Neurophysiological Effects Induced in the Nervous Tissue by Low-Frequency, Pulsed Magnetic Fields

Summary The influence of pulsed magnetic fields (PMF) on the properties of nervous tissue was investigated. Hippocampal slices or synaptosomes obtained from hippocampal tissue were used as model systems. The amplitude of potentials recorded in vitro from one of the hippocampal pathways (Schaffer collaterals that use glutamate as a neurotransmitter) was employed as a measure of the influence of magnetic fields on synaptic efficiency. The synaptic glutamate turnover and radioactive calcium accumulation were used as markers of the PMF influence on biochemistry of synaptic mechanisms. The exposure of hippocampal slices for 30 min to PMF amplified evoked potentials. While the frequency of 0.16 Hz exerted the strongest effect, lower (0.01, 0.07, 0.03 Hz) and higher (0.5 Hz) frequencies were much less effective. The enhancement of the neuronal excitability was correlated with significant increase in the neuronal spontaneous activity mediated by electrical synapses. The PMF-induced changes in the excitability of the tissue were accompanied by an increase in the synaptic turnover of glutamate. The release of radioactive D-Aspartate (a glutamate analog used as a marker for glutamate turnover) from the slices, and its uptake by synaptosomes were enhanced, and reduced respectively, following the stimulation with pulsed magnetic fields. The frequency which was the most efficient in amplification of evoked potentials (0.16 Hz) was also the most effective in the modulation of the release and uptake processes. The PMF-induced changes in neurotransmitter turnover coincided with an increase in ⁴⁵Ca²⁺ accumulation observed in hippocampal slices exposed to PMF.     

Use of Microbial Community to Evaluate Performance of a Wetland System in Treating Pb/Zn Mine Drainage

The performance of a wetland system in treating lead (Pb)/zinc (Zn) mine drainage was evaluated by using the polyurethane foam unit (PFU) microbial community (method), which has been adopted by China as a standardized procedure for monitoring water quality. The wetland system consisted of four cells with three dominant plants: Typha latifolia, Phragmites australis and Paspalum distichum. Physicochemical characteristics [pH, EC, content of total suspended solid (TSS) and metals (Pb, Zn, Cd, and Cu)] and PFU microbial community in water samples had been investigated from seven sampling sites. The results indicated that the concentrations of Pb, Zn, Cd, Cu, and TSS in the mine drainage were gradually reduced from the inlet to the outlet of the wetland system and 99%, 98%, 75%, 83%, and 68% of these metals and TSS respectively, had been reduced in concentration after the drainage passed through the wetland system. A total of 105 protozoan species were identified, the number of protozoa species and the diversity index (DI) gradually increased, while the heterotrophic index (HI) gradually decreased from the inlet to the outlet of the wetland system. The results indicated that DI, HI, and total number species of protozoa could be used as biological indicators indicating the improvement of water quality.     

Hot Spots of Perforated Forest in the Eastern United States

National assessments of forest fragmentation satisfy international biodiversity conventions, but they do not identify specific places where ecological impacts are likely. In this article, we identify geographic concentrations (hot spots) of forest located near holes in otherwise intact forest canopies (perforated forest) in the eastern United States, and we describe the proximate causes in terms of the nonforest land-cover types contained in those hot spots. Perforated forest, defined as a 0.09-ha unit of forest that is located at the center of a 7.29-ha neighborhood containing 60–99% forest with relatively low connectivity, was mapped over the eastern United States by using land-cover maps with roads superimposed. Statistically significant (P < 0.001) hot spots of high perforation rate (perforated area per unit area of forest) were then located by using a spatial scan statistic. Hot spots were widely distributed and covered 20.4% of the total area of the 10 ecological provinces examined, but 50.1% of the total hot-spot area was concentrated in only two provinces. In the central part of the study area, more than 90% of the forest edge in hot spots was attributed to anthropogenic land-cover types, whereas in the northern and southern parts it was more often associated with seminatural land cover such as herbaceous wetlands.     

In situ ground water denitrification in stratified, permeable soils underlying riparian wetlands

The ground water denitrification capacity of riparian zones in deep soils, where substantial ground water can flow through low-gradient stratified sediments, may affect watershed nitrogen export. We hypothesized that the vertical pattern of ground water denitrification in riparian hydric soils varies with geomorphic setting and follows expected subsurface carbon distribution (i.e., abrupt decline with depth in glacial outwash vs. negligible decline with depth in alluvium). We measured in situ ground water denitrification rates at three depths (65, 150, and 300 cm) within hydric soils at four riparian sites (two per setting) using a 15N-enriched nitrate "push-pull" method. No significant difference was found in the pattern and magnitude of denitrification when grouping sites by setting. At three sites there was no significant difference in denitrification among depths. Correlations of site characteristics with denitrification varied with depth. At 65 cm, ground water denitrification correlated with variables associated with the surface ecosystem (temperature, dissolved organic carbon). At deeper depths, rates were significantly higher closer to the stream where the subsoil often contains organically enriched deposits that indicate fluvial geomorphic processes. Mean rates ranged from 30 to 120 microg N kg(-1) d(-1) within 10 m versus <1 to 40 microg N kg(-1) d(-1) at >30 m from the stream. High denitrification rates observed in hydric soils, down to 3 m within 10 m of the stream in both alluvial and glacial outwash settings, argue for the importance of both settings in evaluating the significance of riparian wetlands in catchment-scale N dynamics.     

Atrazine sorption-desorption hysteresis by sugarcane mulch residue

Sorption and desorption kinetics are essential components for modeling the movement and retention of applied agricultural chemicals in soils and the fraction of chemicals susceptible to runoff. In this study, we investigated the retention characteristics of sugarcane (Saccharum spp. hybrid) mulch residue for atrazine (2-chloro-4-ethylamino-6-isopropylamino-1,3,5-triazine) based on studies of sorption-desorption kinetics. A sorption kinetic batch method was used to quantify retention of the mulch residue for a wide range of atrazine concentrations and reaction times. Desorption was performed following 504 h of sorption using successive dilutions, followed by methanol extraction. Atrazine retention by the mulch residue was well described using a linear model where the partitioning coefficient (K(d)) increased with reaction time from 10.40 to 23.4 cm3 g(-1) after 2 and 504 h, respectively. Values for mulch residue K(d) were an order of magnitude higher than those found for Commerce silt loam (fine-silty, mixed, superactive, nonacid, thermic Fluvaquentic Endoaquepts) where the sugarcane crop was grown. A kinetic multireaction model was successful in describing sorption behavior with reaction time. The model was equally successful in describing observed hysteretic atrazine behavior during desorption for all input concentrations. The model was concentration independent where one set of model parameters, which was derived from all batch results, was valid for the entire atrazine concentration range. Average atrazine recovery following six successive desorption steps were 63.67 +/- 4.38% of the amount adsorbed. Moreover, a hysteresis coefficient based on the difference in the area between sorption and desorption isotherms was capable of quantifying hysteresis of desorption isotherms.     

Sustainable land application: an overview

Man has land-applied societal nonhazardous wastes for centuries as a means of disposal and to improve the soil via the recycling of nutrients and the addition of organic matter. Nonhazardous wastes include a vast array of materials, including manures, biosolids, composts, wastewater effluents, food-processing wastes, industrial by-products; these are collectively referred to herein as residuals. Because of economic restraints and environmental concerns about land-filling and incineration, interest in land application continues to grow. A major lesson that has been learned, however, is that the traditional definition of land application that emphasizes applying residuals to land in a manner that protects human and animal health, safeguards soil and water resources, and maintains long-term ecosystem quality is incomplete unless the earning of public trust in the practices is included. This overview provides an introduction to a subset of papers and posters presented at the conference, "Sustainable Land Application," held in Orlando, FL, in January 2004. The USEPA, USDA, and multiple national and state organizations with interest in, and/or responsibilities for, ensuring the sustainability of the practice sponsored the conference. The overriding conference objectives were to highlight significant developments in land treatment theory and practice, and to identify future research needs to address critical gaps in the knowledge base that must be addressed to ensure sustainable land application of residuals.     

Explaining the Performance of Mature Municipal Solid Waste Recycling Programs

This paper assesses the contextual, programmatic and decision-making factors that affect the performance of mature municipal solid waste recycling programs. Tobit models were prepared for cities with populations of less than or more than 25?000 to facilitate analysis of recycling performance. Recycling participation rates were found to be higher among cities in both groups that offered more convenient recycling programs and whose residents had a higher mean household income. The larger cities that achieved higher participation rates employed a decision-making process known as ‘collaborative learning’, imposed sanctions on improper sorting recyclable materials, and had a larger non-minority population. Among smaller cities, higher participation was attained by using variable fee pricing for solid waste collection and by mandating household participation. The study findings suggest that future research should focus on improved ways to characterize and measure the decision-making processes used to make policy changes in order to facilitate analysis of the causal and temporal relationships between decision-making processes and program performance.     

Community-based Environmental Planning: Operational Dilemmas,Planning Principles and Possible Remedies

The operational dilemmas and challenges associated with the practice of community-based environmental planning (CBEP) are examined. The paper examines the frequently invoked ‘bottom-up’ versus ‘top-down’ dichotomy and argues that environmental governance is more complex, dynamic and multi-scalar than this simple dichotomy implies. The paper identifies six key problems with the CBEP approach: (i) the conceptualization of ‘community’ which poorly accounts for difference; (ii) problems of inequality; (iii) the organizational capacity and efficacy of community groups; (iv) the scale of CBEP; (v) the types of knowledge utilized by communities in environmental management; and (vi) the potential for parochial concerns to dominate the priorities and agenda of community organizations. The paper analyses each of these issues, identifies planning principles that may aid resolution, and suggests possible remedies.     

Equilibrium and kinetic studies on biosorption of Hg(II), Cd(II) and Pb(II) ions onto microalgae Chlamydomonas reinhardtii

The microalgae Chlamydomonas reinhardtii was used for the biosorption of Hg(II), Cd(II) and Pb(II) ions. The maximum adsorption of Hg(II) and Cd(II) ions on Chlamydomonas reinhardtii biomass was observed at pH 6.0 and the corresponding value for Pb(II) ions was 5.0. The biosorption of Hg(II), Cd(II) and Pb(II) ions by microalgae biomass increased as the initial concentration of Hg(II), Cd(II) and Pb(II) ions increased in the biosorption medium. The maximum biosorption capacities of microalgae for Hg(II), Cd(II) and Pb(II) ions were 72.2+/-0.67, 42.6+/-0.54 and 96.3+/-0.86 mg/g dry biomass, respectively. The affinity order for algal biomass was Pb(II)>Hg(II)>Cd(II). FT-IR analysis of algal biomass revealed the presence of amino, carboxyl, hydroxyl and carbonyl groups, which were responsible for biosorption of metal ions. Biosorption equilibrium was established in about 60 min and the equilibrium was well described by the Freundlich biosorption isotherms. Temperature change in the range of 5-35 degrees C did not affect the biosorption capacity. The microalgae could be regenerated using 0.1 M HCl, with up to 98% recovery, which allowed the reuse of the biomass in six biosorption-desorption cycles without any considerable loss of biosorption capacity.