Modeling flow and nitrate fate at catchment scale in Brittany (France)

In the intensive pig-farming (Sus scrofa) area of Brittany (western France), many surface and subsurface water resources are contaminated by nitrate (NO3) with concentrations that chronically exceed the European Community 50 mg L(-1) drinking standard. To ensure sustainable water supply, the fate of NO3 must be considered in both surface water and ground water. The fate of N was investigated in a Britain catchment, the Co?t-Dan watershed, with an integrated management tool: the hydrological SWAT model coupled with the ground water model MODFLOW, and its companion contaminant and solute transport model MT3DMS. The model was validated with respect to water quantity during a 6-yr period and for the NO3 concentration during a 44-mo period, at two gauging stations in the catchment. The coupled models reproduced accurately the measurements. At the basin outlet, the Nash-Sutcliffe coefficients were 0.88 for monthly flow for the entire period and 0.87 for monthly N load. Alternative scenarios were simulated and showed potential benefits of decreasing manure application from 210 to 170 kg N ha(-1) as required by the European Commission Nitrates Directive.     

Nitrous oxide emission and denitrification in chronically nitrate-loaded riparian buffer zones

Riparian buffer zones are known to reduce diffuse N pollution of streams by removing and modifying N from agricultural runoff. Denitrification, often identified as the key N removal process, is also considered as a major source of the greenhouse gas nitrous oxide (N2O). The risks of high N2O emissions during nitrate mitigation and the environmental controls of emissions have been examined in relatively few riparian zones and the interactions between controls and emissions are still poorly understood. Our objectives were to assess the rates of N2O emission from riparian buffer zones that receive large loads of nitrate, and to evaluate various factors that are purported to control N emissions. Denitrification, nitrification, and N2O emissions were measured seasonally in grassland and forested buffer zones along first-order streams in The Netherlands. Lateral nitrate loading rates were high, up to 470 g N m(-2) yr(-1). Nitrogen process rates were determined using flux chamber measurements and incubation experiments. Nitrous oxide emissions were found to be significantly higher in the forested (20 kg N ha(-1) yr(-1)) compared with the grassland buffer zone (2-4 kg N ha(-1) yr(-1)), whereas denitrification rates were not significantly different. Higher rates of N2O emissions in the forested buffer zone were associated with higher nitrate concentrations in the ground water. We conclude that N transformation by nitrate-loaded buffer zones results in a significant increase of greenhouse gas emission. Considerable N2O fluxes measured in this study indicate that Intergovernmental Panel on Climate Change methodologies for quantifying indirect N2O emissions have to distinguish between agricultural uplands and riparian buffer zones in landscapes receiving large N inputs.     

Wax perception in honeybees: contact is not necessary

In social insects, much progress has been made in identifying variations in the cuticular signatures of sexes, castes, kin and reproductive status. In contrast to this, we still do not know how the receivers perceive these recognition cues. This study was designed to investigate whether honeybees use contact-chemosensory or olfactory sensilla to perceive wax components. To answer this question in a behavioral assay, we combined classical conditioning of the proboscis extension reaction and a recently established method using zinc sulfate to selectively block antennal contact-chemosensory sensilla. Comparison of the responses to sucrose, wax and geraniol before and after antennal zinc sulfate treatment revealed that the sucrose response is lost after treatment but the responses to wax and geraniol are maintained. As sucrose is perceived by the contact-chemosensory sensilla, the retention of the wax response indicates that contact-chemosensory sensilla are not necessary for wax perception.     

Methods for collecting time/activity pattern information related to exposure to combustion products

Focus groups, surveys and questionnaires, diaries and observations can be used to gather information about people's exposure to a wide range of combustion products. Information about locations and durations of exposure, and sources of exposure can be obtained with these instruments. The types of instruments used must be fine tuned to meet the design characteristics of the community in which the study will be conducted.     

Immobilization of iodide on copper(I) sulfide minerals

In the goal of finding efficient scavengers for radioiodide in conditions (pH, pE) close to those encountered in deep geological sites, sorption of iodide ions on cuprous sulfide minerals (especially roxbyite, Cu(1.75)S) has been studied. Surface analysis by X-ray photoelectron spectroscopy has shown that commercial cuprous sulfides are covered by an oxidized overlayer (mainly in the form of CuSO(4)). Therefore, a synthetic procedure to get roxbyite (typically by mixing Na(2)S with an aqueous suspension of commercial Cu(2)O) was applied to produce pure samples with clean surfaces. Batch equilibration of cuprous sulfide particles suspended in aqueous solutions containing iodide species has revealed significant consumption of iodide. The sorption mechanism involves the formation of a surface complex via the exchange of surface hydroxyl groups by iodide anions, as highlighted by a transient pH increase during the immobilization process. Other copper and mixed copper-iron sulfides (e.g. CuS, CuFeS(2)), which are stable over wide pH and potential ranges are also likely to accumulate iodide species. Because of the specific interaction between iodide and copper(I) centers on the minerals, high distribution coefficients (>1000 ml/g) were observed.     

Monitoring nitrate leaching from submerged drains

Monitoring nitrate N (NO3-N) leaching is important in order to judge the effect that agricultural practices have on the quality of ground water and surface water. Measuring drain discharge rates and NO3-N concentrations circumvents the problem of spatial variability encountered by other methods used to quantify NO3-N leaching in the field. A new flow-proportional drainage water sampling method for submerged drains has been developed to monitor NO3-N leaching. Both low and high discharge rates can be measured accurately, and are automatically compensated for fluctuations in ditch-water levels. The total amount of NO3-N leached was 10.6 kg N ha(-1) for a tile-drained silt-loam soil during the 114-d monitoring period. The NO3-N concentrations fluctuated between 5 mg L(-1) at deep ground water levels and 15 mg L(-1) at shallow levels, due to variations in water flow. A flow-proportional drainage water sampling method is required to measure NO3-N leaching accurately under these conditions. Errors of up to 43% may occur when NO3-N concentrations in the drainage water are only measured at intervals of 30 d and when the precipitation excess is used to estimate cumulative NO3-N leaching. Measurements of NO3-N concentrations in ground water cannot be used to accurately estimate NO3-N leaching in drained soils.     

Ecological impacts of arable intensification in Europe

Although arable landscapes have a long history, environmental problems have accelerated in recent decades. The effects of these changes are usually externalized, being greater for society as a whole than for the farms on which they operate, and incentives to correct them are therefore largely lacking. Arable landscapes are valued by society beyond the farming community, but increased mechanization and farm size, simplification of crop rotations, and loss of non-crop features, have led to a reduction in landscape diversity. Low intensity arable systems have evolved a characteristic and diverse fauna and flora, but development of high input, simplified arable systems has been associated with a decline in biodiversity. Arable intensification has resulted in loss of non-crop habitats and simplification of plant and animal communities within crops, with consequent disruption to food chains and declines in many farmland species. Abandonment of arable management has also led to the replacement of such wildlife with more common and widespread species. Soils have deteriorated as a result of erosion, compaction, loss of organic matter and contamination with pesticides, and in some areas, heavy metals. Impacts on water are closely related to those on soils as nutrient and pesticide pollution of water results from surface runoff and subsurface flow, often associated with soil particles, which themselves have economic and ecological impacts. Nitrates and some pesticides also enter groundwater following leaching from arable land. Greatest impacts are associated with simplified, high input arable systems. Intensification of arable farming has been associated with pollution of air by pesticides, NO2 and CO2, while the loss of soil organic matter has reduced the system's capacity for carbon sequestration. International trade contributes to global climate change through long distance transport of arable inputs and products. The EU Rural Development Regulation (1257/99) provides an opportunity to implement measures for alleviating ecological impacts of arable management through a combination of cross-compliance and agri-environment schemes. To alleviate the problems described in this paper, such measures should take account of opportunities for public/private partnerships and should integrate social, cultural, economic and ecological objectives for multifunctional land use.     

The Role Played by Acetyl Group Distribution Patterns in Substituted Starch Toward Enzymatic De-acetylation and Chain Fragmentation

The nature and distribution of the acetylated groups were evaluated by ¹³C-NMR and ¹H-NMR. The starch substrate with a DS of 1.5 comprises only two patterns: -(14)-d-glucopyranose and 2,3,6-tri-O-acetyl--(14)-d-glucopyranose. The starch with a DS of 3.0 also comprises two patterns: 2,3,4,6-tetra-O-acetyl--(14)-d-glucopyranose and 2,3,6-tri-O-acetyl--(14)-d-glucopyranose; whereas starch (DS = 1.9) contains 4 patterns: 2,3,6-tri-O-acetyl--(14)-d-glucopyranose, 2,3,4,6-tetra-O-acetyl--(14)-d-glucopyranose terminal, 2,6-di-O-acetyl--(14)-d-glucopyranose, and 3,6-di-O-acetyl--(14)-d-glucopyranose. Using esterase from Viscozyme, it has been possible to hydrolyze up to 7% of the DS 3.0 starch. An -amylase (Fungamyl 800) was then added to these acetylesterases. With a 2.4 FAU/mL fraction of -amylase and 2.4 U/mL from the Viscozyme's acetylesterase, 28% of the acetylated end groups were hydrolyzed for the starch substrates with DS 3.0. Moreover, a synergic action between -amylase and acetylesterase was noticed, allowing fragmentation of 32% for DS 1.5, 30% for DS 1.9, and 11% for DS 3.0.     

Origin of the Henze solution/precipitate from morula cells of the blood of the ascidian Phallusia mammillata

 The "Henze solution", derived originally from the aqueous extraction of pelleted whole blood from the ascidian Phallusia mammillata, was examined using spectral studies. The aqueous extraction of fractionated blood cells including compartment cells, signet ring cells, and morula cells obtained using cell separation techniques were also examined. It was found that this Henze solution, and the Henze precipitate itself derived from this solution, emanated solely from the morula cells. Furthermore, it was found that this solution is formed independently of the vanadium metal ions otherwise associated with the vanadocytes. Observation of the Henze precipitate by light microscopy shows that this material partially forms crystallites or microglasses. Received: 27 July 1999 / Accepted in revised form: 28 February 2000