Cesium migration in saturated silica sand and Hanford sediments as impacted by ionic strength

Large amounts of 137Cs have been accidentally released to the subsurface from the Hanford nuclear site in the state of Washington, USA. The cesium-containing liquids varied in ionic strengths, and often had high electrolyte contents, mainly in the form of NaNO3 and NaOH, reaching concentrations up to several moles per liter. In this study, we investigated the effect of ionic strengths on Cs migration through two types of porous media: silica sand and Hanford sediments. Cesium sorption and transport was studied in 1, 10, 100, and 1000 mM NaCl electrolyte solutions at pH 10. Sorption isotherms were constructed from batch equilibrium experiments and the batch-derived sorption parameters were compared with column breakthrough curves. Column transport experiments were analyzed with a two-site equilibrium-nonequilibrium model. Cesium sorption to the silica sand in batch experiments showed a linear sorption isotherm for all ionic strengths, which matched well with the results from the column experiments at 100 and 1000 mM ionic strength; however, the column experiments at 1 and 10 mM ionic strength indicated a nonlinear sorption behavior of Cs to the silica sand. Transport through silica sand occurred under one-site sorption and equilibrium conditions. Cesium sorption to Hanford sediments in both batch and column experiments was best described with a nonlinear Freundlich isotherm. The column experiments indicated that Cs transport in Hanford sediments occurred under two-site equilibrium and nonequilibrium sorption. The effect of ionic strength on Cs transport was much more pronounced in Hanford sediments than in silica sands. Effective retardation factors of Cs during transport through Hanford sediments were reduced by a factor of 10 when the ionic strength increased from 100 to 1000 mM; for silica sand, the effective retardation was reduced by a factor of 10 when ionic strength increased from 1 to 1000 mM. A two order of magnitude change in ionic strength was needed in the silica sand to observe the same change in Cs retardation as in Hanford sediments.     

Characterization of the organic matter of sludge: determination of lipids, hydrocarbons and PAHs from road retention/infiltration ponds in France

This paper presents the results of the organic matter characterization of sludge from two ponds (retention and infiltration) located in France. Special focus was placed on studying hydrocarbons and PAHs. This investigation is part of a global project on road and urban sludge with the aim of identifying a better means for managing these materials. Gas chromatographic and GC/MS analyses indicate that the main component of the organic fraction stems from petroleum-derived products like diesel fuel and motor oil. This finding was confirmed by the presence of biomarkers from the hopane series, as well as by pyrolytic and alkylated PAHs. Results from this study clearly show that the contaminants are mainly generated from anthropogenic petroleum sources. Due to their levels of hydrocarbon contamination, these sludge deposits must be considered as waste and cannot therefore be disposed anywhere, especially within the current context of sustainable development.     

Geochemical evidences of the anthropogenic alteration of trace metal composition of the sediments of Chiricahueto marsh (SE Gulf of California)

Seven sediment cores (60-80 cm) were collected at Chiricahueto marsh, a salt marsh influenced by agrochemical, domestic and industrial effluents. The concentrations of Ag, Al, Cd, Co, Cu, Fe, Li, Mn, Pb, V and Zn were studied in the solid phase at each 1-cm section. The profiles of Ag, Cd, Cu, Mn, Ni, Pb and Zn showed a slight recent pollution in the site with enrichment and anthropogenic factors higher than unity; and correlation analysis indicated a direct association with organic carbon. Al, Co, Cr, Fe, Li, and V concentration profiles displayed a negative correlation with organic C and positive with mud content and no consistent enrichment at surface. Based on the principal component analysis and correlation analysis, two principal groups of metals were identified. The first group includes Al, Co, Cr, Fe and Li, that are derived predominantly from the weathering of parent materials in the local bedrock; and the second group include most of the metals, which were relatively enriched at surficial sediments, that are produced mainly by anthropogenic activities such as agriculture (Cd, Cu and Zn), sewage effluents (Ag, Cd, Cu, Ni, Pb and Zn) and in lesser extent atmospheric deposition (Cd and Pb).     

The photocatalytic disinfection of urban waste waters

In this paper we present the results of the photocatalytic disinfection of urban waste water. Two microbial groups, total coliforms and Streptococcus faecalis, have been used as indexes to test disinfection efficiencies. Different experimental parameters have been checked, such as the effect of TiO2, solar or UV-lamp light and pH. Disinfection of water samples has been achieved employing both UV-lamp and solar light in agreement with data shown by other authors. The higher disinfection rates obtained employing an UV-lamp may be explained by the stronger incident light intensity. Nevertheless no consistent differences have been found between TiO2-photocatalysis and direct solar or UV-lamp light irradiation at natural sample pH (7.8). At pH 5 the presence of TiO2 increases the relative inactivation rate compared with the absence of the catalyst. After the photocatalytic bacterial inactivation, the later bacterial reappearance was checked for total coliforms at natural pH and pH 5, with and without TiO2. Two h after the photocatalytic treatment, CFU increment was almost nill. But 24 and 48 h later an important bacterial CFU increment was observed. This CFU increment is slower after irradiation with TiO2 at pH 5 in non-air-purged samples.     

Examination of environmental quality of raw and composting de-inking paper sludge

Paper sludges were traditionally landfilled or burned. Over the years, the use of paper sludges on soils has increased, as well as the concerns about their environmental effects. Therefore, the chemical characterization of paper sludges and their young (immature) compost needed to be investigated, and over 150 inorganic and organic chemicals were analyzed in de-inking paper sludge (DPS). In general, nitrogen, phosphorus and potassium contents were low but variable in raw DPS and its young compost. The contents of arsenic, boron, cadmium, cobalt, chromium, manganese, mercury, molybdenum, nickel, lead, selenium, and zinc were also low and showed low variability. However, the copper contents were above the Canadian compost regulation for unrestricted use and required a follow-up. The fatty- and resin acids, and polycyclic aromatic hydrocarbons were the organic chemicals measured at the highest concentrations. For resinic acids, care should be taken to avoid that leachates reach aquatic life. For polycyclic aromatic hydrocarbons, naphthalene should be followed until soil content reaches 0.1 microg g(-1), the maximum allowed for soil use for agricultural purposes according to Canadian Environmental Quality Guidelines. In young compost, the concentration of these chemical families decreased over time and most compounds were below the detection limits after 24 weeks of composting. In raw DPS, among the phenol, halogenated and monoaromatic hydrocarbons, dioxin and furan, and polychlorinated biphenyl families, most compounds were below the detection limits. The raw DPS and its young compost do not represent a major threat for the environment but can require an environmental follow-up.     

The environmental impact of shrimp aquaculture: a global perspective

A global perspective on the environmental impacts related to the establishment and operation of shrimp aquaculture is presented. Alternatives to reduce the impacts are considered and research priorities are recommended.     

Solar photocatalytic mineralization of commercial pesticides: acrinathrin

A comparative study of the degradation of commercial acrinathrin spiked in water using TiO2 photocatalysis and photolysis under sunlight was performed. Samples were analysed by liquid chromatography-diode array detector (HPLC-DAD) and gas chromatography-ion trap-mass spectrometric detector (GC-ITMS). Additional total organic carbon (TOC) analyses were carried out to evaluate the mineralisation rates. One photoproduct, 2-phenoxy benzaldehyde, was unequivocally identified and evaluated by GC-ITMS during the processes. Although acrinathrin is almost destroyed when exposed to irradiation for more than 400 h, photocatalysis with TiO2 noticeably reduced degradation to a few hours. In this case, with the additional presence of peroxydisulphate, in less than 2 h acrinathrin is completely destroyed. Mineralisation of acrinathrin, without catalyst, was only around 50% after 400 h of irradiation.     

Mercury levels in muscle of two fish species and sediments from the Cartagena Bay and the Ciénaga Grande de Santa Marta, Colombia

Mercury (Hg) content in sediments and muscle from two fish species were determined in Cartagena Bay and Ciénaga Grande de Santa Marta, an industrialized bay and an unpolluted estuary in the Caribbean coast of Colombia. Sampling was conducted four times during March-November 1996, including both the dry and rainy seasons. Significant differences in Hg concentration were detected both for fish and sediments between the two waterbodies. Hg values ranged from 94 to 10,293 microg/kg dry weight (dw) in sediments from Cartagena Bay and between 20 and 109 microg/kg dw in Ciénaga Grande de Santa Marta. Highest Hg concentrations were observed for the omnivorous species Eugerres plumieri, and lowest concentrations were found in the detritivorous Mugil incilis. High Hg concentrations in sediments of Cartagena Bay were detected in front of the sewage discharge of an extinct chlor-alkali plant, with decreasing concentrations in stations far from the source. Our results suggest that Hg can be persistent in the sediments of previously exposed ecosystems and that the use of their biological resources should be avoided until decontamination programs guarantee safe levels of the metal in the environment.     

Influence of pre-treatment step on PAHs analyses in contaminated soils

There is no specific standardization for the pre-treatment of a soil sample for PAHs analyses. The ISO/FDIS 14507 method for soil quality gives a guidance for sample pre-treatment before measurement of organic contaminants in soil. It refers to cryogenic crushing which is not so easy to carry out. So, analysts lead to develop in house methods which can be very different from a laboratory to another and can involve deviations in the pollution quantification. This study has explored different ways of drying, grinding and sieving in order to determine the influence of the soil sample handling on the measured pollutant concentration. It appears that the influence of pre-treatment depends on the soil nature and on the PAHs distribution. As a conclusion, it is advised "light" drying ways like air drying or drying at 40 degrees C in a drying oven instead of more "drastic" ways (freeze-drying, cryogenic crushing) which can induce some losses. Crushing and sieving are also recommended for more reproducible measures.