Large-scale mercury variations in Lake Vänern (Sweden) 1974-98

Lake V?nern, the largest lake in Sweden, has been seriously contaminated with mercury during the 20th century. In the 1970's and 80's the direct load, mainly from a chlor-alkali industry in the area, of mercury was drastically reduced as a response to new legislation, from three to five tons down to between five and ten kg yr(-1). Large amounts of the disposed pollutant have accumulated in the sediments. The question posed in this work is now, is the effect of the drastic load reduction after more than two decades visible in the sediments? The question is relevant as large areas still are blacklisted for fishing, but also as a follow-up of a major remedy action. The lake also serves as a freshwater reservoir for even Sweden's second largest city. This work synthesises and compares data of mercury in the sediments from three major field programs, in 1974, 1984 and 1998. The interest is focused on both spatial heterogeneity and temporal trends. In 1974, the surface concentrations are significantly higher than in subsequent surveys. Significant differences are also found between 1984 and 1998. Significant spatial differences within the lake are found for respective year. The most contaminated area is located in the north, close to the major point source (a former chlor-alkali industry). This is also the area with the largest improvement, as a direct response to the reduction in load. Further from the outlet, the recovery is more affected by burial and transport processes out into the deeper basins.     

Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.     

Monitoring atmospheric metal pollution: a review of the use of mosses as indicators

This article reviews the literatureon the use of mosses for monitoring atmospheric metalpollution. It discusses the nature of mosses, themechanisms for moss uptake of metals from the air andwet precipitation, the various forms in which mossesare used for this purpose, and cases in which mosseshave been used for monitoring local hot spots ofpollution, and regional patterns of metal pollution.Also highlighted are the questions of uptake of metalsfrom the substrates, interspecies differences, and acomparison of the effectiveness of mosses with otherindicator materials, among other issues.     

Luminescence spectroscopy as a screening tool for the potential carcinogenicity of asphalt fumes

A subset of polycyclic aromatic compounds (PACs), which contain 4-6 annulated rings, has been documented as the source of carcinogenicity in animal skin painting studies of petroleum products and asphalt fumes (M. L. Machado, P. W. Beatty, J. C. Fetzer, A. H. Glickman and E. L. McGinnis, Fundam. Appl. Toxicol., 1993, 21, 492; T. A. Roy, S. W. Johnson, G. R. Blackburn and C. R. Mackerer, Fundam. Appl. Toxicol., 1988, 10, 466). Because of the chemical complexity of these materials, it has been difficult to identify the specific compounds within this broad range of PACs responsible for their carcinogenicity. An alternative approach using luminescence spectroscopy was taken in this study to quantify, without identification, a subset of these compounds that appears to cause cancer. The fluorescence response at a specific wavelength pair was obtained for 39 laboratory asphalt fume condensates from animal skin painting studies, yielding a linear correlation coefficient of R2 = 0.96 between the fluorescence response in these materials and the carcinogenicity found in animal studies. In the absence of other asphalt fume condensates from animal studies, 17 petroleum oils were also evaluated using this method and compared with the available animal skin painting data. The details of the method include a clean-up step that removes the highly polar compounds and spectral subtraction of two- and three-ring PAC interference, both of which add to the fluorescence response, yet were not found to contribute to a carcinogenic response from skin painting studies. Full scan fluorescence plots also produce a fingerprint which can be used to assess contamination, such as coal tar products or mixtures of materials, that are not defined as asphalt, yet may be present in the working environment.     

Influence of environmental parameters on the accuracy of nitrogen dioxide passive diffusion tubes for ambient measurement

Two studies at three sites in the UK provided confirmation that systematic positive bias in NO2 diffusion tube measurement occurred because of changes to "within-tube" chemistry, rather than eddy diffusion at the mouth of the tube. In the first study in Cambridge, UK, sampler overestimation for 1 and 2 week exposures was compared to corresponding time-averaged monitor measurements (NO-NO2-NOx, O3) and weather variables. Noninearity between sampler and monitor NO2 measurements was interpreted in terms of spatial and temporal variations in relative and absolute availability of NO, NO2 and O3 at the site. A maximum overestimation occurred for an exposure mean NO2/NOx approximately 0.5. The separate contributions of reduced NO2 photolysis and eddy diffusion were compared in Study II using samplers of two materials, acrylic and quartz, and of different lengths (40, 55, 71 and 120 mm) at three sites: Norwich background, Cambridge intermediate, London kerbside. For compared sites, NO2 measured by acrylic samplers was significantly higher than for equivalent quartz samplers. For quartz samplers [NO2]mean was only just above the monitor at Norwich and London; sampler/monitor NO2 = 1.04 (P = 0.59) and 1.01(P = 0.76), respectively. For acrylic samplers the order of [NO2]mean was 40 mm > 120 mm > 71 mm > or = 55 mm. Excepting 40 mm samplers, this accords with a chemical bias where co-diffusing NO and 03 molecules in longer tubes have more time to react to form excess NO2. Bias in 40 mm samplers is discussed. Eddy diffusion is negligible for standard samplers because [NO2]mean was equivalent for 55 mm and 71 mm acrylic samplers and close to monitor NO2 for 71 mm quartz tubes. Both studies showed that sampler accuracy was dependent on location. Significantly, overestimation was greatest (approximately 3-4 ppb) where the NO2 annual mean was approximately 20 ppb, close to the UK and EU air quality standard of 21 ppb.     

Assessing the Effects of Atmospheric Ethylene on Epinasty and Tuber Yield of Potato (Solanum Tuberosum L.) Near Polyethylene Manufacturing Plants

A multi-year programme was performed to assess the effects of atmospheric ethylene on potato (Solanum tuberosum L.) in the vicinity of polyethylene manufacturing plants. There was a strong temporal variation of the hourly ethylene concentrations measured close to the sources from 1982 through 1991. Growing seasonal means exceeded 12 g m^–3 ethylene, the threshold for phytotoxic effects under laboratory conditions. Young test plants of potato showed an epinastic response to enhanced levels of ethylene. This response was reversible and did not occur when atmospheric ethylene was not detected. Based on hourly observations for the growing seasons of 1984 through 1991, epinasty occurred on average during circa 5% of the growing season and varied from circa 1% in 1985 to circa 18% in 1991. At night, ethylene concentrations were higher and epinasty was more frequent than during daylight hours. The intermittent exposures to ethylene did not affect tuber yield for the growing seasons of 1982 through 1990. The occurrence of epinasty indicated that ethylene exposure levels in the vicinity of the industrial sources might be sufficiently high to affect sensitive plants.     

The collection of PM10 for toxicological investigation: comparisons between different collecting devices

A positive correlation has been established between increased levels of airborne particulate pollution and adverse health effects, the toxicological mechanisms of which are poorly understood. For toxicologists to unambiguously determine thesemechanisms, truly representative samples of ambient PM₁₀ are required. This presents problems, as PM₁₀ collecting equipment commonly employed, such as the Tapered Element Oscillating Microbalance (TEOM®), heat the inflow toexclude moisture or use fibrous filters, resulting in a PM₁₀sample that may have undergone significant chemical change on thefilter surface or is contaminated by filter fibres. Other systems(i.e. Negretti and Partisol) can successfully collect PM₁₀ without chemical alteration or filter contamination. Comparativecollections from Port Talbot, S. Wales suggest that TEOMs and Negretti/Partisol systems collect different PM₁₀'s; the principle difference arising from the TEOM's heating chamber, which precipitates water-soluble ions and volatilises some organic components. This results in both the mass and compositionof the PM₁₀'s being altered. Particle size distributionsfor Negretti and Partisol collections highlighted differences mainly attributed to different flow rates. The results of thiswork demonstrate that simple correlations between PM₁₀ massand adverse health effects are problematic. Furthermore, elucidation of the complex fractionation and chemical changes indifferent collectors is necessary.     

Degradability and Sediment Sorption of an Alcohol Polyglycol Ether Surfactant Putatively Useful for the Control of Red Swamp Crayfish in Rice Fields

This work reports studies of the degradation rates of a fattyalcohol polyglycol ether non-ionic surfactant, Genapol OXD-080, putatively useful for the control of red swamp crayfish (Procambarus clarkii Girard) in rice fields under laboratory and field conditions. The influence of temperature,sediment site specificity and sorption were taken into account.The degradation kinetics of the surfactant depends on the experimental conditions: type of inocula and temperature. Thedistribution of this chemical in aquatic systems was also examined. Genapol OXD-080 was removed into the sedimentsreadily after application, and sorption was considered the majorpath of removal from the water phase. Data suggest that furtherstudies are required regarding the effects of Genapol OXD-080 in aquatic organisms resident in rice fields, in parallelwith the development of technologies related with the use ofsurfactants to control P. clarkii populations.     

Macroinvertebrate Regionalisation for use in the Management of Aquatic Ecosystems in Victoria, Australia

The development of a broader, more holistic approach to aquaticecosystem management has been called for in recent years. Physical and chemical objectives alone are no longer consideredsufficient for the protection of aquatic ecosystems and shouldbe supplemented with biological objectives. The ubiquitousand sedentary nature of macroinvertebrates, combined with theirmeasurable response to environmental conditions, favour their use as important indicators in environmental policies. To establish biological objectives, there is a need for a regionalframework to limit the variability between ecosystems. Past studies have demonstrated that an a posteriori regionalisationapproach may be more useful than an a priori approach in explaining single component (e.g. macroinvertebrates) patternsacross ecosystems. This is particularly important as aquaticresource management agencies often focus on one or twocomponents of the ecosystem to assess environmental health. This study uses an a posteriori method to delineate and describebiological regions based on edge and riffle macroinvertebrate data. The regionalisation will provide a framework for settingbiological objectives, based on the range of reference conditionsmeasured within each separate region. The objectives will includeregional checklists for taxa and biotic indices. Predictive modelling in the style of RIVPACS or AUSRIVAS will also be usedwithin each region to develop objectives, incorporating local, regional and systematic features as predictor variables.