Effect of manure application timing, crop, and soil type on phosphorus leaching

Phosphorus (P) leaching losses from manure applications may be of concern when artificial drainage systems allow for hydrologic short-cuts to surface waters. This study quantified P leaching losses from liquid manure applications on two soil textural extremes, a clay loam and loamy sand soil, as affected by cropping system and timing of application. For each soil type, manure was applied at an annual rate of 93 800 L ha(-1) on replicated drained plots under maize (Zea mays L.) in early fall, late fall, early spring, and as a split application in early and late spring. Manure was applied on orchardgrass (Dactylis glomerata L.) in split applications in early fall and late spring, and early and late spring. Drain water was sampled at least weekly when lines were flowing, and outflow rate and total P content were determined. High P leaching losses were measured in the clay loam as soon as drain lines initiated flow after manure application. Flow-weighted mean P leaching losses on clay loam plots averaged 39 times higher (0.504 mg L(-1)) than those on loamy sand plots (0.013 mg L(-1)), and were above the USEPA level of concern of 0.1 mg L(-1). Phosphorus losses varied among application seasons on the clay loam soil, with highest losses generally measured for early fall applications. Phosphorus leaching patterns in clay loam showed short-term spikes and high losses were associated with high drain outflow rates, suggesting preferential flow as the main transport mechanism. Phosphorus leaching from manure applications on loamy sand soils does not pose environmental concerns as long as soil P levels remain below the saturation level.     

Space use optimisation and sustainability-environmental assessment of space use concepts

In this paper, as part of a diptych, we discuss the factor space as a means of improving the environmental performance of building projects. There are indicators for space use efficiency and several more or less broadly supported methods for assessment of environmental issues such as ecological quality, use of building materials and energy consumption. These are discussed in this paper. Assessment methods coupling space use to environmental indicators had not been available until now. Beforehand, plans with different spatial properties could therefore not be environmentally compared. We present a method for the implementation of space use in assessments concerning sustainability. This method was applied to the urban case study presented in our second paper in this journal. In this paper, we also present solutions for improved environmental performance through intensive and multiple use of space in the second, third and fourth dimension.     

Reproductive health in Afghanistan: results of a knowledge, attitudes and practices survey among Afghan women in Kabul

A reproductive-health knowledge, attitudes and practices (KAP) survey was carried out among 468 Afghan women of reproductive age. A convenience sample of women was selected from attendees in the outpatient departments of four health facilities in Kabul. Seventy-nine per cent of respondents had attended at least one antenatal consultation during their last pregnancy. Two-thirds (67 per cent) delivered their first child between 13 and 19 years. The Caesarean-section rate was low (1.6 per cent). Two-thirds (67 per cent) of deliveries occurred in the home. The contraceptive prevalence rate was 23 per cent (16 per cent modern and 7 per cent natural methods). Twenty-four per cent had knowledge of any STIs, although most of these women did not know correctly how to prevent them. Most of the women (93 per cent) needed authorization from their husband or a male relative before seeking professional health-care. In multivariate analysis, women's schooling was significantly associated with antenatal-care attendance (AOR 4.78), institutional delivery (AOR 2.29), skilled attendance at birth (AOR 2.07) and use of family planning (AOR 4.59). Reproductive-health indicators were noted to be poor even among these women living in Kabul, a group often considered to be the most privileged. To meet the reproductive-health needs of Afghan women, the socio-cultural aspects of their situation--especially their decision-making abilities -- will need to be addressed. A long-standing commitment from agencies and donors is required, in which the education of women should be placed as a cornerstone of the reconstruction process of Afghanistan.     

Protective effect of different types of bicycle helmets

The effectiveness of bicycle helmets in preventing head injuries is well documented. There are different opinions about the effectiveness of helmets in preventing face injuries, and few studies have analyzed the effect of different types of helmets. This study was performed to examine the effect of different helmet types to head and face injuries. The use of helmets was analyzed in cyclists with head or face injuries and compared with two control groups. The main control group was cyclists that had injuries not including the head or neck, and another control group was cyclists that had been involved in an accident, regardless of whether they had sustained any injury. Cross-table and logistic regression analyses were applied to analyze the protective effect of helmets. A total of 991 injured patients served as a basis for this study. Most of the accidents, (82%) were single accidents with no other persons involved. Of patients with injuries to the head, excluding face, 11.4% had been using hard shell helmets, and 9.6% had been using foam helmets at the time of the accident. Among the emergency room controls, the proportion of hard shell helmet users and foam helmet users was 26.4% and 11.4%, respectively. Compared to non-helmet users, this gave an odds ratio of 0.36 (CI = 0.21-0.60) for getting head injuries if the cyclists had been using hard shell helmets at the time of the injury, and 0.83 (CI = 0.41-1.67) for users of foam helmets. The odds ratio for getting face injuries was 0.90 (CI = 0.58-1.41) among users of hard shell helmets, and 1.87 (CI = 1.03-3.40) for users of foam helmets. The use of hard shell helmets reduced the risk of getting injuries to the head. Children less than nine years old that used foam helmets had an increased risk of getting face injuries. All bicyclists should be recommended to use hard shell bicycle helmets while cycling.     

Assessment of spatial variation of cesium-137 in small catchments

Surface contamination by bomb-derived and Chernobyl-derived 137Cs has been subject to changes due to physical decay and lateral transport of contaminated soil particles, which have resulted in an on-going transfer of radionuclides from terrestrial ecosystems to surface water, river bed sediments, and flood plains. Knowledge of the different sources of spatial variation of 137Cs is particularly essential for estimating 137Cs transfer to fluvial systems and for successfully applying 137Cs as an environmental tracer in soil erosion studies. This study combined a straightforward sediment redistribution model and geostatistical interpolation of point samples of 137Cs activities in soil to distinguish the effects of sediment erosion and deposition from other sources of variation in 137Cs in the small Mochovce catchment in Slovakia. These other sources of variation could then be interpreted. Besides erosion and deposition processes, the initial pattern of 137Cs deposition, floodplain sedimentation, and short-range spatial variation were identified as the major sources of spatial variation of the 137Cs inventory.     

Odor concentration decay and stability in gas sampling bags

This paper presents results of an experimental study into factors contributing to decay of odor samples during storage, between 4 and 40 hr after sample collection. The odor studied was sampled from a tobacco processing plant as part of collaborative research with a view to establishing a manual outlining methods for odor annoyance management, specifically for the tobacco industry. In August and September 1997, an experimental program was carried out in which two types of tobacco odor were sampled: Burley Toaster and Mix. The dependent variable was odor concentration in the bag, measured by dynamic olfactometry in accordance with the draft Comité Européen de Normalisation (CEN) standard EN13725 "Air Quality-Determination of Odor Concentration by Dynamic Olfactometry." The independent variables were sampling bag material, degree of dilution during sampling, dilution gas used, particle removal during sampling, and age of sample in hours. In the first phase, 94 odor analyses were carried out. In a second test, 32 samples were analyzed for odor concentration. In addition, 16 samples were analyzed using gas chromatography-mass spectrometry (GC-MS). Analysis of the results (analysis of variance) led to the unexpected conclusion that Nalophan film bags performed significantly better than metalized Cali-Bond layered film as a bag material. The odor concentration of samples in Nalophan bags remained relatively stable between 4 and 12 hr after sampling. After 30 hr, decay to about half the initial concentration, as measured at 4 hr, was observed. Particle removal during sampling caused the odor concentration in the bags to be reduced by approximately 20%. For practical reasons, particle removal remains useful, to avoid contamination of equipment. Using air or nitrogen as the neutral gas for pre-dilution during sampling or the dilution factor used (between factor 2 and 6) did not appear to have an effect on the decay characteristic of odor samples. The following recommendations are suggested for the practice of collecting odor samples and apply specifically to tobacco processing emissions: Analyze samples as soon as possible, preferably within 12 hr; When samples age for more than 12 hr, decay is likely to cause a reduction in odor concentration to half the original concentration at age 30 hr; Use sampling bags made of Nalophan NA or benchmark performance of other materials against Nalophan NA before using alternative materials; Use pre-dilution when sampling only for the purpose of avoiding condensation during sample storage. Use an appropriate minimum dilution factor to avoid condensation; Both nitrogen and high-purity (synthetic) air are suitable to use as neutral gas for pre-dilution; and When sampling tobacco odors, use an odorless filter to remove particles. This practice removes a source of variation and avoids contamination of equipment. The effect on results, despite being consistently lower in odor concentration, is not meaningful in terms of perceived intensity or annoyance potential.