The recovery of ammonia and hydrogen sulfide from ground-level area sources using dynamic isolation flux chambers: bench-scale studies

Controlled bench-scale laboratory experiments were conducted to evaluate the recovery of ammonia (NH3) and hydrogen sulfide (H2S) from dynamic isolation flux chambers. H2S (80-4000 ppb) and NH3 (5000-40,000 ppb) samples were diffused through the flux chamber to simulate ground level area source emissions while measuring the inlet and outlet flux chamber concentrations simultaneously. Results showed that the recovery of H2S during a 30-min sampling time was almost complete for concentrations >2000 ppb. At the lowest concentration of 80 ppb, 92.55% of the H2S could be recovered during the given sampling period. NH3 emissions exhibited similar behavior between concentrations of 5000-40,000 ppb. Within the 30-min sampling period, 92.62% of the 5000-ppb NH3 sample could be recovered. Complete recovery was achieved for concentrations >40,000 ppb. Predictive equations were developed for gas adsorption. From these equations, the maximum difference between chamber inlet and outlet concentrations of NH3 or H2S was predicted to be 7.5% at the lowest concentration used for either gas. In the calculation of emission factors for NH3 and H2S, no adsorption correction factor is recommended for concentrations >37,500 ppb and 2100 ppb for NH3 and H2S, respectively. The reported differences in outlet and inlet concentration above these ranges are outside the fullscale sensitivity of the gas sensing equipment. The use of 46-90 m of Teflon tubing with the flux chambers has apparently no effect on gas adsorption, because recovery was completed almost instantaneously at the beginning of the tests.     

Laboratory evaluation of thermophilic-anaerobic digestion to produce Class A biosolids. 1. Stabilization performance of a continuous-flow reactor at low residence time.

There is increasing interest in the United States in producing biosolids from municipal wastewater treatment that meet the criteria for Class A designation established by the U.S. Environmental Protection Agency. Class A biosolids are intended to be free of pathogens and also must meet requirements for reduction of the vector-attraction potential associated with untreated sludge. High-temperature processes are considered to produce Class A biosolids if the combination of operating temperature and treatment time exceeds minimum criteria, but this option is not applicable to mixed, continuous-flow reactors. Such reactors, or any combination of reactors that does not meet the holding time requirement at a specific temperature, must be demonstrated to inactivate pathogens to levels consistent with the Class A criteria. This study was designed to evaluate pathogen inactivation by thermophilic anaerobic digestion in a mixed, continuous-flow reactor followed by batch or plug-flow treatment. In this first of a two-part series, we describe the performance of a continuous-flow laboratory reactor with respect to physical and chemical operating parameters; microbial inactivation in the combined continuous-flow and batch treatment system is described in the second part. Sludges from three different sources were treated at 53 degrees C, while sludge from one of the sources was also treated at 55 and 51 degrees C. Relatively short hydraulic retention times (four to six days) were used to represent a conservative operating condition with respect to pathogen inactivation. Treatment of a fermented primary sludge led to an average volatile-solids (VS) destruction efficiency of 45%, while VS destruction for the other two sources was near or below 38%, the Class A criterion for vector attraction reduction. Consistent with other studies on thermophilic anaerobic digestion of sludges at short residence times, effluent concentrations of volatile fatty acids (VFAs) were relatively high. Also consistent with other studies, the most abundant VFA in the effluent was propionate. Gas production ranged from 0.3 to 0.5 m3/kg VS fed and from 0.8 to 1.3 m3/kg VS destroyed.     

Laboratory evaluation of thermophilic-anaerobic digestion to produce Class A biosolids. 2. Inactivation of pathogens and indicator organisms in a continuous-flow reactor followed by batch treatment.

Thermophilic-anaerobic digestion in a single-stage, mixed, continuous-flow reactor is not approved in the United States as a process capable of producing Class A biosolids for land application. This study was designed to evaluate the inactivation of pathogens and indicator organisms in such a reactor followed by batch treatment in a smaller reactor. The combined process was evaluated at 53 degrees C with sludges from three different sources and at 51 and 55 degrees C with sludge from one of the sources. Feed sludge to the continuous-flow reactor was spiked with the pathogen surrogates Ascaris suum and vaccine-strain poliovirus. Feed and effluent were analyzed for these organisms and for indigenous Salmonella spp., fecal coliforms, Clostridium perfringens spores, and somatic and male-specific coliphages. No viable Ascaris eggs were observed in the effluent from the continuous reactor at 53 or 55 degrees C, with greater than 2-log removals across the digester in all cases. Approximately 2-log removal was observed at 51 degrees C, but all samples of effluent biosolids contained at least one viable Ascaris egg at 51 degrees C. No viable poliovirus was found in the digester effluent at any of the operating conditions, and viable Salmonella spp. were measured in the digester effluent in only one sample throughout the study. The ability of the continuous reactor to remove fecal coliforms to below the Class A monitoring limit depended on the concentration in the feed sludge. There was no significant removal of Clostridium perfringens across the continuous reactor under any condition, and there also was limited removal of somatic coliphages. The removal of male-specific coliphages across the continuous reactor appeared to be related to temperature. Overall, at least one of the Class A pathogen criteria or the fecal coliform limit was exceeded in at least one sample in the continuous-reactor effluent at each temperature. Over the range of temperatures evaluated, the maximum time required to meet the Class A criteria by batch treatment of the continuous-reactor effluent was 1 hour for Ascaris suum and Salmonella spp. and 2 hours for fecal coliforms.     

Monitoring of the booster biocide dichlofluanid in water and marine sediment of Greek marinas

Dichlofluanid (N-dichlorofluoromethylthio-N'-dimethyl-N-phenylsulphamide) is used as booster biocide in antifouling paints. The occurrence of dichlofluanid and its metabolite DMSA (N'-dimethyl-N-phenyl-sulphamide) was monitored in seawater and marine sediment from three Greek marinas. Seawater and sediment samples were collected at three representative positions and one suspected hotspot in each marina and shipped to the laboratory for chemical analysis. As part of the project, an analytical method had been developed and validated. Furthermore, some additional experiments were carried out to investigate the potential contribution of paint particle bound dichlofluanid on the total concentration in the sediment. As expected, given its known high hydrolytic degradation rate, no detectable concentrations of dichlofluanid were measured in any of the seawater samples. DMSA was detected in seawater samples at very low concentrations varying from <3 ng l(-1) (LOD) to 36 ng l(-1). During method validation, it had already been demonstrated that dichlofluanid is unstable in sediment and can therefore only be determined as its metabolite DMSA. In a separate experiment, in which marine sediment was spiked with artificial paint particles containing dichlofluanid and then analysed according to the validated method, it was demonstrated that if there is any dichlofluanid originating from paint particles, this would be determined as DMSA. No DMSA was detected in any of the sediment samples. It could therefore be concluded that there were no significant concentrations of dichlofluanid in the sediment samples.     

Effects of nutrient and temperature on degradation of petroleum hydrocarbons in contaminated sub-Antarctic soil

Mesocosm studies using sub-Antarctic soil artificially contaminated with diesel or crude oil were conducted in Kerguelen Archipelago (49 degrees 21' S, 70 degrees 13' E) in an attempt to evaluate the potential of a bioremediation approach in high latitude environments. All mesocosms were sampled on a regular basis over six months period. Soils responded positively to temperature increase from 4 degrees C to 20 degrees C, and to the addition of a commercial oleophilic fertilizer containing N and P. Both factors increased the hydrocarbon-degrading microbial abundance and total petroleum hydrocarbons (TPH) degradation. In general, alkanes were faster degraded than polyaromatic hydrocarbons (PAHs). After 180 days, total alkane losses of both oils reached 77-95% whereas total PAHs never exceeded 80% with optimal conditions at 10 degrees C and fertilizer added. Detailed analysis of naphthalenes, dibenzothiophenes, phenanthrenes, and pyrenes showed a clear decrease of their degradation rate as a function of the size of the PAH molecules. During the experiment there was only a slight decrease in the toxicity, whereas the concentration of TPH decreased significantly during the same time. The most significant reduction in toxicity occurred at 4 degrees C. Therefore, bioremediation of hydrocarbon-contaminated sub-Antarctic soil appears to be feasible, and various engineering strategies, such as heating or amending the soil can accelerate hydrocarbon degradation. However, the residual toxicity of contaminated soil remained drastically high before the desired cleanup is complete and it can represent a limiting factor in the bioremediation of sub-Antarctic soil.     

Feral swine disturbance at important archaeological sites

Feral swine are well known as environmentally destructive invasive animals in many areas around the world, where they degrade native habitats, harm rare plant and animal species, damage agricultural interests, and spread disease. We provide the first quantification of their potential as agents of disturbance at archaeological sites. Our study was conducted in south-central Florida at Avon Park Air Force Range, a base comprising over 40,000 ha and containing many archaeological sites. To determine the identifiable prevalence of feral swine disturbance, we examined 36 sites registered with the Florida State Historic Preservation Office and also eligible for inclusion in the National Register of Historic Places (NRHP). Moreover, we evaluated the extent of swine disturbance at a prehistoric site of extraordinary significance to Florida’s prehistory, “Dead Cow.” Fifteen of the 36 NRHP-eligible sites (42 %) had some level of swine disturbance, including 14 of 30 (47 %) sites known to have artifacts within 20 cm of the surface (well within swine rooting depths). At the Dead Cow site, we documented disturbance at 74 % of shovel test points. Sites with shallow artifact depositions appeared highly vulnerable to disturbance by feral swine, threatening destruction of artifact stratigraphy and provenience. Our observations likely are a minimal representation of accumulated damage. These irreplaceable sites tell the area’s land use story across the millennia. That they are under threat from feral swine should serve broad notice of potential threats that feral swine may pose to archaeological sites globally, making effective swine management imperative for site protection.     

Anaerobic degradation of diethyl phthalate, di-n-butyl phthalate, and di-(2-ethylhexyl) phthalate from river sediment in Taiwan

We investigated anaerobic degradation rates for three phthalate esters (PAEs), diethyl phthalate (DEP), di-n-butyl phthalate (DBP), and di-(2-ethylhexyl) phthalate (DEHP), from river sediment in Taiwan. The respective anaerobic degradation rate constants for DEP, DBP, and DEHP were observed as 0.045, 0.074, and 0.027 1/day, with respective half-lives of 15.4, 9.4, and 25.7 days under optimal conditions of 30 °C and pH 7.0. Anaerobic degradation rates were enhanced by the addition of the surfactants brij 35 and triton N101 at a concentration of 1 critical micelle concentration (CMC), and by the addition of yeast extract. Degradation rates were inhibited by the addition of acetate, pyruvate, lactate, FeCl₃, MnO₂, NaCl, heavy metals, and nonylphenol. Our results indicate that methanogen, sulfate-reducing bacteria, and eubacteria are involved in the degradation of PAEs.     

Surface Consolidation of Pentelic Marble: Criteria for the selection of methods and materials - The Acropolis case (6 pp)

Goal and Scope In order to realize surface consolidation of Pentelic marble on the Acropolis monuments, we have collected the criteria that have to be fulfilled by the methods and materials without side effects on the marbles (and other stones). When the existing methods and materials did not satisfy the requirements (criteria), we invented new ones.Methods The criteria were collected from the literature, by thermodynamic and kinetic viewpoints, by laboratory experiments and in situ observations on monuments, both in Greece and in several countries in which the various methods and materials were applied. Concerning our method of ‘Inversion of sulfation’, performed by spraying a K2CO3 solution, its concentration and its temperature were controlled in order to have a total inversion (certified by liquid crystals) of gypsum back to CaCO3. For the new material of ours, ‘Reinforced Lime’, in order to eliminate the disadvantages of plain lime (low carbonation rate, low mechanical properties of CaCO3 formed, lack of carbonation in the bulk of lime), measurements of the rate of carbonation were performed in plain lime and in lime with a different CaCO3 concentration beforehand as well as in a different CO2 environments, using DTG and XRD to measure the rate of carbonation. The detachment (kg/cm2) of marble specimens stuck by lime in each case was also measured. A microscope was also used to measure the dimensions of the grain in each case as well as ammonium citrate and thymolphthalein to certify the depth of carbonation in each case. Part of the work was communicated in an international congress.Results A table with the criteria of the selection of the methods and materials for the consolidation of Pentelic marble surfaces (and other stones) was established. None of the employed methods and materials fulfilled the criteria. Only the ‘Inversion of gypsum ‘ and the ‘Reinforced Lime’ were adopted and applied to the Acropolis monuments and to other monuments in Greece and in several other countries.Recommendation and Outlook All criteria must be used for the selection of methods and materials for the consolidation of the monument surfaces. This is why we have already studied with the same procedures, methods and materials for restoration, surface cleaning and protection.     

The effects of perennial ryegrass and alfalfa on microbial abundance and diversity in petroleum contaminated soil

Enhanced rhizosphere degradation uses plants to stimulate the rhizosphere microbial community to degrade organic contaminants. We measured changes in microbial communities caused by the addition of two species of plants in a soil contaminated with 31,000 ppm of total petroleum hydrocarbons. Perennial ryegrass and/or alfalfa increased the number of rhizosphere bacteria in the hydrocarbon-contaminated soil. These plants also increased the number of bacteria capable of petroleum degradation as estimated by the most probable number (MPN) method. Eco-Biolog plates did not detect changes in metabolic diversity between bulk and rhizosphere samples but denaturing gradient gel electrophoresis (DGGE) analysis of PCR-amplified partial 16S rDNA sequences indicated a shift in the bacterial community in the rhizosphere samples. Dice coefficient matrices derived from DGGE profiles showed similarities between the rhizospheres of alfalfa and perennial ryegrass/alfalfa mixture in the contaminated soil at week seven. Perennial ryegrass and perennial ryegrass/alfalfa mixture caused the greatest change in the rhizosphere bacterial community as determined by DGGE analysis. We concluded that plants altered the microbial population; these changes were plant-specific and could contribute to degradation of petroleum hydrocarbons in contaminated soil.