Environmental effects of soil contamination by shale fuel oils

Estonia is currently one of the leading producers of shale oils in the world. Increased production, transportation and use of shale oils entail risks of environmental contamination. This paper studies the behaviour of two shale fuel oils (SFOs)—‘VKG D’ and ‘VKG sweet’—in different soil matrices under natural climatic conditions. Dynamics of SFOs’ hydrocarbons (C10–C40), 16 PAHs, and a number of soil heterotrophic bacteria in oil-spiked soils was investigated during the long-term (1 year) outdoor experiment. In parallel, toxicity of aqueous leachates of oil-spiked soils to aquatic organisms (crustaceans Daphnia magna and Thamnocephalus platyurus and marine bacteria Vibrio fischeri) and terrestrial plants (Sinapis alba and Hordeum vulgare) was evaluated. Our data showed that in temperate climate conditions, the degradation of SFOs in the oil-contaminated soils was very slow: after 1 year of treatment, the decrease of total hydrocarbons’ content in the soil did not exceed 25 %. In spite of the comparable chemical composition of the two studied SFOs, the VKG sweet posed higher hazard to the environment than the heavier fraction (VKG D) due to its higher mobility in the soil as well as higher toxicity to aquatic and terrestrial species. Our study demonstrated that the correlation between chemical parameters (such as total hydrocarbons or total PAHs) widely used for the evaluation of the soil pollution levels and corresponding toxicity to aquatic and terrestrial organisms was weak.     

On-farm measurement of electrical conductivity for the estimation of ammonium nitrogen concentration in pig slurry

Pig (Sus scrofa domesticus) slurry (PS) is commonly applied as fertilizer to agricultural fields. Knowledge of PS nitrogen content is essential for good management, but PS nitrogen content is highly variable, not only between farms but also within a farm. Laboratory analysis of animal slurries is often expensive and impractical for routine farmer use. Therefore, when slurry is spread on land, its fertilizer value is generally unknown, resulting in the risk of pollution. In this work, two rapid and suitable for field use methods for determining PS ammonium N (NH(4)+-N) concentration (Quantofix and conductimetry) are evaluated. The electrical conductivity of a dilution 1 PS:9 distilled water had better results than Quantofix, did not need reagents, and gave a direct value of NH(4)+-N concentrations (range, 1.0-7.6 kg NH(4)+-N m(-3)). The conductimetry method allows the use of alternative waters with EC <1.9 dS m(-1) for dilution. This method is being introduced to farmers in northeast Spain to improve PS management and has been well received due to its low cost and ease of use.     

Implications of geographic variability on Comparative Toxicity Potentials of Cu, Ni and Zn in freshwaters of Canadian ecoregions

Current methods of estimating potential environmental impacts of metals in hazard and Life Cycle Impact Assessment (LCIA) do not consider differences in chemistry and landscape properties between geographic sites. Here, we developed and applied a model for regional aquatic impact characterization of metals using an updated method for estimating environmental fate factor (FF), bioavailability factor (BF) and aquatic ecotoxicity factor (EF). We applied the model to analyze differences in Comparative Toxicity Potentials (CTPs) of Cu, Ni and Zn for 24 Canadian ecoregions. The combined impacts of regional variability in ambient chemistry (in particular DOC, pH and hardness) and landscape properties (water residence time) can change the CTPs of these metals for freshwater by up to three orders of magnitude and change the relative ranking of metal hazard between ecoregions. Variation among Canadian freshwater chemistries and landscape characteristics influence the FFs within two orders of magnitude, BFs within two orders of magnitude for Ni and Zn and four orders of magnitude for Cu, and EFs within one order of magnitude. Sensitivity of metal FFs to environmental parameters alone spans three orders of magnitude when a constant water chemistry was used for all ecoregions. These results indicate that application of regionalised metal CTPs can have a significant influence in the analysis of ecotoxicological impacts in the life cycle assessment of products and processes.     

Implication of nitric oxide in the heat-stress-induced cell death of the symbiotic alga <Emphasis Type="Italic">Symbiodinium microadriaticum</Emphasis>

One of the major consequences of global warming is a rise in sea surface temperature which may affect the survival of marine organisms including phytoplankton. Here, we provide experimental evidence for heat-induced cell death in a symbiotic microalga. Shifting Symbiodinium microadriaticum from 27 to 32°C resulted in an increase in mortality, an increase in caspase 3-like activity, and an increase in nitric oxide (NO) production. The caspase-like activity was strongly correlated with the production of NO in thermally challenged microalgae. For this experiment, the application of Ac-DEVD-CHO, a mammalian caspase 3-specific inhibitor, partly prevented (by 65%) the increase in caspase-like activity. To verify the relationship between NO and the caspase-like activity, S. microadriaticum were subsequently incubated with 1.0 mM of the following chemical NO donors: sodium nitroprusside (SNP), S-nitrosoglutathione (GSNO), S-nitroso-N-acetylpenicillamine (SNAP) and 3,3bis(Aminoethyl)-1-hydroxy-2-oxo-1-triazene (NOC-18). The supplementation of both SNP and NOC-18 caused a significant increase in caspase-like activity compared to the control treatment. Pre-treatment of the microalgae with the inhibitor Ac-DEVD-CHO before the supplementation of the different NO donors completely prevented the increase in caspase-like activity. These results suggest that NO could play a role in the induction of cell death in heat-stressed S. microadriaticum by mediating an increase in caspase-like activity.     

Noise disturbance caused by outdoor activities�� a simulated-environment study for Ali Sami Yen Stadium, ?stanbul

Negative effects of noise on individuals, the inevitable result of urbanization, have become a significant urban problem in our day. Introduction of an approach to the noise problem on an urban-planning scale lightens the burden of measures required to be taken against noise at the stages of regional and developmental planning. Stadiums, which should be also evaluated from the point of noise problem when planning decisions are made on the urban planning scale, may cause very serious problems differing depending on the region they are located in. In this article, various dimensions of the noise problem caused by stadiums have been exemplified by making an assessment on Ali Sami Yen football stadium located in Mecidiyeköy district which is among important residential and commercial centres of ?stanbul or Turkey. When the simulation results obtained for ordinary days and match days are evaluated, it has been found out that the people living in the area are exposed to noise levels substantially exceeding the acceptable values. Results of the survey conducted in the area have clearly revealed the existence of noise problem, too.     

NONPARAMETRIC TESTS FOR TREND DETECTION IN WATER QUALITY TIME SERIES1

ABSTRACT: A review of nonparametric tests for trend leads to the conclusion that Mann-Whitney, Spearman, and Kendall tests are the best choice for trend detection in water quality time series. Recently these tests have been adapted to account for dependence and seasonality in such series (Lettenmaier, 1976; Hirsch, et al., 1972; Hirsch and Slack, 1984). For monotonic trends, a procedure allowing to select the pertinent tests considering the characteristics of time series is proposed and the practical limitations of the tests are also brought out. This procedure has been applied to identify the appropriate trend detection test for the time series of nine water quality parameters at Lake Laflamme (Québec). When a time series can be tested with the Mann-Whitney, Kendall, Spearman, or Lettenmaier (1976) test, the number of observations required to detect trends of a given magnitude, for selected significance and power levels can be calculated with the power function of the t test. When the test proposed by Hirsch, et al. (1984), Hirsch and Slack (1984), or Farrell (1980) need to be used, the number of observations can only be estimated approximately from the results of empirical power studies.     

On the usefulness of life cycle assessment of packaging

In reaction to a paper inEnvironmental Management in which the sense and sensibility of environmental assessments of packaging were questioned, it is argued that these types of assessments may be very useful, provided the relevant types of questions are posed. These boundary conditions are discussed, along with an overview of more recent methodological developments with respect to environmental assessment of products.     

A Baumol–Oates approach to solid waste taxation

A national Baumol–Oates tax on waste in Denmark helped achieve a reduction of 26% in net solid waste from 1987 to 1998. The tax, which is levied per ton of waste, was particularly effective as regards the heavier waste streams such as construction waste and garden waste. When it comes to industrial and commercial waste, there are indications that the waste tax is not sufficiently significant to induce changes in behavior, and that except for very waste-intensive enterprises, companies do not seem to be very price sensitive. For household waste, the impact of the tax can be improved where tariffs for garbage collection are weight based, rather than per unit. However, the waste sector is an area in which the price signals are modified and filtered by institutionalized practices in municipal administration, and in which true-cost pricing is not easy to achieve. Hence, the rational choice assumption of environmental economics needs to be supplemented by an institutional dimension to interpret responses to environmental taxes correctly. Received: July 13, 2001 / Accepted: October 2, 2001     

Analysis of the recycling system for aluminum cans,focusing on collection,transportation, and the intermediate processing methods

In this article, the systems for the collection and intermediate processing of used beverage cans (UBCs) are compared and analyzed, focusing on the time taken and the cost of processing, the energy consumption, and the emissions of CO₂, SO _x , and NO _x , during the process. We found that cases where the UBCs were crushed in the discharging process gave better results, and how the UBCs were collected was the most important factor. It was more desirable to treat UBCs in one place than in two places. When the transportation distance was longer, the pressed form of UBCs was more convenient. When the transportation distance was short, the original form, the crushed form, and the shredded form of UBCs were all suitable. That is, the contribution of the transportation process to the evaluation was large when the transport distance was long, and the contribution of the treatment process was large when the transport distance was short.