Bagasse-assisted bioremediation of ammonia from shrimp farm wastewater.

Development of new economically feasible ecofriendly products from agricultural wastes or byproducts for shrimp farm wastewater treatment is the objective of our continued research. Ammonia is a nitrogenous toxicant, which is commonly found in wastewater from shrimp farms. In the present study, we explored the possibility of the use of simply and inexpensively prepared bagasse products so that this abundant crop byproduct could be used to remove ammonia from shrimp farm wastewater. Bagasse, a natural highly fibrous lignocellulosic byproduct of sugarcane, was converted into five different products. Experimental results have shown that ammonia is efficiently removed from wastewater by four bagasse products with a dose of 1 to 6 g/L within 24 hours. The effect of bagasse products on other water quality parameters and growth kinetics of biofilm bacteria onto bagasse fiber have also been studied. Efficacies of products were compared by using statistical analysis. Products developed from bagasse are useful and economical.     

Quality assured measurements of animal building emissions: gas concentrations

Comprehensive field studies were initiated in 2002 to measure emissions of ammonia (NH3), hydrogen sulfide (H2S), carbon dioxide (CO2), methane (CH4), nonmethane hydrocarbons (NMHC), particulate matter <10 microm in diameter, and total suspended particulate from swine and poultry production buildings in the United States. This paper focuses on the quasicontinuous gas concentration measurement at multiple locations among paired barns in seven states. Documented principles, used in air pollution monitoring at industrial sources, were applied in developing quality assurance (QA) project plans for these studies. Air was sampled from multiple locations with each gas analyzed with one high quality commercial gas analyzer that was located in an environmentally controlled on-farm instrument shelter. A nominal 4 L/min gas sampling system was designed and constructed with Teflon wetted surfaces, bypass pumping, and sample line flow and pressure sensors. Three-way solenoids were used to automatically switch between multiple gas sampling lines with > or =10 min sampling intervals. Inside and outside gas sampling probes were between 10 and 115 m away from the analyzers. Analyzers used chemiluminescence, fluorescence, photoacoustic infrared, and photoionization detectors for NH3, H2S, CO2, CH4, and NMHC, respectively. Data were collected using personal computer-based data acquisition hardware and software. This paper discusses the methodology of gas concentration measurements and the unique challenges that livestock barns pose for achieving desired accuracy and precision, data representativeness, comparability and completeness, and instrument calibration and maintenance.     

Long-term comparison of trace organics removal performances between conventional and membrane activated sludge processes.

The removal of trace organic compounds through membrane bioreactors (MBR) compared with a conventional wastewater treatment plant (WWTP) in a long-term study was investigated. Two MBR pilot plants were operated in parallel to a full-scale WWTP fed with the same municipal raw wastewater. Polar compounds (phenazone-type pharmaceuticals, their metabolites, and carbamazepine) and less polar estrogenic steroids (estradiol, estrone, and ethinylestradiol) were quantified. The removal rate of phenazone, propyphenazone, and formylaminoantipyrine by the conventional WWTP was less than 15%. Significantly higher removal rates (60 to 70%) started to be clearly monitored in the pilot plants after approximately 5 months. Higher removal rates coincided with higher temperatures in the summer. The conventional WWTP removed, on average, more than 90% of the natural steroids estrone and estradiol and approximately 80% of the synthetic ethinylestradiol. Approximately 99% of estradiol and estrone and approximately 95% of ethinylestradiol was eliminated by the MBR processes.     

Fine route for an efficient removal of 2,4-dichlorophenoxyacetic acid (2,4-D) by zeolite-supported TiO2

Zeolites HY, Hbeta and HZSM-5 with different physico-chemical properties were chosen as support for TiO2 to illustrate their adsorption, dispersion and electronic structure in photocatalysis. The extent of TiO2 loading was monitored by XRD and BET surface area measurements. The adsorption capacity of HY zeolite was found to be high and hence chosen for further modification to continue the investigation. Photodegradation kinetics were carried out with 2,4-dichlorophenoxyacetic acid (2,4-D) in aqueous solution. The extent of 2,4-D degradation on TiO2/HY loading revealed the importance of adsorption in photocatalysis. Mineralisation studies on all three zeolites with 1 wt.% TiO2 loading demonstrated the good dispersion properties of TiO2/HY. Its photocatalytic activity was found to be excellent with formulated 2,4-D. Comparison of relative photonic efficiencies demonstrated that supported photocatalysts exhibited higher activity than some of the commercial photocatalysts. The high activity of supported TiO2 is due to synergistic effects of improved adsorption of 2,4-D and efficient delocalisation of photogenerated electrons by zeolite support.     

Histological examination of sublethal effects of diazinon on ovary of bluegill,Lepomis macrochirus

The effects of the insecticide, diazinon (an organophosphorous compound), on the ovaries of bluegill (Lepomis macrohirus) were studied. Histological preparations of bluegill ovarian tissue was examined at 24, 48, 72 and 96 h and 1, 2 and 3 weeks following exposure to sublethal doses of diazinon (60 microg/l). The control contained primary follicles with an intact ovigerous lamellae and tunica albuginea. The control also revealed well developed stage IV oocytes with properly distributed provitelline nucleoli. After 24 h of exposure to diazinon, primary follicles began to show adhesion and cytoplasmic retraction in oocyte II occured. Cytoplasmic degeneration and additional adhesion and more retraction were visible at 48 h in oocyte II; 72 h brought forth adhesion, retraction and cytoplamic expulsion from oocyte IV. The number of atretic oocytes increased. Damages to the oocyte IV started to occur after 72 h of exposure. Cytoplasmic retraction and clumping was more visible at 96 h in oocyte IV. Partial destruction of the ovigerous lamellae and vitellogenic membrane occurred after 1 week. Two weeks continued to reveal destruction of follicles. Severe damage of the ovigerous lamellae, increased intrafollicular spaces, vacuolated cytoplasm, extrusion of karyoplasm and necrosis in the cytoplasm were most evident following 3 weeks of exposure. The ovarian wall became frayed and broken. Additionally, a marked increase of atretic follicles, shrinkage, and embedded nucleoli into the surrounding cytoplasm in oocyte II, III and IV were observed at week 3. This study revealed that oocytes at their different stages of maturation get affected differently at various exposure. Based on observations of the ovarian tissue compositional and structural changes following given exposure times, it becomes evident that consistent sublethal doses of diazinon can and will alter microscopic anatomy of the fish ovary.     

Changes of copper speciation in maize rhizosphere soil

Chemical forms of copper in the rhizosphere and bulk soil of maize were investigated using rhizobox cultivation and sequential extraction techniques. The copper accumulations were also determined. The results demonstrated that there were continuous changes in copper fractionation within the maize rhizosphere. Initially, the amount of exchangeable copper increased before dropping below the initial level after 40 days or so. Carbonate associated copper followed a similar trend of change, but with a slower pace than the exchangeable copper. The increase in carbonate associated copper only become evident after 30 days, with the net loss occurring after 60 days. There were also initial increases in oxide bound copper as well as decreases in the organic matter associated copper, both followed by a turnover after 40-50 days. The accumulation of copper in the maize plant was found to be biomass dependent. The amount of accumulated copper absorbed in the plant material exceeded the initial quantity of the exchangeable copper in the soil, revealing a transformation from less bioavailable to more bioavailable fractions. During cultivation, decreases in redox potential and increases in pH, dissolved organic carbon (DOC), and microbial activity in the maize rhizosphere were observed. The change in copper speciation may result from root-induced changes in DOC, redox potential, and microbial activity in the rhizosphere.     

Uranium transport around the reactor zone at Bangombé and Okélobondo (Oklo): examples of hydrogeological and geochemical model integration and data evaluation

The sites at Bangombé and Okélobondo (Oklo) in Gabon provide a unique opportunity to study the behaviour of products from natural nuclear reactions in the vicinity of reactor zones which were active around two billion years ago. The Commission of the European Communities initiated the Oklo Natural Analogue Programme. One of the principal aims was to study indications of present time migration of elements from the reactor zones under ambient conditions. The hydrogeological and hydrochemical data from the Oklo sites were modelled in order to better understand the geochemical behaviour of radionuclides in the natural system, by using independent models and by comparing the modelling outcome. Two modelling approaches were used: M3 code (hydrochemical mixing and mass balance model), developed by the Swedish Nuclear Fuel and Waste Management Company (SKB) and HYTEC (reactive transport model) developed by Ecole des Mines de Paris. Two different reactor zones were studied: Bangombé, a shallow site, the reactor being at 11 m depth, and OK84 at Okélobondo, situated at about 450 m depth, more comparable with a real repository location. This allowed the validation of modelling tools in two different sedimentary environments: one shallow, with a more homogeneous layering situated in an area of meteoric alteration, and the other offering the opportunity to study radionuclide migration from the reaction zone over a distance of 450 m through very heterogeneous sedimentary layers. The modeling results indicate that the chemical reactions retarding radionuclide transport are very different at the two sites. At Bangombé, the decomposition of organic material consumes oxygen and at Okélobondo the oxygen is consumed by inorganic reactions resulting, in both cases, in uranium retardation. Both modelling approaches (statistic with M3 code and deterministic with HYTEC code) could describe this situation. The goal of this exercise is to test codes which can help to describe and understand the processes taking place at the sites, validate the models with in situ data, and thus build confidence in the tools used for future site characterization. Ultimately, this allows identifying and selecting processes and parameters that can be used as input into repository performance assessment calculations and modelling exercises.     

Metal ion removal from water by sorption on paper mill sludge

Chromatographic columns packed with paper mill sludge are employed for metal ion recovery from water. The breakthrough curves show that cadmium, copper, lead and silver are removed from acid solutions (pH 2, 4); the affinity series is Pb(II)>Cu(II)>Ag(I)>Cd(II). Both the amount of metal retained and the metal-matrix interaction are pH dependent; the sorptive capacity increases with increasing pH. When the metals are present together at the same initial concentrations a competition among the different ions occurs although the affinity order remains unchanged. In metal recovery from the paper mill sludge column, the total amount of the cadmium and copper is displaced by HCl 1.0 M, 65% of the lead by HCl 0.1 M and 75% of the silver by HNO(3) 0.1 M. More than 95% of copper and lead and less than 20% of cadmium were recovered with HCl 0.1 M when the metals were present at the same time.     

Can aquatic distribution of human pharmaceuticals be related to pharmacological data?

The recognition of pharmaceuticals as significant environmental contaminants has only been a recent phenomenon. Therefore there is a paucity of data relating to the fate and effects of pharmaceuticals once they enter an aquatic receiving system. The amount of work that needs to be done in terms of risk assessment for pharmaceuticals required by regulatory agencies is substantial. This paper has determined the environmental partitioning coefficient (K_d) of 13 diverse human pharmaceuticals in three model systems of differing combinations of solid phases and solutions. The K_d values were then compared with distribution values of the pharmaceuticals in the human body determined from pharmacological studies. This was done to assess the functional relationship between K_d and distribution values in the human body (V_D). K_d values ranged from 3 to 2450 L kg⁻¹. Regression coefficients ranged from r² = 0.62–0.72, indicating that V_D values are a useful indicator for the K_d values of the tested pharmaceuticals within the batch sorption systems. The relationship between K_d and V_D should therefore be further explored to determine whether this relationship can be applied to a broader range of pharmaceuticals in more diverse environmental systems. Exploiting available human pharmacological data in such a way would be of great benefit in prioritising human pharmaceuticals as environmental contaminants in the risk assessment process.     

Development of a microscale emission factor model for particulate matter for predicting real-time motor vehicle emissions

The U.S. Environmental Protection Agency's National Exposure Research Laboratory is pursuing a project to improve the methodology for modeling human exposure to motor vehicle emissions. The overall project goal is to develop improved methods for modeling the source through the air pathway to human exposure in significant exposure microenvironments. Current particulate matter (PM) emission models, particle emission factor model (used in the United States, except California) and motor vehicle emission factor model (used in California only), are suitable only for county-scale modeling and emission inventories. There is a need to develop a site-specific real-time emission factor model for PM emissions to support human exposure studies near roadways. A microscale emission factor model for predicting site-specific real-time motor vehicle PM (MicroFacPM) emissions for total suspended PM, PM less than 10 microm aerodynamic diameter, and PM less than 2.5 microm aerodynamic diameter has been developed. The algorithm used to calculate emission factors in MicroFacPM is disaggregated, and emission factors are calculated from a real-time fleet, rather than from a fleet-wide average estimated by a vehicle-miles-traveled weighting of the emission factors for different vehicle classes. MicroFacPM requires input information necessary to characterize the site-specific real-time fleet being modeled. Other variables required include average vehicle speed, time and day of the year, ambient temperature, and relative humidity.