Prospects for Exhaust Control by Engine Modification

In order to assist in assessing potential odor problems arising from chemical manufacturing operations, the odor thresholds of 53 commercially important odorant chemicals have been determined using a standardized and defined procedure. The odor threshold data previously available have shown wide variation reflecting the diversity of procedures and techniques used. Factors that may affect the odor threshold measurement include the mode of presentation of the stimulus to the observer, the influence of extraneous odorants in the presentation system, the type of observer used, the definition of the odor response, the treatment of the data obtained, and the chemical purity of the odorant. The experimental approach used has minimized these variations. The odorants were presented to a trained odor panel in a static air system utilizing a low odor background air as the dilution medium. The odor threshold is defined as the first concentration at which all panel members can recognize the odor. The effect of chemical purity has been determined by measuring the odor threshold of materials representing different modes of manufacture or after purification by gas chromatographic procedures. The threshold concentrations range over six orders of magnitude. Trimethylamine exhibited the lowest threshold (0.00021 ppm volume); methylene chloride was not recognizable below 214 ppm. Of the 53 chemicals, sulfur bearing compounds exhibit low threshold values on the order of parts per billion. Aside from the sulfides, it is not possible to anticipate the odor threshold of a material based on its chemical structure or functionality.     

Effects of Constant versus Diurnally-Varying Light Intensity on Ozone Formation

Abstract

1-Bromo-propane (1-BP) is a replacement for high-end chlorofluorocarbon (HCFC) solvents. Its reaction rate constant with the OH radical is, on a weight basis, significantly less than that of ethane. However, the overall smog formation chemistry of 1-BP appears to be very unusual compared with typical volatile organic compounds (VOCs) and relatively complex because of the presence of bromine. In smog chamber experiments, 1-BP initially shows a faster ozone build-up than what would be expected from ethane, but the secondary products containing bromine tend to destroy ozone such that 1-BP can have a net overall negative reactivity. Alternative sets of reactions are offered to explain this unusual behavior. Follow-up studies are suggested to resolve the chemistry. Using one set of bromine-related reactions in a photo-chemical grid model shows that 1-BP would be less reactive toward peak ozone formation than ethane with a trend toward even lower ozone impacts in the future.     

Degradation of atrazine,metolachlor, and pendimethalin in pesticide‐contaminated soils: Effects of aged residues on soil respiration and plant survival

Abstract

This study was conducted to determine the effects of pesticide mixtures on degradation patterns of parent compounds as well as effects on soil microbial respiration. Bioavailability of residues to sensitive plant species was also determined. Soil for this study was obtained from a pesticide‐contaminated area within an agrochemical dealer site. Degradation patterns were not affected by the presence or absence of other herbicides in this study. Atrazine concentrations were significantly lower at 21 through 160 days aging time compared to day 0 concentrations. Metolachlor and pendimethalin concentrations were not significantly different over time and remained high throughout the study. Microbial respiration was suppressed in treated soils from day 21 to day 160. Soybean and canola were the most successful plant species in the germination and survival tests. Generally, with increased aging of pesticides in soil, germination time decreased. Survival time of plants increased over time for some treatments indicating possible decreased bioavailability of pesticide residues. In some cases, survival time decreased at the longer 160‐day aging period, possibly indicating a change in bioavailability, perhaps as the result of formation of more bioavailable and phytotoxic metabolites. No interactive effects were noted for mixtures of pesticides compared to individually applied pesticides in terms of degradation of the parent compound or on seed germination, plant survival, or microbial respiration.     

Cutleaf coneflower (Rudbeckia laciniata L.) response to ozone and ethylenediurea (EDU)

Cutleaf coneflower (Rudbeckia laciniata L.) seedlings were placed into open-top chambers in May, 2004 and fumigated for 12 wks. Nine chambers were fumigated with either carbon-filtered air (CF), non-filtered air (NF) or twice-ambient (2×) ozone (O₃). Ethylenediurea (EDU) was applied as a foliar spray weekly at 0 (control), 200, 400 or 600 ppm. Foliar injury occurred at ambient (30%) and elevated O₃ (100%). Elevated O₃ resulted in significant decreases in biomass and nutritive quality. Ethylenediurea reduced percent of leaves injured, but decreased root and total biomass. Foliar concentrations of cell-wall constituents were not affected by EDU alone; however, EDU × O₃ interactions were observed for total cell-wall constituents and lignocellulose fraction. Our results demonstrated that O₃ altered the physiology and productivity of cutleaf coneflower, and although reducing visible injury EDU may be phytotoxic at higher concentrations.     

Impact of Dredging on Phosphorus Transport in Agricultural Drainage Ditches of the Atlantic Coastal Plain1

Abstract: Drainage ditches can be a key conduit of phosphorus (P) between agricultural soils of the Atlantic Coastal Plain and local surface waters, including the Chesapeake Bay. This study sought to quantify the effect of a common ditch management practice, sediment dredging, on fate of P in drainage ditches. Sediments from two drainage ditches that had been monitored for seven years and had similar characteristics (flow, P loadings, sediment properties) were sampled (0‐5 cm) after one of the ditches had been dredged, which removed fine textured sediments (clay = 41%) with high organic matter content (85 g/kg) and exposed coarse textured sediments (clay = 15%) with low organic matter content (2.2 g/kg). Sediments were subjected to a three‐phase experiment (equilibrium, uptake, and release) in recirculating 10‐m‐long, 0.2‐m‐wide, and 5‐cm‐deep flumes to evaluate their role as sources and sinks of P. Under conditions of low initial P concentrations in flume water, sediments from the dredged ditch released 13 times less P to the water than did sediments from the ditch that had not been dredged, equivalent to 24 mg dissolved P. However, the sediments from the dredged ditch removed 19% less P (76 mg) from the flume water when it was spiked with dissolved P to approximate long‐term runoff concentrations. Irradiation of sediments to destroy microorganisms revealed that biological processes accounted for up to 30% of P uptake in the coarse textured sediments of the dredged ditch and 18% in the fine textured sediments of the undredged ditch. Results indicate that dredging of coastal plain drainage ditches can potentially impact the P buffering capacity of ditches draining agricultural soils with a high potential for P runoff.     

A Study of Sulfur Dioxide in Photochemical Smog I. Effect of SO2 and Water Vapor Concentration in the 1-Butene/NOx/SO2 System

There is an appreciable chemical interaction between SO₂ and photochemical smog which depends on the concentration of SO₂ and water vapor. The rate of decay of SO₂ concentration is greatly increased in the presence of photochemical smog. With 0.75 ppm SO₂, a light-scattering aerosol is produced in dry systems and systems at 22 and 55% relative humidity (RH). Aerosol is not observed until after the NO₂ peak has been reached and the NO concentration has fallen to a very low value. The formation of aerosol corresponds in time to the region of most rapid decrease in the SO₂ profile. In systems at 65% RH or with smaller amounts of SO₂, no light scattering is observed, but the percentage of SO₂ disappearing is greater. In relatively dry systems the presence of SO₂ results in a general slowing down of the photochemical smog reactions. In systems containing water vapor concentrations comparable to those found in the atmosphere, the inhibiting influence of SO₂ on the smog reaction is less pronounced. However, the maximum concentration of oxidant produced by the photochemical smog reactions is significantly lower when SO₂ is present.     

The Stack Height Requirements Implicit In the Federal Standards of Performance For New Stationary Sources

The promulgation of Federal standards of performance for certain classes of new stationary sources requires that such sources have minimum stack heights to meet also the requirements of national air quality standards. The determination of minimum stack height is complicated by the fact that the performance and air quality standards are stated on different averaging time bases; that the extent of preemption of the assimilative capacity of the air by any individual source will vary among jurisdictions and, in some cases, among different geographic areas of a single jurisdiction; and that some new sources will be designed to emit appreciably less than the performance standard requirement. However, these complications can be resolved and equations and charts prepared from which minimum stack height can be selected.     

Development of a High Purity Filter for High Temperature Particulate Sampling and Analysis

This paper is directed to those interested in measuring trace metals in high-temperature particulate emissions. Particulate handsheet filters with satisfactory purity, efficiency, thermal stability, cost, strength (about 1 lb/in.), and flexibility for analysis of particulates in gases up to 800°C have been made with 99.2% Si0₂ Microquartzfibers. Almost all purity requirements for optimum atomic absorption and flame emission spectrophotometric analysis for trace metals have been achieved. The filters appear highly promising for X-ray fluorescence analysis but should be further evaluated. Suitability of the filters for neutron activation analysis is uncertain and should also be further evaluated. Dioctyl phthal-ate (DOP) aerosol efficiencies of 99 to 99.99% have been achieved by using fibers of various diameters. The filters are insensitive to humidity, insoluble In most acids and organic solvents. The handsheet filters have a slightly alkaline pH, but similar filters have been made on a papermaking machine with a pH of 6.4. Cost is estimated to be about $2.00/ft².