Thermo- and fluid-dynamical modelling of two-phase multi-component carbon dioxide mixtures

A method for calculating the transport and depressurization of a two-phase multi-component CO₂ mixture is presented. The thermodynamical and transport properties for a CO₂–CH₄ mixture are calculated using the Soave–Redlich–Kwong equation of state (SRK). The fluid flow is described by a drift-flux model, which is solved using the multi-stage (MUSTA) centred scheme. Numerical results are shown, illustrating the effect of mixture composition and the feasibility of the approach.     

Brominated phenols,anisoles, and dioxins present in blue mussels from the Swedish coastline

Introduction  

Naturally occurring hydroxylated polybrominated diphenyl ethers (OH-PBDEs), their methoxylated counterparts (MeO-PBDEs), and polybrominated dibenzo-p-dioxins (PBDDs), together with their potential precursors polybrominated phenols (PBPs) and polybrominated anisoles (PBAs), were analyzed in blue mussels (Mytilus edulis) gathered along the east coast (bordering the Baltic Sea) and west coast of Sweden (bordering the North Sea). Brown algae (Dictyosiphon foenicolaceus) and cyanobacteria (Nodularia spumigena) from the Baltic Sea, considered to be among the primary producers of these compounds, were also analyzed for comparison.     

Waste products from the steel industry with NiO as additive as oxygen carrier for chemical-looping combustion

Fe₂O₃-containing waste materials from the steel industry are proposed as oxygen carrier for chemical-looping combustion. Three such materials, red iron oxide, brown iron oxide and iron oxide scales, have been examined by oxidation and reduction experiments in a batch fluidized-bed reactor at temperatures between 800 and 950 °C. NiO-based particles have been used as additive, in order to examine if it is possible to utilize the catalytic properties of metallic Ni to facilitate decomposition of hydrocarbons into more reactive combustion intermediates such as CO and H₂. The experiments indicated modest reactivity between the waste materials and CH₄, which was used as reducing gas. Adding small amounts of NiO-based particles to the sample increased the yield of CO₂ in a standard experiment, typically by a factor of 1.5–3.5. The fraction of unconverted fuel typically was reduced by 70–90%. The conversion of CH₄ to CO₂ was 94% at best, corresponding to a combustion efficiency of 96%. This was achieved using a bed mass corresponding to 57 kg oxygen carrier per MW fuel, of which only 5 wt% was NiO-based synthetic particles. The different materials fared differently well during the experiments. Red iron oxide was fairly stable, while brown iron oxide was soft and subject to considerable erosion. Iron oxide scales experienced increased reactivity and porosity as function of the numbers of reduction cycles.     

Toxicity of leachate from bottom ash in a road construction

A test road constructed with municipal solid waste incineration (MSWI) bottom ash was monitored over a period of 36 months. Using chemical and toxicological characterisation, the environmental impact of leachates from bottom ash was evaluated and compared with leachates from gravel used as reference. Initial leaching of Cl, Cu, K, Na, NH4-N and TOC from bottom ash was of major concern. However, the quality of the bottom ash leachate approached that of the gravel leachate with time. Leachates from the two materials were compared regarding the concentration of pollutants using multivariate data analyses (MVDA). A standardized luminescent bacteria assay using Vibrio fischeri did not show any toxicity, most likely because saline contamination can mask the toxic response and stimulate luminescence in these marine bacteria. A mung bean assay using Phaseolus aureus revealed that the toxicity of bottom ash leachate collected at the very beginning of the experimental period (October 2001 and May 2002) might be attributed to the following components and their respective concentrations in mg l(-1): Al (34.2-39.2), Cl (2914-16,446), Cu (0.48-1.92), K (197-847), Na (766-4180), NH4-N (1.80-8.47), total-N (12.0-18.5), and TOC (34.0-99.0). The P. aureus assay was judged as a promising environmental tool in assessing the toxicity of bottom ash leachate.     

Evaluation of the critical factors controlling stability of chromium, copper, arsenic and zinc in iron-treated soil

Various environmental factors are expected to affect the mobility of elements in chemically stabilized soils. The aim of this study was to evaluate the effects of pH, oxidizing-reducing potential (Eh), liquid-to-solid ratio (L/S), presence of organic matter (OM) and microbial activity (MA) on the mobility of chromium, copper, arsenic and zinc in zerovalent iron (Fe(0))-stabilized soil. A 2(5) full factorial design was applied to assess the leaching of the elements from the treated soil. The factor having the most impact on the mobility of Cr, Cu and Zn was pH; low pH (3) led to the release of these elements. Arsenic remobilization was controlled by L/S and MA, whilst Eh, though also significant, had less influence. In the identified worst-case scenarios, more than half of the total Zn and Cu and 14% of As can be expected to remobilize from the treated soil. The leaching procedure concerning sample agitation and type of filtration showed to substantially affect the results of As leaching, especially in OM rich soil.     

Element contents and food safety of water spinach (Ipomoea aquatica Forssk.) cultivated with wastewater in Hanoi, Vietnam

Extensive aquatic or semi-aquatic production of water spinach (Ipomoea aquatica Forssk.) for human consumption takes place in Southeast Asia. The aim of this study was to assess the concentrations of 38 elements in soil and water spinach cultivated under different degrees of wastewater exposure in Hanoi, Vietnam. The results showed no effect of wastewater use on the overall element concentrations in soil and water spinach. Mean soil concentrations for selected potentially toxic elements at the studied field sites had the following ranges 9.11–18.7 As, 0.333–0.667 Cd, 10.8–14.5 Co, 68–122 Cr, 34.0–62.1 Cu, 29.9–52.8 Ni, 32.5–67.4 Pb, 0.578–0.765 Tl and 99–189 Zn mg kg⁻¹ dry weight (d.w.). In all samples Cd, Pb and Zn soil concentrations were below the Vietnamese Guideline Values (TCVN 7209-2002) for agricultural soils whereas As and Cu exceeded the guideline values. Maximum site element concentrations in water spinach were 0.139 As, 0.032 Cd, 0.135 Cr, 2.01 Cu, 39.1 Fe, 57.3 Mn, 0.16 Ni, 0.189 Pb and 6.01 Zn mg kg⁻¹ fresh weight (f.w.). The site and soil content of organic carbon were found to have high influence on the water spinach element concentrations whereas soil pH and the total soil element concentrations were of less importance. The estimated average daily intake of As, Cd, Cu, Fe, Pb and Zn for adult Vietnamese consumers amounts to <11% of the maximum tolerable intake proposed by FAO/WHO for each element. It is assessed that the occurrence of the investigated elements in water spinach will pose low health risk for the consumers.     

Continuous ‘Passive’ flow-proportional monitoring of drainage using a new modified Sutro weir (MSW) unit

In view of their crucial role in water and solute transport, enhanced monitoring of agricultural subsurface drain tile systems is important for adequate water quality management. However, existing monitoring techniques for flow and contaminant loads from tile drains are expensive and labour intensive. The aim of this study was to develop a cost-effective and simple method for monitoring loads from tile drains. The Flowcap is a modified Sutro weir (MSW) unit that can be attached to the outlet of tile drains. It is capable of registering total flow, contaminant loads and flow-averaged concentrations. The MSW builds on a modern passive sampling technique that responds to hydraulic pressure and measures average concentrations over time (days to months) for various substances. Mounting the samplers in the MSW allowed a flow-proportional part of the drainage to be sampled. Laboratory testing yielded high linear correlation between the accumulated sampler flow, q _total, and accumulated drainage flow, Q _total (r ²?>?0.96). The slope of these correlations was used to calculate the total drainage discharge from the sampled volume, and therefore contaminant load. A calibration of the MSW under controlled laboratory condition was needed before interpretation of the monitoring results was possible. The MSW does not require a shed, electricity, or maintenance. This enables large-scale monitoring of contaminant loads via tile drains, which can improve contaminant transport models and yield valuable information for the selection and evaluation of mitigation options to improve water quality. Results from this type of monitoring can provide data for the evaluation and optimisation of best management practices in agriculture in order to produce the highest yield without water quality and recipient surface waters being compromised.     

Prediction of odor from pig production based on chemical odorants

The present work was performed to investigate the use of odorant measurements for prediction of odor concentration in facilities with growing-finishing pigs and to analyze the odorant composition in facilities with different floor and ventilation systems. Air was sampled in Nalophan bags, odor concentrations were measured by dilution-to-threshold olfactometry, and concentrations of odorants were measured by proton-transfer-reaction mass spectrometry (PTR-MS). Olfactometry and chemical analyses were synchronized to take place at identical time intervals after sampling. A principal component analysis revealed that different facilities for growing-finishing pigs can be distinguished based on the odorants. Pit ventilation comprising a small amount of the total ventilation air (10-20%) in facilities with both room and pit ventilation can be used to concentrate odorants, whereas the room ventilation contains lower concentrations of most odorants. A partial least squares regression model demonstrated that prediction of the odor concentration based on odorants measured by PTR-MS is feasible. Hydrogen sulfide, methanethiol, trimethylamine, and 4-methylphenol were identified as the compounds having the largest influence on the prediction of odor concentration, whereas carboxylic acids had no significant influence. In conclusion, chemical measurement of odorants by PTR-MS is an alternative for expressing the odor concentration in facilities with growing-finishing pigs that can be used to increase the understanding of odor from different types of facilities and improve the development of odor reduction technologies.     

Brief overview of dye-sensitized solar cells

Dye-sensitized solar cells (DSC) are based on molecular and nanometer-scale components. Record cell efficiencies of 12%, promising stability data and means of energy-efficient production methods have been accomplished. As selling points for the DSC technology the prospect of low-cost investments and fabrication are key features. DSCs offer the possibilities to design solar cells with a large flexibility in shape, color, and transparency. The basic principles of the operation of DSC, the state-of-the-art as well as the potentials for future development are described.     

Impact of Climate Change on Ecological Quality Indicators and Biogeochemical Fluxes in the Baltic Sea: A Multi-Model Ensemble Study

Multi-model ensemble simulations using three coupled physical-biogeochemical models were performed to calculate the combined impact of projected future climate change and plausible nutrient load changes on biogeochemical cycles in the Baltic Sea. Climate projections for 1961-2099 were combined with four nutrient load scenarios ranging from a pessimistic business-as-usual to a more optimistic case following the Helsinki Commission's (HELCOM) Baltic Sea Action Plan (BSAP). The model results suggest that in a future climate, water quality, characterized by ecological quality indicators like winter nutrient, summer bottom oxygen, and annual mean phytoplankton concentrations as well as annual mean Secchi depth (water transparency), will be deteriorated compared to present conditions. In case of nutrient load reductions required by the BSAP, water quality is only slightly improved. Based on the analysis of biogeochemical fluxes, we find that in warmer and more anoxic waters, internal feedbacks could be reinforced. Increased phosphorus fluxes out of the sediments, reduced denitrification efficiency and increased nitrogen fixation may partly counteract nutrient load abatement strategies.