Oxidative degradation of phenol by sulfidated zero valent iron under aerobic conditions: The effect of oxalate and tripolyphosphate ligands

After adding either organic or inorganic ligands, sulfidated nano-zero-valent iron (SnZVI) was used for aerobic degradation of phenol, and the effect of the ligand species on oxidation performance was investigated. We found that SnZVI hardly degraded phenol in the absence of ligand addition. Ligands initiated and promoted the degradation of pollutants by SnZVI. The data herein show that a characteristic inorganic ligand, tripolyphosphate (TPP), is more effective in enhancing oxidation than a characteristic organic ligand oxalate. In addition to the scavenging of reactive oxidants by the organic ligand, more ferrous ion (Fe(II)) dissolution from SnZVI in the TPP system is another cause for the superior enhancement by the inorganic ligand. In the oxalate system, as the sulfur content of SnZVI increased, the oxidation efficiency increased because FeS shell promoted the transfer of electrons to produce more reactive oxygen species (ROS). In TPP system, the effect of sulfur content on oxidation performance is more complex. The SnZVI with low sulfur content showed poor oxidation performance compared with that of nZVI. Further experiments proved that sulfidation might weaken the complexation of TPP with surface bound Fe, which would slow down the ionic Fe(II) dissolution rate. Therefore, sulfidation has the dual effects of enhancing electron transfer and inhibiting the complexation of inorganic ligands. In addition, the mechanisms of ROS generation in different ligand systems were investigated herein. Results showed that the critical ROS in both the oxalate and TPP systems are hydroxyl radicals, and that they are produced via one-electron activation of O₂.     

Diopside-based glass-ceramics from MSW fly ash and bottom ash

By utilising MSW fly ash from the Shanghai Yuqiao municipal solid waste (MSW) incineration plant as the main raw material, diopside-based glass-ceramics were successfully synthesized in the laboratory by combining SiO(2), MgO and Al(2)O(3) or bottom ash as conditioner of the chemical compositions and TiO(2) as the nucleation agent. The optimum procedure for the glass-ceramics is as follows: melting at 1500 degrees C for 30 min, nucleating at 730 degrees C for 90 min, and crystallization at 880 degrees C for 10h. It has been shown that the diopside-based glass-ceramics made from MSW fly ash have a strong fixing capacity for heavy metals such as lead (Pb), chromium (Cr), cadmium (Cd) etc.     

均相Fenton氧化-混凝法强化处理印染废水

采用均相Fenton氧化—混凝法对印染废水进行了强化处理。结果表明,该法特别适用于处理同时含有亲水性和疏水性染料的印染废水,处理过程充分发挥了均相Fenton氧化和混凝的协同作用,对废水中的水溶性有机物、胶粒和疏水性污染物均有较好的去除效果。在印染废水初始pH4.0左右,H2O2、FeSO4·7H2O和絮凝剂聚硅酸氯化铝(PASC)的加入量分别为3.6,1.8,8mL时,处理后废水的色度降到35,COD降到103mg/L,去除率分别高达95%和94.3%,脱色效果显著。     

分子印迹技术在环境科学领域中的应用

分子印迹技术（MIT）是一门新兴的边缘科学技术,它的产生与发展为环境科学打开了又一视角。介绍了MIT的产生与发展及基本原理,综述了MIT在环境科学领域中的应用,主要包括MIT在固相萃取、膜分离、色谱分析、传感器及分子印迹聚合物作为催化剂在环境修复中的应用。     

脱除SO2活性炭的再生方法

分别用溶剂和气体对脱除SO2后失活的活性炭进行了再生。在固定床反应器上考察了再生后活性炭的脱硫性能。实验结果表明：用溶剂再生时,质量分数为60％的HNO3溶液的再生效果最好,活性炭的再生率达到80％以上。用气体再生时,400℃左右时的再生效果最好,活性炭的再生率达到70％以上。再生后活性炭的比表面积和pH是衡量活性炭再生效果的重要参数。在实际脱硫生产中,用H2O对失活活性炭进行反复洗涤再生,是一种经济、实用的方法,活性炭的再生率达60％以上。     

高效喷淋泡沫脱硫技术及装置的应用

SO2是产生酸雨的主要气体,其主要来源于工业燃煤锅炉.以沈阳一家电厂为例,该厂选用新型高效的喷淋泡沫脱硫除尘器对锅炉排放的SO2进行治理.进入喷淋泡沫塔前的SO2平均浓度为2780 mg/m3,经脱硫后出塔平均浓度为289.3 mg/m3,去除率为89.6%.结果表明,这种有别于传统湿法的新型高效的喷淋泡沫脱硫技术及装置具有脱硫效率高、装置占地少、运行稳定、沉淀物易于回收利用等特点,对锅炉排放的SO2进行治理是非常有效的.     

城市环境地球化学调查研究方法综述

总结了城市环境地球化学调查的技术路线,论述了城市环境地球化学解释的思路和方法,提出了城市环境地球化学调查研究的重点问题及研究方向,为开展城市环境调查和评价工作提供了有参考价值的研究线索。     

原料含水率及成型直径对秸秆成型燃料耐久性的影响

原料含水率及成型直径对秸秆成型燃料耐久性具有重要影响,通过试验发现含水率对秸秆固化成型(SDBF)技术的抗渗水性影响很显著,原料含水率10%～15%(质量分数,下同)范围内得到的SDBF渗水分解超过4 h;原料含水率也显著影响SDBF的抗跌碎性,含水率不大于15%的SDBF失重率一般不超过5%,能满足规模化技术的应用.对于HPB-成型机生产的SDBF,成型直径大的SDBF抗渗水性时间较长,随着成型直径减小抗渗水性时间减少,抗渗水性能降低.     

用于干式脱污的CaO蒸汽活化实验研究

利用小型活化转炉实验台对以CaO为主要成分的钙基脱污剂在300～650℃的温度范围内进行蒸汽活化处理,结合X射线衍射和压汞仪的分析结果,初步探讨了蒸汽活化的机理.研究表明,蒸汽活化温度在600℃以上时,脱污剂孔隙结构有显著的改善,比孔容积和比表面积有着显著的增加,微孔(＜100nm)的数量大量增加,而低温下蒸汽活化的效果不是十分明显;研究还发现高温下延长活化时间有利于改善脱污剂的孔隙结构.     

水源水中摇蚊幼虫的孳生与生态控制

摇蚊幼虫(红虫)在城市供水系统中的出现,成为困扰水厂正常生产运行的又一水处理难题.首先对其生理特性与环境因子之间的关系进行了论述,然后从生态学角度出发,利用生态群落中的食物链关系,分析了富营养化水体中摇蚊幼虫大量孳生的原因.在此基础上提出了利用合理的生物操纵技术,通过鱼类与水生生物间的"下行效应",以达到恢复生态平衡并控制摇蚊幼虫孳生为目的的生态治理方案.