Soil contamination of heavy metals in the Katedan Industrial Development Area, Hyderabad, India

Studies on quantitative soil contamination due to heavy metals were carried out in Katedan Industrial Development Area (KIDA), south of Hyderabad, Andhra Pradesh, India under the Indo-Norwegian Institutional Cooperation Programme. The study area falls under a semi-arid type of climate and consists of granites and pegmatite of igneous origin belonging to the Archaean age. There are about 300 industries dealing with dyeing, edible oil production, battery manufacturing, metal plating, chemicals, etc. Most of the industries discharge their untreated effluents either on open land or into ditches. Solid waste from industries is randomly dumped along roads and open grounds. Soil samples were collected throughout the industrial area and from downstream residential areas and were analysed by X-ray Fluorescence Spectrometer for fourteen trace metals and ten major oxides. The analytical data shows very high concentrations of lead, chromium, nickel, zinc, arsenic and cadmium through out the industrial area. The random dumping of hazardous waste in the industrial area could be the main cause of the soil contamination spreading by rainwater and wind. In the residential areas the local dumping is expected to be the main source as it is difficult to foresee that rain and wind can transport the contaminants from the industrial area. If emission to air by the smokestacks is significant, this may contribute to considerable spreading of contaminants like As, Cd and Pb throughout the area. A comparison of the results with the Canadian Soil Quality Guidelines (SQGL) show that most of the industrial area is heavily contaminated by As, Pb and Zn and local areas by Cr, Cu and Ni. The residential area is also contaminated by As and some small areas by Cr, Cu, Pb and Zn. The Cd contamination is detected over large area but it is not exceeding the SQGL value. Natural background values of As and Cr exceed the SQGL values and contribute significantly to the contamination in the residential area. However, the availability is considerably less than anthropogenic contaminants and must therefore be assessed differently. The pre- and post-monsoon sampling over two hydrological cycles in 2002 and 2003 indicate that the As, Cd and Pb contaminants are more mobile and may expect to reach the groundwater. The other contaminants seem to be much more stable. The contamination is especially serious in the industrial area as it is housing a large permanent residing population. The study not only aims at determining the natural background levels of trace elements as a guide for future pollution monitoring but also focuses on the pollution vulnerability of the watershed. A plan of action for remediation is recommended.     

Soil and vegetation carbon stocks in Brazilian Western Amazonia: relationships and ecological implications for natural landscapes

The relationships between soils attributes, soil carbon stocks and vegetation carbon stocks are poorly know in Amazonia, even at regional scale. In this paper, we used the large and reliable soil database from Western Amazonia obtained from the RADAMBRASIL project and recent estimates of vegetation biomass to investigate some environmental relationships, quantifying C stocks of intact ecosystem in Western Amazonia. The results allowed separating the western Amazonia into 6 sectors, called pedo-zones: Roraima, Rio Negro Basin, Tertiary Plateaux of the Amazon, Javari-Juruá-Purus lowland, Acre Basin and Rondonia uplands. The highest C stock for the whole soil is observed in the Acre and in the Rio Negro sectors. In the former, this is due to the high nutrient status and high clay activity, whereas in the latter, it is attributed to a downward carbon movement attributed to widespread podzolization and arenization, forming spodic horizons. The youthful nature of shallow soils of the Javari-Juruá-Purus lowlands, associated with high Al, results in a high phytomass C/soil C ratio. A similar trend was observed for the shallow soils from the Roraima and Rondonia highlands. A consistent east–west decline in biomass carbon in the Rio Negro Basin sector is associated with increasing rainfall and higher sand amounts. It is related to lesser C protection and greater C loss of sandy soils, subjected to active chemical leaching and widespread podzolization. Also, these soils possess lower cation exchangeable capacity and lower water retention capacity. Zones where deeply weathered Latosols dominate have a overall pattern of high C sequestration, and greater than the shallower soils from the upper Amazon, west of Madeira and Negro rivers. This was attributed to deeper incorporation of carbon in these clayey and highly pedo-bioturbated soils. The results highlight the urgent need for refining soil data at an appropriate scale for C stocks calculations purposes in Amazonia. There is a risk of misinterpreting C stocks in Amazonia when such great pedological variability is not taken into account.     

Extraction of labile metals from solid media by dilute hydrochloric acid

Extraction of labile metals from solid media is environmentally more meaningful than a total digestion. A variety of reagents have been introduced in the literature, but dilute HCl has received the greatest attention. We compare metal concentrations liberated by a dilute HCl leach with the sum of the 3-step optimized (standardized) BCR sequential extraction procedure. This is the first study to compare these procedures over a range of grain sizes. Road-deposited sediments from 10 sites in Honolulu were fractionated into six grain size classes. Aliquots of individual fractions were digested with dilute HCl, the 3-step BCR procedure (‘labile’), and a 4-acid (total) procedure. Results indicated that the weighted labile concentrations of Al, Cu, Fe, Mn, Ni, Pb and Zn were statistically greater than those from the dilute HCl leach. However, regression analysis indicated strong statistically significant relationships between the two partial extraction procedures for all metals. On a whole-sample basis, the toxicity classifications for anthropogenic-enhanced metals (Cu, Pb and Zn) were similar between extractions. Taken together, results suggest that the application of dilute HCl to solid media provides a rapid, cost-effective, and environmentally meaningful approach for contaminant monitoring.     

Is PM10 mass measurement a reliable index for air quality assessment? An environmental study in a geographical area of north-eastern Italy

The aim of this study was to measure the concentration of some metals (Cd, Cr, Cu, Fe, Mn, Ni, Pb, and Ti) in PM(10) samples collected in one urban and one industrial site and to assess that PM(10) total mass measurement may be not sufficient as air quality index due to its complex composition. Metals were determined by inductively coupled plasma-atomic emission spectroscopy (ICP-AES) and differential pulsed anodic stripping voltammetry (DPASV). The measured concentrations were used to calculate the content of metals in the PM(10) total mass, and to estimate the enrichment factors and the correlations between PM(10), metal concentrations and meteorological data for the two sites. The mean PM10 concentration during the sampling period in the urban site exceeded the annual European Union (EU) standard (40 microg/m(3)) and, for some sampling days, the daily EU standard (50 microg/m(3)) was also exceeded. In opposite, both EU standards were never exceeded in the industrial site. The overall metal content was nearly double in the industrial site compared to the urban one, and the mean Ni concentration exceeded the EU annual limit value (10 ng/m(3)). The metals with the highest enrichment factor were Cd, Cu, Ni and Pb for both sites, suggesting a dominant anthropogenic source for these metals. Metal concentrations were very low and typical of rural background during Christmas holidays, when factories were closed. PM(10) total mass measurement is not a sufficient air quality index since the metal content of PM(10) is not related to its total mass, especially in sites with industrial activities. This measurement should be associated with the analysis of toxic metals.     

Assessing Landscape Condition Relative to Water Resources in the Western United States: A Strategic Approach

The Environmental Monitoring and Assessment Program (EMAP) is proposing an ambitious agenda to assess the status of streams and estuaries in a 12-State area of the western United States by the end of 2003. Additionally, EMAP is proposing to access landscape conditions as they relate to stream and estuary conditions across the west. The goal of this landscape project is to develop a landscape model that can be used to identify the relative risks of streams and estuaries to potential declines due to watershed-scale, landscape conditions across the west. To do so, requires an understanding of quantitative relationships between landscape composition and pattern metrics and parameters of stream and estuary conditions. This paper describes a strategic approach for evaluating the degree to which landscape composition and pattern influence stream and estuary condition, and the development and implementation of a spatially-distributed, landscape analysis approach.     

Calculating losses of crops in Denmark caused by high ozone levels

In order to help guide air pollution legislation at the European level, harmful air pollution effects on agriculture crops and the consequent economic implications for policy have been studied for more than a decade. Ozone has been labeled as the most serious of the damaging air pollutants to agriculture, where growth rates and consequently yields are dramatically reduced. Quantifying the effects has formed a key factor in policymaking. Based on the widely held view that AOT40 (Accumulated exposure Over Threshold of 40 ppb) is a good indicator of ozone-induced damage, the Danish Eulerian Model (DEM) was used to compute reduced agriculture yields on a 50 km×50 km grid over Europe. In one set of scenarios, a ten year meteorological time series was combined with realistic emission inventories. In another, various idealized emission reduction scenarios are applied to the same meteorological time series. The results show substantial inter-annual variability in economic losses, due in most part to meteorological conditions which varied much more substantially than the emissions during the same period. It is further shown that, taking all uncertainties into account, estimates of ozone-induced economic losses require that a long meteorological record is included in the analysis, for statistical significance to be improved to acceptable levels for use in policy analysis. In this study, calculations were made for Europe as a whole, though this paper presents results relevant for Denmark.     

The Need for Scale Sensitive Approaches in Spatially Explicit Land Use Change Modeling

This paper introduces some of the issues that are relevant to the spatially explicit modeling of land use systems. A short overview is given of the ways and means in which a number of different land use change models describe the land use system. Specific attention is given to the empirical modeling approach used in the CLUE (Conversion of Land Use and its Effects) modeling framework. This approach is demonstrated for three case studies in China, Ecuador and the Atlantic Zone of Costa Rica. These case-studies illustrate the methodology for multi-scale analysis of land use driving factors and their application in spatially explicit modeling exercises. Model functioning, performance and limitations are discussed. The presented case-studies indicate that empirical modeling results can contribute to a better theoretic imbedding of land use change research in scale sensitive and integrated theories.     

Migratory crustaceans as biomonitors of metal pollution in their nursery areas. The Lesina lagoon (SE Italy) as a case study

Lichens collected in an unpolluted forest (background) in November 2004, transplanted at 41 sampling sites along the Madina-Tetteh Quarshie road, retrieved in February 2005 and analysed were found to contain higher concentrations of Manganese (Mn), Vanadium (V), lead, Cadmium (Cd), Chromium (Cr) and Nickel (Ni) than in the background area. Observations showed that of all the heavy metals studied, Manganese concentrations were highest at all sampling points with maximum values around a traffic light, an intersection and car fitting/mechanic workshops. Significant correlations were found between Ni and Mn, Mn and Cr and Mn and V. Statistical analysis also revealed a relatively even dispersion of the studied elements on the eastern side of the road than on the western side.     

Magnesium hydroxide bulk and colloid-associated 152Eu in an alkaline environment: colloid characterisation and sorption properties in the presence and absence of carbonate

The distribution of 152Eu between magnesium hydroxide bulk, colloids and solution has been assessed under alkaline conditions, such as those in nuclear fuel storage ponds. The colloidal phase has been characterised by two complementary methods: coupled ultrafiltration-ICP-AES and scanning electron microscopy. The quantity and the size distribution of the colloidal phase is strongly ionic strength-dependent. A decrease of the quantity of colloids, in particular the larger size ranges, has been observed with increasing ionic strength. Small colloids (1 kDa-10 kDa fraction) are predominant at all ionic strengths. The morphology of colloids, observed by field-emission gun scanning electron microscopy, appears to change from hexagonal prismatic (characteristic to the mineral) to spherical (energetically more favourable) as size decreases. The distribution of 152Eu between the solid and liquid/colloidal phases has been investigated at carbonate concentrations ranging from 0 to 10(-2) M by coupled ultrafiltration and gamma-spectrometry. Mg(OH)2 bulk appears to be a very strong sorbent for 152Eu, since complete sorption onto the bulk happens for carbonate concentrations as high as 10(-3) M. Scavenging of 152Eu by Mg(OH)2 colloids is negligible in the presence of Mg(OH)2 bulk. The distribution of 152Eu between liquid and colloidal phases has been investigated in the absence of bulk at various carbonate concentrations. A significant uptake of 152Eu by the colloids in solution has been observed, which decreases with increasing carbonate concentration. 152Eu appears to be mainly associated to the smallest colloids (1 kDa-10 kDa fraction). There is a strong correlation between the sorption properties and the surface area of the colloids.