Assessment of imidacloprid toxicity on reproductive organ system of adult male rats

In the current study it was aimed to investigate the toxicity of low doses of imidacloprid (IMI) on the reproductive organ systems of adult male rats. The treatment groups received 0.5 (IMI-0.5), 2 (IMI-2) or 8 mg IMI/kg body weight by oral gavage (IMI-8) for three months. The deterioration in sperm motility in IMI-8 group and epidydimal sperm concentration in IMI-2 and IMI-8 groups and abnormality in sperm morphology in IMI-8 were significant. The levels of testosterone (T) and GSH decreased significantly in group IMI-8 compared to the control group. Upon treatment with IMI, apoptotic index increased significantly only in germ cells of the seminiferous tubules of IMI-8 group when compared to control. Fragmentation was striking in the seminal DNA from the IMI-8 group, but it was much less obvious in the IMI-2 one. IMI exposure resulted in elevation of all fatty acids analyzed, but the increases were significant only in stearic, oleic, linoleic and arachidonic acids. The ratios of 20:4/20:3 and 20:4/18:2 were decreased and 16:1n-9/16:0 ratio was increased. In conclusion, the present animal experiments revealed that the treatment with IMI at NOAEL dose-levels caused deterioration in sperm parameters, decreased T level, increased apoptosis of germ cells, seminal DNA fragmentation, the depletion of antioxidants and change in disturbance of fatty acid composition. All these changes indicate the suppression of testicular function.     

Multiple comparisons of organic,microbial, and fine particulate pollutants in typical indoor environments: Diurnal and seasonal variations

This study was performed to investigate the possible sources as well as seasonal and diurnal variations of indoor air pollutants in widely used four different environments (house, office, kindergarten, and primary school) in which people spend most of their time. Bioaerosol levels and species, volatile organic compound (VOC) levels, and PM_2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) levels were determined in different parts of these environments in parallel with outdoor sampling. Air pollution samplings were carried out in each microenvironment during five subsequent days in both winter and summer in Ankara, Turkey. The results indicated that bioaerosol, VOC, and PM_2.5 levels were higher in the winter than in the summer. Moreover, PM_2.5 and bioaerosol levels showed remarkable daily and diurnal variations, whereas a good correlation was found between the VOC levels measured in the morning and in the afternoon. Bacteria levels were, in general, higher than fungi levels. Among the VOCs, toluene was the most predominant, whereas elevated n-hexane levels were also observed in the kindergarten and the primary school, probably due to the frequent wet cleaning during school days. According to factor analysis, several factors were found to be significantly influencing the indoor air quality (IAQ), and amongst them, VOC-based products used indoors ranked first. The overall results indicate that grab sampling in naturally ventilated places may overestimate or underestimate the IAQ due to the inhomogeneous composition of indoor air caused by irregular exchanges with the outdoor air according to the season and/or occupants' habits.

Implications Seasonal and diurnal variations of VOCs, PM_2.5, bioaerosols in house, office, and schools were observed, in which PM_2.5 and bioaeorosols showed marked both intra- and interday variability, but VOCs did not. VOC-containing products were the most common source of air pollutants affecting the indoor air quality. External factors affecting the indoor air quality were season and indirectly ventilation. A grab sample cannot be representative in evaluating the air quality of a naturally ventilated environment precisely.     

Mitigation of odor causing emissions—Bench-scale investigation

Emissions of malodors are considered to be the greatest threat to the compost industry. In work presented here, several simple odor mitigation alternatives were investigated for their effectiveness in preventing the release of common odorants, such as terpenes, ammonia, and reduced sulfur compounds. The mitigation methods studied included the use of a blanket of finished compost, compost amendment mixed within the feedstock, odor neutralizing agents (ONAs), and oxygen release compounds (ORCs). Among the mitigation alternatives investigated in this study, the use of finished compost as a blanket and finished compost as an amendment yielded the most conclusive and significant results. Both of these alternatives yielded a substantial emission reduction for terpenes, ammonia, and reduced sulfur compounds. The application of finished compost blanket resulted in up to 95% reduction of terpene and 25% reduction of ammonia emissions. Blending the feedstock with finished compost also provided substantial reduction of terpene emissions ranging from 73.6 to 93.1% at the 24% blending ratio, and up to 85% ammonia reduction a the 35% blending ratio. Use of finished compost also provided 75% lower reduced sulfur compound emissions at the 12% blending ratio. Misting and application of odor neutralizing agents did not result in any consistent reduction in emissions for any of the odorous compounds tested.

Implications The odor emissions from composting are often considered to be the biggest threat to composting facilities. Because most facilities cannot afford enclosures and contained composting vessels, there is a need to inexpensively and effectively control the odor emissions from composting facilities. The findings of this research can lead the way for efforts to control odor easily and cost effectively. In fact, the application of a compost blanket for odor control is already gaining acceptance by the composting industry.     

Radical precursors and related species from traffic as observed and modeled at an urban highway junction

Nitrous acid (HONO) and formaldehyde (HCHO) are important precursors for radicals and are believed to favor ozone formation significantly. Traffic emission data for both compounds are scarce and mostly outdated. A better knowledge of today's HCHO and HONO emissions related to traffic is needed to refine air quality models. Here the authors report results from continuous ambient air measurements taken at a highway junction in Houston, Texas, from July 15 to October 15, 2009. The observational data were compared with emission estimates from currently available mobile emission models (MOBILE6; MOVES [MOtor Vehicle Emission Simulator]). Observations indicated a molar carbon monoxide (CO) versus nitrogen oxides (NO_x) ratio of 6.01 ± 0.15 (r ² = 0.91), which is in agreement with other field studies. Both MOBILE6 and MOVES overestimate this emission ratio by 92% and 24%, respectively. For HCHO/CO, an overall slope of 3.14 ± 0.14 g HCHO/kg CO was observed. Whereas MOBILE6 largely underestimates this ratio by 77%, MOVES calculates somewhat higher HCHO/CO ratios (1.87) than MOBILE6, but is still significantly lower than the observed ratio. MOVES shows high HCHO/CO ratios during the early morning hours due to heavy-duty diesel off-network emissions. The differences of the modeled CO/NO_x and HCHO/CO ratios are largely due to higher NO_x and HCHO emissions in MOVES (30% and 57%, respectively, increased from MOBILE6 for 2009), as CO emissions were about the same in both models. The observed HONO/NO_x emission ratio is around 0.017 ± 0.0009 kg HONO/kg NO_x which is twice as high as in MOVES. The observed NO₂/NO_x emission ratio is around 0.16 ± 0.01 kg NO₂/kg NO_x, which is a bit more than 50% higher than in MOVES. MOVES overestimates the CO/CO₂ emission ratio by a factor of 3 compared with the observations, which is 0.0033 ± 0.0002 kg CO/kg CO₂. This as well as CO/NO_x overestimation is coming from light-duty gasoline vehicles.

Implications: Nitrous acid (HONO) and formaldehyde (HCHO) are important precursors for radicals that ultimately contribute to ozone formation. There still exist uncertainties in emission sources of HONO and HCHO and thus regional air quality modeling still tend to underestimate concentrations of free radicals in the atmosphere. This paper demonstrates that the latest U.S. Environmental Protection Agency (EPA) traffic emission model MOVES still shows significant deviations from observed emission ratios, in particular underestimation of HCHO/CO and HONO/NO_x ratios. Improving the performance of MOVES may improve regional air quality modeling.     

Evaluation of best management practice products in preventing discharge of metals: a laboratory evaluation

Heavy metal accumulation in soil poses serious environmental and health risks, as metals are carried with eroded soils. In this study, 17 different soil erosion and sediment control products were investigated for their effectiveness in controlling transport of particulate heavy metals (Cu, Zn, Pb, Cd). Among the treatments investigated, wood mulch and tackifiers were found to be the most effective in reducing total suspended solids (TSS) and total heavy metal losses. They reduced TSS to an undetectable level during short-term simulation tests. Paper mulch was the only treatment that had no significant reduction in both total metal loss and TSS. Fiber rolls, silt fences, and gravel bags were effective in reducing sediment loss. Although the netting/blanket treatments were not effective in reducing total metal discharge, they significantly reduced sediment loss compared with the control.     

On-farm measurement of electrical conductivity for the estimation of ammonium nitrogen concentration in pig slurry

Pig (Sus scrofa domesticus) slurry (PS) is commonly applied as fertilizer to agricultural fields. Knowledge of PS nitrogen content is essential for good management, but PS nitrogen content is highly variable, not only between farms but also within a farm. Laboratory analysis of animal slurries is often expensive and impractical for routine farmer use. Therefore, when slurry is spread on land, its fertilizer value is generally unknown, resulting in the risk of pollution. In this work, two rapid and suitable for field use methods for determining PS ammonium N (NH(4)+-N) concentration (Quantofix and conductimetry) are evaluated. The electrical conductivity of a dilution 1 PS:9 distilled water had better results than Quantofix, did not need reagents, and gave a direct value of NH(4)+-N concentrations (range, 1.0-7.6 kg NH(4)+-N m(-3)). The conductimetry method allows the use of alternative waters with EC <1.9 dS m(-1) for dilution. This method is being introduced to farmers in northeast Spain to improve PS management and has been well received due to its low cost and ease of use.     

A theoretical overview of the relationship between the resource curse and genuine savings as an indicator for “weak” sustainability

This paper shows the strong relation between the factors that lead to the resource curse (RC) and factors that lead to a decline of genuine savings (GS). There is substantial empirical evidence that economies that rely predominantly on their natural resources are also characterized by slower economic growth. This so‐called RC is commonly traced back to the fact that natural resources' generate rents that are independent of a country's economic performance, which can lead to suboptimal reinvestments of this consumed natural capital. We argue that the factors responsible for the RC also have a negative effect on GS, a concept that measures “weak” sustainable development by considering reinvestment of natural capital rents in physical and human capital. We discuss whether the RC hampers possibilities for resource abundant countries to obtain sufficiently high rates of GS, and find indeed many reasons why resource‐dependent countries have problems achieving positive GS rates. We survey both areas of research, emphasizing the influence of the exogenous and endogenous determinants of economic growth, which are usually used to theoretically and empirically explain the RC on the three different forms of capital considered by GS. We specify why most countries suffering from the RC have negative GS rates and explain in detail where the linkages are. This overview could help with potential advancements in the explanation of GS through the inclusion of RC effects.     

Characterization of silver release from commercially available functional (nano)textiles

Silver, both in the nano as well as in other forms, is used in many applications including antimicrobial textiles. Washing of such textiles has already been identified as an important process that results in the release of silver into wastewater. This study thus investigated the release of silver from eight different commercially available silver-textiles during a washing and rinsing cycle. The silver released was size-fractionated and characterized using electron microscopy. In addition, the antimicrobial functionality of the textiles was tested before and after washing. Three of the textiles contained nanosized silver (labeled or confirmed by manufacturers’ information), another used a metallic silver wire and four contained silver in undeclared form. The initial silver content of the textiles was between 1.5 and 2925 mg Ag/kg. Only four of the investigated textiles leached detectable amounts of silver, of which 34-80% was in the form of particles larger than 450 nm. Microscopic analysis of the particles released in the washing solutions identified Ti/Si-AgCl nanocomposites, AgCl nanoparticles, large AgCl particles, nanosilver sulfide and metallic nano-Ag, respectively. The nanoparticles were mainly found in highly agglomerated form. The identified nanotextiles showed the highest antimicrobial activity, whereas some of the other textiles, e.g. the one with a silver wire and the one with the lowest silver content, did not reduce the growth of bacteria at all. The results show that different silver textiles release different forms of silver during washing and that among the textiles investigated AgCl was the most frequently observed chemical form in the washwater.     

The structure of the fire fighting foam surfactant Forafac®1157 and its biological and photolytic transformation products

For several decades, perfluorooctane sulfonate (PFOS) has widely been used as a fluorinated surfactant in aqueous film forming foams used as hydrocarbon fuel fire extinguishers. Due to concerns regarding its environmental persistence and toxicological effects, PFOS has recently been replaced by novel fluorinated surfactants such as Forafac®1157, developed by the DuPont company. The major component of Forafac®1157 is a 6:2 fluorotelomer sulfonamide alkylbetaine (6:2 FTAB), and a link between the trade name and the exact chemical structure is presented here to the scientific community for the first time. In the present work, the structure of the 6:2 FTAB was elucidated by ¹H, ¹³C and ¹⁹F nuclear magnetic resonance spectroscopy and high-resolution mass spectrometry. Moreover, its major metabolites from blue mussel (Mytilus edulis) and turbot (Scophthalmus maximus) and its photolytic transformation products were identified. Contrary to what has earlier been observed for PFOS, the 6:2 FTAB was extensively metabolized by blue mussel and turbot exposed to Forafac®1157. The major metabolite was a deacetylated betaine species, from which mono- and di-demethylated metabolites also were formed. Another abundant metabolite was the 6:2 fluorotelomer sulfonamide. In another experiment, Forafac®1157 was subjected to UV-light induced photolysis. The experimental conditions aimed to simulate Arctic conditions and the deacetylated species was again the primary transformation product of 6:2 FTAB. A 6:2 fluorotelomer sulfonamide was also formed along with a non-identified transformation product. The environmental presence of most of the metabolites and transformation products was qualitatively demonstrated by analysis of soil samples taken in close proximity to an airport fire training facility.