Three-dimensional modeling of air flow and pollutant dispersion in an urban street canyon with thermal effects

Effects of excess ground and building temperatures on airflow and dispersion of pollutants in an urban street canyon with an aspect ratio of 0.8 and a length-to-width ratio of 3 were investigated numerically. Three-dimensional governing equations of mass, momentum, energy, and species were modeled using the RNG k-epsilon turbulence model and Boussinesq approximation, which were solved using the finite volume method. Vehicle emissions were estimated from the measured traffic flow rates and modeled as banded line sources, with a street length and bandwidths equal to typical vehicle widths. Both measurements and simulations reveal that pollutant concentrations typically follow the traffic flow rate; they decline as the height increases and are higher on the leeward side than on the windward side. Three-dimensional simulations reveal that the vortex line, joining the centers of cross-sectional vortexes of the street canyon, meanders between street buildings and shifts toward the windward side when heating strength is increased. Thermal boundary layers are very thin. Entrainment of outside air increases, and pollutant concentration decreases with increasing heating condition. Also, traffic-produced turbulence enhances the turbulent kinetic energy and the mixing of temperature and admixtures in the canyon. Factors affecting the inaccuracy of the simulations are addressed.     

Mathematical model for carbon dioxide evolution from the thermophilic composting of synthetic food wastes made of dog food

The impacts of the aeration and the agitation on the composting process of synthetic food wastes made of dog food were studied in a laboratory-scale reactor. Two major peaks of CO(2) evolution rate were observed. Each peak represented an independent stage of composting associated with the activities of thermophilic bacteria. CO(2) evolutions known to correlate well with microbial activities and reactor temperatures were fitted successfully to a modified Gompertz equation, which incorporated three biokinetic parameters, namely, CO(2) evolution potential, specific CO(2) evolution rate, and lag phase time. No parameters that describe the impact of operating variables are involved. The model is only valid for the specified experimental conditions and may look different with others. The effects of operating parameters such as aeration and agitation were studied statistically with multivariate regression technique. Contour plots were constructed using regression equations for the examination of the dependence of CO(2) evolution potentials on aeration and agitation. In the first stage, a maximum CO(2) evolution potential was found when the aeration rate and the agitation parameter were set at 1.75 l/kg solids-min and 0.35, respectively. In the second stage, a maximum existed when the aeration rate and the agitation parameter were set at 1.8 l/kg solids-min and 0.5, respectively. The methods presented here can also be applied for the optimization of large-scale composting facilities that are operated differently and take longer time.     

我国小康生活水平的测量尺度与标准

本文在分析我国经济、社会发展规划、目标和现代化进程的基础上,借鉴国际上的通用标准,并结合我国国情,提出了我国小康生活水平的测量标准,建立了由20个指标构成的小康生活水平指标体系。     

PRED问题与地理工程

本文首先定义了由人口、资源、环境和发展构成的PRED问题的思路,讨论了它的性质;然后提出用地理工程解决PRED问题,并构建了地理工程的理论框架。     

危险化学品活性反应危害及混配危险的规则研究(Ⅱ)

第四类芳香烃 活性特点: 芳香烃化合物的分子里至少含有6个碳原子,并且含氢的比例较脂肪类化合物少得多,为共轭环状结构,非常稳定.     

Accumulation and phytoavailability of benzo[a]pyrene in an acid sandy soil

Effects of benzo[a]pyrene (B[a]P) on ryegrass (Lolium perenne L.) growth, plant accumulation and dissipiation of B[a]P in a red sandy soil (Hapli-Udic Argosol) were studied in a pot experiment. The plants were grown for 61 days in soil spiked with B[a]P at 0, 12.5, 25 and 50 mg kg⁻¹. Control pots without plants were also set up. Soil extractable B[a]P, plant shoot and root biomass, and concentrations of B[a]P in plant shoots and roots were determined. Ryegrass biomass was increased by addition of B[a]P and root B[a]P concentrations were significantly correlated with B[a]P application rate, but no such correlation was found for shoot B[a]P concentrations. This indicates that B[a]P enhanced the growth of the ryegrass. The extractable B[a]P concentration in the planted soil was significantly lower than that in the unplanted control soil at the rate of 50 mg B[a]P kg⁻¹. This indicates that ryegrass may help to dissipate B[a]P in soil at concentrations over 50 mg kg⁻¹ soil although the mechanism for this is not understood.     

新型聚乙烯填料生物滴滤床净化硫化氢气体的启动研究

研究了新型高密度聚乙烯改良型拉西环填料生物滴滤床净化硫化氢气体的启动过程,重点比较了启动过程中不同的挂膜方式对启动时间及效能的影响.结果表明,采用液相连续流强化挂膜法成膜时间短,在环境温度20～28℃时7 d可以挂膜成功.在启动过程中,随着工艺参数的突然改变(GRT缩短)和入口浓度波动,液相连续流强化挂膜后反应器的硫化氢去除率更稳定.在进气浓度最高为343 mg/m³时硫化氢去除率稳定在95%以上.试验过程中还发现,将SO₄^2-浓度作为活性污泥驯化完成的监测指标、液相S^2-去除率作为挂膜完成的监测指标更合理.启动结束后,通过2种途径减去喷淋液中的碳源并未影响硫化氢的去除率,这进一步表明生物滴滤床中硫化氢的净化主要由自养菌完成.     

Decomposition of silicate minerals by Bacillus mucilaginosus in liquid culture

The extraction of K⁺ and SiO₂ from silicate minerals by Bacillus mucilaginosus in liquid culture was studied in incubation experiments. B. mucilaginosus was found to dissolve soil minerals and mica and simultaneously release K⁺ and SiO₂ from the crystal lattices. In contrast, the bacterium did not dissolve feldspar. B. mucilaginosus also produced organic acids and polysaccharides during growth. The polysaccharides strongly adsorbed the organic acids and attached to the surface of the mineral, resulting in an area of high concentration of organic acids near the mineral. The polysaccharides also adsorbed SiO₂ and this affected the equilibrium between the mineral and fluid phases and led to the reaction toward SiO₂ and K⁺ solubilization. These two processes led to the decomposition of silicate minerals by the bacterium.     

Seasonal variation of the distribution of PCBs in sediments and biota in a PCB-contaminated estuary

To elucidate the effects of seasonal variation of precipitation on the distribution of polychlorinated biphenyls (PCBs) in estuarine sediments and benthic feeders, PCB concentrations of river surface sediments and mullet fish (Liza macrolepis) were investigated in the estuary of Er-Jen River near former PCB contamination sites before and after each wet season from 2002 to 2004. Analyses of grain size distribution and organic matter revealed that the pre-existing surface sediments were covered by and mixed with the soil particulates brought by surface runoff after each wet season. Obvious increment of PCB content and significantly elevated fraction (p < 0.005) of light PCBs of the river mouth’s sediments after each wet season indicated that the invading particles were rich in unweathered PCBs. PCBs previously buried in the surface soil of heavily contaminated sites were flushed into this estuary through surface runoff. The precipitation altered the PCB patterns in sediment organic matter, the dietary source of mullet, and consequently changed that of mullets accordingly, which all possessed significant greater fraction of light PCBs. In this study, it was demonstrated that seasonal summer precipitation affected the distribution of PCBs on surface sediments and the mullets of this estuary. PCB residuals retained in this region still pose potential threats to biota resided here.     

Removal of trichloroethylene from water by cellulose acetate supported bimetallic Ni/Fe nanoparticles

In this study, cellulose acetate (CA) supported Ni/Fe nanoparticles were prepared and the ability of these nanoparticles to remove trichloroethylene (TCE) from water was studied. The effects of TCE reduction by the nanoparticles and sorption by the CA support were accounted for separately in the model. CA supported post-coated Ni/Fe nanoparticles were used to investigate the effect of metal particle composition on the observed reduction rate constant. The results show that the metal mass normalized observed reduction rate constant was proportional to the Ni content in the post-coated Ni/Fe nanoparticles in the range of 0-14.3 wt.%. This constant reached a maximum between 14.3 and 21.4 wt.% and decreased with further increase in Ni content. CA supported co-reduced Ni/Fe bimetallic nanoparticles gave poorer performance compared to CA supported post-coated Ni/Fe bimetallic nanoparticles at the same Ni content in Ni/Fe nanoparticles.