2D brine sewage after impinging on a shallow sea free surface

We consider the problem of the vertically upwards disposal of heavy brine sewage from a two-dimensional diffuser in a lighter, homogeneous, motionless and shallow ambient sea. The rejected high salinity water of seawater desalination plants for urban and agricultural uses is such a case of a two dimensional fountain. The disposal of brine sewage produces a negative buoyant jet due to its initial momentum, which impinges on the free surface, spreads laterally on it and then sinks downwards, because of the negative buoyancy. Laboratory experiments and dimensional considerations are used in this paper in order to investigate the spreading behavior (width) of the vertical fountain which impinges on the free surface of the shallow ambient fluid. The experimental results have been used to derive an equation relating the width at the free surface with the initial parameters of the flow. In addition, the experimentally measured dilution of the heavier brine sewage on the recipient’s surface is compared with the dilution which was calculated by a numerical simulation of a well-known commercial software package, CORJET (a CORMIX sub model).     

A stochastic Lagrangian micromixing model for the dispersion of reactive scalars in turbulent flows: role of concentration fluctuations and improvements to the conserved scalar theory under non-homogeneous conditions

Several reaction schemes, based on the conserved scalar theory, are implemented within a stochastic Lagrangian micromixing model to simulate the dispersion of reactive scalars in turbulent flows. In particular, the formulation of the reaction-dominated limit (RDL) reaction scheme is here extended to improve the model performance under non-homogeneous conditions (NHRDL scheme). The validation of the stochastic model is obtained by comparison with the available measurements of reactive pollutant concentrations in a grid-generated turbulent flow. This test case describes the dispersion of two atmospheric reactant species (NO and O₃) and their reaction product (NO₂) in an unbounded turbulent flow. Model inter-comparisons are also assessed, by considering the results of state-of-the-art models for pollutant dispersion. The present validation shows that RDL reaction scheme provides a systematic overestimation (relative error of ca. 85% around the centreline) in computing the local reactant consumption/production rate, whereas the NHRDL scheme drastically reduces this gap (relative error lower than 5% around the centreline). In terms of NO₂ production (or reactant consumption), neglecting concentration fluctuations determines overestimations of the product mean of around 100% and a NO₂ local production of one order of magnitude higher than the reference simulation. In terms of standard deviations, the concentration fluctuations of both the passive and reactive scalars are generally of the same order of magnitude or up to 1 or 2 orders of magnitudes higher than the corresponding ensemble mean values, except for the background reactant close to the plume edges. The study highlights the importance of modelling pollutant reactions depending on the instantaneous instead of the mean concentrations of the reactants, thus quantifying the role of the turbulent fluctuations of concentration, in terms of scalar statistics (mean, standard deviation, intensity of fluctuations, skewness and kurtosis of concentration, segregation coefficient, simulated reaction rate). This stochastic particle method represents an efficient numerical technique to solve the convection–diffusion equation for reactive scalars and involves several application fields: micro-scale air quality (urban and street-canyon scales), accidental releases, impact of odours, water quality and fluid flow industrial processes (e.g. combustion).     

Evaluation of existing equations for temporal scour depth around circular bridge piers

Scour is defined as the processes of removal of sediment particles from water stream bed by the erosive action of activated water, and also carries sediment away from the hydraulic structures. Scour is the main cause of pier failure. Numerous equations are available for estimating temporal and equilibrium scour depth. The present study describes the phenomenon of temporal scour depth variation at bridge piers and deals with the methods for its estimation. The accuracy of six temporal scour depth equations are also checked in this study. After graphical and statistical analysis, it was found that the relationship proposed by Oliveto and Hager (J Hydraul Eng (ASCE) 128(9):811–520, 2002) predicts temporal scour depth better than other equations. Three equations of equilibrium time of scour are also used for computing equilibrium time. Equilibrium time equation proposed by Choi and Choi (Water Environ J 30(1–2):14–21, 2016) gives better agreements with observed values.     

Simulation of dam/levee-break hydrodynamics with a three-dimensional implicit unstructured-mesh finite element model

Dam failures usually cause huge economic and life losses , especially in urban areas where there is a high concentration of inhabitants and economic actors. In order to understand the physical mechanisms of the formation and development of dam-break flooding, lots of efforts have been put into different types of modelling techniques. However, most of existing models are 1D (one-dimensional) or 2D models based on the shallow water equations. In this paper, we present a 3D numerical modelling investigation of dam-break flow hydrodynamics in an open L-shape channel. A newly developed 3D unstructured mesh finite element model is used here. An absorption-like term is introduced to the Navier–Stokes equations in order to control the conditioning of the matrix equation in the numerical solution process and thus improve the stability. A wetting and drying algorithm is used here to allow the free surface height to be treated with a high level of implicitness and stability. The 3D model has been validated by comparing the results with the published experimental data. Good agreement has been achieved at six selected locations. This study shows that the 3D unstructured mesh model is capable of capturing the 3D hydraulic aspects and complicated local flows around structures in simulation of dam-break flows.     

Spatiotemporal changes and fragmentation of mangroves and its effects on fish diversity in Ca Mau Province (Vietnam)

Mangroves are important economically and ecologically, however mangrove cover has declined dramatically leading to habitat fragmentation and biodiversity loss. Information on mangrove cover change, fragmentation and impacts on fish diversity is poorly understood. The aims of this study are to detect spatiotemporal changes and mangrove status, examine fragmentation changes and associated effects on fish diversity. Landsat images in1989, 2000, and 2013 were used to classify mangrove cover in Ca Mau Province (Vietnam) and validated against high resolution Pleiades imagery. Fragmentation changes in mangrove cover were examined using series of landscape metrics evaluated against fish diversity indices (Simpson’s index, Jaccard’s coefficient and relative abundance). Results show that mangrove cover has declined 24.6% in the province. Currently, high and moderately dense mangroves distribute in southern half of the region while the low density mangroves occurs in the northern half. Over the 24 year study periods, the number of patches and edge density has increased 58% and 53.9%, respectively, while the mean patch size and mean patch edge has decreased 52.3% and 26.6%. Fish diversity in the more highly fragmented mangrove area was 1.78 times lower than the less fragmented mangrove. The study illustrates the applicability of using Landsat satellite imagery for use in mangrove fragmentation studies as well as the impact of fragmentation.     

Modeling and data assessment of longitudinal salinity in a low-gradient estuarine river

Continuous data of vertical-profile salinity were analyzed for four stations located successively upriver in a macrotidal estuary, the lower St. Johns River (Northeast Florida, USA). The data analysis confirmed well-mixed salinity conditions in the river with at most 1.3 ppt of vertical variability at Dames Point (river km 20), where the main variations of salinity are along the longitudinal axis of the river. Given the well-mixed salinity conditions and dominant horizontal structure of salinity variations in the river, we present and apply a barotropic, two-dimensional modeling approach for hydrodynamic-salinity transport simulation in the lower St. Johns River. When properly forced by offshore surge, high-resolution wind fields and freshwater river inflows, the model replicated the salinity measurements remarkably well, including the separation into tidal and sub-tidal components. The data and model results show that, at times, offshore winds and surge can be more influential on longitudinal salinity variations than local winds over the river. We demonstrate the importance of using proper boundary conditions to force the model relative to the minimal sensitivity of the model to parameter adjustment of horizontal mixing and uncertainty-based perturbation of wind and inflow forcings.     

Mechanism of the intermittent motion of two-phase debris flows

A typical two-phase debris flow exhibits a high and steep flow head consisting of rolling boulders and cobbles with intermittent or fluctuating velocity. The relative motion between the solid phase and the liquid phase is obvious. The motion of a two-phase debris flow depends not only on the rheological properties of the flow, but also on the energy transmission between the solid and liquid phases. Several models have been developed to study two-phase debris flows. An essential shortcoming of most of these models is the omission of the interaction between the two phases and identification of the different roles of the different materials in two-phase debris flows. The tracer particles were used for the velocity of solid phase and the velocity of liquid phase was calculated by the water velocity on the surface of the debris flow in the experiments. This paper analyzed the intermittent feature of two-phase debris flows based on videos of debris flows in the field and flume experiments. The experiments showed that the height of the head of the two-phase debris flow increased gradually in the initiation stage and reached equilibrium at a certain distance from the start of the debris flow. The height growth and the velocity of the flow head showed fluctuating characteristics. Model equations were established and the analyses proved that the average velocity of the two-phase debris flow head was proportional to the flood discharge and inversely proportional to the volume of the debris flow head.     

Froude scaling limitations in modeling of turbidity currents

The scaling problem associated with the modeling of turbidity currents has been recognized but is yet to be explored systematically. This paper presents an analysis of the dimensionless governing equations of turbidity currents to investigate the scale effect. Three types of flow conditions are considered: (i) conservative density current; (ii) purely depositional turbidity current; and (iii) mixed erosional/depositional turbidity current. Two controlling dimensionless numbers, the Froude number and the Reynolds number, appear in the non-dimensional governing equations. When densimetric Froude similarity is satisfied, the analysis shows that the results would be scale-invariant for conservative density current under the rough turbulent condition. In the case of purely depositional flows, truly scale-invariant results cannot be obtained, as the Reynolds-mediated scale effects appear in the bottom boundary conditions of the flow velocity and sediment fall velocity. However, the scale effect would be relatively modest. The Reynolds effect becomes more significant for erosional or mixed erosional/depositional turbidity currents as Reynolds-mediated scale effects also appear in the sediment entrainment relation. Numerical simulations have been conducted at three different scales by considering densimetric Froude scaling alone as well as combined densimetric Froude and Reynolds similarity. Simulation results confirm that although the scaling of densimetric Froude number alone can produce scale-invariable results for conservative density currents, variations occur in the case of turbidity currents. The results become scale invariant when densimetric Froude and Reynolds similarities are satisfied simultaneously.     

Technology and science: innovation at the International Symposium on Sustainable Systems and Technology

While science advances technology, it is also true that technology advances science. Thus, the two bodies of knowledge are increasingly recognized as interdependent. Nonetheless, recent advances in information communication technology (ICT), in particular, may have profound implications for the norms by which science is conducted. For example, treatment of data will increasingly be in terms of probability distributions, rather than as point estimates, because the cost of computation is now so low that more robust approaches to treatment of uncertainty are within the grasp of normal science. Perhaps more importantly, the techniques by which scientists collaborate, communicate, and curate science are undergoing a rare period of rapid change. The papers in this special section exemplify the evolution of the relationship between technology and science in these two important ways: (1) treatment of data uncertainties and (2) participation in novel methods of publication and review. The latter was fostered by the 2016 meeting of the International Symposium on Sustainable Systems and Technologies (ISSST), at which all of the papers in this special section were presented. This editorial summarizes some of the trends in ICT that are the subject of experimentation in ISSST and introduces the idea that scientific societies in the information age are more likely to take the form of a network than they are likely to look like the societies of the last several centuries.     

The progress of interdisciplinarity in invasion science

Interdisciplinarity is needed to gain knowledge of the ecology of invasive species and invaded ecosystems, and of the human dimensions of biological invasions. We combine a quantitative literature review with a qualitative historical narrative to document the progress of interdisciplinarity in invasion science since 1950. Our review shows that 92.4% of interdisciplinary publications (out of 9192) focus on ecological questions, 4.4% on social ones, and 3.2% on social–ecological ones. The emergence of invasion science out of ecology might explain why interdisciplinarity has remained mostly within the natural sciences. Nevertheless, invasion science is attracting social–ecological collaborations to understand ecological challenges, and to develop novel approaches to address new ideas, concepts, and invasion-related questions between scholars and stakeholders. We discuss ways to reframe invasion science as a field centred on interlinked social–ecological dynamics to bring science, governance and society together in a common effort to deal with invasions.