Influence of hydrogeochemical processes on zero-valent iron reactive barrier performance: a field investigation

Geochemical and mineralogical changes were evaluated at a field Fe0-PRB at the Oak Ridge Y-12 site concerning operation performance during the treatment of U in high NO3- groundwater. In the 5-yr study period, the Fe0 remained reactive as shown in pore water monitoring data, where increases in pH and the removal of certain ionic species persisted. However, coring revealed varying degrees of cementation. After 3.8-yr treatment, porosity reduction of up to 41.7% was obtained from mineralogical analysis on core samples collected at the upgradient gravel-Fe0 interface. Elsewhere, Fe0 filings were loose with some cementation. Fe0 corrosion and pore volume reduction at this site are more severe due to the presence of NO3- at a high level. Tracer tests indicate that hydraulic performance deteriorated: the flow distribution was heterogeneous and under the influence of interfacial cementation a large portion of water was diverted around the Fe0 and transported outside the PRB. Based on the equilibrium reductions of NO3- and SO4(2-) by Fe0 and mineral precipitation, geochemical modeling predicted a maximum of 49% porosity loss for 5 yr of operation. Additionally, modeling showed a spatial distribution of mineral precipitate volumes, with the maximum advancing from the interface toward downgradient with time. This study suggests that water quality monitoring, coupled with hydraulic monitoring and geochemical modeling, can provide a low-cost method for assessing PRB performance.     

Tylosin sorption to silty clay loam soils, swine manure, and sand

The objectives of this study were to assess sorption and desorption of tylosin, a macrolide antimicrobial chemical used in swine, cattle, and poultry production, in three silty clay loam soils of South Dakota and compare soil sorption to sand and manure sorption. The silty clay loam soils, from a toposequence in eastern South Dakota, standardized sand samples, and swine manure were used in 24-h batch sorption studies with tylosin concentrations ranging from 25 to 232 micro mole/L. Desorption from soil was conducted over a four-day period. Partition coefficients, based on the Freundlich isotherm (K(f)) or K(d) values, were calculated. K(f) values for the silty clay loams were similar, not influenced by landscape position, and averaged 1,350 with isotherm slopes ranging from 0.85 to 0.93. K(f) values for sand were dependent on solution/sand ratios and pH, ranging from 1.4 to 25.1. K(d) values of manure were dependent on the solution type and ranged from 840 L/kg with urine to about 175 L/kg when sorbed from water. Desorption of tylosin from each soil over the four-day period was < 0.2% of the amount added. The soils' high K(f) values and low desorption amounts suggest that once tylosin is in these soils, leaching to lower depths may not occur. However, this does not preclude runoff with soil eroded particles. If tylosin reaches a sand aquifer, through bypass flow or other mechanism(s), movement in the aquifer most likely would occur.     

Predictions by the Odor From Feedlots, Setback Estimation Tool (OFFSET) compared with observations by neighborhood monitors

A comparison between predicted and observed odor intensities at 20 neighborhood residences in the vicinity of seven various livestock farms in five different Minnesota counties was made to evaluate the Odor From Feedlots, Setback Estimation Tool (OFFSET) developed by the University of Minnesota. Observations by neighborhood monitors suggest that the OFFSET-predicted separation distances for annoyance-free frequencies of 99, 98, and 97% are large enough. The observations additionally indicate that predicted distances to obtain 94 and 91% annoyance-free frequencies may be large enough for some farms, but for other farms, greater distances may be needed. For two farms in the study, no significant difference between all of the observed and predicted intensities could be found. At four sites, a significant difference was found, and at three of these the difference was considerable. Odor emission rates used in the OFFSET model seem to describe the average emission fairly well for many odor sources, but improvement may be needed for some types of sources. Possible reasons for observations of annoying odor when not predicted include fluctuations in the odor emissions, wind speed fluctuations, topographic variation between sites, sensitivity differences by neighborhood monitors, and background emissions from other sources.     

Inter- and intra-species variation in acute zinc tolerance of field-collected cladoceran populations

Acute zinc toxicity was assessed for 10 freshwater cladoceran species collected in six different ecosystems across Europe and for two standard laboratory-reared species (Daphnia magna and Ceriodaphnia dubia). The collected organisms belonged to five different genera: Daphnia (subgenus Daphnia and Ctenodaphnia), Ceriodaphnia, Simocephalus, Acroperus and Chydorus. The 48-h EC50 of the field-collected organisms tested in standard laboratory water ranged from 375+/-141 to 4314+/-1513 microg Znl(-1). The laboratory clone of D. magna was less sensitive than the majority of the field-collected species, while our laboratory Ceriodaphnia dubia was the second most sensitive. Considerable inter-species variation was found within the genus of Ceriodaphnia (factor 6) and within the genus Daphnia (factor 8). Among the different (sub)genera tested, Chydorus and Ctenodaphnia were significantly more tolerant than the others (up to a factor 3 difference). A significant positive relationship (r2=0.67, p<0.05) between the mean cladoceran 48-h EC50 and the ambient zinc concentration of the different aquatic systems was demonstrated, suggesting a role of acclimation and/or adaptation. No significant correlation between the acute zinc tolerance and the length of the organisms was found.     

Laboratory evaluation of thermophilic-anaerobic digestion to produce Class A biosolids. 2. Inactivation of pathogens and indicator organisms in a continuous-flow reactor followed by batch treatment.

Thermophilic-anaerobic digestion in a single-stage, mixed, continuous-flow reactor is not approved in the United States as a process capable of producing Class A biosolids for land application. This study was designed to evaluate the inactivation of pathogens and indicator organisms in such a reactor followed by batch treatment in a smaller reactor. The combined process was evaluated at 53 degrees C with sludges from three different sources and at 51 and 55 degrees C with sludge from one of the sources. Feed sludge to the continuous-flow reactor was spiked with the pathogen surrogates Ascaris suum and vaccine-strain poliovirus. Feed and effluent were analyzed for these organisms and for indigenous Salmonella spp., fecal coliforms, Clostridium perfringens spores, and somatic and male-specific coliphages. No viable Ascaris eggs were observed in the effluent from the continuous reactor at 53 or 55 degrees C, with greater than 2-log removals across the digester in all cases. Approximately 2-log removal was observed at 51 degrees C, but all samples of effluent biosolids contained at least one viable Ascaris egg at 51 degrees C. No viable poliovirus was found in the digester effluent at any of the operating conditions, and viable Salmonella spp. were measured in the digester effluent in only one sample throughout the study. The ability of the continuous reactor to remove fecal coliforms to below the Class A monitoring limit depended on the concentration in the feed sludge. There was no significant removal of Clostridium perfringens across the continuous reactor under any condition, and there also was limited removal of somatic coliphages. The removal of male-specific coliphages across the continuous reactor appeared to be related to temperature. Overall, at least one of the Class A pathogen criteria or the fecal coliform limit was exceeded in at least one sample in the continuous-reactor effluent at each temperature. Over the range of temperatures evaluated, the maximum time required to meet the Class A criteria by batch treatment of the continuous-reactor effluent was 1 hour for Ascaris suum and Salmonella spp. and 2 hours for fecal coliforms.     

Dicarboxylic acid concentration trends and sampling artifacts

Dicarboxylic acids associated with airborne particulate matter were measured during a summer period in Philadelphia that included multiple air pollution episodes. Samples were collected for two 10 h periods each day using a high-volume sampler with two quartz fiber filters in series, and analyzed by gas chromatography mass spectrometry (GCMS) with diazomethane derivatization. Among the dicarboxylic acids investigated, phthalic acid and adipic acid exhibited the greatest diurnal variations and the strongest linear relationship with maximum daily ozone concentration. Dicarboxylic acids and ozone concentration exhibited a poor linear relationship with organic to elemental carbon ratio. All species investigated were affected by significant sampling artifact errors at low concentrations, but sampling errors were negligible at high concentrations observed during ozone episodes.     

Applicability of Fenton and H2O2/UV reactions in the treatment of tannery wastewaters

In this paper we evaluated the H2O2/UV and the Fenton's oxidation processes for the treatment of tannery wastewater under different experimental conditions. Efficiencies were judged by the amounts of organic substances degraded or eliminated under these treatment techniques. Daphnia magna and Vibrio fischeri were used to monitor toxicity. Organic compounds contained in the untreated and treated tannery wastewater were determined and identified using substance specific techniques. Gas chromatography-mass spectrometry (GC-MS) in positive electron impact (EI(+)) mode was applied to determine volatile organics. Atmospheric pressure ionization (API) mass (MS) and tandem mass spectrometry (MS-MS) coupled with flow injection analysis (FIA) or liquid chromatography (LC) were used to detect or identify polar organic pollutants. The experimental results indicated that both oxidation processes--H2O2/UV at pH 3 and Fenton at pH 3.5--are able to reduce TOC content by mineralisation of the organic compounds.     

Graduate Education for Air Pollution Control Personnel

Tendergreen bean plants were grown from seeding to seed maturity under continuous exposure to HF gas at fairly uniform concentrations averaging 0.58, 2.1, 9.1, and 10.5 µg F/m³. Progeny of these plants and of comparable control plants were grown in a clean atmosphere to determine if subsequent generations were affected by HF treatment of the parents.

No effects of HF were found among the progeny of the plants grown at 0.58 µg F/m³. The F₁ generation progeny of the other HF treated plants were less vigorous than control plant progeny, as shown by later emergence, smaller primary leaves, and slower stem growth. This probably was a consequence of the lower starch content of the seed of the HF treated plants. The primary leaves of some F₁ progeny of the plants grown in the three highest HF treatments were severely stunted and distorted. This also may have been due to the low starch content of the seed, or perhaps it resulted from damage to the plumules in shriveled, distorted seed produced in these treatments.

Some of the early trifoliate leaves of many F₁ generation progeny of the plants grown at 2.1 µg F/m³ and higher were abnormal in the separation and number of their leaflets. This abnormality apparently was heritable, for in the next (F₂) generation it occurred most frequently among plants whose parents were abnormal. However, considerably fewer F₃ generation plants had abnormal trifoliate leaves, indicating rapid reversal to the normal form.     

The Radial Distribution of Sulfur Dioxide Source Strength and Concentration in Nashville

This progress report describes the National Air Pollution Technical Information Center currently under development in the Division of Air Pollution, Public Health Service. It briefly reviews the report "Science, Government, and Information" (Weinberg Report) and the White House delegation of responsibility to the Department of Health, Education, and Welfare for handling air pollution technical information.     

Pencycuron application to soils: degradation and effect on microbiological parameters

Clay loam soil from agricultural fields of alluvial (AL) soil (typic udifluvent) and coastal saline (CS) soil (typic endoaquept) were investigated for the degradation and effect of pencycuron application at field rate (FR), 2-times FR (2FR) and 10-times FR (10FR) with and without decomposed cow manure (DCM) on soil microbial variables under laboratory conditions. Pencycuron degraded faster in CS soil and in soil amended with DCM. Pencycuron spiking at FR and 2FR resulted in a short-lived (in case of 10FR slightly longer) and transitory toxic effect on soil microbial biomass-C (MBC), ergosterol content and fluorescein diacetate hydrolyzing activity (FDHA). Amendment of DCM did not seem to have any counteractive effect of the toxicity of pencycuron on the microbial variables. The ecophysiological status of the soil microbial communities as expressed by microbial metabolic quotient (qCO2) and microbial respiration quotient (Q(R)) changed, but for a short period, indicating pencycuron induced disturbance. The duration of this disturbance was slightly longer at 10FR. Pencycuron was more toxic to the metabolically activated soil microbial populations, specifically the fungi. It is concluded that side effects of pencycuron at 10FR on the microbial variables studied were only short-lived and probably of little ecological significance.