基于加速度限控制策略的振动试验过载停机实验研究

西门子Simcenter Testlab振动控制采集分析系统在航天振动试验领域应用十分广泛,但是在实际工程应用中常常由于对软件工作机制理解不到位,参数设置不合理造成试验异常中断,这不仅给产品带来了巨大的安全隐患,而且也增加了试验时间和成本,严重影响研制进度。因此,本文针对某航天产品正弦振动试验的过载停机故障,从软件加速度限控制功能的角度分析了潜在原因,并且开展了实验验证。首先描述了振动试验过程和过载停机现象,排除了硬件原因,然后对可能的加速度限控制功能设置和通道量程过小等原因设计了三组实验进行分析验证,得出了此次试验过载停机①与加速度限控制(频域)设置无关,②而与通道量程(时域)设置有关,③通过忽略限幅通道过载设置可使试验正常进行的分析结论,最后针对Simcenter Testlab加速度限控制功能和通道量程设置提出了使用建议,为后续航天产品振动试验提供参考。     

Efficiency of mercapto flavor compounds in removing acrylamide under high temperature and low humidity conditions

Acrylamide (AA) is a potential human carcinogen, genotoxicant, and neurotoxicant. Thus, the aim of this study was to examine the ability of mercapto flavor compounds to remove AA released from consumer packaging into food products. Four mercapto flavor compounds including 1,2-ethanedithiol, 1-butanethiol, 2-methyl-3-furanthiol, and 2-furanmethanethiol were employed to extract AA in model system using high temperature and low humidity. Our study showed that mercaptans were effective in eliminating AA in our model system. In order to remove 0.2 μmol AA, the optimal conditions in the reaction system were mercaptan flavor chemicals at 5 μmol, temperature 180 °C, and reaction time 25 min. In the presence of a higher pH, the greater was the amount of AA eliminated. Evidence indicates that employment of mercapto flavor chemicals under certain temperature and pH conditions is a reliable method to remove any unwanted AA from food products.     

High zinc removal from water and soil using struvite-supported diatomite obtained by nitrogen and phosphate recovery from wastewater

Zinc is known as an essential element of human life. However, excessive zinc discharge into water and soil causes water pollution, leading to serious health issues such as septicemia, meningitis and iron-deficiency anemia. Here, a novel material made of struvite-supported diatomite was obtained from eutrophic water treated by mesoporous MgO-modified diatomite. This material was applied for zinc remediation in aqueous solutions and contaminated soils to test the reuse of P-containing products. Struvite-supported diatomite was characterized by field emission scanning electron microscopy and X-ray diffraction. Results show that the maximum removal efficiency of Zn(II) from wastewater streams reached 90.54% at an initial pH of 5 and struvite-supported diatomite dosage of 0.3 g/L. Moreover, the X-ray diffraction patterns of precipitates after Zn(II) sorption show that the combination between zinc and the phosphate group played a key role for zinc removal in solution. For Zn-contaminated soils amended with 10% struvite-supported diatomite, available Zn decreased by 65.38% and acid soluble Zn decreased by 56.9% after 56 days.     

锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

Non-microcystin producing Microcystis wesenbergii (Komárek) Komárek (Cyanobacteria) representing a main waterbloom-forming species in Chinese waters

It is well known that several morphospecies of Microcystis, such as Microcystis aeruginosa (Kützing) Lemmermann and Microcystis viridis (A. Brown) Lemmermann can produce hepatotoxic microcystins. However, previous studies gave contradictory conclusions about microcystin production of Microcystis wesenbergii (Komárek) Komárek. In the present study, ten Microcystis morphospecies were identified in waterblooms of seven Chinese waterbodies, and Microcystis wesenbergii was shown as the dominant species in these waters. More than 250 single colonies of M. wesenbergii were chosen, under morphological identification, to examine whether M. wesenbergii produce hepatotoxic microcystin by using multiplex PCR for molecular detection of a region (mcyA) of microcystin synthesis genes, and chemical analyses of microcystin content by ELISA and HPLC for 21 isolated strains of M. wesenbergii from these waters were also performed. Both molecular and chemical methods demonstrated that M. wesenbergii from Chinese waters did not produce microcystin.     

高效液相色谱法测定南昌市环境空气PM10中16种多环芳烃

建立了以二极管阵列检测器和荧光检测器串联的高效液相色谱分析方法,在标样未完全分离的情况下,采用双激发波长有效地改善了色谱分离条件.在设定的色谱条件下,各种多环芳烃(PAHs)的检出限为0.11～39.83μg/L,平均回收率为76.7%～98.3%,相对标准偏差为3.6%～12.6%.在南昌市布设4个环境空气采样点,测定PM10中PAHs含量.结果表明,八一广场、南昌市区二中老校区和罗家集区苯并(a)芘日均质量浓度最大值均超过<环境空气质量标准>(GB 3095-1996)的限值,PAHs污染状况较严重.     

Effects of open burning of rice straw on concentrations of atmospheric polycyclic aromatic hydrocarbons in central Taiwan

The sizes and concentrations of 21 atmospheric polycyclic aromatic hydrocarbons (PAHs) were measured at Jhu-Shan (a rural site) and Sin-Gang (a town site) in central Taiwan in October and December 2005. Air samples were collected using semi-volatile sampling trains (PS-1 sampler) over 16 days for rice-straw burning and nonburning periods. These samples were then analyzed using a gas chromatograph with a flame-ionization detector (GC/FID). Particle-size distributions in the particulate phase show a bimode, peaking at 0.32-0.56 microm and 3.2-5.6 microm at the two sites during the nonburning period. During the burning period, peaks also appeared at 0.32-0.56 microm and 3.2-5.6 microm at Jhu-Shan, with the accumulation mode (particle size between 0.1 and 3.2 microm) accounting for approximately 74.1% of total particle mass. The peaks at 0.18-0.32 microm and 1.8-3.2 microm at Shin-Gang had an accumulation mode accounting for approximately 70.1% of total particle mass. The mass median diameter (MMD) of 3.99-4.35 microm in the particulate phase suggested that rice-straw burning generated increased numbers of coarse particles. The concentrations of total PAHs (sum of 21 gases + particles) at the Jhu-Shan site (Sin-Gang site) were 522.9 +/- 111.4 ng/ml (572.0 +/- 91.0 ng/ml) and 330.1 +/- 17.0 ng/ml (or 427.5 +/- 108.0 ng/ml) during burning and nonburning periods, respectively, accounting for a roughly 58% (or 34%) increase in the concentrations of total PAHs due to rice-straw burning. On average, low-weight PAHs (about 87.0%) represent the largest proportion of total PAHs, followed by medium-weight PAHs (7.1%), and high-weight PAHs (5.9%). Combustion-related PAHs during burning periods were 1.54-2.57 times higher than those during nonburning periods. The results of principal component analysis (PCA)/absolute principal component scores (APCS) suggest that the primary pollution sources at the two sites are similar and include vehicle exhaust, coal/wood combustion, incense burning, and incineration emissions. Open burning of rice straw was estimated to contribute approximately 5.0-33.5% to the total atmospheric PAHs at the two sites.     

Improved blending strategy for membrane modification by virtue of surface segregation using surface-tailored amphiphilic nanoparticles

Membrane modification is one of the most feasible and effective solutions to membrane fouling problem which tenaciously hampers the further augmentation of membrane separation technology. Blending modification with nanoparticles (NPs), owing to the convenience of being incorporated in established membrane production lines, possesses an advantageous viability in practical applications. However, the existing blending strategy suffers from a low utilization efficiency due to NP encasement by membrane matrix. The current study proposed an improved blending modification approach with amphiphilic NPs (aNPs), which were prepared through silanization using 3-(Trimethoxysilyl)propyl methacrylate (TMSPMA) as coupling agents and ZnO or SiO₂ as pristine NPs (pNPs), respectively. The Fourier transform infrared and X-ray photoelectron spectroscopy analyses revealed the presence of appropriate organic components in both the ZnO and SiO₂ aNPs, which verified the success of the silanization process. As compared with the pristine and conventional pNP-blended membranes, both the ZnO aNP-blended and SiO₂ aNP-blended membranes with proper silanization (100% and 200%w/w) achieved a significantly increased blending efficiency with more NPs scattering on the internal and external membrane surfaces under scanning electron microscope observation. This improvement contributed to the increase of membrane hydrophilicity. Nevertheless, an extra dosage of the TMSPMA led to an encasement of NPs, thereby adversely affecting the properties of the resultant membranes. On the basis of all the tests, 100% (w/w) was selected as the optimum TMSPMA dosage for blending modification for both the ZnO and SiO₂ types.

Open image in new window

     

Distribution of thifluzamide,fenoxanil and tebuconazole in rice paddy and dietary risk assessment

Distribution behaviors of thifluzamide, fenoxanil, and tebuconazole applied to rice were investigated in South China. Analysis was by a modified QuEChERS method with gas chromatography (thifluzamide and fenoxanil) and liquid chromatography mass spectrometry (tebuconazole). Thifluzamide and tebuconazole partitioned mainly into the soil, with half-lives in the paddy soil of 12–14 and 5.3–7.8 days, respectively. Fenoxanil partitioned mainly into the rice plants, with half-lives of 3.3–4.4 days. The half-lives of thifluzamide, fenoxanil, and tebuconazole in paddy water were 0.17–0.89, 1.8–3.0, and 1.6–4.0 days, respectively. The residues in rice grains at the pre-harvest interval of 14 days were all below the established maximum limit values. The dietary risks assessed as hazard quotients at the pre-harvest interval were less than 1.     

2种毒性评估方法对PAHs污染场地人体健康风险的比较研究

毒性评估是人体健康风险评价的重要部分,目前主要存在2种方法,一种基于PAHs相对于苯并[a]芘(BaP)的毒性当量因子,采用Ba P致癌斜率因子参数(方法 1),另一种直接采用各PAHs致癌斜率因子和非致癌参考剂量等参数(方法 2)。然而2种毒性评估方法得到的风险及修复量是否存在差异以及引起差异的原因等问题鲜有讨论。针对苏南某焦化厂PAHs污染土壤,采用分层土壤健康风险评价模型,对比了2种毒性评估方法确定的PAHs风险、修复目标污染物及土方量的差异,并对引起差异的关键因素进行探讨。结果表明:对于0.0~1.0 m表层土壤,方法 1和方法 2确定的致癌风险最大值分别1.48E-05和1.32E-05,均超过可接受致癌风险,修复土方量分别为27 846 m~3和28 667 m3,修复目标污染物均为Ba P和二苊烃(Acy)。对于1.0~3.0 m深层土壤,方法 1确定的致癌风险最大值为3.36E-08,低于可接受致癌风险,不需要修复;而方法 2确定的致癌风险最大值为3.73E-04,非致癌危害指数最大值为6.96E+01,分别超过可接受致癌风险和非致癌危害商,需要修复,修复目标污染物为萘(NaP),修复土方量为35 944 m~3。最终,方法 2确定的总修复土方量(64 611 m~3)为方法 1确定土方量(27 846 m~3)的2.45倍,而这种差异主要是由于方法 1低估了深层土壤中高挥发性PAH单体尤其是NaP的风险所致。因此,从保守角度建议采用方法 2进行PAHs风险评价。