Techniques for High-Quality Ambient Coarse Particle Mass Measurements

ABSTRACT

Several recent studies have shown associations between ambient concentrations of particle mass (PM) and rates of morbidity and mortality in the general population. These studies have raised the issue of quality of coarse mass (CM, PM between 2.5 and 10 µm) data used for these purposes. CM data may have precision three or more times worse than the associated PM _2.5 or PM₁₀ data, depending on the measurement method, PM _2.5 to PM ₁₀ ratios, and CM concentrations. CM is measured either as the difference between collocated _PM10 and _PM2.5 samplers or more directly with a dichotomous (virtual impactor) sampler. CM precision for the difference method is degraded due to the increased errors inherent with using the difference between two independent measurements, as well as the high PM_2.5 to PM₁₀ ratios (and low CM concentrations) typical of the eastern United States. The dichotomous sampler (dichot) makes a more direct measurement of CM, but there is a potential for significant postexposure loss of particles from unoiled CM dichot filters, as well as uncertainties in the dichot’s CM channel enrichment factor. Compared to the dichot, low-volume inertial impactor samplers such as the Harvard Impactor (HI) or PM2.5 Federal Reference Method (FRM) are simpler to operate and maintain, provide sharper cut points, and do not require oiled filters to prevent loss of CM from the filter during transport. With the recent interest in CM spatial and temporal variability with respect to PM health effects, we have developed modifications to the HI PM method to provide measurements of 24-hour PM with estimated CM precision of better than 5% CV and r² higher than 0.95, primarily by lowering field blank variability and increasing gravimetric analytical precision. These high-precision PM techniques are not limited to the HI sampler; they can also be applied to the _PM2.5 FRM sampler. The measurement methods described here can be applied to future PM studies to avoid the potential problems with exposure assessment caused by CM measurements that have poor precision.     

Removal of Chromium from Abrasive Blast Media by Leaching and Electrochemical Precipitation

ABSTRACT

Water is effective in leaching out Cr⁶⁺ from a mixture of paint powders and abrasive blast media. However, acids such as HNO₃, HCl, and H₂SO₄ significantly enhance the leaching procedure. Cr ions in the leaching solutions are successfully removed by electrochemical precipitation. The consumable Fe electrodes generate ferrous ions to cause the reduction of Cr⁶+ to Cr³+. Cr³+ ions along with Fe²+ and Fe³+ are then removed mainly by precipitation as Cr(OH)₃, Fe(OH)₂, and Fe(OH)₃ near the cathode where OH^- ions are generated by water electrolysis. The electrochemical process is capable of discharging low levels of Cr⁶+, less than 1 mg/L, without pH adjustment.     

Development and Demonstration of an Explicit Lumped-Parameter Biofilter Model and Design Equation Incorporating Monod Kinetics

Abstract

Biofiltration is an economical air pollution control (APC) technology, particularly suitable for the treatment of air-streams having high flow rates and low concentrations of volatile organic compounds (VOCs). This technology utilizes enzymatic catalysis at ambient conditions to mineralize such pollutants to CO₂, H₂O, and salts. A pilot-scale study conducted for more than 4 years investigated the development of a new biofiltration technology employing trickle bed air biofilters (TBABs). Following the completion of this experimental study, additional data analysis was performed to develop a simple lumped-parameter biofilter model, assuming first-order kinetics. This model related the observed biofilter performance to the principle independent physical, thermodynamic, and biochemical parameters. The initial model has subsequently been expanded to incorporate Monod kinetics. In this paper, the development and use of the final explicit lumped-parameter biofilter model and design equation, incorporating Monod kinetics, are presented. To facilitate the application of this model, practical procedures are also presented for the determination of VOC solubility, VOC biokinetic Monod parameters, and the maximum practical biofilter inlet VOC concentration.     

Distribution of seven heavy metals among hot pepper plant parts

The main objective of this investigation was to monitor concentrations of seven metals (Cd, Pb, Ni, Mo, Cu, Zn, and Cr) in the fruits, leaves, stem, and roots of Capsicum annuum L. (cv. Xcatic) plants grown under four soil management practices: yard waste (YW), sewage sludge (SS), chicken manure (CM), and no-much (NM) bare soil. Elemental analyses were conducted using inductively coupled plasma mass spectrometer. Pb and Cd concentrations in soil amended with YW, SS, and CM were not significantly different (P < 0.05) compared to NM soil, whereas Mo and Cu concentrations were significantly greater in YW compared to SS, CM, and NM treatments. Concentrations of Cd in the fruits of plants grown in NM soil were greater compared to the fruits of plants grown in other treatments. Total Ni concentration (sum of Ni in all plant parts) in plants grown in NM bare soil was greater than in plants grown in SS-, YW-, and CM-amended soils. Values of the bioaccumulation factor indicated that pepper fruits of plants grown in YW, SS, and CM did not show any tendency to accumulate Pb, Cr, and Ni in their edible fruits.     

A new device for formaldehyde and total aldehydes real-time monitoring

A new sensitive technique for the quantification of formaldehyde (HCHO) and total aldehydes has been developed in order to monitor these compounds, which are known to be involved in air quality issues and to have health impacts. Our approach is based on a colorimetric method where aldehydes are initially stripped from the air into a scrubbing solution by means of a turning coil sampler tube and then derivatised with 3-methylbenzothiazolinone-2-hydrazone in acid media (pH?=??0.5). Hence, colourless aldehydes are transformed into blue dyes that are detected by UV–visible spectroscopy at 630 nm. Liquid core waveguide LCW Teflon® AF-2400 tube was used as innovative optical cells providing a HCHO detection limit of 4 pptv for 100 cm optical path with a time resolution of 15 min. This instrument showed good correlation with commonly used techniques for aldehydes analysis such as DNPH derivatisation chromatographic techniques with off-line and on-line samplers, and DOAS techniques (with deviation below 6 %) for both indoor and outdoor conditions. This instrument is associated with simplicity and low cost, which is a prerequisite for indoor monitoring.     

Modeling the dynamics of DDT in a remote tropical floodplain: indications of post-ban use?

Significant knowledge gaps exist regarding the fate and transport of persistent organic pollutants like dichlorodiphenyltrichloroethane (DDT) in tropical environments. In Brazil, indoor residual spraying with DDT to combat malaria and leishmaniasis began in the 1950s and was banned in 1998. Nonetheless, high concentrations of DDT and its metabolites were recently detected in human breast milk in the community of Lake Puruzinho in the Brazilian Amazon. In this work, we couple analysis of soils and sediments from 2005 to 2014 at Puruzinho with a novel dynamic floodplain model to investigate the movement and distribution of DDT and its transformation products (dichlorodiphenyldichloroethylene (DDE) and dichlorodiphenyldichloroethane (DDD)) and implications for human exposure. The model results are in good agreement with the accumulation pattern observed in the measurements, in which DDT, DDE, and DDD (collectively, DDX) accumulate primarily in upland soils and sediments. However, a significant increase was observed in DDX concentrations in soil samples from 2005 to 2014, coupled with a decrease of DDT/DDE ratios, which do not agree with model results assuming a post-ban regime. These observations strongly suggest recent use. We used the model to investigate possible re-emissions after the ban through two scenarios: one assuming DDT use for IRS and the other assuming use against termites and leishmaniasis. Median DDX concentrations and p,p′-DDT/p,p′-DDE ratios from both of these scenarios agreed with measurements in soils, suggesting that the soil parameterization in our model was appropriate. Measured DDX concentrations in sediments were between the two re-emission scenarios. Therefore, both soil and sediment comparisons suggest re-emissions indeed occurred between 2005 and 2014, but additional measurements would be needed to better understand the actual re-emission patterns. Monte Carlo analysis revealed model predictions for sediments were very sensitive to highly uncertain parameters associated with DDT degradation and partitioning. With this model as a tool for understanding inter-media cycling, additional research to refine these parameters would improve our understanding of DDX fate and transport in tropical sediments.     

Transition to Non-toxic Gunshot Use in Olympic Shooting: Policy Implications for IOC and UNEP in Resolving an Environmental Problem

Olympic shooters discharge, annually, thousands of tons of lead shot which pose toxic risks to animals and may pollute both surface and ground waters. Non-toxic steel shot is an acceptable and effective substitute, but International Shooting Sports Federation (ISSF) rules prevent its adoption. The present policy and rules of the ISSF on lead shot use contravene the International Olympic Committee (IOC) Charter position on environmental protection. The United Nations Environment Programme (UNEP), a formal Olympic partner on environmental protection, has no stated policy on contamination from lead ammunition, despite having declared lead a Priority Area for remedial action, and is pressing to remove lead from the global human environment. The IOC Sport and Environment Commission and UNEP could examine the continued use of lead shot ammunition and advise the IOC Executive Board on appropriate changes in policy and rules that could halt the massive lead shot contamination of shooting range environments world-wide.     

Glucosinolates in collard greens grown under three soil management practices

Glucosinolates (GSLs, β-D-thioglucoside-N-hydroxysulfates) are polar compounds present in varying amounts in members of the Brassicaceae family. They suppress soil-borne pests due to the biofumigant properties of the highly toxic isothiocyanates present in Brassica vegetables. The objectives of this investigation were to: (1) assess variation in GSLs concentrations among collard plants grown under three soil management practices: sewage sludge (SS) mixed with native soil, chicken manure (CM) mixed with native soil, and no-mulch (NM) native soil, (2) quantify GSLs concentrations in collard roots, leaves, and stems at harvest for potential use of their crude extracts in plant protection, and (3) assess myrosinase activity in soil amended with CM and SS mixed with native soil. Separation of GSLs was accomplished by adsorption on a DEAE-Sephadex ion exchange resin using disposable pipette tips filled with DEAE, a weak base, with a net positive charge when ionized and exchange anions such as GSLs (hydrophilic plant secondary metabolites). Quantification of total GSLs was based on inactivation of collard endogenous myrosinase and liberation of the glucose moiety from the GSLs molecule by addition of standardized myrosinase and colorimetric determination of the liberated glucose moiety. Across all treatments, SS and CM increased soil organic matter content from 2.2% in native soil to 4.2 and 6.5%, respectively. GSLs concentrations were significantly greater in collard leaves (30.9 µmoles g^?1 fresh weight) compared to roots and stems (7.8 and 1.2 µmoles g^?1 fresh weight), respectively. Leaves of collard grown in soil amended with SS contained the greatest concentrations of GSLs compared to leaves of plants grown in CM and NM treatments. Accordingly, leaves of collard plants grown in soil amended with SS could play a significant role in sustainable agriculture as alternative tools for soil-borne disease management in conventional and organic agriculture.     

Repellency and oviposition deterrence of wild tomato leaf extracts to spider mites,Tetranychus urticae Koch

Glandular trichomes on the leaves of wild tomato, Lycopersicon hirsutum f. hirsutum Mull, also known as Solanum habrochaites (Solanaceae) synthesize and accumulate high levels of methyl ketones (MKs). The potential of using MKs as alternatives to synthetic acaricides for controlling the twospotted spider mite, Tetranychus urticae Koch, is explored in this study. Plants of L. hirsutum accession LA 407 having high concentrations of MKs were grown from seeds under greenhouse conditions. The main objective of this investigation was to conduct bioassays that are quick and easy to implement, consistent over time (repeatable) with the ability to utilize small amounts of test material for testing repellency and fecundity (number of eggs laid by a female mite) of MKs in pure forms and in LA 407 crude extracts. Four MKs (2-tridecanone, 2-undecanone, 2-dodecanone, 2-pentadecanone) and their mixture were screened for their repellency and ability to alter fecundity of spider mites. All MKs repelled spider mites at the two periods tested. Following spraying of tomato leaf extracts prepared in ethanol (ethanol extracts), average number of eggs laid per female mite on bean leaf discs dropped from 0.8 to 0.3 and from 0.9 to 0.3 at 4 and 24 h after exposure representing 65 and 68% reduction, respectively. However, spraying of tomato leaf extracts prepared in water (water extracts) reduced number of eggs laid per female mite from 1.7 to 0.7 and from 2.6 to 0.9 at 4 and 24 h after exposure representing 60 and 67% reduction, respectively. We concluded that all MKs have repellent and egg laying deterrence activities against spider mites. This investigation suggests that ethanol and water extracts of LA 407 have a potential for repelling female spider mites and reducing their laid eggs which might be explored under field conditions for managing populations of spider mites, which could reduce reliance on synthetic acaricides.     

Kinetics of the oxidation of sucralose and related carbohydrates by ferrate(VI)

The kinetics of the oxidation of sucralose, an emerging contaminant, and related monosaccharides and disaccharides by ferrate(VI) (Fe(VI)) were studied as a function of pH (6.5-10.1) at 25°C. Reducing sugars (glucose, fructose, and maltose) reacted faster with Fe(VI) than did the non-reducing sugar sucrose or its chlorinated derivative, sucralose. Second-order rate constants of the reactions of Fe(VI) with sucralose and disaccharides decreased with an increase in pH. The pH dependence was modeled by considering the reactivity of species of Fe(VI), (HFeO(4)(-) and FeO(4)(2-)) with the studied substrates. Second-order rate constants for the reaction of Fe(VI) with monosaccharides displayed an unusual variation with pH and were explained by considering the involvement of hydroxide in catalyzing the ring opening of the cyclic form of the carbohydrate at increased pH. The rate constants for the reactions of carbohydrates with Fe(VI) were compared with those for other oxidant species used in water treatment and were briefly discussed.