Effects of metal cations on sorption-desorption of p-nitrophenol onto wheat ash

The mutual e ects of metal cations (Cu2+, Pb2+, Zn2+, and Cd2+) and p-nitrophenol (NP) on their adsorption desorption behavior onto wheat ash were studied. Results suggested that Cu2+, Pb2+, and Zn2+ diminished the adsorption and increased the desorption of NP remarkably, while Cd2+ had no such e ect. In contrast, NP diminished the adsorption of Cu2+, Pb2+, and Zn2+ onto ash, however, this suppression e ect depended on the initial concentrations of metal cations. NP had no e ect on Cd2+ adsorption on ash. Fourier transform infrared (FT-IR) and X-ray absorption spectroscopic (XAS) studies suggested the following mechanisms responsible for the metal suppression e ect on NP adsorption: (1) large hydrated Cu2+, Pb2+, and Zn2+ shells occupied the surface of ash and prevent nonspecific adsorption of NP onto ash surface; (2) Cu2+, Pb2+, and Zn2+ may block the micropores of ash, resulting in decreased adsorption of NP; (3) complexation of Cu2+, Pb2+, and Zn2+ was likely via carboxyl, hydroxylic and phenolic groups of wheat ash and these same groups may also react with NP during adsorption. As a “soft acid”, Cd2+ is less e cient in the complexation of oxygencontaining acid groups than Cu2+, Pb2+, and Zn2+. Thus, Cd2+ had no e ect on the adsorption of NP on wheat ash.     

医疗废物焚烧过程中脱氯机理和试验

医疗废物中包括含有大量的PVC,焚烧时会产生HCl从而污染环境,因此医疗废物在焚烧处理时需要进行脱氯。经热力学计算可知,医疗废物焚烧炉内喷入脱氯吸收剂在燃烧过程脱氯,效果最好的脱氯剂是Ca(OH)2、CaO、CaCO3、MgCO3、Mg(OH)2和MgO。在固定床上进行的医疗废物焚烧过程中脱氯试验结果表明:温度对脱氯有着重要的影响,最佳脱氯温度为800℃左右;吸收剂粒径越小,脱氯效率越高;随着Ca/Cl值的增大脱氯率增大,但增加的速度却趋于平缓,所得最佳Ca/Cl值为2.5~3。     

浅谈挥发性有机废气的处理方法

本文介绍了挥发性有机废气的生物处理方法和技术应用,对在国内外应用较广的吸附法、热破坏法、冷凝法、生物法进行了阐述,通过和其它废气处理工艺进行的经济技术对比,表明了生物处理工艺在其适用范围内的优越性.     

城市生活垃圾好氧堆肥中氨气变化及其影响

堆肥过程中氮素损失比较严重,而氨气挥发是氮损失的主要途径。利用城市生活垃圾进行好氧堆肥,研究其堆肥过程中氨气变化规律及其对堆肥性质的影响。结果表明:在堆肥期间,氨气含量先增加后减小,最后基本稳定在5 mg/kg左右;而全氮含量先降低后增加;硝态氮含量先降低后增加;铵态氮是先快速增加,后缓慢减小至稳定;pH值先下降后升高,最终稳定在中性范围内;w(C)/w(N)先增加后下降;有机质含量显著下降。     

生物膜载体填料-污泥资源化研究

污泥资源化是污泥处置的发展趋势,以脱水污泥为主料,添加适量粉煤灰和粘土,制备生物膜载体填料是实验研究的主要内容。实验表明,污泥使用量为70％、粉煤灰和粘土各15％时,烧成温度为1000±25℃、保温时间为40min,烧制的填料抗压强度能达到25mpa、吸水率17％;用于药厂废水处理测试,在常温下的化学需氧量（CODCr）的平均去除率为74．0％、悬浮物（SS）的去除率为54．1％。使用扫描电镜、显微镜像检测,分析了填料烧制中孔隙形成机理、填料外貌、表面微孔结构等。实验表明,以污泥代替天然原料,在一定条件下可以烧制成填料,并能用作污水处理中生物膜载体。     

Nanomaterials for environmental burden reduction, waste treatment, and nonpoint source pollution control: a review

Nanomaterials are applicable in the areas of reduction of environmental burden, reduction/treatment of industrial and agricultural wastes, and nonpoint source (NPS) pollution control. First, environmental burden reduction involves green process and engineering, emissions control, desulfurization/denitrification of nonrenewable energy sources, and improvement of agriculture and food systems. Second, reduction/treatment of industrial and agricultural wastes involves converting wastes into products, groundwater remediation, adsorption, delaying photocatalysis, and nanomembranes. Third, NPS pollution control involves controlling water pollution. Nanomaterials alter physical properties on a nanoscale due to their high specific surface area to volume ratio. They are used as catalysts, adsorbents, membranes, and additives to increase activity and capability due to their high specific surface areas and nano-sized effects. Thus, nanomaterials are more effective at treating environmental wastes because they reduce the amount of material needed.     

周期换向电絮凝法用于处理含铬废水研究

以铁作为极板,采用周期换向电絮凝法处理含铬废水,考察了初始pH值,电流密度,处理时间,初始质量浓度及周期换向时间等因素的影响.结果表明,在初始pH值为8.0~9.0,电流密度为16.37A/m2,处理时间为3.0min,初始浓度为40mg/l时,总铬和六价铬的去除效果理想,去除率均在99.5%以上;10~15min的换向周期在一定程度上解决了极板钝化问题,可降低10%~20%的能耗.实验结果表明周期换向电絮凝法处理含铬废水效果好,且可降低能耗.     

奶牛粪便排泄系数测定

随着奶牛养殖业的发展,养殖粪便也大幅度的增加,而准确量化所产生的污染物,是环保部门需要解决的问题。通过实验测定奶牛粪便排泄系数,有利于对奶牛养殖污染物的排放进行管理。     

电絮凝去除废水中多种重金属影响因素研究

目的以铁作为电极,研究电絮凝法处理含多种重金属废水的影响因素及效果。方法通过控制pH、停留时间、电流密度、电导率、废水初始浓度等因素至不同水平,考察处理效果、能耗及极板消耗的变化。结果随着停留时间、pH值及电流密度的升高,处理效果越好,但升高至一定程度后,处理效果提升并不明显;电导率对处理效果影响并不显著,但过低的电导率会增加能耗;废水初始浓度越高,要达到处理目标所需的能耗及极板消耗均越高。结论当pH为8.5~9.0、进水电导率为1500~2000μs/cm、停留时间为3~4 min、废水初始质量浓度20 mg/L、电流密度为13.2~19.8 A/m2时,处理效果最理想,对总铜、总镍、总铅、总锌、总镉及总铬的去除率达到99%以上,且能耗与极板消耗均为最低,电絮凝法更适合于重金属废水的深度处理。     

余杭区环评市场质与价的博弈关系分析

随着《环评法》的颁布实施,环评市场不断扩大,本文针对杭州市余杭区环评价格高低有错、环评质量良莠不齐的现象,分析了环评机构间的环评价格博弈关系、环评机构与环保管理部门间的环评质量博弈关系,并指出环保管理部门适当融入到环评市场中有利于突破＂囚徒困境＂及＂小偷与守卫＂博弈,引导环评市场健康、有序发展。