零价铁与甲醇支持的生物-化学法去除富氧水中的硝酸盐氮

针对富氧水中硝酸盐氮(NO-3-N),采用零价铁(ZVI)和甲醇支持的生物-化学联合法开展了批实验研究,探讨了ZVI类型、CH3OH∶N比、初始溶解氧(DO)浓度、初始NO-3-N浓度和水温等5个因素对联合法除氧脱氮效果的影响。结果表明,ZVI的除氧能力由高至低依次为:ZVI-C(0.124 d)>ZVI-A(0.141 d)>ZVI-B(0.179 d)。ZVI支持的联合法NO-3-N去除率由高至低依次为:ZVI-A(99.6%)>ZVI-C(95.3%)>ZVI-B(92.2%)。CH3OH∶N≤3.5∶1时,联合法去除<52.0%的NO-3-N;CH3OH∶N=10∶1时,去除100%的NO-3-N;CH3OH∶N=200∶1时,去除70.2%的NO-3-N。当初始DO浓度介于3.6~5.3 mg/L之间时,联合法的NO-3-N去除率介于98.8%~99.6%之间。在任意时刻,低底物浓度(5.2 mg/L)时的NO-3-N去除率低于高浓度(21.1 mg/L)时的去除率;低底物浓度下完全脱氮所需时间比高浓度下长2 d。15.0℃时联合法需要7 d可以达到完全脱氮,然而在27.5℃时则需要5 d。低温时亚硝酸盐氮浓度最大值(4.4 mg/L)显著高于高温时的最大值(1.1 mg/L)。ZVI类型、CH3OH∶N、初始NO-3-N浓度和水温显著影响联合法的脱氮效果,而初始DO浓度对联合法的影响不大。     

污泥活性炭的表征及其对Cr（Ⅵ）的吸附特性

以城市污水处理厂污泥为原料,采用磷酸活化一微波热解法制备得到污泥活性炭,并将其用于吸附水溶液中的Cr（Ⅵ）。分别采用元素分析仪（VarioELcube）、比表面积孔径分布测定仪（ASAP2020）、扫描电镜（SEM）和傅里叶红外光谱（FT—IR）等仪器对原污泥及污泥活性炭的表面组成和结构进行表征,探讨污泥活性炭的孔隙结构参数和表面化学性能。通过静态吸附实验,考察了溶液初始pH,接触时间,初始Cr（Ⅵ）浓度对污泥活性炭吸附Cr（Ⅵ）效果的影响,并探讨了污泥活性炭去除Cr（Ⅵ）的机理。实验结果表明,pH越低吸附效果越好,吸附平衡时间为100h。不同温度下吸附过程均符合Langmuir等温吸附模型,30℃时最大吸附容量为27．55mg／g;吸附动力学过程符合准二级速率方程（R2〉0．99）;污泥活性炭对Cr（Ⅵ）的去除是一个吸附-还原耦合的过程。     

Process analysis of a regional air pollution episode over Pearl River Delta Region,China, using the MM5-CMAQ model

This study focuses on the influences of a warm high-pressure meteorological system on aerosol pollutants, employing the simulations by the Models-3/CMAQ system and the observations collected during October 10–12, 2004, over the Pearl River Delta (PRD) region. The results show that the spatial distributions of air pollutants are generally circular near Guangzhou and Foshan, which are cities with high emissions rates. The primary pollutant is particulate matter (PM) over the PRD. MM5 shows reasonable performance for major meteorological variables (i.e., temperature, relative humidity, wind direction) with normalized mean biases (NMB) of 4.5–38.8% and for their time series. CMAQ can capture one peak of all air pollutant concentrations on October 11, but misses other peaks. The CMAQ model systematically underpredicts the mass concentrations of all air pollutants. Compared with chemical observations, SO₂ and O₃ are predicted well with a correlation coefficient of 0.70 and 0.65. PM_2.5 and NO are significantly underpredicted with an NMB of 43% and 90%, respectively. The process analysis results show that the emission, dry deposition, horizontal transport, and vertical transport are four main processes affecting air pollutants. The contributions of each physical process are different for the various pollutants. The most important process for PM₁₀ is dry deposition, and for NO_x it is transport. The contributions of horizontal and vertical transport processes vary during the period, but these two processes mostly contribute to the removal of air pollutants at Guangzhou city, whose emissions are high. For this high-pressure case, the contributions of the various processes show high correlations in cities with the similar geographical attributes. According to the statistical results, cities in the PRD region are divided into four groups with different features. The contributions from local and nonlocal emission sources are discussed in different groups.

Implications: The characteristics of aerosol pollution episodes are intensively studied in this work using the high-resolution modeling system MM5/SMOKE/CMAQ, with special efforts on examining the contributions of different physical and chemical processes to air concentrations for each city over the PRD region by a process analysis method, so as to provide a scientific basis for understanding the formation mechanism of regional aerosol pollution under the high-pressure system over PRD.     

镧施用下黄潮土酶活性的动态变化

通过模拟试验研究了镧施用下黄潮土酶活性的动态变化。土壤脱氢酶、碱性磷酸酶、脲酶及蔗糖酶活性均随培养时间延长而降低。镧强烈抑制土壤脱氢酶活性 ,在 3 0mg/kg时达到显著水平 (P <0 0 5 ) ,最大抑制率达到 3 9%。镧对土壤碱性磷酸酶活性也有抑制 ,最大抑制率为 1 5 %。镧对土壤脲酶活性影响不明显。镧对土壤蔗糖酶活性表现出不同程度的刺激作用 ,最大刺激率达到 1 5 %。土壤脱氢酶活性是评价稀土元素环境效应的敏感指标。     

二氧化钛/碳纳米管/壳聚糖薄膜的制备及对苯的降解性能

研究了光催化降解挥发性有机化合物过程中催化剂二氧化钛/碳纳米管/壳聚糖薄膜的制备以及该催化剂对苯的光催化性能。首先采用溶胶-凝胶法制备纳米复合材料二氧化钛/碳纳米管,然后利用壳聚糖作为交联剂,制得二氧化钛/碳纳米管/壳聚糖复合材料催化薄膜。通过傅立叶红外光谱(FT-IR)、X射线衍射(XRD)透射电镜扫描(TEM)和紫外-可见光漫反射(UV-Vis)等技术分析了复合材料薄膜的组成、结构、形貌和对光的吸收性能,然后使用该催化剂对室内常见的污染物苯进行降解,并在同样的实验条件下,使用催化剂二氧化钛(P25)/壳聚糖对苯进行降解,对两者催化性能进行对比,结果表明,二氧化钛/碳纳米管/壳聚糖对苯有更强的吸附能力和更高的催化活性。     

Life cycle and economic assessment of source-separated MSW collection with regard to greenhouse gas emissions: a case study in China

In China, the continuously increasing amount of municipal solid waste (MSW) has resulted in an urgent need for changing the current municipal solid waste management (MSWM) system based on mixed collection. A pilot program focusing on source-separated MSW collection was thus launched (2010) in Hangzhou, China, to lessen the related environmental loads. And greenhouse gas (GHG) emissions (Kyoto Protocol) are singled out in particular. This paper uses life cycle assessment modeling to evaluate the potential environmental improvement with regard to GHG emissions. The pre-existing MSWM system is assessed as baseline, while the source separation scenario is compared internally. Results show that 23 % GHG emissions can be decreased by source-separated collection compared with the base scenario. In addition, the use of composting and anaerobic digestion (AD) is suggested for further optimizing the management of food waste. 260.79, 82.21, and ?86.21 thousand tonnes of GHG emissions are emitted from food waste landfill, composting, and AD, respectively, proving the emission reduction potential brought by advanced food waste treatment technologies. Realizing the fact, a modified MSWM system is proposed by taking AD as food waste substitution option, with additional 44 % GHG emissions saved than current source separation scenario. Moreover, a preliminary economic assessment is implemented. It is demonstrated that both source separation scenarios have a good cost reduction potential than mixed collection, with the proposed new system the most cost-effective one.     

文丘里对脉冲喷吹过滤系统清灰的影响

在自建的脉冲喷吹实验台上,利用Y—YD-7044型压电式传感器和MYD-8801加速度传感器,测试0120×2000mm覆PTFE膜无纺布滤袋在不同喷吹压力下,加文丘里与不加文丘里时的最大侧壁压力峰值和最大反向加速度,并对比计算了获得同样清灰强度时的脉冲阀一次喷吹耗气量。结果显示,添加文丘里能显著增大滤袋中下部最大侧壁压力峰值和整条滤袋上的最大反向加速度,即提高脉冲喷吹清灰强度;对应同样的喷吹压力,加文丘里时的平均最大侧壁压力峰值和平均最大反向加速度比不加文丘里时分别平均提高大约70％和50％;加文丘里获得同样清灰强度时的脉冲阀一次喷吹耗气量比不加文丘里时节省40％左右。证实对于脉冲喷吹清灰系统,添加文丘里能有效改善清灰效果以及减小能量？肖耗。     

碘掺杂TiO2可见光光催化性能研究

在低于100℃温度条件下,采用溶胶-凝胶法以钛酸正丁酯为钛源,碘酸钾为碘源,制备了I掺杂纳米TiO2催化剂(I-TiO2),运用X-射线衍射(XRD)、透射电镜(TEM)及X-射线光电子能谱(XPS)等对催化剂进行表征,结果表明,TiO2及I-TiO2催化剂均为锐钛矿,I吸附并包裹在TiO2表面或以间隙进入的形式存在,并未进入TiO2晶格。通过在可见光照射下(λ>420 nm)以罗丹明B(Rhodamine B,RhB)的光催化降解为探针反应研究了在不同条件下制备催化剂的催化性能,结果表明,掺杂比为nI:nTi=0.05∶1,焙烧温度为400℃,降解介质条件pH=7时,I-TiO2光催化活性明显优于未掺杂的TiO2。光催化降解过程通过红外光谱(IR),总有机碳(TOC)跟踪测定,比较了TiO2掺杂前后降解RhB和对氯苯酚(4-CP)的光催化特性差异;同时采用苯甲酸荧光光度法跟踪测定体系中的氧化物种,表明在可见光下,I-TiO2光催化体系中产生.OH高活性氧化物种从而氧化降解目标化合物。