Assessment of sulfurous springs in the west of Iraq for balneotherapy,drinking, irrigation and aquaculture purposes

This research deals with the sulfurous spring waters flow along the course of the Euphrates River in western Iraq in the area extended between Haqlaniya and Hit within the Al-Anbar governorate. Eleven springs (3 in Haqlanya, 4 in Kubaysa and 4 in Hit) have been addressed for the purpose of water evaluation for balneology, drinking, irrigation and aquaculture (fish farming). In order to meet the objectives of this research, all springs were sampled and analyzed for the total dissolved solid, electrical conductivity, pH, temperature, major cations (Ca²⁺, Mg²⁺, Na⁺ and K⁺), major anions (SO₄ ^2?, Cl^?, HCO₃ ^? and CO₃ ^2?), minor anions (PO₄ ^3?and NO₃ ^?) as well as the trace elements that included Pb, Zn, Cd, Ni, Fe, Mn, Cu, Br, F, Ba, B, Sr, Al, As, Cr, Hg and Se. The International Standards of World Health Organization are used for assessing the water quality. The results revealed that the springs belong to the tepid springs of 27–30 °C and classified as hypothermal to the thermal springs. Lithochemistry and geochemical processes clearly affected the water chemistry. The hydrogeochemical processes are responsible for the element enrichment in water by the chemical dissolution of carbonate and gypsum and evaporation as well. The results of the study indicate the possibility of using spring water for therapeutic purposes, but not allowed for drinking and aquaculture (fish farming), except those free of H₂S gas. On the other hand, it can be used for irrigation with risk. However, soil type as well as proper selection of plants should be taken into consideration.     

Study on the dissipation pattern and risk assessment of metalaxyl-M in rice grains and paddy soil and water by liquid chromatography-tandem mass spectrometry

Environmental Science and Pollution Research - Herein, field experiment trials were conducted at two different sites (Heilongjiang and Hubei Province) in China to determine the residual levels and...     

Wind speed pattern data and wind energy potential in Pakistan: current status,challenging platforms and innovative prospects

Environmental Science and Pollution Research - Energy is an essential parameter for the economic growth and sustainable development of any country. Due to the rapid increase in energy demand,...     

Phosphate-arsenate relations to affect arsenic concentration in plant tissues,growth, and antioxidant efficiency of sunflower (Helianthus annuus L.) under arsenic stress

Environmental Science and Pollution Research - Relations between phosphate and arsenate are important but inconsistent to influence arsenic (As) phytotoxicity depending on many plant and soil...     

Government management and overexploitation of groundwater resources: absence of local community initiatives in Ardabil plain-Iran

Although mismanagement of groundwater resources has resulted in their destruction over centuries, climate change is speeding up this process more than ever. On the one hand, urgent action by government bodies is needed to address the challenge. On the other hand, a vast body of literature proves that bottom-up collective action, although requiring a longer time period, is a better solution to manage such resources. This research aims to address this dilemma. The groundwater resource in Ardabil plain in Iran, which has long been managed solely through government intervention, has been chosen as a case study to explore the opportunities and limitations of managing a critically endangered area from a common pool resource perspective. Our study suggests that managing Ardabil groundwater resources should be conducted on two scales. The bottom-up institutional agreements should take place at village scale while the government should stay in charge of the overall organization at plain scale.     

Evaluation of the potential of Sasobit® to reduce required heat energy and CO2 emission in the asphalt industry

Warm-mix asphalt (WMA) has been gaining popularity in the asphalt industry primarily because of its ability to lower the energy required to blend asphalt mixes, which in turn results in less fuel consumption, slower aging of the asphalt binder and reduced emission of greenhouse gases. This paper evaluates the effects of different quantities of a WMA additive known as Sasobit^® on the required heat energy and the amount of CO₂ produced to increase the temperature of two aggregates from three sources and one binder from 25 °C to the point of mixing. The results showed that incorporating 1% Sasobit^® can potentially reduce the required heat energy and amount of CO₂ produced by 2.8% and 3.0%, respectively, for all aggregate types and sources investigated. The paper also presented design charts that enable energy policy makers and engineers to select the appropriate Sasobit^® content to produce the most cost effective asphalt mixture with less environmental impact. The design charts show that 1.6% Sasobit^® content is the most suitable proportion to be blended into the asphalt binder without compromising pavement resistance against fatigue failure. Two similar aggregates from different sources may exhibit similar specific gravities, but their specific heat capacities can vary widely. These differences have a significant effect on the required heat energy, asphalt production cost and the amount of emissions released into the environment.     

Optimization of alkaline extraction of natural dye from Henna leaves and its dyeing on cotton by exhaust method

The alkaline conditions for extraction of natural dye from Henna leaves were optimized and the resulting extract was used to further optimize its dyeing conditions on cotton by exhaust method. Dyeings without any mordant were compared with those obtained with premordanting and postmordanting with alum and iron. It was found that dyeings produced with alkaline extracts of Henna leaves have better colour strength than the dye extracts obtained in distilled water. Furthermore, dyeings with alkaline extracts have moderate to good fastness properties and that mordanting did not result in any significant improvement in fastness properties. Finally, in comparative studies between synthetic and this natural dye, it was inferred that natural dye has good potential to act as co-partner with synthetic dye.     

Investigation of thermal treatment on selective separation of post consumer plastics prior to froth flotation

Plastics have become the widely used materials because of their advantages, such as cheapness, endurance, lightness, and hygiene. However, they cause waste and soil pollution and they do not easily decompose. Many promising technologies are being investigated for separating mixed thermoplastics, but they are still uneconomical and unreliable. Depending on their surface characteristics, these plastics can be separated from each other by flotation method which is useful mineral processing technique with its low cost and simplicity.The main objective of this study is to investigate the flotation characteristics of PET and PVC and determine the effect of plasticizer reagents on efficient plastic separation. For that purpose, various parameters such as pH, plasticizer concentration, plasticizer type, conditioning temperature and thermal conditioning were investigated. As a result, PET particles were floated with 95.1% purity and 65.3% efficiency while PVC particles were obtained with 98.1% purity and 65.3% efficiency.     

Reliable method for prediction of the flash point of various classes of amines on the basis of some molecular moieties for safety measures in industrial processes

This work presents a novel, reliable and simple method of estimating the flash point of various types of flammable amines, which are important for safety measures in industrial processes. Different amines include aliphatic amines such as primary, secondary, tertiary and cyclic amines as well as aromatic amines and hetero arenes containing nitrogen heteroatom. The proposed correlation is based on the contribution of some specific molecular moieties and functional groups, which can easily be used for any types of amines. Intermolecular forces are important in the new method, which are counted by two increasing and decreasing parameters. The root mean square (rms) deviation is 18 K for different classes of amines including 133 diverse compounds. The estimated flash points have been compared with one of the best available predictive methods, which gives much lower value of the rms deviation.     

Impacts of urban growth on forest cover in Istanbul (1987–2007)

This article reports findings of a study that examined the impacts of urban growth on forest cover in Istanbul between 1987 and 2007. Four Landsat images from 1987, 1990, 2000, and 2007 were classified with maximum likelihood supervised classification method by using ERDAS IMAGINE 9.1. Forest and urban areas were given highest importance in the classification, while other land-use characteristics, like agriculture and bare soil, were grouped into a third class as others. The study revealed that rapid increase in population and accompanying unplanned urban growth in Istanbul resulted in significant changes in land use after 1987. Urban areas have expanded 87.9% from 1987 to 2007, while forest areas declined 5.4% in the same period. One of the most significant results of the study was that total forest areas in Istanbul have increased 0.3% between 2000 and 2007. This suggests that progress has been made in Istanbul not only in having sustainable urban growth, but also in preserving, restoring, and even expanding forest areas, especially after the year 2000.