A biomimetic absorbent for removal of trace level persistent organic pollutants from water

A novel biomimetic absorbent containing the lipid triolein was developed for removing persistent organic pollutants (POPs) from water. The structural characteristics of the absorbent were obtained by SEM and a photoluminescence method. Under optimum preparation conditions, triolein was perfectly embedded in the cellulose acetate (CA) spheres, the absorbent was stable and no triolein leaked into the water. Dieldrin, endrin, aldrin and heptachlor epoxide were effectively removed by the CA--triolein absorbent in laboratory batch experiments. This suggests that CA-triolein absorbent may serve as a good absorbent for those selected POPs. Triolein in the absorbent significantly increased the absorption capacity, and lower residual concentrations of POPs were achieved when compared to the use of cellulose acetate absorbent. The absorption rate for lipophilic pollutants was very fast and exhibited some relationship with the octanol--water partition coefficient of the analyte. The absorption mechanism is discussed in detail.     

Remobilization of polycyclic aromatic hydrocarbons during the resuspension of Yangtze River sediments using a particle entrainment simulator

Remobilization of 16 polycyclic aromatic hydrocarbons (PAHs) during sediment resuspension was investigated using a particle entrainment simulator at shear stress from 0.2 to 0.5Nm(-2), typical of the energy levels present in many tidally driven aquatic environments. The results suggested that desorption from the entrained particles was the primary source of dissolved PAHs. summation operatorPAHs concentrations in particles on volume normalization increased about four times. However, on mass weight basis, summation operatorPAHs concentrations decreased from 6039.74+/-138.28microgkg(-1) to 1665.39+/-112.26microgkg(-1). The same trend was observed for individual PAHs. Dissolved concentrations of PAHs demonstrated significant differences depending on molecular weight and applied shear. The distribution of PAHs between particle and water phase suggested that for three-ring PAHs, the amounts of PAHs in particles were higher than the predicted values during our experiments. This might be due to presence of another active sorbent.     

催化湿式氧化技术处理山梨酸生产废水的研究

采用催化湿式氧化技术处理生产山梨酸过程中产生的高浓度有机废水,对催化剂组分进行优选.对反应温度、O2分压(Po2)和废水pH等工艺条件进行考察.实验结果表明:采用自制CuO-Cr2O3-La2O3/TiO2为复合催化剂处理该有机废水时表现出较好的催化活性;在190℃、Po2=2.1 MPa、pH=6.1、COD=10 030.0 mg/L时,反应90 min的COD去除率达到98.3%,而在相同条件下未加催化剂的湿式氧化的COD去除率只有60.1%.     

Decolorization of cationic red X-GRL by wet air oxidation: performance optimization and degradation mechanism

The decolorization of a strong colored azo dye solution of cationic red X-GRL was investigated by wet air oxidation under relatively mild conditions (60-180 degrees C, PO2 = 0-1.2 MPa). Mono-factor experiments were carried out to investigate the effect of the operation factors and the relatively important parameters were selected for optimization using response surface methodology to explore the interactions of these relatively important parameters. Model regeneration analysis and the check experiments showed that the data of the general linear model agreed with the experiment results well. With multistage Monte-Carlo optimization, the best region of these variables could be predicted to dye color removal. At typical operational conditions, the intermediates of dye degradation were detected and confirmed by GC/MS system. Considering the intermediates and the structure analysis with the help of Gaussian 03W (version 6.0) and the theory of dye color, a possible degradation mechanism for the wet air oxidation of cationic red X-GRL was discussed and the probable degradation pathway was deduced.     

零价铁复合有机膨润土处理染料废水的研究

针对目前印染废水处理现状及膨润土在水处理中回收困难等问题,提出将零价铁复合到有机膨润土中制成零价铁复合有机膨润土(ZVI-OB),以达到高效吸附并降解污染物的目的。以染料废水(Orange II) 作为研究对象,考察了废水中染料的初始浓度、pH以及吸附时间对ZVI-OB去除染料效率的影响,并研究了吸附后降解过程中时间和pH对污染物降解的影响以及降解前后膨润土层结构的变化。研究结果表明,ZVI-OB相对于CTMAB改性的有机膨润土而言,其吸附量有所降低,但ZVI-OB在吸附污染物之后能有效降解有机物。ZVI-OB在饱和吸附Orange II后经催化氧化,总有机碳含量降低为原来的19%,可以重复利用。     

林可霉素菌(Streptomyces lincolnensis)利用吡唑酮废水的研究

采用被吡唑酮废液驯化、分离、筛选后的林可霉素菌,并对其在摇瓶上利用吡唑酮废液中的硫酸铵发酵(7 d)生产林可霉素进行了研究。实验结果表明,废液加入培养基体积比都为1∶10,实验1中菌丝代谢和对照比正常,其中还原糖利用最快,在发酵后期为0.24 mg/L,林可霉素起步效价最低为2 100 IU/mL,与对照相比最后发酵效价降低了70 IU/mL;实验2发酵过程pH值偏低,全程为5.86～6.50,氨基氮代谢缓慢为40 mg/100 mL,最后林可霉素效价最低为4 480 IU/mL;实验3中废液在发酵进入48 h中后期的时候补入能促进菌丝体分泌,最后林可霉素为5 180 IU/mL,比对照发酵水平高出8.82%。可见实验3的实验设计有利于林可霉素菌利用吡唑酮废液生产林可霉素,为废物循环利用、变废为宝的可行性作了有意义尝试。     

南京市气溶胶PM2.5中多环芳烃来源识别

对2005年7月至2006年2月采集到的南京市气溶胶Pm2.5 进行季节性初步分析,并对其中的15种优控多环芳烃(PAHs)进行分析研究,通过比值法判断南京市PAHs夏季主要来源于柴油型燃烧,冬季主要来源于柴油和煤型相结合的燃烧.对15种优控PAHs两两之间的相关性分析,发现各化合物之间显著相关,表明各化合物的来源有相似之处.     

Determination and potential importance of diterpene (kaur-16-ene) emitted from dominant coniferous trees in Japan

Reactive volatile organic compounds (VOCs) are known to affect atmospheric chemistry. Biogenic VOCs (BVOCs) have a significant impact on regional air quality due to their large emission rates and high reactivities. Diterpenes (most particularly, kaur-16-ene) were detected in all of the 205 enclosure air samples collected over multiple seasons at two different sites from Cryptomeria japonica and Chamaecyparis obtusa trees, the dominant coniferous trees in Japan,. The emission rate of kaur-16-ene, was determined to be from 0.01 to 7.1 μg dwg⁻¹ h⁻¹ (average: 0.61 μg dwg⁻¹ h⁻¹) employing branch enclosure measurements using adsorbent sampling followed by solid phase-liquid extraction techniques. The emission rate was comparable to that of monoterpenes, which is known major BVOC emissions, collected from the same branches. In addition, total emission of kaur-16-ene at 30 °C was estimated to exceed that of total anthropogenic VOC emissions.     

基于剩余污泥的超声法提取微生物絮凝剂

通过超声系列实验,对超声法从剩余污泥中提取微生物絮凝剂(MBF)进行了系统研究。从剩余污泥中提取的MBF在碱性条件下表现出较好的絮凝活性。提高污泥浓度有利于提取出较高絮凝活性的MBF。由于超声波的破解作用,超声频率或功率过高均不利于MBF的提取。在20 kHz的超声频率下,连续超声比脉冲为1、4或8 s超声时的提取效果均要好。经过工艺优化,采用20 kHz、120 W的超声波对剩余污泥(19.4 g/L)连续超声30 s,所提取的MBF对高岭土悬浊液的絮凝率接近70%。结果表明,超声法可用于从剩余污泥中直接提取MBF,在降低MBF生产成本的同时实现污泥的资源化利用。     

关于1#滤毒罐防护范围的进一步探讨

本文通过实验的方法,对1#滤毒罐防护范围进行了探讨,说明1#罐不仅能防护CNCL、HCN,对苯、SO2等毒剂也能起到有效的防护作用,同时提出了如何选择滤毒罐的建议。