改性活性炭对水中铬离子(Ⅵ)的吸附性能

为了研究改性前后活性炭对水中铬离子(Ⅵ)的吸附效果,以磷酸活性炭(PAC)为原料,用10%硝酸改性得到硝酸改性活性炭(N-PAC)及直接蒸发法载铁改性得到载铁活性炭(Fe-PAC)。通过静态吸附研究表明,改性后活性炭对Cr(Ⅵ)的吸附率有较大提高。在常温、自然pH条件下,0.2 g活性炭处理50 mL浓度为100 mg/L的含Cr(Ⅵ)溶液,N-PAC和Fe-PAC对Cr(Ⅵ)的吸附率分别为79.21%和90.59%,都高于原PAC对Cr(Ⅵ)的吸附率49.58%。pH从2.2升高到11.92,Fe-PAC对Cr(Ⅵ)的吸附率从99.86%降低到14.77%,N-PAC则从99.86%降低到3.23%,PAC从97.05%降低到2.53%。温度从25℃升高到70℃,3种活性炭对Cr(Ⅵ)吸附率都有较大提高,都增加到98%以上。且吸附过程较符合Langmuir等温吸附模型。     

Enhanced degradation of ortho-nitrochlorobenzene by the combined system of zero-valent iron reduction and persulfate oxidation in soils

ortho-Nitrochlorobenzene (o-NCB) in soil poses significant health risks to human because of its persistence and high toxicity. The removal of o-NCB by both zero-valent iron (ZVI) and chemical oxidation (persulfate) was investigated by batch experiments. The o-NCB removal rate increases significantly from 15.1 to 97.3 % with an increase of iron dosage from 0.1 to 1.0 mmol g^?1. The o-NCB removal rate increases with the decrease of the initial solution pH, and a removal efficiency of 90.3 % is obtained at an initial pH value of 6.8 in this combined system. It is found that temperature and soil moisture could also increase the o-NCB removal rate. The o-NCB degradation rate increases from 83.9 to 96.2 % and from 41.5 to 82.4 % with an increase of temperature (15 to 35 °C) and soil moisture (0.25 to 1.50 mL g^?1), respectively. Compared to the persulfate oxidation system and ZVI system, the persulfate–iron system shows high o-NCB removal capacity. o-NCB removal rates of 41.5 and 62.4 % are obtained in both the persulfate oxidation system and the ZVI system, while the removal rate of o-NCB is 90.3 % in the persulfate–iron system.     

Quantifying interactions between propranolol and dissolved organic matter (DOM) from different sources using fluorescence spectroscopy

Beta blockers are widely used pharmaceuticals that have been detected in the environment. Interactions between beta blockers and dissolved organic matter (DOM) may mutually alter their environmental behaviors. To assess this potential, propranolol (PRO) was used as a model beta blocker to quantify the complexation with DOM from different sources using the fluorescence quenching titration method. The sources of studied DOM samples were identified by excitation–emission matrix spectroscopy (EEMs) combined with fluorescence regional integration analysis. The results show that PRO intrinsic fluorescence was statically quenched by DOM addition. The resulting binding constants (log K _oc) ranged from 3.90 to 5.20, with the surface-water-filtered DOM samples claiming the lower log K _oc and HA having the highest log K _oc. Log K _oc is negatively correlated with the fluorescence index, biological index, and the percent fluorescence response (P _i,n) of protein-like region (P _I,n) and the P _i,n of microbial byproduct-like region (P _II,n) of DOM EEMs, while it is correlated positively with humification index and the P _i,n of UVC humic-like region (P _III,n). These results indicate that DOM samples from allochthonous materials rich in aromatic and humic-like components would strongly bind PRO in aquatic systems, and autochthonous DOM containing high protein-like components would bind PRO more weakly.     

Some technical issues in managing PCBs

Polychlorinated biphenyls (PCBs) were important industrial chemicals featuring high thermal and chemical stability and low flammability. They were widely used as dielectric and thermal fluid in closed electro-technical applications (transformers, capacitors…) and also in numerous dispersive uses, ranking from auto-copying paper to sealant or coatings. During the 1960s, severe environmental consequences started becoming apparent. The stability of PCBs contributed to their persistence in the environment, their lipophilic character to bio-magnification. Fish-eating species seemed threatened in their existence. In Japan and in Taiwan, thousands of people consumed PCB-contaminated oil. The production of PCBs stopped completely during the 1980s. Usage could continue in closed applications only. In this paper, particular attention is given to two issues: the cleaning of PCB electric transformers and the potential impact of PCB-containing building materials. Other contributions will cover the management and treatment of PCB-contaminated soil, sludge or fly ash. The complete survey is being prepared by request of the Knowledge Center for Engineers and Professionals.     

A comparison of statistical methods for deriving freshwater quality criteria for the protection of aquatic organisms

Species sensitivity distributions (SSDs) are increasingly used in both ecological risk assessment and derivation of water quality criteria. However, there has been debate about the choice of an appropriate approach for derivation of water quality criteria based on SSDs because the various methods can generate different values. The objective of this study was to compare the differences among various methods. Data sets of acute toxicities of 12 substances to aquatic organisms, representing a range of classes with different modes of action, were studied. Nine typical statistical approaches, including parametric and nonparametric methods, were used to construct SSDs for 12 chemicals. Water quality criteria, expressed as hazardous concentration for 5 % of species (HC₅), were derived by use of several approaches. All approaches produced comparable results, and the data generated by the different approaches were significantly correlated. Variability among estimates of HC₅ of all inclusive species decreased with increasing sample size, and variability was similar among the statistical methods applied. Of the statistical methods selected, the bootstrap method represented the best-fitting model for all chemicals, while log-triangle and Weibull were the best models among the parametric methods evaluated. The bootstrap method was the primary choice to derive water quality criteria when data points are sufficient (more than 20). If the available data are few, all other methods should be constructed, and that which best describes the distribution of the data was selected.     

Ag/ZnO hollow sphere composites: reusable photocatalyst for photocatalytic degradation of 17α-ethinylestradiol

Characterizations of Ag/ZnO hollow sphere by scanning electron microscopy, X-ray diffraction, X-ray photoelectron spectra, and UV–vis absorption spectra have been made after its synthesis. The results showed that the composite was hollow structure with diameters of about 1–4 μm. The samples synthesized were tested and identified as silver doped ZnO, which have extended and boosted the spectral absorption. The photocatalytic activity of Ag/ZnO hollow spheres was assessed using 17α-ethinylestradiol aqueous solution under UV irradiation. It has been observed that the 17α-ethinylestradiol absorption efficiency and degradation rate is higher for Ag/ZnO hollow spheres. As reusable photocatalysts, Ag/ZnO hollow spheres which could be easily separated from a suspension will facilitate their application in wastewater treatment with enhanced photostability.     

Major ionic compositions of fine particulate matter in an animal feeding operation facility and its vicinity

Animal feeding operations (AFOs) produce particulate matter (PM) and gaseous pollutants. Investigation of the chemical composition of PM_2.5 inside and in the local vicinity of AFOs can help to understand the impact of the AFO emissions on ambient secondary PM formation. This study was conducted on a commercial egg production farm in North Carolina. Samples of PM_2.5 were collected from five stations, with one located in an egg production house and the other four located in the vicinity of the farm along four wind directions. The major ions of NH₄⁺, Na⁺, K⁺, SO₄^2?, Cl^?, and NO₃^? were analyzed using ion chromatography (IC). In the house, the mostly abundant ions were SO₄^2?, Cl^?, and K⁺. At ambient stations, SO₄^2?, and NH₄⁺ were the two most abundant ions. In the house, NH₄⁺, SO₄^2?, and NO₃^? accounted for only 10% of the PM_2.5 mass; at ambient locations, NH₄⁺, SO₄^2?, and NO₃^? accounted for 36–41% of the PM_2.5 mass. In the house, NH₄⁺ had small seasonal variations indicating that gas-phase NH₃ was not the only major force driving its gas–particle partitioning. At the ambient stations, NH₄⁺ had the highest concentrations in summer. In the house, K⁺, Na⁺, and Cl^? were highly correlated with each other. In ambient locations, SO₄^2? and NH₄⁺ had a strong correlation, whereas in the house, SO₄^2? and NH₄⁺ had a very weak correlation. Ambient temperature and solar radiation were positively correlated with NH₄⁺ and SO₄^2?. This study suggests that secondary PM formation inside the animal house was not an important source of PM_2.5. In the vicinity, NH₃ emissions had greater impact on PM_2.5 formation.

ImplicationsThe chemical composition of PM_2.5 inside and in the local vicinity of AFOs showed the impact of the AFO emissions on ambient secondary PM_2.5 formation, and the fate and transport of air pollutants associated with AFOs. The results may help to manage in-house animal facility air quality, and to develop regional air quality control strategies and policies, especially in animal agriculture-concentrated areas.     

竹制填料生物接触氧化工艺处理污染河水简

针对受污染的湖溪河水质特征,以传统弹性塑料填料做对比,研究以竹球和竹丝为填料的生物接触氧化工艺,考察填料的挂膜时间、生物量和污水处理效果;确定连续曝气和间歇曝气时反应器的最优运行工况：连续曝气时为HRT=7.5 h,DO=3 mg/L;间歇曝气时为厌氧1.2 h、好氧6.3 h交替运行。实验结果表明,与弹性塑料填料相比,竹制填料挂膜速度快,竹球填料的水处理效果最好;连续曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别为66.7%、47.9%、57.1%和30.6%;间歇曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别64.08%、39.95%、60.7%和54.68%;竹制填料可替代传统的塑料填料作为生物接触氧化工艺的载体填料。     

膜吸收法净化低浓度甲醛和氨气简

基于膜吸收技术自制双层平板式膜吸收器,搭建净化低浓度甲醛和氨气污染模拟系统,考察不同膜结构参数、进气流量、吸收剂流量等因素对其净化效果的影响。结果表明,聚偏氟乙烯PVDF对低浓度甲醛和氨气的净化效率高于聚四氟乙烯PTFE。对同一材质膜,随着膜孔隙率的增大,甲醛和氨气的净化率呈上升趋势。随着进气流量的增加,甲醛和氨气的净化效率降低;而吸收剂流量对其净化效率影响不大。对于所有实验条件,平均膜孔径为0.22 μm的PVDF 4^#在进气流量u_g=120 L/h时,甲醛和氨气的净化效率最高,分别达94.7%和96.3%。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天,DMSO去除率达98.5%,表明MBR内的污泥已驯化成功;在MBR运行的正式期,当DMSO处于高负荷状态时,DMSO去除率较低;随蔗糖加入量的增加,DMSO去除率逐渐提高,最终恢复到DMSO高负荷冲击前的DMSO去除效果;正常运行时,装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L）,DMSO去除率为96.4%~99.6%（平均值为98.9%）;在MBR运行的正式期,污泥体积指数小于100 mL/g,表明污泥的沉降性能较好,MLVSS/MLSS较高,表明污泥的活性高,MBR内MLSS的平均值为5.52 g/L,MLVSS的平均值为4.78 g/L;MBR适宜的HRT为12 h。