Adsorption of methabenzthiazuron on six allophanic and nonallophanic soils: effect of organic matter amendment

This article reports on methabenzthiazuron [1-(1,3-benzothiazol-2-yl)-1,3-dimethylurea] (MBT) adsorption process on six agricultural allophanic and nonallophanic soils. The effect of amendment with exogenous organic matter was also studied. Adsorption kinetic fits an hyperbolic model. MBT adsorption reached an apparent equilibrium within 2 h and followed a second-order reaction. The maximum adsorbed amounts for natural soils ranged from 32 to 145 microg g(-1). Rate constants were considered relatively low (0.27-1.5 x 10(-4) [microg g(-1)](1-n) s-1); the slow process was attributed to a combined effect of difussion and adsorption. MBT adsorption fits the Freundlich model with r values > or =0.998 at P < or = 0.001 significance levels. Kf and Freundlich exponents (l/n) ranged from 5.3 to 82.1 cm3 g(-1) and from 0.66 to 0.73, respectively. Kf values for soils with a low organic matter content were lower than that obtained from the only typical allophanic soil derived from volcanic ash under study. Lineal regression analysis between Kf and organic matter content of nonallophanic soils gave a correlation coefficient of 0.980 (P = 0.02). Dispersion of Kd values together with close values of K(OM) indicate that organic matter (OM) was the principal component responsible for MBT adsorption in unamended soils. Addition of peat decreased soil pH and increased adsorption capacity for allophanic and nonallophanic soils. Kinetic experiments showed enhancements of Xmax values and lower rate constants.     

Surfactant enhanced recovery of tetrachloroethylene from a porous medium containing low permeability lenses. 1. Experimental studies

A matrix of batch, column and two-dimensional (2-D) box experiments was conducted to investigate the coupled effects of rate-limited solubilization and layering on the entrapment and subsequent recovery of a representative dense NAPL, tetrachloroethylene (PCE), during surfactant flushing. Batch experiments were performed to determine the equilibrium solubilization capacity of the surfactant, polyoxyethylene (20) sorbitan monooleate (Tween 80), and to measure fluid viscosity, density and interfacial tension. Results of one-dimensional column studies indicated that micellar solubilization of residual PCE was rate-limited at Darcy velocities ranging from 0.8 to 8.2 cm/h and during periods of flow interruption. Effluent concentration data were used to develop effective mass transfer coefficient (Ke) expressions that were dependent upon the Darcy velocity and duration of flow interruption. To simulate subsurface heterogeneity, 2-D boxes were packed with layers of F-70 Ottawa sand and Wurtsmith aquifer material within 20-30 mesh Ottawa sand. A 4% Tween 80 solution was then flushed through PCE-contaminated boxes at several flow velocities, with periods of flow interruption. Effluent concentration data and visual observations indicated that both rate-limited solubilization and pooling of PCE above the fine layers reduced PCE recovery to levels below those anticipated from batch and column measurements. These experimental results demonstrate the potential impact of both mass transfer limitations and subsurface layering on the recovery of PCE during surfactant enhanced aquifer remediation.     

Performance evaluation of laser-induced breakdown spectrometry as a multimetal continuous emission monitor

Laser-induced breakdown spectroscopy (LIBS) has been evaluated as a multimetal continuous emissions monitor (CEM) at the U.S. Environmental Protection Agency (EPA) rotary kiln incinerator simulator (RKIS) facility in Raleigh, NC. Two detection systems with a bifurcated optical fiber bundle were used for simultaneously monitoring the concentrations of Be, Cd, Cr, and Hg in the test. Two calibration techniques were evaluated in the laboratory for the field measurements. On-line calibration of relative metal concentration was also performed in the simulated incinerator gas stream. Toxic metal concentrations measured with LIBS have been compared with the EPA reference method (RM) results.     

Seveso Women's Health Study: does zone of residence predict individual TCDD exposure?

The compound, 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD), is produced as an unwanted by-product of various chemical reactions and combustion processes, including the manufacture of chlorinated phenols and derivatives. In animals, TCDD exposure is associated with toxic, carcinogenic, developmental, and reproductive effects. In 1976, a chemical plant explosion in Seveso, Italy, exposed the residents in the surrounding community to the highest exposure to TCDD known in humans. Materials from an aerosol cloud of sodium hydroxide, sodium trichlorophenate and TCDD were deposited over an 18.1 km2 area. As evidence of the significant level of TCDD exposure, numerous animals died and 193 cases of chloracne were reported among residents of the area. Initially, the contaminated area was divided into three major exposure Zones (A, B, R) based on the concentration of TCDD in surface soils. To date, the majority of epidemiologic studies conducted in Seveso have used Zone of residence as a proxy measure of exposure. The purpose of the present study is to validate the use of Zone of residence in Seveso as a proxy measure of exposure against individual serum TCDD measurement, and to determine whether questionnaire information can improve the accuracy of the exposure classification. Using data collected from the Seveso Women's Health Study (SWHS), the first comprehensive epidemiologic study of the reproductive health of women in Seveso, we determined that Zone of residence is a good predictor of individual serum TCDD level, explaining 24% of the variance. Using questionnaire information could have improved prediction of individual exposure levels in Seveso, increasing the percent of the variation in serum TCDD levels explained to 42%.     

Time to death response in carabid beetles exposed to multiple stressors along a gradient of heavy metal pollution

We investigated the responses of invertebrates inhabiting polluted environments to multiple stressors. Carabid beetles (Pterostichus oblongopunctatus F.) were subjected to food deprivation and insecticide treatment (dimethoate) to resolve trends associated with a gradient of heavy metal pollution. Metal concentrations along the gradient of five sites ranged from approximately 150 to 10,500 mg/kg Zn, 136 to 2600 mg/kg Pb, and 0.84 to 81.9 mg/kg Cd. There was no difference in body mass along the pollution gradient. However, the beetles originating from the most contaminated sites were significantly less tolerant to food deprivation than beetles from the reference site. Median survival time was 120 h for the two most polluted sites, compared with 168 h at the reference site. Beetles from the two most polluted sites were also significantly more susceptible to dimethoate at 0.1 microgram active ingredient/beetle. Median survival times were 12 and 123 h for beetles from the two most polluted sites and 359 h for the reference site. Carabid beetles exposed to chronic pollution, therefore, exhibit elevated susceptibility to additional stressors.     

ESF Workshop

Dioxin and PCB monitoring programs for food and feeding stuff in most countries of the world, including many European Countries are currently inadequate. Better control of food production lines and food processing procedures is needed to minimize entry of dioxin to the food chain and will help to avoid dioxin contamination accidents. This would also improve the ability to trace back a possible contamination to its source. European guidelines for monitoring programs should be established to ensure comparable and meaningful results. These guidelines should define the minimum requirements for the design of monitoring programs, analytical methods, and quality assurance. Though data from Northern Europe shows that the general population exposure to dioxin and PCB has decreased during the last ten years these compounds continue to be a risk of accidental contamination of the food chain. The most prominent recent example is the Belgian dioxin contamination of feeding stuff in 1999. The Belgian dioxin contamination was not detected due to dioxin monitoring programs but by their direct biological effects seen in animals. Four other cases of dioxin contamination have been detected in Europe since 1997 due to local monitoring programs. One of them (citrus pulp pellets 1998) was in a much larger scale than the Belgian dioxin contamination. The general population's exposure to dioxins and PCBs is still in the same range (1-4 pg WHO-TEQ/kg body weight and day) as the recently revised WHO tolerable daily intake (TDI). There is concern that short-term high level exposure to dioxins, furans, and PCB may cause biological effects on the human fetal development and further research is required. Further actions to control sources building on considerable advances already made in many countries may need to be supplemented by measures to prevent direct contamination of feeding stuff or food to reduce general population exposure further.     

Adsorption of imidazolinone herbicides on ferrihydrite-humic acid associations.

Adsorption of the imidazolinone herbicides imazapyr, imazethapyr and imazaquin was studied on two binary systems (ferrihydrite-humic acid) prepared by treating ferrihydrite (Fh) immediately after its precipitation with a soil humic acid (HA) at different loadings (4% and 8% HA content), and on a blank ferrihydrite sample prepared in the same way, but without HA addition. Imidazolinone adsorption on pure Fh and on the 4% Fh-HA decreased with increasing of the herbicide hydrophobicity (imazaquin相似文献   

Management, disposal and recycling of waste industrial organic solvents in Hong Kong.

An attempt has been made to establish a mass balance of industrial organic solvents in Hong Kong. It is estimated that only a small portion, less than 4%, of all the organic solvents consumed in Hong Kong are collected as waste solvents and properly treated, while the remainder are used either in the formulation of solvent containing products, or are lost to the environment through vapour emissions, leaks and spills, or dumped illegally. It was found that solvent recycling has been a common practice in some industries but the existing level of solvent recycling in Hong Kong is difficult to estimate. About 87.4% of all the waste organic solvents disposed of at the licensed facilities are potentially recyclable although whether they can be recycled in practice depends on many factors. Examples of existing waste organic solvent management and recycling practices from selected industries in Hong Kong are presented. The economic feasibility of current and future potential recycling systems is evaluated for a few selected cases. An integrated waste organic solvent management strategy is proposed to minimize adverse impacts of organic solvents to the environment and human health.     

Degradation of 14C-carbofuran in soil using a continuous flow system

14C-carbofuran underwent considerable mineralization (approximately 30% of the applied activity) in Vertisol soil under moist and flooded conditions during 60 days incubation. Bound residues were formed under both the conditions, the extent being more in moist soils (approximately 55% of the applied activity) than under flooded conditions (approximately 41% of the applied activity). 3-Keto carbofuran was the only significant metabolite observed under flooded conditions.     

The organic precursors affecting the formation of disinfection by-products with chlorine dioxide

The object of this research was to study the formation of disinfection by-products by using chlorine dioxide (ClO2) as a disinfectant reacting with different properties of organic substance in natural aquatic environment. The adsorbent resin (XAD-4, XAD-7) was used to divide the organic matters in raw water into three groups. The influence of the function groups on structure, reaction tendency, and formation of disinfection by-products generated by the reaction of these organic substances with chlorine dioxide was explored. The experimental results show that the three different organic groups formed using adsorbent resin were hydrophobic substance, hydrophilic acid, and non-acid hydrophilics in proportions of 43%, 41%, and 16%, respectively. Within the raw water in our study, the hydrophilic substance had a higher distribution proportion than that described in general articles and journals, which indicates that this water was contaminated with pollution from human beings. The exploration of the reactivity of the three different organic substances with chlorine dioxide shows that the unit consumption of disinfection agent per unit organic matters (represented by ClO2/DOC) is in the following sequence hydrophobic substance > hydrophilic substance > non-acid hydrophilics. It indicated that larger molecular organic precursors had larger consumption of disinfectant. We also discovered that after the reaction of the three different organic substances with chlorine dioxide, the largest amount of disinfection by-products were generated by the non-acid hydrophilics.