基于三角随机模拟和ArcGIS的河流水环境健康风险评价模型

基于河流水环境系统中随机性、模糊性等多种不确定性共存或交叉存在的特性,将三角模糊数与随机模拟方法相耦合,构建了三角随机模拟模型,并将其应用到湘江(长沙段)的健康风险评价中。通过将各参数浓度进行三角模糊化和随机模拟,结果表明,各断面污染物造成的健康风险的变化趋势,总体沿湘江上游至下游逐步降低,表现为昭山 > 猴子石 > 五一桥 > 橘子洲 > 乔口 > 三汊矶,且昭山、三汊矶断面和乔口断面均有恶化趋势。相对于常规的确定性方法,本模型能够得出评价区域健康风险的可能值区间及其相应的概率水平等定量信息,更加客观、全面地表征评价区域的风险状态及其空间分布差异,为决策者提供更多有用的信息。     

Simultaneous determination of estrogenic odorant alkylphenols,chlorophenols, and their derivatives in water using online headspace solid phase microextraction coupled with gas chromatography-mass spectrometry

A simple online headspace solid-phase microextraction (HS-SPME) coupled with the gas chromatography-mass spectrometry (GC-MS) method was developed for simultaneous determination of trace amounts of nine estrogenic odorant alkylphenols and chlorophenols and their derivatives in water samples. The extraction conditions of HS-SPME were optimized including fiber selection, extraction temperature, extraction time, and salt concentration. Results showed that divinylbenzene/Carboxen/polydimethylsiloxane (DVB/CAR/PDMS) fiber was the most appropriate one among the three selected commercial fibers, and the optimal extraction temperature, time, and salt concentration were 70 °C, 30 min, and 0.25 g/mL, respectively. The developed method was validated and showed good linearity (R ²?>?0.989), low limit of detection (LOD, 0.002–0.5 μg/L), and excellent recoveries (76–126 %) with low relative standard deviation (RSD, 0.7–12.9 %). The developed method was finally applied to two surface water samples and some of these target compounds were detected. All these detected compounds were below their odor thresholds, except for 2,4,6-TCAS and 2,4,6-TBAS wherein their concentrations were near their odor thresholds. However, in the two surface water samples, these detected compounds contributed to a certain amount of estrogenicity, which seemed to suggest that more attention should be paid to the issue of estrogenicity rather than to the odor problem.     

酸碱改性对活性焦烧结烟气脱硫性能的影响

选取一定目数范围的活性焦,用3种酸(HCl、H2SO4和HNO3)、3种碱(KOH、NaOH和NH3·H2O)和酸碱两步(HNO3和KOH)对其进行改性处理,对比这几种方法改性的活性焦对烧结烟气的脱硫性能,实验结果表明,20~40目范围的活性焦脱硫性能最好;HCl改性活性焦的脱硫性能基本无变化,HNO3改性后有促进作用但作用不大,H2SO4改性反而降低了活性焦的脱硫活性;KOH和NaOH溶液改性活性焦对其脱硫性能有很大的提升作用,其中KOH改性效果更好,NH3·H2O改性基本无影响;先KOH后HNO3两步改性的活性焦效果最佳,并且能维持一定时间100%的脱硫效率。     

聚醚砜小球负载Comamonas sp.(bdq06)生物降解水中的喹啉

以聚醚砜为原料制备了一种具有多孔道的小球载体,负载睾丸酮丛毛单孢菌(bdq06)降解水中喹啉。制备的小球直径约3 mm,表面光滑,存在厚度约20μm的致密层。经过浸蚀去掉致密层后,露出粗糙表面,有助于细菌粘附和生殖。同时出现大量直径约1.5μm的孔道,且由外向内,孔径逐渐增大,细菌可以通过表层孔进入球内生殖。在pH为5、10和温度为40℃的条件下,负载菌的小球对水中喹啉的降解效果优于游离菌。小球具有良好的溶胀性和机械强度,经过多次重复使用后,球形完整而未破裂,细菌在球表面大量生殖形成生物膜,显著提高降解效率,能够在1 h内完全降解100 mg/L喹啉。以聚醚砜为原料制备的小球在废水处理中具有潜在应用前景。     

分子筛吸附法脱除废水中的聚丙烯酰胺

聚丙烯酰胺(PAM)用于油田驱油产生大量难处理的含聚废水。以分子筛为吸附剂处理含聚废水,研究分子筛类型(Y、Beta和ZSM-5,H型和Na型)和物化性质对其吸附PAM性能的影响,并测定吸附等温线。结果表明,吸附性能顺序为Beta>Y>ZSM-5,H型优于Na型。H-Beta对PAM的吸附来自分子筛中阳离子与PAM中阴离子的静电作用,Si—O和Al—OH与PAM中酰胺基的氢键作用。H-Beta开放的通道结构,较高的介孔比例和表面积,较强的酸性和良好的酸中心可接近性使其具有优异的吸附性能。SiO2/Al2O3=26的H-Beta对浓度为200 mg/L的PAM溶液,PAM脱除率可达95.2%。在低PAM平衡浓度时,PAM在H-Beta上的吸附符合Langmuir单层吸附特征,饱和吸附量达70.2 mg/g,在高浓度区域则由于PAM疏水缔合作用加强呈现多层吸附。     

300 MW燃煤锅炉机组超细颗粒聚并器的实验研究

为了解决燃煤锅炉烟气中超细颗粒难以脱除的问题,基于流体动力学原理设计了一种超细颗粒聚并器,并在300 MW燃煤锅炉机组电除尘器的前置烟道中进行了实验研究。结果表明,聚并器内部存在超细颗粒之间以及超细颗粒与大颗粒之间的相互聚集行为,从而使超细颗粒数量显著减少。例如,对于粒径在2.65和10.48 μm以下的颗粒,其体积比例在聚并器出口分别减少了56.7%和62.3%,在电除尘器出口的粉尘浓度减少了26.34 mg/Nm3,这表明,基于流体动力学原理的聚并器对超细颗粒的聚并作用明显,具有良好的应用前景。     

基于压力响应关系法的湖泊营养物基准制定

湖泊富营养化与氮、磷及有机物含量过高密切相关,建立数字型营养物基准能够防止富营养化对水体指定用途造成影响.太湖流域是我国华东地区经济腹地,近年来流域内湖泊水质每况愈下,对其基准研究可为湖泊治理提供依据.详细介绍了压力响应关系法制定湖泊营养物基准的步骤,并将此方法运用到太湖流域营养物基准制定研究中.为满足大多数水体指定用途,研究中将该流域湖泊基本功能确定为娱乐、永生生物栖息地及饮用水,以此构建流域概念模型.选择压力变量为总氮(TN)、总磷(TP)和有机物,响应变量为叶绿素a(chl-a).用非参数分析法和线性回归法分别建立压力-响应模型,通过2种方法相互验证得到TN、TP和CODMn基准分别为0.593、0.067和4.092 mg/L.     

页岩对污泥氨气挥发的抑制作用

氨气是城市污水污泥产生的恶臭气体之一,控制或抑制其产生是资源化利用甚至处置过程中至关重要的.通过改进氨气测量方法定量分析外掺页岩对污泥氨气挥发的抑制作用和机理,实验研究了页岩掺量、陈放形式以及环境温度对污泥氨气挥发浓度的影响.结果表明,外掺页岩对污泥氨气挥发具有明显的抑制作用,随温度升高、陈放时间延长抑制效果有所减弱但仍具有明显作用;页岩对污泥氨气挥发的抑制作用主要为对氨气的吸附作用.     

Positive matrix factorization as source apportionment of soil lead and cadmium around a battery plant (Changxing County,China)

Chemical compositions of soil samples are multivariate in nature and provide datasets suitable for the application of multivariate factor analytical techniques. One of the analytical techniques, the positive matrix factorization (PMF), uses a weighted least square by fitting the data matrix to determine the weights of the sources based on the error estimates of each data point. In this research, PMF was employed to apportion the sources of heavy metals in 104 soil samples taken within a 1-km radius of a lead battery plant contaminated site in Changxing County, Zhejiang Province, China. The site is heavily contaminated with high concentrations of lead (Pb) and cadmium (Cd). PMF successfully partitioned the variances into sources related to soil background, agronomic practices, and the lead battery plants combined with a geostatistical approach. It was estimated that the lead battery plants and the agronomic practices contributed 55.37 and 29.28 %, respectively, for soil Pb of the total source. Soil Cd mainly came from the lead battery plants (65.92 %), followed by the agronomic practices (21.65 %), and soil parent materials (12.43 %). This research indicates that PMF combined with geostatistics is a useful tool for source identification and apportionment.