Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Review of in situ remediation technologies for lead,zinc, and cadmium in soil

This article presents a review of in situ technologies for the remediation of soils contaminated with lead, zinc, and/or cadmium. The objective of this review is to assess the developmental status of the available in situ technologies and provide a general summary of typical applications and limitations of these technologies. The literature review identified seven in situ remediation technologies—solidification/stabilization, vitrification, electrokinetic remediation, soil flushing, phytoextraction, phytostabilization, and chemical stabilization. These technologies were considered for their ability to meet a specific set of remediation objectives under a range of conditions. Each of these technologies has both strengths and weaknesses for addressing particular remedial situations discussed in the article for each of the technologies. A general summary of which technologies are most applicable to common remedial scenarios is also provided. © 2004 Wiley Periodicals, Inc.     

Nitrogen removal in laboratory model leachfields with organic-rich layers

Septic system leachfields can release dissolved nitrogen in the form of nitrate into ground water, presenting a significant source of pollution. Low cost, passive modifications, which increase N removal in traditional leachfields, could substantially reduce the overall impact on ground water resources. Bench-scale laboratory models were constructed to evaluate the effect of placing an organic layer below the leachfield on total N removal. The organic layer provides a carbon source for denitrification. Column units representing septic leachfields were constructed with sawdust-native soil organic layers placed 0.45 m below the influent line and with thicknesses of 0.0, 0.3, 0.6, and 0.9 m. Using a synthetic septic tank effluent, NO(3)-N concentrations at 3.8 m below the influent line were consistently below 1 mg L(-1) during 10 months of operation compared with a NO(3)-N concentration of nearly 12 mg L(-1) in the control column. The average total N removal increased from 31% without the organic layer to 67% with the organic layer. Total N removal appeared limited by the extent of organic N oxidation and nitrification in the 0.45-m aerobic zone. Design modifications targeted at improving nitrification above the organic layer may further increase total N removal. Increased organic layer thicknesses from 0.3 m to 0.9 m did not significantly improve average total N removal, but caused a shift in residual nitrogen from organic N to ammonia N. Results indicate that addition of a layer of carbon source material at least 0.3 m thick below a standard leachfield substantially improves total N removal.     

Influence of ozone stress on growth processes, yields and grain quality characteristics among soybean cultivars

Field studies were conducted at USDA Beltsville Agricultural Research Center, Beltsville, Maryland, in 1984 and 1985 using open-top chambers to acquire information on the responses of 12 soybean (Glycine max L. Merr.) cultivars to O3 stress and to examine the interactions between maturity groups and O3 stress. Cultivars representing Groups III, IV, and V were exposed for approximately 3 months to charcoal-filtered air (CF) and nonfiltered air plus 40 nl litre(-1) O3 (NF + O3). Ozone was added 6 h d(-1), 5 d week(-1) for 13 weeks. The CF effectively reduced the accumulative oxidant exposure (AOX) to less than 1.0 microl litre(-1) h and the NF + O3 treatment approximately doubled the ambient AOX (16.7 microl litre(-1) h) to about 30 microl litre(-1) h. The AOX estimates the total O3 exposure above 30 nl litre(-1) during an entire growing season. Plant growth rates and relative growth rates were reduced by 17.0 and 14.4%, respectively, when averaged over cultivars. Based on growth rates, the Group III cultivars were the most affected by O3 stress. Averaged over cultivars, leaf expansion rates, leaf conductance, and transpiration rates were lower in the NF + O3 treatment compared to the CF control; however, wide variation was found with the stomatal results from field observations. Combined over years and cultivars, grain yield was reduced by an average of 12.5% by O3 stress with 3 of 12 cultivars showing significant reductions. Grain protein content was increased by 0.7% by O3 stress, but cultivar differences were equal to the differences caused by the O3 treatments. Grain oil content was unchanged by the O3 treatments. Group IV cultivars showed the greatest decrease in grain yield due to O3 stress. Multiple regression analyses were calculated using the difference between the CF and NF + O3 treatment as a measure of O3 stress. Significant positive relationships were found among net assimilation rates, plant growth rates, relative growth rates, and leaf expansion rates, which suggest that growth analysis characteristics would be useful in addition to yield in air pollution tolerance improvement studies with soybeans.     

Impact of continental margins in the Mediterranean Sea: Hints from the surface colour and temperature historical record

The surface colour and temperature fields of the Mediterranean Sea, as appearing in time series, of basin-wide images available in the CZCS (1979–1985) and AVHRR (1982–1991) historical archives, differentiate between basin interior and continental margins affected by coastal patterns, river plumes, and mesoscale features. The original data were processed to apply calibration factors, to correct for atmospheric contamination, and to estimate chlorophyll-like pigment concentration and surface temperature. Composites were derived, as monthly and annual means, using a fixed equal-area projection with a 1-km² pixel grid. Enhanced pigment values and lower temperatures along the northern coastal areas (i.e. the Ligurian, Provençal and Balearic basins, as well as the Adriatic, and Aegean Seas) have been associated with the impact of runoff from continental margins (i.e. both a direct impact due to the sediment load and one induced on the planktonic flora by the associated nutrient load) and with vertical mixing due to the prevailing winds (i.e. the Mistral in the northwest, the Bora in the Adriatic, the Etesians in the Aegean). The pattern of increasing pigments and decreasing temperatures in seen to develop in the monthly images from the coastal zone towards the open sea from summer to winter, and then back from winter to summer. The southern coastal areas show different values, namely lower pigments and higher temperatures (except in areas where the data are altered by signal contamination). It is suggested that differences in geomorphology and meteorology of the basin margins have an impact on both water biogeochemistry and dynamics, influencing the biooptical and thermal properties of the various sub-basins, and of the entire Mediterranean region.     

Elemental (C, N and P) analysis of metamorphosing bonefish (Albula sp.) leptocephali: relationship to catabolism of endogenous organic compounds, tissue remodeling, and feeding ecology

Whole-body carbon (C), nitrogen (N) and phosphorus (P) content, and stable-isotope composition (¹³C:¹²C and ¹⁵N:¹⁴N), were followed during metamorphosis of bonefish (Albula sp.) larvae (leptocephali). Metamorphosing larvae depend entirely on endogenous carbon compounds (some of which contain N and P) as an energy source. Two fundamental questions are (1) Do the demands of extensive tissue remodeling during metamorphosis require the efficient retention of N and P during the catabolism of carbon compounds? (2) What effect does the lack of feeding have on stable-isotope composition? Our results showed that both C and N decreased by ～35 to 40%, reflecting the utilization of neutral lipid (triacylglycerols) and N-containing compounds (phosphatidylethanolamine and keratan sulfate glycosaminoglycan) as energy sources, and indicating that larvae have little or no capacity to retain N. Evidence suggested that collagen breakdown, measured as a loss of hydroxyproline content, also contributed to N loss. Stable-isotope ratios, expressed as ¹³C and ¹⁵N, showed no statistically significant differences in early and advanced metamorphosing larvae. In contrast to C and N, phosphorus was conserved during metamorphosis and most probably is utilized in the increased bone mineralization occurring in advanced larvae. We show, however, that advanced larvae are P-limited and that normal ossification is dependent upon a supply of exogenous P obtained after the resumption of feeding. The N:P ratio of 12.3 in early larvae decreased to 8.1 in advanced larvae owing to the conservation of P as N was lost. The mean ¹⁵N value in early metamorphic larvae (11.6‰) is consistent with results from other studies, and provides further support for the view that premetamorphic leptocephali feed at a very low trophic level.     

Predicting bicycle helmet wearing intentions and behavior among adolescents

INTRODUCTION: Cycling accidents in Australia, especially those resulting in head injuries, are a substantive cause of death and disability; but despite legislation and evidence that helmets reduce the risk of head injury, few adolescents wear them. METHOD: This study employed a revised version of the Theory of Planned Behavior (TPB; [Ajzen, I. (1991). The theory of planned behavior. Organizational Behavior and Human Decision Processes, 50, 179-211]) to investigate the determinants of helmet use among a sample of adolescents. Participants in the initial data collection were 294 high school students in Year 8 and Year 11, with 266 completing a follow-up questionnaire measuring behavior over the previous two weeks. RESULTS: Social norms, perceptions of control, and past behavior significantly predicted intentions to use helmets and perceptions of control and past behavior predicted actual helmet use. CONCLUSIONS: Strengthening the routine of helmet use and building young people's confidence that they can overcome any perceived barriers to helmet use will improve adherence to helmet wearing behavior.     

Footedness and Mounting—Short Review and Two Case Studies

Footedness is a personal quality like handedness. Footedness may be associated with moving ability during mounting, dismounting, and jumping movements. Occupational accidents have occurred during movement at different working levels, during the use of access and exit systems, and during the mounting of vehicles. Aging can also affect accident risk and body laterality. For example, falling accidents on stairs are common among the elderly. One reason for accidents may be that the structure of the access system or stair system is unsuitable for individual moving patterns depending partly on body laterality. Footedness and the way the feet are used may be contradictory to the demands of the moving situation, especially during uncommon or rapid situations. This contradiction may trigger disturbance during moving. The aims of this pilot study were (a) to review the literature briefly and (b) to describe the use of the dominant and nondominant foot by farmers and the elderly when mounting a tractor and stairs, respectively. The study also gives ideas for future studies based on both (a) and (b).     

Ergonomic Aspects of a Virtual Environment

A virtual environment is an interactive graphic system mediated through computer technology that allows a certain level of reality or a sense of presence to access virtual information. To create reality in a virtual environment, ergonomics issues are explored in this paper, aiming to develop the design of presentation formats with related information, that is possible to attain and to maintain user-friendly application.