Isokinetic Sampler for Continuous Airborne Aerosol Measurements

For aerosol measurements, especially those concerned with the aerosol particle size distribution, it is important to sample in isokinetic conditions. Most available instrumentation for aerosol measurements is intended for use on the ground under light wind conditions; intake air speeds rarely exceed a few meters per second. If the same instrumentation is used onboard an aircraft, the air must be decelerated 60 or more m/sec before It is sampled by individual instruments.

On The Pennsylvania State University Meteorology research aircraft, the air for all aerosol instruments is decelerated in a single isokinetic sampler located above the roof of the cabin outside the aircraft boundary layer. The air enters the sampler through a carefully designed circular intake. Its velocity is reduced as the cross section increases along a 7° conical diffuser. The expansion cone terminates in a cylindrical chamber in which the air velocity is 1/16 the aircraft speed. Behind the sampling chamber the air is accelerated in a second conical section to an end exhaust port. Exhaust porf "pumping" is used to compensate internal losses and, thus, helps preserve the isokinetic nature of the sampler.

Tubes leading to individual instruments are located in the sampling chamber and may be individually adapted to match the air sampling velocity with the local air speed inside the sampling chamber. The level of turbulence (u_rms/û) in the sampling section is =^0.05.

The sampler has been thoroughly wind tunnel and flight tested and successfully used in August and November, 1974, for field programs in the St. Louis and Tucson metropolitan areas, respectively.     

Odor Determination Techniques for Air Pollution Control

Abstract

An airborne lidar was used to study the smoke plume from the burning of a controlled oil spill on the ocean. The ratio of the amount of light (at a wavelength, λ, of 0.532 u.m) backscattered by the smoke to the amount of light extinguished by the smoke was determined by measuring the strength of a laser beam after it had passed through the smoke plume, been reflected from the ocean, and passed through the smoke plume again, and comparing this to the strength of the laser beam reflected directly from the ocean. The optical depth of the smoke (at λ = 0.532 µm) was typically between 0.2 and 0.5. The mass fluxes of smoke particles that passed through four vertical cross sections of the (nonsteady state) smoke plume were estimated from lidar measurements to be 142, 175, 423, and 414 g ^s-1, compared to an average smoke mass production rate of ~770 g s^-1. The spatial distribution of smoke mass along the long axis of the plume was also estimated from the lidar measurements; derived smoke mass concentrations were generally <300 µg ^m-3, with a few isolated values up to ~800 µg ^m-3.     

Control of Organic Emissions from Surface Coating Operations

ABSTRACT

Step tracer tests were carried out on lab-scale biofilters to determine the residence time distributions (RTDs) of gases passing through two types of biofilters: a standard biofilter with vertical gas flow and a modified biofilter with horizontal gas flow. Results were used to define the flow patterns in the reactors. “Non-ideal flow” indicates that the flow reactors did not behave like either type of ideal reactor: the perfectly stirred reactor [often called a "continuously stirred tank reactor" (CSTR)] or the plug-flow reactor.

The horizontal biofilter with back-mixing was able to accommodate a shorter residence time without the usual requirement of greater biofilter surface area for increased biofiltration efficiency. Experimental results indicated that the first bed of the modified biofilter behaved like two CSTRs in series, while the second bed may be represented by two or three CSTRs in series. Because of the flow baffles used in the horizontal biofilter system, its performance was more similar to completely mixed systems, and hence, it could not be modeled as a plug-flow reactor. For the standard biofilter, the number of CSTRs was found to be between 2 and 9 depending on the airflow rate. In terms of NH₃ removal efficiency and elimination capacity, the standard biofilter was not as good as the modified system; moreover, the second bed of the modified biofilter exhibited greater removal efficiency than the first bed. The elimination rate increased as biofilter load increased. An opposite trend was exhibited with respect to removal efficiency.     

Large‐Scale Fine‐Resolution Hydrological Modeling Using Parameter Regionalization in the Missouri River Basin

This study simulated crop and water yields in the Missouri River Basin (MRB; 1,371,000 km²), one of the largest river basins in the United States, using the Soil and Water Assessment Tool (SWAT) at a fine resolution of 12‐digit Hydrological Unit Codes (HUCs) using the regionalization calibration approach. Very few studies have simulated the entire MRB, and those that have developed were at a coarser resolution of 8‐digit HUCs and were minimally calibrated. The MRB was first divided into three subbasins and was further divided into eleven regions. A “head watershed” was selected in each region and was calibrated for crop and water yields. The parameters from the calibrated head watershed were extrapolated to other subwatersheds in the region to complete comprehensive spatial calibration. The simulated crop yields at the head watersheds were in close agreement with observed crop yields. Spatial validation of the aggregated crop yields resulted in reasonable predictions for all crops except dryland corn in a few regions. Simulated and observed water yields in head watersheds and also in the validation locations were in close agreement in naturalized streams and poor agreement in streams with high groundwater‐surface water interactions and/or reservoirs found upstream of the gauges. Overall, the SWAT model was able to reasonably capture the hydrological and crop growth dynamics occurring in the basin despite some limitations.     

From Global to Local: Providing Actionable Flood Forecast Information in a Cloud‐Based Computing Environment

Global and continental scale flood forecast provide coarse resolution flood forecast, but from the perspective of emergency management, flood warnings should be detailed and specific to local conditions. The desired refinement can be provided by the use of downscaling global scale models and through the use of distributed hydrologic models to produce a high‐resolution flood forecast. Three major challenges associated with transforming global flood forecasting to a local scale are addressed in this work. The first is using open‐source software tools to provide access to multiple data sources and lowering the barriers for users in management agencies at local level. This can be done through the Tethys Platform that enables web water resources modeling applications. The second is finding a practical solution for the computational requirements associated with running complex models and performing multiple simulations. This is done using Tethys Cluster that manages distributed and cloud computing resources as a companion to the Tethys Platform for web app development. The third challenge is discovering ways to downscale the forecasts from the global extent to the local context. Three modeling strategies have been tested to address this, including downscaling of coarse resolution global runoff models to high‐resolution stream networks and routing with Routing Application for Parallel computatIon of Discharge (RAPID), the use of hierarchical Gridded Surface and Subsurface Hydrologic Analysis (GSSHA) distributed models, and pre‐computed distributed GSSHA models.     

Establishing and using study criteria to ensure the rigor and robustness of survival compliance testing at hydroelectric dams

An elaborate set of criteria have been developed by fish managers and regulators to assure the accuracy, precision, representativeness, and robustness of survival compliance studies coordinated within the Federal Columbia River Power System in the northwestern USA. Dam passage survival, defined as survival from the dam face to the tailrace mixing zone, must be ≥96 % for spring out migrating juvenile salmonids [i.e., yearling Chinook salmon (Oncorhynchus tshawytscha) and steelhead (O. mykiss)] and ≥93 % for summer outmigrants (i.e., subyearling Chinook salmon). Survival must be estimated with a standard error ≤1.5 %. However, these quantitative benchmarks are only part of a multifaceted set of criteria, including representative dam operations, river discharge levels, and fish selection, along with tests of model validity that must be satisfied. These criteria are illustrated using acoustic-tag survival compliance studies conducted at The Dalles Dam on the Columbia River, 2010–2012. The results suggest evaluation criteria for survival compliance tests must balance the needs for rigor and robustness with the ability to reasonably perform the tests in naturally varying riverine systems.     

Direct and indirect land-use change as prospective climate change indicators for peri-urban development transitions

With urban areas responsible for a significant share of total anthropogenic emissions, greenhouse gas (GHG) emissions due to land-use change (LUC) induced by peri-urban (PU) development have the potential to be considerable. Despite this, there is little research into the transition from PU cropland to housing in terms of contribution to global warming. This paper presents a cross-sectoral integrative method for prospective climate change evaluation of PU LUC. Specifically, direct LUC (dLUC) GHG emissions from converting PU cropland to greenfield housing were examined. Additionally, GHG emissions due to displaced crop production inducing indirect LUC (iLUC) elsewhere were assessed. GHG impacts of dLUC and iLUC were each determined to be approximately 8 per cent of total GHG emissions due to a greenfield housing development displacing PU cropland. This magnitude of dLUC and iLUC emissions suggests that both have importance in future land-use decision making with respect to PU environments.     

The development of alum rates to enhance the remediation of phosphorus in fluvial systems following manure spills

Following the remediation of animal manure spills that reach surface waters, contaminated streambed sediments are often left in place and become a source for internal phosphorus (P) loading within the stream in subsequent flow. The objective of this study was to develop treatment rates and combinations of alum and CaCO(3) to mitigate P from contaminated sediments of different particle size distributions following a manure spill. Sediment specific alum and CaCO(3) treatment rates were developed based upon the resultant alum treatment ranges established for each sediment type. Clay loam sediments required 54% more alum to mitigate P desorption relative to sediments that contain at least 60% sand. Amending sediments with the highest rates of alum/alum + CaCO(3), resulted in a 98-100% reduction in P desorption and a similar water column pH for all sediments types. Observations from this study demonstrated the effectiveness of alum/alum + CaCO(3) to increase P retention in sediments following a manure spill.     

Comparison of total mercury and methylmercury cycling at five sites using the small watershed approach

The small watershed approach is well-suited but underutilized in mercury research. We applied the small watershed approach to investigate total mercury (THg) and methylmercury (MeHg) dynamics in streamwater at the five diverse forested headwater catchments of the US Geological Survey Water, Energy, and Biogeochemical Budgets (WEBB) program. At all sites, baseflow THg was generally less than 1ng L(-1) and MeHg was less than 0.2ng L(-1). THg and MeHg concentrations increased with streamflow, so export was primarily episodic. At three sites, THg and MeHg concentration and export were dominated by the particulate fraction in association with POC at high flows, with maximum THg (MeHg) concentrations of 94 (2.56)ng L(-1) at Sleepers River, Vermont; 112 (0.75)ng L(-1) at Rio Icacos, Puerto Rico; and 55 (0.80)ng L(-1) at Panola Mt., Georgia. Filtered (<0.7microm) THg increased more modestly with flow in association with the hydrophobic acid fraction (HPOA) of DOC, with maximum filtered THg concentrations near 5ng L(-1) at both Sleepers and Icacos. At Andrews Creek, Colorado, THg export was also episodic but was dominated by filtered THg, as POC concentrations were low. MeHg typically tracked THg so that each site had a fairly constant MeHg/THg ratio, which ranged from near zero at Andrews to 15% at the low-relief, groundwater-dominated Allequash Creek, Wisconsin. Allequash was the only site with filtered MeHg consistently above detection, and the filtered fraction dominated both THg and MeHg. Relative to inputs in wet deposition, watershed retention of THg (minus any subsequent volatilization) was 96.6% at Allequash, 60% at Sleepers, and 83% at Andrews. Icacos had a net export of THg, possibly due to historic gold mining or frequent disturbance from landslides. Quantification and interpretation of Hg dynamics was facilitated by the small watershed approach with emphasis on event sampling.     

Comparison of speciation sampler and PC-BOSS fine particulate matter organic material results obtained in Lindon, Utah, during winter 2001-2002

The Particle Concentrator-Brigham Young University Organic Sampling System (PC-BOSS) has been previously verified as being capable of measuring total fine particulate matter (PM2.5), including semi-volatile species. The present study was conducted to determine if the simple modification of a commercial speciation sampler with a charcoal denuder followed by a filter pack containing a quartz filter and a charcoal-impregnated glass (CIG) fiber filter would allow for the measurement of total PM2.5, including semi-volatile organic material. Data were collected using an R&P (Rupprecht and Pastasnik Co., Inc.) Partisol Model 2300 speciation sampler; an R&P Partisol speciation sampler modified with a BOSS denuder, followed by a filter pack with a quartz and a CIG filter; a Met One spiral aerosol speciation sampler (SASS); and the PC-BOSS from November 2001 to March 2002 at a U.S. Environmental Protection Agency (EPA) Science to Achieve Results (STAR) sampling site in Lindon, UT. Total PM2.5 mass, ammonium nitrate (both nonvolatile and semi-volatile), ammonium sulfate, organic carbon (both non-volatile and semi-volatile), and elemental carbon were determined on a 24-hr basis. Results obtained with the individual samplers were compared to determine the capability of the modified R&P speciation sampler for measuring total PM2.5, including semi-volatile components. Data obtained with the modified speciation sampler agreed with the PC-BOSS results. Data obtained with the two unmodified speciation samplers were low by an average of 26% because of the loss of semi-volatile organic material from the quartz filter during sample collection.