Antenatal diagnosis and palliative treatment of non-immune hydrops fetalis secondary to fetal parvovirus B19 infection

Hydrops fetalis was diagnosed at 22 weeks. An ultrasound examination demonstrated cardiomegaly and a fetal blood specimen obtained by cordocentesis revealed thrombocytopenia, anaemia, and neutropenia. Fetal paracentesis yielded straw-coloured fluid with electrolytes indicative of a transudate. Non-enveloped icosahedral viral particles approximately 23 mm in diameter were visualized in the ascitic fluid by electron microscopy. Immune electron microscopy confirmed human parvovirus B19. Direct fetal digitalization led to a reduction in umbilical artery resistance, a decline in the abdominal circumference from 20·3 to 17·8 cm, and resolution of the ascites within 72 h. Despite this dramatic response to therapy, fetal death occurred on day 5 of treatment. The initial maternal serum was positive for anti-B19 IgM and IgG antibodies. Electron microscopy of fetal cardiac tissue obtained post-mortem revealed intranuclear viral particles typical of B19, confirming the antenatal diagnosis of myocarditis. This case demonstrates that direct viral identification is applicable to prenatal diagnosis. To our knowledge, this is the first reported case of the antenatal diagnosis and palliative treatment of fetal viral infection.     

A survey of antennal responses by five species of coniferophagous bark beetles (Coleoptera: Scolytidae) to bark volatiles of six species of angiosperm trees

Summary. Using Porapak Q traps, we collected the bark volatiles of six angiosperm trees native to British Columbia: black cottonwood, Populus trichocarpa Torr. & A. Gray (Salicaceae), trembling aspen, P. tremuloides Michx. (Salicaceae), paper birch, Betula papyrifera Marsh. (Betulaceae), bigleaf maple, Acer macrophyllum Pursh (Aceraceae), red alder, Alnus rubra Bong. (Betulaceae), and Sitka alder, A. viridis ssp. sinuata (Regel) á. L?ve & D. L?ve (Betulaceae). Utilising coupled gas chromatographic-electroantennographic detection analysis, the captured volatiles were assayed for antennal responses in five species of coniferophagous bark beetles (Coleoptera: Scolytidae), sympatric with most or all of the angiosperm trees: the Douglas-fir beetle, Dendroctonus pseudotsugae Hopkins, the mountain pine beetle, D. ponderosae Hopkins, the spruce beetle, D. rufipennis (Kirby), the western balsam bark beetle, Dryocoetes confusus Swaine, and the pine engraver, Ips pini (Say). The identities of 25 antennally-active compounds were determined by coupled gas chromatographic-mass spectroscopic analysis, and co-chromatographic comparisons with authentic chemicals. The compounds identified were: hexanal, (E)-2-hexenal, (Z)-3-hexen-1-ol, 1-hexanol, heptanal, α-pinene, frontalin, benzaldehyde, β-pinene, 2-hydroxycyclohexanone, 3-carene, limonene, β-phellandrene, benzyl alcohol, (E)-ocimene, salicylaldehyde, conophthorin, guaiacol, nonanal, methyl salicylate, 4-allylanisole, decanal, thymol methyl ether, (E)-nerolidol, and dendrolasin. A number of these compounds are known semiochemicals that are active in the behaviour of other organisms, including bark beetles, suggesting a high degree of semiochemical parsimony. Antennally-active compounds ranged from seven in A. viridis to 17 in P. trichocarpa. The fewest number of compounds (9) were detected by I. pini and the largest number (24) were detected by D. pseudotsugae. Six compounds excited the antennae of all five species of bark beetles. The large number of antennally-active compounds detected in common by numerous bark beetles and present in common in numerous nonhost trees supports the hypothesis of olfaction-based recognition and avoidance of nonhost angiosperm trees during the process of host selection by coniferophagous bark beetles. Received 13 December 1999; accepted 14 March 2000     

Equilibration time scales of organic aerosol inside thermodenuders: Evaporation kinetics versus thermodynamics

The interpretation of thermodenuder (TD) data often relies on the assumption that thermodynamic equilibrium is reached inside the instrument. We modeled the evaporation of three organic aerosol types (adipic acid, α-pinene SOA and aged OA) inside a thermodenuder with a mass transfer model, and calculated equilibration time scales for these systems at realistic conditions. The equilibrium times varied from less than a second to several hours, decreasing with increasing aerosol concentrations, decreasing particle sizes, decreasing volatilities and increasing mass accommodation coefficients. The results indicate that generally TDs measure particle evaporation rates rather than equilibria, and time-dependent modeling of the evaporation is usually needed to interpret the data. Measurements at varying residence times and temperatures, on the other hand, are desirable to investigate the equilibration of the studied aerosol and decouple the kinetic effects from the effects caused by the thermodynamic properties of the aerosol. Organic aerosol is likely to be further from equilibrium under typical field conditions compared with laboratory data. When determining the aerosol properties from TD data, assuming incorrectly equilibrium results in under-prediction of the vaporization enthalpy of the evaporating species. Similar under-estimation is predicted if multicomponent aerosols are approximated with single-component properties.     

The Formation of Mg3Ca(S04)4 during the Sulfation Reaction of Dolomite

Abstract

Inspection and maintenance programs for motor vehicles in the United States increasingly use loaded mode mass emissions testing (IM240). A method was developed to predict mass emission rates and mass emission changes, particularly from repair benefits, using a low-cost, portable four-gas non-dispersive infrared (NDIR) vehicle exhaust gas analyzer. A single vehicle was tested several times with the analyzer while on the dynamometer and undergoing successive repairs. Excellent correlations for CO and HC were observed. Five vehicles were measured using an on-road driving loop before and after emissions-related repairs, while another three vehicles were tested with no repairs performed. The on-road concentration data used to guide the repair process were converted to grams per gallon; when divided by estimated miles per gallon, this gave grams per mile emissions for comparison to IM240. Correlation coefficients (r²) of 0.87 for CO and 0.76 for HC were achieved for the 13 tests. The linear correlations between IM240 and emissions measured by this method would allow repair facilities to perform a relatively inexpensive test for diagnostic purposes and to estimate repair effectiveness without the need for a dynamometer.     

An Overview of EPA’s Quality Assurance Program

Quality Assurance has been defined in many different ways to express concern for the “quality” of the output of some operation or function. For the purpose of this presentation, quality assurance is defined as the sum of those activities within an environmental monitoring or measurement program which are primarily for the purpose of documenting the precision, accuracy, representativeness, and completeness of the data that are produced. Further, we view quality assurance as a management tool which encompasses both administrative and technical functions which generally fall into three categories: (1) Prevention which includes those activities carried out prior to the proper placement and operation of the measurement system; (2) Evaluation which includes the continuous overview and checks on the performance of the systems and operators; and (3) Correction which includes changes made to improve or stabilize the capability and performance of the system.     

R&D Activities,Operating Experience Discussed at Fabric Alternatives Forum

ABSTRACT

Previously reported volatile organic compounds (VOC) radiocarbon (¹⁴C) measurements for 1992 summertime Atlanta, GA, have been compared with chromatographic data and emissions inventory predictions. The chromatographic approach that was used provided a more comprehensive VOC characterization than typically achieved, and the emissions inventory was research-grade level (date-, site-, and time-specific). The comparisons are in general agreement that biogenic emissions contribute only modestly (<10%) to the VOC content of the particular ambient samples that were collected and measured. The choices of sampling site (near city-center) and times (early morning and late evening) are major influences on the results, which consequently should not be regarded as representing the average VOC biogenic impact for the Atlanta area.     

Comparison of EDTA-enhanced phytoextraction and phytostabilisation strategies with Lolium perenne on a heavy metal contaminated soil

Phytoremediation is a promising and cost-effective strategy to manage heavy metal polluted sites. In this experiment, we compared simultaneously phytoextraction and phytostabilisation techniques on a Cd and Zn contaminated soil, through monitoring of plant accumulation and leaching. Lolium perenne plants were cultivated for 2 months under controlled environmental conditions in a 27.6 dm³-pot experiment allowing the collect of leachates. The heavy metal phytoextraction was promoted by adding Na-EDTA (0.5 g kg⁻¹ of soil) in watering solution. Phytostabilisation was assessed by mixing soil with steel shots (1%) before L. perenne sowing. Presence of plants exacerbated heavy metal leaching, by improving soil hydraulic conductivity. Use of EDTA for phytoextraction led to higher concentration of heavy metal in shoots. However, this higher heavy metal extraction was insufficient to satisfactory reduce the heavy metal content in soil, and led to important heavy metal leaching induced by EDTA. On the other hand, addition of steel shots efficiently decreased both Cd and Zn mobility, according to 0.01 M CaCl₂ extraction, and leaching. However, improvement of growth conditions by steel shots led to higher heavy metal mass in shoot tissues. Therefore, soil heavy metal mobility and plant metal uptake are not systematically positively correlated.