Physiological mechanisms of a wetland plant (Echinodorus osiris Rataj) to cadmium detoxification

Environmental Science and Pollution Research - Physiological responses of Echinodorus osiris Rataj plant under cadmium (Cd) stress (5 and 15 mg L?1) were studied by...     

电子元件制造行业典型危险废物产生节点及处置建议

电子元件制造行业是国家战略性新兴行业,同时也是高污染的行业,其生产工艺具有更新换代快、中间产物多、排污方式复杂等特点.行业危险废物也具有来源多、成分复杂、产生量大等特点,若未经妥善处置而排放到环境中,会对环境造成巨大的危害.通过对印制电路板、铝电解电容器、半导体器件3类典型电子元件的工艺流程进行梳理,分析典型危险废物的...     

Nitrogen removal from landfill leachate via ex situ nitrification and sequential in situ denitrification

Ex situ nitrification and sequential in situ denitrification represents a novel approach to nitrogen management at landfills. Simultaneous ammonia and organics removal was achieved in a continuous stirred tank reactor (CSTR). The results showed that the maximum nitrogen loading rate (NLR) and the maximum organic loading rate (OLR) was 0.65 g N l^?1 d^?1 and 3.84 g COD l^?1 d^?1, respectively. The ammonia and chemical oxygen demand (COD) removal was over 99% and 57%, respectively. In the run of the CSTR, free ammonia (FA) inhibition and low dissolved oxygen (DO) were found to be key factors affecting nitrite accumulation. In situ denitrification was studied in a municipal solid waste (MSW) column by recalculating nitrified leachate from CSTR. The decomposition of MSW was accelerated by the recirculation of nitrified leachate. Complete reduction of total oxidized nitrogen (TON) was obtained with maximum TON loading of 28.6 g N t^?1 TS d^?1 and denitrification was the main reaction responsible. Additionally, methanogenesis inhibition was observed while TON loading was over 11.4 g N t^?1 TS d^?1 and the inhibition was enhanced with the increase of TON loading.     

焦炭和废铁屑微电解预处理垃圾渗滤液的研究

研究表明,废铁屑和焦炭微电解是预处理垃圾渗滤液的一种有效方法,可去除垃圾渗滤液COD、色度和腐殖酸等污染物质,改善其可生化性、降低负荷,为后续生化处理创造良好的条件.通过静态正交实验确定废铁屑和焦炭最佳投加体积比为1∶3;最佳反应pH值为4;动态实验中,反应时间为1 h时,COD和色度去除率分别高达68%和91%;BOD/COD从0.3提高到0.5左右.     

一种光催化体系光催化降解苯胺的研究

以钛酸丁酯为原料．以膨润土为载体,用酸性溶胶法合成TiO2纳米复合物,并利用该复合物作催化剂,在H2O2存在下进行光催化降解苯胺溶液。结果表明,该催化剂在UV／H2O2系统中对苯胺溶液有很好的光催化降解效果,其效果优于纯TiO2;H2O2的存在提高了苯胺光催化降解速率,在本实验条件下其最佳摩尔浓度是5mmol／L;溶液pH是影响反应速率的重要因素．pH在中性范围内具有更强的光催化活性;该体系中苯胺能够有效地被降解,其光催化反应遵循一级反应动力学规律。     

Knowledge map and global trends in extreme weather research from 1980 to 2019: a bibliometric analysis

Environmental Science and Pollution Research - There is an increasing number of studies focusing on extreme weather all over the world, but global trends and research topics related to extreme...     

分光光度法测定染色废水的色度

为消除测定染色废水色度的主观误差，采用分光光度法测定染色废水的色度，与稀释倍数法相比，具有精确，重现性好，适用范围广等特点，ＰＨ值对色度的测定有明显影响，控制ＰＨ值为７．６０，测定色度具有可比性。     

进出料频率对牛粪两相厌氧发酵特性的影响

以牛粪为发酵原料,在中温(35±2)℃的条件下,采用自行设计的两相厌氧发酵中试装置,在水力停留时间确定的前提下,酸化原料分别以每天、间隔1 d和间隔2 d 3种不同进出料频率加入产甲烷罐,观察挥发性固体(VS)产气率和甲烷含量的变化情况。实验结果表明:保持产酸相与产甲烷相水力停留时间(HRT)分别为3 d和17 d,每天进出料产气效果最佳,原料VS产气率和甲烷含量最大值分别为0.29 m3/(kg·VS)和58.36%。     

偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附

以腈纶纤维为原料络合Fe3+制得偕胺肟合铁(Ⅲ)纤维,用其处理α-萘酚溶液,研究了偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附工艺条件和吸附动力学参数。实验结果表明,偕胺肟合铁(Ⅲ)纤维对α-萘酚的最佳吸附工艺条件为pH=3.0、吸附温度313.15K和吸附时间45min。在最佳工艺条件下,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附在所研究的α-萘酚浓度范围内符合Freundlich等温吸附方程。未达到饱和吸附前,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附符合一级反应动力学特征。     

微生物絮凝剂与聚合氯化铝复配处理涂料废水的响应面优化

采用响应面分析法对聚合氯化铝(PAC)与污泥生产的微生物絮凝剂复配处理涂料废水的过程进行了优化,设定的响应值为COD和色度去除率。实验分别拟合了关于COD去除率和色度去除率的二次模型,根据响应值的分布情况,确定涂料废水的最佳絮凝条件为微生物絮凝剂浓度47 mg/L,PAC浓度39 mg/L,pH为8.2,CaCl2浓度0.38 g/L,搅拌速度210 r/min。最佳絮凝条件下,微生物絮凝剂对涂料废水中COD和色度的去除率分别达到77.6%和68.9%。