曝气和pH对城市污染河道底泥氮形态的影响

以城市重污染河道表层沉积物为研究对象,采用模拟实验方法,探讨了不同曝气方式(水曝气和泥曝气)、上覆水初始pH(自然状态pH=7和pH=11)对城市污染河道底泥氮形态的影响。结果表明:采用水曝气+pH11方式对城市重污染河道上覆水、间隙水中总氮去除率分别为70.03%和44.66%;泥曝气+pH7方式对上覆水、间隙水、底泥中氨氮去除率分别为94.31%、84.07%和68.29%;底泥pH与上覆水总氮浓度呈正相关(p<0.05);泥曝气+pH11方式使底泥含水率、烧失率明显升高,继而影响各形态氮在泥水系统中的赋存,其中底泥吸附态氨氮含量与底泥含水率呈显著负相关(p<0.01),间隙水可溶态氨氮浓度与底泥烧失率显著正相关(p<0.01)。     

清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。     

抗压实验法厌氧颗粒污泥机械强度的测定及影响因素分析

通过首先对厌氧颗粒污泥样品进行筛分,然后测定其机械强度,解决了实际操作过程中现有抗压实验法出现的精确度与重现性较差的问题。通过对不同来源厌氧颗粒污泥样品机械强度的测定、对比分析发现,厌氧颗粒污泥的机械强度大小与反应器的规模、反应器所采用水力负荷存在一定的正相关性,且与其主要金属元素（Ca、Fe和Mg）含量的大小存在着密切的关系。     

生物膜填料塔净化模拟烟气和电厂烟气中SO2和NOx的对比实验

对生物膜填料塔对模拟烟气和电厂烟气的净化效果进行了实验研究。实验对比分析了在相同的实验条件下生物膜填料塔对不同烟气中SO2和NOx的净化效率。实验结果表明,在循环液温度在24～35℃、空床停留时间（EBRT）为60s、喷淋量为8～10L／h、脱硫塔的pH为0．8～1．5、脱氮塔的pH为7．5～8．0的条件下,生物膜填料塔对模拟烟气和电厂烟气中SO2的净化效率都很高,但模拟烟气条件下的总脱氮率的平均值为80％,而在电厂烟气条件下只有35％。经分析认为,脱氮率产生差异的主要原因是电厂烟气中杂质的影响,以及烟气中氧气含量的不同,同时因为生长条件不同从而驯化出的微生物群体组成也不同。     

生物倍增工艺同步脱氮除磷强化途径分析

通过对生物倍增工艺处理市政污水的沿程污染物降解规律的考察表明,工艺对有机物的去除效果显著,COD和BOD5出水分别为47.80 mg/L和19.80 mg/L;氨氮去除率可达100%。发现厌氧区提前发生反硝化并一定程度上影响系统除磷效果;通过对各主要影响因素进行分析,认为低碳源的进水条件是影响系统同步脱氮除磷效果的关键因素;提出在进水口直接添加碳源以及分点进水的碳源分配＋辅助化学除磷的方式可强化氮磷去除效果。     

某矿区土壤和地下水重金属污染调查与评价

为了解湘南某矿区土壤和地下水重金属污染状况,对该矿区东河流域附近重金属污染源进行了调查,同时,对地下水和土壤样品进行了采样分析,结果表明：（1）该矿区东河流域附近的主要污染源有18个,其中有色金属选厂、尾矿库、采矿场和冶炼厂是排放重金属较多的污染源;（2）20个采样点中土壤重金属Pb、Cd、Zn、As和Hg大部分超过国家土壤环境质量标准（GB15618-1995）,综合污染指数P综〉1,该矿区主要的重金属污染元素为Cd、As和Hg,且土壤中Cd、Zn和As的含量两两之间存在着极显著的正线性相关关系;（3）重金属元素在土壤中的纵向迁移不明显,该矿区附近20个采样点的地下水并未受到污染,综合污染指数P综〈1。20个采样点地下水Pb、Cd、Zn、As、Hg浓度均能达到地下水质量标准（GB／T14848．9）中的Ⅲ类标准。     

Kinetics of peanut shell pyrolysis and hydrolysis in subcritical water

Biomass is recognized as an important solution to energy and the environmental problems related to fossil fuel usage. The rational utilization of biomass waste is important not only for the prevention of environmental issues, but also for the effective utilization of natural resources. Pyrolysis and hyrolysis in subcritical water are promising processes for biomass waste conversion. This paper deals with hydrolysis and pyrolysis of peanut shells. Hydrolysis and pyrolysis kinetics of peanut shell wastes were investigated for the in-depth exploration of process mechanisms and for the control of the reactions. Hydrolysis kinetics was conducted in a temperature range of 180–240 °C. A simplified kinetic model to describe the hydrolysis of peanut shells was proposed. Hydrolysis activation energy as well as the pre-exponential factor was determined according to the model. The target products of peanut shell hydrolysis, reducing sugars, can reach up to 40.5 % (maximum yield) at 220 °C and 180 s. Pyrolysis characteristics were investigated. The results showed that three stages appeared in this thermal degradation process. Kinetic parameters in terms of apparent pyrolysis activation energy and pre-exponential factor were obtained by the Coats–Redfern method.     

以焦炭为填料的生物滴滤塔处理含挥发性脂肪酸臭气

在以焦炭为填料的生物滴滤塔对挥发性脂肪酸臭气的处理研究中考察了空床停留时间、臭气浓度、体积负荷以及进气温度等参数对净化效果的影响。结果表明,空床停留时间较长时对臭气降解有利。在停留时间超过97 s时,能实现完全降解;此外,净化率随臭气浓度和体积负荷的不断增加呈先增加后降低的趋势。当臭气浓度为24.29 mg/m³即臭气的体积负荷为3 g/（m³·h）时,去除率约为96%;当臭气浓度增至1 345.74 mg/m³即体积负荷增至18 g/（m³·h）,去除率达100%;然而,当臭气浓度增至4 934.38 mg/m³即体积负荷增至66 g/（m³·h）时,去除率降至73.1%。另外,进气温度对净化率也有一定程度影响。当进气温度较低时,净化效率相对较高。     

盐析分相微萃取—高效液相色谱法测定水中含氯除草剂

采用盐析分相微萃取—高效液相色谱法同时测定水中3种含氯除草剂,建立并优化了反相离子对液相色谱条件,考察了萃取剂种类、盐析剂的种类和加入量及试样pH对萃取效果的影响。对氯苯氧乙酸、2,4-二氯苯氧乙酸和2,4-滴丁酯的质量浓度在0.1~100.0mg/L内与色谱峰面积呈良好的线性关系,相关系数不低于0.9992。平均回收率分别为96.29%、79.16%和70.21%,相对标准偏差小于5.3%。该方法操作简便、绿色环保,适合于水中含氯除草剂的测定。     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.