策;小城镇空间数据库的建库技术,贴合我国小城镇信息化的现状,技术可行、经济合理.     

延边地区公路沿线边坡失稳试验分析

延边地区公路沿线分布着大量软岩，其岩性具有强膨胀性，致使这一地区公路边坡出现了多处滑坡现象。为了合理地处理这一工程地质问题，需要认真研究该种软岩的膨胀特性。选取滑坡体软岩为研究对象，定量分析了其自由膨胀率、无荷膨胀率和有荷膨胀率，并具体测定了其膨胀力，探讨了其膨胀率和膨胀力的变化规律，揭示了研究区软岩的膨胀特性，为公路建设中软岩边坡加固参数的选取提供了科学的依据。     

城市公共安全规划与灾害应急管理的集成研究

随着城市公共安全理论研究与应用的不断深入,对于安全规划与灾害应急管理的孤立研究已渐露弊端.探讨了研究城市公共安全规划与灾害应急管理的融合模式,剖析了城市公共安全规划的空间范围与应变管理空间需求之间的关系,提出了以整合观和可持续发展观构建城市公共安全规划,以空间观构建城市应急管理机制的设想.在此基础上,根据有效服务范围和资源量,提出了城市各类防救灾设施的规划标准与建构模式,以建立城市救灾单元区域.     

利用GPS-RTK技术进行既有线曲线整正测量研究

既有线曲线整正测量是铁路既有线提速改造和工务部门大修设计的主要任务之一。需要改造的既有铁路一般均为繁忙干线,并行车密度较高。传统的测量方法是将测量仪器安置在线路上,这样不仅在作业过程中受行车干扰,作业效率也不够高,而曲线地段通视条件差,作业难度是相当大的。同时,作业人员的安全问题也变得十分突出。笔者提出采用先进的GPS-RTK技术,对既有线曲线整正进行测量。采用该技术不仅能克服气候条件的限制,而且能以较高的频率,较高的精度测定互不通视的各被测点的坐标,克服了传统的作业方法要求置镜点与被测点之间必须通视、作业受天气影响、存在误差累积、内业计算工作量大等缺陷。该法在保证作业人员安全的前提下大大提高作业效率。     

Research status,challenges and future prospects of renewable synthetic fuel catalysts for CO2 photocatalytic reduction conversion

Environmental Science and Pollution Research - In recent years, with global climate change, the utilization of carbon dioxide as a resource has become an important goal of human society to achieve...     

The effectiveness of the e-money incentive mechanism in promoting separation of recyclables at source in Malaysia

Journal of Material Cycles and Waste Management - A new concept of a reward system by two e-money-incentive systems aimed at improving separation at source toward reducing residual waste generation...     

Analysis of urban carbon emission efficiency and influencing factors in the Yellow River Basin

Environmental Science and Pollution Research - The Yellow River Basin is an energy-rich area. The low-carbon development of the Yellow River Basin is one of the ways to achieve ecological...     

含阶梯结构的高层楼梯井内烟气湍流及输运特征量的全局敏感性分析

高层建筑竖井火灾中影响因素众多,并且各因素对高层楼梯井火灾中重要现象、关键数值等的影响大小不一,使得此类火灾中的实验或理论研究成本较高。通过建立全局敏感性分析平台,定量考察了高层楼梯井结构所涉及因素的影响大小,并能够方便地筛选掉对所考察量影响较小的因素,以降低实验或计算成本。使用数值模拟方法,通过CFD软件对包含阶梯几何框架的高层楼梯井结构火灾进行了共计60次工况计算。并且根据计算结果,使用全局参数敏感性分析方法,得出建筑尺寸、热释放速率、环境参数对高层楼梯井内烟气湍流特性及输运特性的敏感性排序。结果表明,火源热释放速率对各输出参数的影响均占38%以上。     

Determination of trace metal concentrations in soil profiles of municipal waste dumps in Nigeria

The concentrations of trace metals (Cd, Pb, Cu, Cr, Fe, Ni, Zn and Co) were studied in soil profiles of eight municipal waste dump sites in Warri metropolis. The results indicate that concentrations of trace metals varied widely among the different dumpsites and decreased with depths in a studied soil profile. The accumulation pattern for the heavy metals in the soil profiles follows the order: Fe > Pb > Mn > Co > Cr > Zn > Ni > Cu > Cd. The concentrations of metals found in these sites was below the Canadian remediation criteria for land for agricultural, residential and commercial/industrial purposes except for the cadmium levels in some sites that exceeded criterion values for agricultural and residential. In such sites, remedial actions are required before any form of chosen development can take place. The levels of heavy metals found in these dump sites were higher than that of the control site. The examined metals showed no significant correlation with soil physicochemical properties at the surface horizon, which is suggestive evidence that these metals arise from anthropogenic input.     

Critical Review of Norms and Standards for Biodegradable Agricultural Plastics Part II: Composting

The critical review of norms and standards and corresponding tests to determine the compostability of biodegradable plastics, possibly applicable also to biodegradable agricultural plastics, shows that many norms concerning testing and labelling of compostable plastics have been established at the international level. Some of them are about plastic materials, some others are about products like packaging. The media and conditions of testing cover mainly the conditions designed for industrial composting facilities, and only a few concern home composting conditions. Considering that the end of life management of biodegradable agricultural plastic products will be done at the farm to reduce the management of the waste and also its cost, only a few of these norms are considered to be suitable for adaptation to cover also biodegradable agricultural plastic products. The biodegradability validation criteria under composting conditions, such as the threshold percentage of biodegradation and disintegration, the time and temperature, and the ecotoxicity, are presented for the main norms and standard testing methods. Based on these different norms and their content, a list of specs and technical requirements that could be adapted to meet farm composting conditions for agricultural compostable plastics is proposed. These requirements may be used as criteria for the establishment of a new integrative norm for agricultural compostable plastics.