超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

Determination of partition and diffusion coefficients of formaldehyde in selected building materials and impact of relative humidity

The partition and effective diffusion coefficients of formaldehyde were measured for three materials (conventional gypsum wallboard, "green" gypsum wallboard, and "green" carpet) under three relative humidity (RH) conditions (20%, 50%, and 70% RH). The "green" materials contained recycled materials and were friendly to environment. A dynamic dual-chamber test method was used. Results showed that a higher relative humidity led to a larger effective diffusion coefficient for two kinds of wallboards and carpet. The carpet was also found to be very permeable resulting in an effective diffusion coefficient at the same order of magnitude with the formaldehyde diffusion coefficient in air. The partition coefficient (K(ma)) of formaldehyde in conventional wallboard was 1.52 times larger at 50% RH than at 20% RH, whereas it decreased slightly from 50% to 70% RH, presumably due to the combined effects of water solubility of formaldehyde and micro-pore blocking by condensed moisture at the high RH level. The partition coefficient of formaldehyde increased slightly with the increase of relative humidity in "green" wallboard and "green" carpet. At the same relative humidity level, the "green" wallboard had larger partition coefficient and effective diffusion coefficient than the conventional wallboard, presumably due to the micro-pore structure differences between the two materials. The data generated could be used to assess the sorption effects of formaldehyde on building materials and to evaluate its impact on the formaldehyde concentration in buildings.     

Rapidly eliminating pathogenic microorganisms in large air space using spraying *OH radicals

A new method for rapidly eliminating pathogenic microorganisms in large air space using spraying *OH radicals is presented in this paper With a physical method of strong electric-field discharge, large numbers of *OH radicals were produced by the oxygen activated particles of O2+, O(1D), O(3P), etc., and the introducing reagent HO2-. The gram-positive bacteria Bacillus subtilis, the gram-negative bacteria Serratia marcescens, and Bacillus spores were used for the eliminating experiments. Results show that the different microorganisms were rapidly killed by *OH radicals with a concentration of 0.8 mg/L and spraying density of 21 microL/m2 within 4 sec. Cell morphological changes were also observed under microscope. The cells of B. subtilis and Bacillus spores in their cellular wall, cellular membrane, or cell protoplasm were greatly destroyed when being exposed to a killing dosage of *OH radicals.     

Second-order chlorine decay and trihalomethanes formation in a pilot-scale water distribution systems

It is well known that model-building of chlorine decay in real water distribution systems is difficult because chlorine decay is influenced by many factors (e.g., bulk water demand, pipe-wall demand, piping material, flow velocity, and residence time). In this paper, experiments were run to investigate the kinetic model of chlorine decay and the formation model of trihalomethanes (THMs) in pilot-scale water distribution systems. Experimental results show that the rate constants of chlorine decay, including wall decay and bulk decay, increasing with temperature. Moreover, the kinetic model of chlorine decay and the formation model of THMs describe experiment data of pilot-scale water distribution systems. The effect of different piping material on chlorine decay and THMs formation were also investigated. The rate constants of chlorine decay are ranked in order: stainless steel pipe, ductile iron pipe, and last, polyethelene pipe because wall decay is the largest in stainless steel pipe than that in other piping material. Correspondingly, the rate of THMs formation follows the order of stainless steel pipe, ductile iron pipe, and last, polyethelene pipe because of less chlorine in bulk water reacting with the trihalomethane formation potential (THMFP).     

VFAs、TOC及COD作为生物除磷能力指标的探讨

在实际生活污水的处理中,研究了通过A/O运行模式对生物除磷过程中磷的变化情况及在厌氧释磷过程中COD、TOC与VFAs变化之间的关系。结果表明,在厌氧释磷过程中VFAs的变化更能准确地反映系统内释磷进程,实际生活污水中能直接用于磷释放的有机物含量占COD的13.33%,并且释放1 mg P所需VFAs为1.401 mg,此值明显低于前期研究结果。通过对COD、TOC和VFAs 3种组分的分析,可将实际生活污水中的有机底物分为3类:易生物降解含碳有机物、难降解的含碳有机物和水中存在的无机性还原物质,含量分别占COD的13.33%、31.7%和54.97%,其中只有13.33%的含量对生物释磷有直接作用,并可对实际生活污水除磷有指导意义。     

原位臭氧氧化污泥减量工艺的运行效能

采用ASBR/SBR原位臭氧污泥减量工艺,重点研究了原位臭氧氧化对SBR段污泥产率和出水水质的影响。两个相同的ASBR/SBR组合工艺同时运行,每隔3个周期向臭氧投加组SBR的曝气阶段原位间歇投加臭氧,臭氧投加量为0.027 g O3/g MLSS,连续运行40 d;对照组不投加臭氧作为对比。结果表明,原位臭氧氧化实现污泥减量约43.9%,臭氧投加组SBR段平均污泥产率系数为0.1447 g SS/g SCOD,而对照组为0.2580 g SS/g SCOD,投加组没有惰性污泥的累积,并且污泥沉淀性能得到改善。原位臭氧氧化对出水水质影响不大,投加组与对照组相比,臭氧投加3周期后的出水COD、NH4+-N、TN和TP平均值分别为47.8、0.76、14.1和6.4 mg/L,去除率分别下降了4%、2%、3%和7.7%,其中COD、NH4+-N和TN均能达到《城镇污水处理厂污染物排放标准》(GB18918-2002)一级A标准。     

厌氧池-复合型人工湿地系统污水处理效果的季节变化

利用厌氧池-复合型人工湿地(AT-ICW)系统处理农村生活污水,探讨工艺系统不同季节对污水的处理效果。结果表明,该工艺系统春、夏、秋季对氨氮(NH4+-N)、总磷(TP)表现出稳定且较好的去除效果,去除率分别为92.8%～97.0%和56.4%～65.9%,冬季去除率相对较差,平均去除率分别为67.1%和42.5%。NO3--N的去除效果差,四季均出现积累,累积率达到71.5%～342.9%。系统春、夏季对总氮(TN)去除效果较好,去除率为57.3%～68.9%,秋、冬季去除效果相对较差,为24.5%～35.8%。系统夏季COD去除效果好,平均去除率达到78.3%,冬、春季去除效果较差,为37.8%～43.5%。各项污水排放指标均达到城镇污水处理厂污染物排放一级A类标准。AT-ICW系统不仅处理效果好,而且运行费用低,适用于农村分散型生活污水处理。     

椰壳活性炭吸附消除VOCs

对一种椰壳活性炭对甲基丙烯酸甲酯的吸附消除行为进行了研究,重点考察了甲基丙烯酸甲酯的浓度、流速和吸附温度等条件以及水汽存在时对活性炭吸附行为的影响。结果表明,该颗粒活性炭对甲基丙烯酸甲酯有良好的吸附效果,甲基丙烯酸甲酯进口浓度和进气量的改变均会影响吸附饱和时间,导致其增加或减少。通过变温吸附实验确定降低环境温度对其吸附有促进作用。湿度为50%时吸附量相对干气饱和吸附量影响较小,说明该活性炭抗水汽能力较好。经多次重复再生实验,其饱和吸附量未见明显下降。     

热解吸对土壤中POPs农药的去除及土壤理化性质的影响

为探索土壤热解吸修复技术对POPs污染土壤的修复效果及修复后土壤可耕作性,选择北京某农药厂旧址的POPs农药污染土壤,研究了不同温度下热解吸处理后土壤中滴滴涕(DDTs)和六六六(HCHs)各组分的去除率以及土壤理化性质的变化。结果表明,热解吸修复技术可有效去除土壤中POPs农药,其中,p,p’-DDE与α-HCH组分去除率受热解吸温度的影响比其他组分更为明显。∑HCH与∑DDT在310℃、340℃时分别达到97%、99%的去除率,且此时土壤中的污染物含量低于我国《展览会用地土壤环境质量评价标准》,此后去除率受温度的影响不明显。热解吸温度对修复后土壤的理化性质有一定的影响,不同温度影响的程度各不相同,其中,有机质含量与全氮含量分别由0.78%、0.0352%降至0.14%、0.0107%;pH波动幅度较小,由7.80变至8.25;阳离子交换量变化存在波动,但呈整体下降趋势,由7.87 mg/kg降至5.00mg/kg;土壤中速效磷显著增加,由7.59 mg/kg升至21.8 mg/kg。而在最优温度条件下,土壤理化性质受热解吸温度的影响较小。由此可以说明,热解吸技术可以用于POPs污染土壤的修复,选择适当的热解吸温度对土壤的可耕作性影响有限,因而是一种潜在的绿色修复技术。     

玉米深加工废水的混凝实验

在室温条件下,分别选用聚合氯化铝(PAC)、聚合氯化铝铁(PAFC)及三氯化铁(FeCl3)对玉米深加工废水进行混凝实验。综合考虑各种混凝剂对磷、COD以及SS的去除效果,最终选取PAC作为混凝剂。采用PAC和聚丙烯酰胺(PAM)作为复合混凝剂,对其去除效果做进一步研究,并确定了最佳投加量及pH值。实验结果表明,在PAC投加量25mg/L,PAM投加量0.5 mg/L,pH为8条件下,混凝效果最佳。磷、COD、SS去除率可分别达到90.1%、53.3%和88.2%,对应的出水质量浓度分别为0.41、26.8和2 mg/L。