Study on the initial velocity distribution of exhaled air from coughing and speaking

Increasing concerns about the spread of airborne pathogens such as severe acute respiratory syndrome (SARS) and novel swine-origin influenza A (H1N1) have attracted public attention to bioaerosols and protection against them. The airborne pathogens are likely to be expelled from coughing or speaking, so the physical data of the exhaled particles plays a key role in analyzing the pathway of airborne viruses. The objective of this study was to analyze the initial velocity and the angle of the exhaled airflow from coughing and speaking of 17 males and 9 females using Particle Image Velocimetry (PIV) and acrylic indoor chamber. The results showed that the average initial coughing velocity was 15.3 m/s for the males and 10.6 m/s for the females, while the average initial speaking velocity was 4.07 m/s and 2.31 m/s respectively. The angle of the exhaled air from coughing was around 38° for the males and 32° for the females, while that of the exhaled air from speaking was around 49° and 78° respectively. Also, the linear relation between the tested subject’s height and their coughing and speaking velocity was shown in this study.     

Characteristics of products and PCDD/DF emissions from a pyrolysis process of urethane/styrofoam waste from electrical home appliances

A plastic fraction consisting mainly of polyurethane/styrofoam waste is generated after separating valuable spare parts and metals from used electrical home appliances. In Korea, such waste is currently incinerated in cement kilns or is landfilled. However, owing to its high volatile matter content, conversion into gaseous or liquid pyrolysis products is a preferable alternative. A pyrolysis process of polyurethane and styrofoam waste from electrical home appliances was evaluated by characterizing the products generated at 500°–800°C. The para meters determined were the yields of gas, oil, and char; the characteristics of the remaining char; and the con centration of polychlorinated dibenzo-p-dioxins/polychlorinated dibenzo-furans in the product gas. As expected, the char yield decreased at higher temperatures, whereas gas and oil yields showed increasing tendency. The oil products could be used as storable fuels with a calorific value of 6000–8000 kcal/kg. Fine pores were observed in the char. The adsorption and decolorizing ability of the char were almost the same as those of activated carbon, so that pyrolysis char has potential for use as a sorbent. Further feasibility studies will be needed before utilizing pyrolysis technology to recover either fuels or usable products from polyurethane/styrofoam waste.     

Allocation and banking in Korean permits trading

This paper investigates how Korean industry would respond to four different allocation and banking options in CO₂ permit trading within a fully dynamic computational general equilibrium framework. Four different allocations are categorized—a uniform allocation and three performance-based allocations. We explore that performance-based allocation and banking lower losses in Korean potential GDP, allowing energy-intensive industry more flexibility in inter-temporal decision making on purchasing and selling permits. The steel industry can derive a particular advantage from a performance-based allocation with respect to energy use, while the semiconductor industry would prefer a performance-based allocation with respect to value-added. The two key conclusions are (i) the Korean economy should replace an absolute allocation with a performance-based allocation, and (ii) the banking of permits enables market players to reallocate allowances more efficiently in a long-term commitment period. These results support the findings of the key study by Kling and Rubin (1997).     

Biodegradability and biodegradation rate of poly(caprolactone)-starch blend and poly(butylene succinate) biodegradable polymer under aerobic and anaerobic environment

The biodegradability and the biodegradation rate of two kinds biodegradable polymers; poly(caprolactone) (PCL)-starch blend and poly(butylene succinate) (PBS), were investigated under both aerobic and anaerobic conditions. PCL-starch blend was easily degraded, with 88% biodegradability in 44 days under aerobic conditions, and showed a biodegradation rate of 0.07 day⁻¹, whereas the biodegradability of PBS was only 31% in 80 days under the same conditions, with a biodegradation rate of 0.01 day⁻¹. Anaerobic bacteria degraded well PCL-starch blend (i.e., 83% biodegradability for 139 days); however, its biodegradation rate was relatively slow (6.1 mL CH₄/g-VS day) compared to that of cellulose (13.5 mL CH₄/g-VS day), which was used as a reference material. The PBS was barely degraded under anaerobic conditions, with only 2% biodegradability in 100 days. These results were consistent with the visual changes and FE-SEM images of the two biodegradable polymers after the landfill burial test, showing that only PCL-starch blend had various sized pinholes on the surface due to attack by microorganisms. This result may be use in deciding suitable final disposal approaches of different types of biodegradable polymers in the future.     

Feasibility of producing ethanol from food waste

Food waste generated in Korea is rich in carbohydrate as high as 65% of total solids. Using the food waste, the feasibility of ethanol production was investigated in a lab-scale fermentor. Pretreatment with hydrolyzing enzymes including carbohydrase, glucoamylase, cellulase and protease were tested for hydrolysis of food waste. The carbohydrase was able to hydrolyze and produce glucose with a glucose yield of 0.63 g glucose/g total solid. Enzymatic hydrolysis and ethanol fermentation by using carbohydrase and Saccharomyces cerevisiae were conducted in the batch mode. For separated hydrolysis and fermentation (SHF), ethanol concentration reached at the level corresponding to an ethanol yield of 0.43 g ethanol/g total solids. For simultaneous saccharification and fermentation (SSF), the ethanol yield was 0.31 g ethanol/g total solids. During the continuous operation of SHF, the volumetric ethanol production rate was 1.18 g/lh with an ethanol yield of 0.3g ethanol/g total solids. For SSF process, the volumetric ethanol production rate was 0.8 g/lh with an ethanol yield of 0.2g ethanol/g total solids.     

Enhanced methane recovery by food waste leachate injection into a landfill in Korea

The current food waste leachate (FWL) disposal practice in Korea warrants urgent attention and necessary action to develop an innovative and sustainable disposal strategy, which is both environmentally friendly and economically beneficial. In this study, methane production by FWL injection into a municipal solid waste landfill with landfill gas (LFG) recovery facility was evaluated for a period of more than 4 months. With the target of recovering LFG with methane content ~50%, optimum LFG extraction rate was decided by a trial and error approach during the field investigation in five different phases. The results showed that, upon FWL injection, LFG extraction rate of ~20 m(3)/h was reasonable to recover LFG with methane content ~58%. Considering the estimated methane production potential of 31.7 m(3) CH(4) per ton of FWL, methane recovery from the landfill was enhanced by 14%. The scientific findings of this short-term investigation indicates that FWL can be injected into the existing sanitary landfills to tackle the present issue and such landfills with efficient liner and gas collection facility can be utilized as absolute and sustainable environmental infrastructures.     

Performance evaluation of an in situ nitrous acid measurement system and continuous measurement of nitrous acid in an indoor environment

Nitrous acid (HONO) may cause adverse effects to mucous membranes and lung function when people are exposed to higher HONO concentrations than those present in typical indoor residential environments. Therefore, determination of HONO concentration in indoor environments is required to investigate occurrences of high HONO levels. In this work, a high-time-resolution measurement system was utilized to better understand the levels and dynamic behavior of HONO in an indoor environment. The performance of the in situ HONO analyzer applied to this work was evaluated using a 12-hr integrated annular denuder technique under ambient conditions. Both methods for the measurements of HONO were in good agreement, with a regression slope of 0.84, an intercept of 0.09, and correlation coefficient (r2) of 0.67. Indoor HONO and nitrogen oxide concentrations were also observed for approximately 5 days in winter in the living room of an apartment that had a gas range for cooking in the kitchen. Investigation of the relationships among nitric oxide (NO), nitrite (NO2), and HONO concentrations suggests that HONO production during combustion could be the result of direct emission, whereas the heterogeneous NO2 chemistry during the background period and after combustion was the possible pathway of HONO production. Controlled combustion experiments, performed at a burning rate of 50% valve setting, show peak HONO concentrations during the unvented combustion to be approximately 8-10 times higher than background levels depending on the time of day. At a burning rate setting of 50%, the peak concentration of HONO during unvented combustion was found to be 33-37% higher than those from "weak" (airflow = 340 m3/hr) and "strong" (airflow = 540 m3/hr) vented combustions. The decay rate of the HONO concentrations for the unvented combustion conditions was approximately 2-fold higher in the daytime than in the nighttime and significantly less than those of NO and NO2.     

Measurement of real time black carbon for investigating spot loading effects of Aethalometer data

Measurements of real-time continuous PM_2.5 black carbon (BC) concentrations were made using a single-wavelength Aethalometer (@880 nm) in three different environments, i.e., an indoor office, a residential indoor living room and an urban site, to evaluate the difference in temporal behaviors of BC particles and investigate the optical shadowing effect in the Aethalometer BC data. An empirical method was used for correcting the optical saturation effect on the original BC data obtained from the measurements at the three sites. Also, the elemental carbon (EC) concentrations from 24-h filter-based measurements of PM_2.5 particles were determined using a thermal optical transmittance (TOT) method at the same urban site for comparison with the Aethalometer BC results. Transient events of BC were often observed for period of a few hours at all sites, reaching a maximum level of 27.3 μg m^?3 at the urban site. The diurnal cycles of the BC concentrations observed at the two indoor environments were found to be considerably affected by the air exchange rate, occupants' behavior patterns and nearby traffic emissions. The time-series plots of the Aethalometer data showed obvious discontinuities at the filter spot change, and a rise in the apparent BC concentrations after filter tape advances. Also, the relationship between the attenuation and BC concentration was found to be non-linear at all sites. The empirical approach presented here demonstrated a definite improvement in the continuity of the BC data across the time gaps of each tape advance. The compensated BC concentration was 1.10–1.23 times greater than the raw BC data, depending on the observation sites, with the highest difference observed between the raw and compensated BC data at an indoor office near a small traffic road. The 24-h integrated EC concentration was approximately 12% higher than the original 24-h average BC concentration and 6% lower than the loading compensated BC concentration, showing that the loading compensation process accounted for the saturation effect of the filter tape.     

Biochemical and cellular effects of electrophiles present in ambient air samples

Ambient vapor-phase samples collected in Riverside, California had shown that both redox and electrophilic activity were present, with the vapor phase containing higher levels of electrophiles than the particle phase. In this study, the biochemical effects of the vapor-phase electrophiles were examined using the purified thiol proteins, glyceraldehyde-3-phosphate dehydrogenase (GAPDH), protein tyrosine phosphatase 1B (PTP1B) and KELCH-1 like ECH-associated protein 1 (Keap1). The results demonstrated that the thiol proteins were inactivated by the vapor-phase samples through covalent modifications. Next, two cellular responses, epidermal growth factor receptor (EGFR)/mitogen-activated protein (MAP) kinase and NF-E2-related factor 2 (Nrf2), to the ambient vapor-phase samples were assessed in A549 and RAW 264.7 cell lines, respectively. The vapor-phase samples, at non-oxidative concentrations, increased phosphorylation of EGFR, which is negatively regulated by PTP1B, and its downstream MAP kinase, extracellular signal-regulated kinase (ERK)1/2. Activation of Nrf2, which requires Keap1 alkylation, and expression of its downstream proteins were also observed. The electrophilic compounds present in ambient vapor-phase were shown to modify cellular proteins through covalent modification and to activate diverse cellular responses that can lead to inflammatory and adaptive responses.     

Toxicological evaluation of the chemical oxidation methods for landfill stabilization

As the stabilization criteria for landfill sites, only chemical criteria for the leachate discharges from the landfill sites have been used in Japan and many other countries. Recently, chemical oxidation has been developed as a method for the early-stabilization of landfills. However, by-products that are difficult to detect by chemical analysis can be produced by this method. Therefore, toxicity tests are useful tools for detecting the changes of leachate quality after application of this method. The heat source in the A landfill was analyzed by organic position inquiry technology, and ozone-treated leachate was sprayed back to the heat source in the landfill. Toxicity changes of the leachate after the spray were monitored using Microtoxtrade mark, ToxScreen-II, and DaphTox tests. The hardly-degradable organic matter was efficiently removed and toxicities of the leachate in the heat source decreased after the application. These toxicity results were significantly related to chemical oxygen demand (COD) changes. Thus, it was concluded that the toxicity tests were effective for monitoring the leachate quality after applying the chemical oxidation method for landfill stabilization, and its incorporation to establish the criteria for early-stabilization of landfill sites needs to be considered.