Beach topography mapping—a comparsion of techniques

A comparison of current techniques for measuring elevations in the beach and near-shore zones is presented. Techniques considered include traditional methods such as ground survey along transects and airborne stereophotogrammetry, and also newer methods based on remote sensing such as airborne scanning laser altimetry (LiDAR). The approach taken was to identify a representative group of users of beach elevation data, elicit their requirements regarding these data, then assess how well the different methods met these requirements on both technical and financial grounds. Potential users of beach height measurements include those concerned with coastal defence, coastal environmental management economic exploitation of the intertidal zone, and coastal flood forecasting. Three test areas in the UK were identified covering a range of such users and also different beach types. A total of 17 basic user requirements were elicited. For each requirement each method was scored according to the degree to which it could meet the requirement. Total scores were calculated and each method ranked. This was undertaken for all the requirements together, for a subset relating to survey of narrow beaches, and for a subset relating to survey of wide beaches. Approximate costs were also established for the top six methods. Airborne stereophotogrammetry proved to be the best method technically, but was also the most expensive. Ground survey provides very good technical performance on narrower beaches at moderate cost. Airborne LiDAR can achieve good technical performance on both narrow and wide beaches at lower cost than ground survey. The satellite-based waterline method was also inexpensive and gave good results on wide beaches. An overall conclusion is that, while the traditional methods of ground survey and airborne stereophotogrammetry remain the best for engineering-related surveys requiring high levels of accuracy, airborne LiDAR in particular looks set to have a significant impact on beach survey for applications for which a vertical accuracy of 20 cm is acceptable, provided that its technology evolves satisfactorily.     

An elegant application of appropriate technology: the Sheep Creek Hatchery

Alaska's program for rebuilding salmon stock is calledfishery enhancement. Hatchery technology can produce dramatic increases in numbers of fish homing to selected streams. The Sheep Creek Hatchery is unusually efficient— it increases a fish run by a factor of 3000 and produces salmon at 9–11c/kg by minimizing mechanical energy inputs and human labor. The design harnesses the force of gravity and capitalizes on instinctual behavior of the fish. Since migratory fish collect protein from ocean pasturage, the technology increases the share of this resource collected and concentrated for harvest in a specific country or region. While small seaside hatcheries can solve biological problems of depleted fish stocks, economic and political considerations may preclude efficient utilization of the protein produced. Further, the potential for one state or country to concentrate fish near its shores poses new dilemmas for international regulation of harvests.     

The Cotingo Dam as a test of Brazil's system for evaluating proposed developments in Amazonia

The proposed Cotingo Dam in Brazil's far northern state of Roraima is examined with the objective of drawing lessons for Brazil's system of evaluating environmental, social, and financial consequences of development decisions. The Cotingo Dam illustrates the difficulty of translating into practice the principles of economic and environmental assessment. Examination of the financial arguments for the Cotingo Dam indicates that justifications in this sphere are insufficient to explain why the project is favored over other alternatives and points to political factors as the best explanation of the project's high priority. Strong pressure from political and entrepreneurial interest groups almost invariably dominates decision making in Amazonia. The analysis indicates the inherent tendency of the present system to produce decisions in favor of large construction projects at the expense of the environment and local peoples. The requirements intended to assure proper weight for these concerns, such as the report on environmental impacts (RIMA) and the public hearing, fail to serve this role. Cotingo also provides a test case for constitutional protections restricting construction of dams in indigenous lands.     

Resolving conflicting priorities in Ontario agriculture

Changes in global patterns of grain production have affected the profitability of commercial, cash-crop agriculture in North America. The current financial crisis has highlighted a perceived conflict between the priorities of (1) strengthening net farm profit, (2) maintaining the productive potential of the land base, (3) enhancing the health and cohesiveness of the agricultural community, and (4) addressing societal demands for safe foodstuffs. Reducing input costs by reducing the need for privately owned machinery can minimize the scale-dependence of agricultural practices, as illustrated with examples involving silage and intensively managed pasture in Ontario. This approach could improve farming opportunities for nontraditional, part-time farmers, and at the same time, create a niche for professional custom operators and managers. Enhancing the viability of nontraditional farm operations, a historically neglected component of the farming community, as well as commercial farms is viewed as one approach to sustaining and improving both the agricultural land base and the agricultural community. Applying resource-extensive rather than resource-intensive approaches to forage management reveals that these apparently divergent priorities are, in fact, interlocking pieces of the same puzzle.     

Spectrophotometric determination of sulphur dioxide

Sulphur dioxide, an important industrial gas and air pollutant, is usually estimated using mercury salts. The authors have developed a method in which hazardous mercury salts are avoided. Sulphur dioxide is trapped in aqueous morpholine and mixed with the excess of dichromate solution in acidic medium. The hexavalent chromium in dichromate is reduced to trivalent chromium by sulphur dioxide and the excess of hexavalent chromium is determined with diphenylcarbazide which yields a soluble red-violet complex with an absorption maximum at 540 nm. The decrease in the absorbance values of the red-violet complex formed after reduction, when compared to that of a reagent control, is proportional to the concentration of sulphur dioxide used for reduction. Beer's law operates between 0.4 and 4 microg ml(-1) concentration of sulphur dioxide in solution.     

Removal of BTEX vapor from waste gases by a trickle bed biofilter

The system performance of a trickle bed biofilter for treating single and mixed benzene, toluene, ethylbenzene, and o-xylene (BTEX) vapors from waste gases was investigated under different gas flow rates and influent BTEX concentrations. When a single substrate was fed, removal efficiencies of greater than 90% could be achieved for the loads below 64 g benzene/m3/hr, 110 g toluene/m3/hr, 53 g ethylbenzene/m3/hr, and 55 g o-xylene/m3/hr. When a mixed substrate was fed, removal efficiencies of each compound could be above 90% at BTEX loads below 96 g/m3/hr. The trickle bed biofilter appears to be an effective treatment process for removing both single and mixed BTEX vapors with low to high loads. Under similar substrate loads, BTEX vapors were preferentially biodegraded in the order of toluene, benzene, o-xylene, and ethylbenzene. The volumetric removal rates (elimination capacities) of BTEX vapors for a single-substrate feed were higher than those for a mixed-substrate feed under similar substrate loads; these differences were enhanced at higher substrate loads and less significant for a preferred substrate.     

Characterization of biomass pyrolysis vapors with molecular beam, single photon ionization time-of-flight mass spectrometry

A single photon ionization, molecular beam sampling, reflectron time-of-flight mass spectrometer (SPI/MBTOFMS) has been developed and used to study pyrolysis products from a selection of biomass materials. Spectra are characterized by high resolution and decreased fragmentation compared to electron-impact ionization mass spectra from related molecular beam mass spectrometer systems equipped with quadrupole mass analyzers.     

Variability of pesticide residues in cauliflower units collected from a field trial and market places in Greece

To estimate the variability of pesticide residue levels present in cauliflower units, a total of 142 samples were collected from a field trial of a cooperative farmer, and 120 samples were collected from different market places in Thessaloniki, Greece. The collected samples were extracted using the quick, easy, cheap, effective, rugged, and safe (QuEChERS) extraction technique, and the residues were determined by liquid chromatography–tandem mass spectrometry. The developed method was validated by evaluating the accuracy, precision, linearity, limit of detection (LOD), and limit of quantification (LOQ). The average recoveries for all the analytes, derived from the data of control samples fortified at 0.01, 0.05, 0.1, and 0.2 mg/kg, ranged from 74 to 110% with a relative standard deviation of ≤8%. The correlation coefficient (R²) was ≥0.997 for all the analytes using matrix-matched calibration standards. The LOD values ranged from 0.001 to 0.003 mg/kg, and the LOQ was determined at 0.01 mg/kg for all the sought analytes. The matrix effect was found to be at a considerable level, especially for cypermethrin and deltamethrin, amounting to +90% and +145%, respectively. For the field samples, the unit-to-unit variability factors (VFs) calculated for cypermethrin and deltamethrin were 2.38 and 2.32, respectively, while the average VF for the market basket samples was 5.11. In the market basket samples, residues of cypermethrin, deltamethrin, chlorpyrifos, and indoxacarb were found at levels ≥LOQ and their respective VFs were 7.12, 5.67, 5.28, and 2.40.     

Occurrence of UV filter compounds from sunscreens in surface waters: regional mass balance in two Swiss lakes

Consumer care products often contain UV filters, organic compounds which absorb ultraviolet light. These compounds may enter surface waters directly (when released from the skin during swimming and bathing) or indirectly via wastewater treatment plants (when released during showering or washed from textiles). Predicted and measured UV filter concentrations were compared in a regional mass balance study for two Swiss lakes: Lake Zurich, a typical midland lake which is also an important drinking water resource, and Hüttnersee, a small bathing lake. Both lakes are extensively used for recreational activities and considerable direct input of UV filters is thus expected. This input was estimated from the number of visitors at swimming areas around the lakes and a survey of the usage of sunscreen products among these visitors. Possible additional indirect input via wastewater treatment plants was not considered in this study. The quantitatively most important UV filters, as indicated by the survey data, ethylhexyl methoxycinnamate, octocrylene, 4-methylbenzylidene camphor, butyl methoxydibenzoylmethane, and benzophenone-3, all lipophilic compounds, were selected for analysis by gas chromatography-mass spectrometry. Concentrations of individual UV filters in water from Lake Zurich were low, ranging from <2 ng l(-1) (detection limit) to 29 ng l(-1), and somewhat higher at Hüttnersee, ranging from <2 to 125 ng l(-1), with the highest concentrations found in summer, consistent with direct inputs to the lakes during this time. The concentrations were clearly lower than predicted from input estimates based on the surveys. This may be in part due to (i) an overestimation of these inputs (e.g. less than the 50% wash-off of UV filters assumed to occur during swimming), and (ii) some removal of these compounds from the lakes by degradation and/or sorption/sedimentation. UV filters were also detected in semipermeable membrane devices (SPMDs) deployed at Lake Zurich and Greifensee, another midland lake, at concentrations of 80-950 ng SPMD(-1), confirming the presence of the compounds in surface waters and indicating a certain potential for bioaccumulation. SPMD-derived water concentrations were in the range of 1-10 ng l(-1) and thus corresponded well with those determined in water directly. No UV filters were detected above blank levels in SPMDs deployed at a remote mountain lake used for background measurements.