Arsenic stabilization by zero-valent iron,bauxite residue,and zeolite at a contaminated site planting Panax notoginseng

Panax notoginseng (Burk.) F.H. Chen, a rare traditional Chinese medicinal herb, is a widely used phytomedicine used all over the world. In recent years, the arsenic contamination of the herb and its relative products becomes a serious problem due to elevated soil As concentration. This study aimed to evaluate the effects of different types and dosages of amendments on As stabilization in soil and its uptake by P. notoginseng. Results showed that comparing to control treatment, the As concentrations of P. notoginseng declined by 49–63%, 43–61% and 52–66% in 0.25% zero-valent iron (Fe(0)), 0.5% bauxite residue, and 1% zeolite treatment, respectively; whereas the biomasses were elevated by 62–116%, 45–152% and 114–265%, respectively. The As(III) proportions of P. notoginseng increased by 8%, 9%, and 8%, and the transfer factors of As from root to shoot increased by 37%, 42% and 84% in the optimal treatments of Fe(0), bauxite residue, and zeolite. For soil As, all the three amendments could transform the non-specifically adsorbed As fraction to hydrous oxides Fe/Al fractions (by Fe(0) and red mud) or specifically adsorbed As fraction (by zeolite), therefore reduced the bioavailability of soil As. With a comprehensive consideration of stabilization efficiency, plant growth, environmental influence, and cost, Fe(0) appeared to be the best amendment, and zeolite could also be a good choice. In conclusion, this study was of significance in developing As contamination control in P. notoginseng planting areas, and even other areas for medicinal herb growing.     

SO2 inhalation causes synaptic injury in rat hippocampus via its derivatives in vivo

SO₂ remains a common air pollutant, almost half of the world’s population uses coal and biomass fuels for domestic energy. Limited evidence suggests that exposure to SO₂ may be associated with neurotoxicity and increased risk of hospitalization and mortality of many brain disorders. However, our understanding of the mechanisms by which SO₂ causes harmful insults on neurons remains elusive. To explore the molecular mechanism of SO₂-induced neurotoxic effects in hippocampal neurons, we evaluated the synaptic plasticity in rat hippocampus after exposure to SO₂ at various concentrations (3.5 and 7 mg m⁻³, 6 h d⁻¹, for 90 d) in vivo, and in primary cultured hippocampal neurons (DIV7 and DIV14) after the treatment of SO₂ derivatives in vitro. The results showed that SYP, PSD-95, NR-2B, p-ERK1/2 and p-CREB were consistently inhibited by SO₂/SO₂ derivatives in more mature hippocampal neurons in vivo and in vitro, while the effects were opposite in young hippocampal neurons. Our results indicated that in young neurons, SO₂ exposure produced neuronal insult is similar to ischemic injury; while in more mature neurons, SO₂ exposure induced synaptic dysfunctions might participate in cognitive impairment. The results implied that SO₂ inhalation could cause different neuronal injury during brain development, and suggested that the molecular mechanisms might be involved in the changes of synaptic plasticity.     

六氯苯微生物降解研究进展

微生物降解已经成为当前六氯苯环境污染治理研究的重点和前沿。介绍了六氯苯的结构、物理化学性质、来源及其危害,分析了其微生物降解的可行性,从降解菌群的来源、降解途径及降解的影响因素等方面,对六氯苯的微生物好氧降解和厌氧降解进行了系统地归纳和总结,同时对今后六氯苯微生物降解的研究方向进行了展望。     

微米Cu／Fe对污染土壤洗脱液中有机氯农药的降解

以表面活性剂TritonX-100（TX-100）为洗脱剂,某有机氯农药（organochlorinepesticides,OCPs）污染场地土壤为对象,七氯、氯丹和灭蚁灵为目标污染物,研究微米Cu／Fe双金属对污染土壤洗脱液中OCPs的降解效果。考察了洗脱液中OCPs初始浓度、洗脱液pH值、微米零价铁加入量和cu负载量对Cu／Fe去除OCPs效果的影响。结果表明,微米Cu／Fe可以有效的去除土壤洗脱液中目标污染物。当微米零价铁加入量为1．0g（25g／L）,cu负载量为1．0％,洗脱液pH值为6．89时,Cu／Fe对2号土壤洗脱液中七氯、γ-氯丹、α-氯丹和灭蚁灵的去除效果最好,去除率分别为100．0％、99．3％、80．8％和71．1％。洗脱液中OCPs初始浓度越低,微米零价铁加入量越大,Cu／Fe对OCPs去除率越高;偏酸性条件有利于Cu／Fe对γ-氯丹和灭蚁灵的去除,而α-氯丹在中性条件下去除效果最好;1号土壤和2号土壤洗脱液的最佳铜负载量分别为2．O％和1．0％。     

混凝辅助电化学法处理橙黄G染料废水

以石墨板为阳极,研究了电化学氧化法对橙黄G染料废水的降解效果。比较了在NaCl、Na2 SO4以及NaCl与FeSO4·7H2O组合的支持电解质体系中的处理效果,同时考察了电压、初始pH、电解质浓度、电极间距和电解时间等因素对废水中橙黄G脱色率及COD去除率的影响。研究结果表明,橙黄G的脱色主要是活性氯的氧化作用,橙黄G分子的矿化可能主要是电解过程中产生的·OH的作用,FeSO4·7H2O的加入增加了混凝作用,使得处理效果进一步提高。最佳脱色条件下橙黄G脱色率和COD的去除率分别为97．6％和56．3％,B／C（BOD／COD）由0．09提高至0．41,可生化性有较大改善,并且随着降解时间的增加,COD去除率逐渐升高。此结果表明,橙黄G废水COD的去除相对于脱色存在滞后性。     

不同瓦斯压力下煤体力学特性试验研究

为研究瓦斯对煤体力学特性的影响,设计不同瓦斯压力条件下煤体单轴压缩试验,研究煤样力学参数及变形特征随瓦斯压力的变化趋势,探讨瓦斯对煤体力学性质的影响机制,得出单轴压缩下煤样力学参数,并记录煤样的破坏形态.研究结果表明:随瓦斯压力增大,应力-应变曲线压实阶段增大,弹性阶段缩小,失稳破坏后曲线缓慢下降,抗压强度和弹性模量单...     

重金属污染土壤接种丛枝菌根真菌对蚕豆毒性的影响

采用盆栽实验的方法,研究了重金属(包括Cu、Zn、Pb和Cd)复合污染和接种丛枝菌根真菌(arbuscular mycorrhizal fungi,AMF)Glomus mosseae对蚕豆(Vicia faba)生长及DNA损伤的影响.结果表明,虽然接种菌根真菌对蚕豆生物量的影响并不显著,但是却显著影响植物对重金属的吸收,接种菌根真菌对蚕豆吸收4种重金属元素的作用有差异.采用单细胞凝胶电泳(single cell gel electrophoresis,SCGE)法研究接种菌根真菌对蚕豆叶片的DNA损伤的影响,与重金属吸收的结果相吻合.结果表明,接种处理可显著增加蚕豆叶片的DNA损伤程度,这与接种处理可提高植物的重金属吸收相一致.     

活性污泥对甲醛废水的净化性能

采用微生物法处理低浓度甲醛废水达标排放是比较经济的方法之一.在研究中采用序批式活性污泥法(SBR)工艺,考察了曝气时间、进水甲醛浓度、进水 pH 和水温对微生物净化低浓度甲醛废水的影响.结果表明,随着曝气时间的延长,活性污泥对甲醛的去除率增大.进水甲醛浓度在 40～120 mg/L 范围内,随着浓度升高甲醛污泥负荷增加,微生物对甲醛的降解速率增加,但对甲醛的去除率降低.活性污泥在 pH 为 5～7 的中性和弱酸性环境中对甲醛的降解速率较高.在15～35℃范围内,污泥对废水中甲醛的去除率随温度升高而上升,微生物对甲醛的降解速率随温度升高呈指数递增趋势.     

Applications of open-path Fourier transform infrared for identification of volatile organic compound pollution sources and characterization of source emission behaviors

An open-path Fourier transform infrared spectroscopy (OP-FTIR) system was set up for 3-day continuous line-averaged volatile organic compound (VOC) monitoring in a paint manufacturing plant. Seven VOCs (toluene, m-xylene, p-xylene, styrene, methanol, acetone, and 2-butanone) were identified in the ambient environment. Daytime-only batch operation mode was well explained by the time-series concentration plots. Major sources of methanol, m-xylene, acetone, and 2-butanone were identified in the southeast direction where paint solvent manufacturing processes are located. However, an attempt to uncover sources of styrene was not successful because the method detection limit (MDL) of the OP-FTIR system was not sensitive enough to produce conclusive data. In the second scenario, the OP-FTIR system was set up in an industrial complex to distinguish the origins of several VOCs. Eight major VOCs were identified in the ambient environment. The pollutant detected wind-rose percentage plots that clearly showed that ethylene, propylene, 2-butanone, and toluene mainly originated from the tank storage area, whereas the source of n-butane was mainly from the butadiene manufacturing processes of the refinery plant, and ammonia was identified as an accompanying reduction product in the gasoline desulfuration process. Advantages of OP-FTIR include its ability to simultaneously and continuously analyze many compounds, and its long path length monitoring has also shown advantages in obtaining more comprehensive data than the traditional multiple, single-point monitoring methods.     

Surface functional characteristics (C, O, S) of waste tire-derived carbon black before and after steam activation

The effects of steam activation on the surface functional characteristics of waste tire-derived carbon black were investigated. Two carbon-based materials, powdered carbon black (PCB) and PCB-derived powdered activated carbon (PCB-PAC), were selected for this study. A stainless steel tubular oven was used to activate the PCB at an activation temperature of 900 degrees C and 1 atm using steam as an activating reagent. X-ray photoelectron spectroscopy (XPS) was adopted to measure the surface composition and chemical structure of carbon surface. Various elemental spectra (C, O, and S) of each carbon sample were further deconvoluted by peak synthesis. Results showed that the surfaces of PCB and PCB-PAC consisted mainly of C-C and C-O. The PCB-PAC surface had a higher percentage of oxygenated functional groups (C=O and O-C=O) than PCB. The O1s spectra show that the oxygen detected on the PCB surface was mainly bonded to carbon (C-O), whereas the oxygen on the PCB-PAC surface could be bonded to hydrogen (O-H) and carbon (C-O). Sulfur on the surface of PCB consisted of 58.9 wt% zinc sulfide (ZnS) and 41.1 wt% S=C=S, whereas that on the surfaces of PCB-PAC consisted mainly of S=C=S. Furthermore, the increase of oxygen content from 9.6% (PCB) to 11.9% (PCB-PAC) resulted in the increase of the pH values of PCB-PAC after steam activation.