Isolation and identification of intermediates from biodegradation of low chlorinated biphenyls (Delor-103)

Microorganism Pseudomonas species P2 metabolizes polychlorinated biphenyls (PCBs) and biphenyl, producing the whole spectrum of intermediates, among them coloured intermediates, which are suitable for the monitoring of PCBs degradation by optical sensors. Knowledge of chemical structures and conditions of development of colour metabolites is necessary for application of optical analytical methods. The main goal of this work was the isolation and identification of intermediates from the biodegradation of the mixture of low chlorinated biphenyls (Delor-103), which is based on the solid phase extraction (SPE) of the whole mixture using LiChrolut EN cartridges, then silylation of the extract as one way to the identification of one part of intermediates by GC-MS, and acetylation of the extract as a way for the further concentration and analysis of more polar chlorobiphenylols and chlorobiphenyldiols. The combination of SPE and following acetylation allows to obtain chlorobiphenylols and chlorobiphenyldiols as an almost pure fraction. The acetylation method could be also used instead SPE procedure with the same final concentration effect. Using the simulation mass spectrometry program, two new compounds, dihydrodihydroxytrichloro- and tetrahydrodihydroxytrichlorobiphenyl, as silylderivatives, were identified.     

Release of uranium from rock matrix--a record of glacial meltwater intrusions?

Uranium release observed in a rock matrix around water-carrying fractures was studied using U-series disequilibrium (USD) modelling and mass balance calculations. Several release scenarios were tested, with specific attention to the glacial aspects. The release appears to have occurred in two or three violent episodes during the last 300 ky. A release after the last glaciation can be excluded on mass flow grounds. Continuous release for more than 300 ky can be excluded on radioactive disequilibrium grounds. Repeated inflows of oxic glacial meltwater seem to have triggered the release episodes.     

Yield responses of different crop species to long-term fumigation with sulphur dioxide in open-top chambers

Potted plants of commercial cultivars of rape (Brassica napus L., cv. 'callypso'), summer barley (Hordeum vulgare L., cvs. 'arena' and 'hockey') and bush beans (Phaseolus vulgaris L., cvs. 'rintintin' and 'rosisty') were continuously exposed in open-top chambers to sulphur dioxide (SO(2)) for the whole growing season in order to assess effects of this pollutant on growth and various yield parameters. Treatments consisted of charcoal-filtered air (CF) and CF supplemented with four levels of SO(2), resulting in mean exposure concentrations (microg m(-3)) of approximately 8, 50, 90, 140 and 190. With the exception of the 1000 seeds weight, which was slightly reduced, dry matter production and yield parameters of rape remained unaffected by all SO(2) concentrations or were even stimulated. Compared to CF vegetative growth of both bean cultivars was reduced by 10-26% at all SO(2) levels; however, with significant effects only for cv. 'rintintin'. While all SO(2) additions reduced significantly the yield (dry weight of pods) of the bean cultivar 'rosisty' between 17% and 32%, cv. 'rintintin' showed a significant reduction of up to 42% only at the two highest pollutant concentrations. Dry matter production of the barley cultivars was mainly impaired at SO(2) concentrations > 100 microg m(-3) with a reduction of 30-52%. While nearly all yield parameters of cv. 'hockey' reacted similar to the dry matter production, the yield of cv. 'arena' was reduced already at the low SO(2) levels. At a treatment concentration of 90 microg SO(2) m(-3) a significant yield loss of 30% was recorded. A reduction of the 1000 grains weight mainly contributed to these yield losses observed for both barley cultivars. From these results, it may be assumed that SO(2) concentrations within the range 50-90 microg m(-3) are potentially phytotoxic to some crop species.     

The assessment of the possible inhibitory effect of dyestuffs on aerobic waste-water bacteria experience with a screening test

This paper describes the development of, and one year's experience with, a screening method based on the measurement of the respiration rate of activated sludge for assessing the possible inhibitory effect of dyestuffs on aerobic waste-water bacteria. Of the 202 dyestuffs tested, about 10% showed an inhibiting effect such that should significant quantities be likely to reach a sewage treatment plant a closer assessment of the likely effects would be indicated.     

Exposure to benzene,toluene, xylenes and total hydrocarbons among snowmobile drivers in Sweden

The exposure to benzene, toluene, xylenes and total hydrocarbons among 25 individuals exposed to exhaust from a snowmobile equipped with a two-stroke engine has been evaluated. Sampling was performed by pumped and diffusive sampling in parallel. There was a relatively bad agreement between the two air-sampling methods. The bad agreement can in part be explained by back diffusion of the substances from the samplers, a high face velocity, and deposition of droplets of unburned gasoline onto or in the vicinity of the samplers.

The levels of benzene ranged from not detectable (0.01 mg m⁻³) to 2.5 mg m⁻³. For toluene, xylenes and total hydrocarbons the exposure was 0.10–12.0, 0.05–13.0 and 0.90–273 mg m⁻³ respectively. The result from two measurements on individuals travelling on an open sleigh at the rear of the vehicle indicated higher levels of benzene, 0.7–0.8 mg m⁻³. Children are often riding as a passenger on a sledge and may thus have a higher exposure than their parents. This study indicates that spare time driving a snowmobile may cause a considerable exposure to benzene. Using a four-stroke engine equipped with a catalyst could reduce the exposure. To reduce the exposure for the passenger on a sleigh an extension of the exhaust pipe may be effective.     

Coping with uncertainty: a call for a new science-policy forum

The scientific and policy worlds have different goals, which can lead to different standards for what constitutes "proof" of a change or phenomena, and different approaches for characterizing and conveying uncertainty and risk. These differences can compromise effective communication among scientists, policymakers, and the public, and constrain the types of socially compelling questions scientists are willing to address. In this paper, we review a set of approaches for dealing with uncertainty, and illustrate some of the errors that arise when science and policy fail to coordinate correctly. We offer a set of recommendations, including restructuring of science curricula and establishment of science-policy forums populated by leaders in both arenas, and specifically constituted to address problems of uncertainty.     

Laboratory shake flask batch tests can predict field biodegradation of aniline in the Rhine

The aim of this study was to compare degradation rates of aniline in laboratory shake flask simulation tests with field rates in the river Rhine. The combined events of a low flow situation in the Rhine and residual aniline concentrations in the effluent from the BASF treatment plant in Ludwigshafen temporarily higher than normal, made it possible to monitor aniline at trace concentrations in the river water downstream the wastewater outlet by means of a sensitive GC headspace analytical method. Aniline was analyzed along a downstream gradient and the dilution along the gradient was calculated from measurements of conductivity, sulfate and a non-readily biodegradable substance, 1,4-dioxane. Compensating dilution, field first-order degradation rate constants downstream the discharge of BASF were estimated at 1.8 day⁻¹ for two different dates with water temperatures of 21.9 and 14.7 °C, respectively. This field rate estimate was compared with results from 38 laboratory shake flask batch tests with Rhine water which averaged 1.5 day⁻¹ at 15 °C and 2.0 day⁻¹ at 20 °C. These results indicate that laboratory shake flask batch tests with low concentrations of test substance can be good predictors of degradation rates in natural water bodies––at least as ascertained here for short duration tests with readily degradable compounds among which aniline is a commonly used reference.