A patch use model to separate effects of foraging costs on giving-up densities: an experiment with white-tailed deer (<Emphasis Type="Italic">Odocoileus virginianus</Emphasis>)

The giving-up density of food (GUD), the amount of food remaining in a patch when a forager ceases foraging there, can be used to compare the costs of foraging in different food patches. But, to draw inferences from GUDs, specific effects of foraging costs (predation risk, metabolic and missed opportunities costs) on GUDs have to be identified. As high predation risk, high metabolic costs and abundant food all should produce high GUDs, this does not allow us to infer directly the quality of a habitat. In order to separate the effect of each foraging cost, we developed an optimal foraging model based on food supplementation. We illustrate the use of our model in a study where we assessed the impact of a power line right-of-way in a white-tailed deer (Odocoileus virginianus) winter yard by determining whether the negative effects of cover loss outweigh the positive effects of browse regeneration.     

Geotechnical properties of municipal solid waste at different phases of biodegradation

This paper presents the results of laboratory investigation conducted to determine the variation of geotechnical properties of synthetic municipal solid waste (MSW) at different phases of degradation. Synthetic MSW samples were prepared based on the composition of MSW generated in the United States and were degraded in bioreactors with leachate recirculation. Degradation of the synthetic MSW was quantified based on the gas composition and organic content, and the samples exhumed from the bioreactor cells at different phases of degradation were tested for the geotechnical properties. Hydraulic conductivity, compressibility and shear strength of initial and degraded synthetic MSW were all determined at constant initial moisture content of 50% on wet weight basis. Hydraulic conductivity of synthetic MSW was reduced by two orders of magnitude due to degradation. Compression ratio was reduced from 0.34 for initial fresh waste to 0.15 for the mostly degraded waste. Direct shear tests showed that the fresh and degraded synthetic MSW exhibited continuous strength gain with increase in horizontal deformation, with the cohesion increased from 1 kPa for fresh MSW to 16–40 kPa for degraded MSW and the friction angle decreased from 35° for fresh MSW to 28° for degraded MSW. During the triaxial tests under CU condition, the total strength parameters, cohesion and friction angle, were found to vary from 21 to 57 kPa and 1° to 9°, respectively, while the effective strength parameters, cohesion and friction angle varied from 18 to 56 kPa and from 1° to 11°, respectively. Similar to direct shear test results, as the waste degrades an increase in cohesion and slight decrease in friction angle was observed. Decreased friction angle and increased cohesion with increased degradation is believed to be due to the highly cohesive nature of the synthetic MSW. Variation of synthetic MSW properties from this study also suggests that significant changes in geotechnical properties of MSW can occur due to enhanced degradation induced by leachate recirculation.     

Comparison of coal/solid recovered fuel (SRF) with coal/refuse derived fuel (RDF) in a fluidized bed reactor

An experimental study was undertaken to compare the differences between municipal solid waste (MSW) derived solid recovered fuel (SRF) (complying with CEN standards) and refuse derived fuel (RDF). Both fuels were co-combusted with coal in a 50 kW fluidised bed combustor and the metal emissions were compared. Synthetic SRF was prepared in the laboratory by grinding major constituents of MSW such as paper, plastic, textile and wood. RDF was obtained from a local mechanical treatment plant. Heavy metal emissions in flue gas and ash samples from the (coal + 10% SRF) fuel mixture were found to be within the acceptable range and were generally lower than that obtained for coal + 10% RDF fuel mixture. The relative distribution of heavy metals in ash components and the flue gas stream shows the presence of a large fraction (up to 98%) of most of the metals in the ash (except Hg and As). Thermo-gravimetric (TG) analysis of SRF constituents was performed to understand the behaviour of fuel mixtures in the absence and presence of air. The results obtained from the experimental study will enhance the confidence of fuel users towards using MSW-derived SRF as an alternative fuel.     

Mineralisation of target hydrocarbons in three contaminated soils from former refinery facilities

This study investigated the microbial degradation of ¹⁴C-labelled hexadecane, octacosane, phenanthrene and pyrene and considered how degradation might be optimised in three genuinely hydrocarbon-contaminated soils from former petroleum refinery sites. Hydrocarbon mineralisation by the indigenous microbial community was monitored over 23 d. Hydrocarbon mineralisation enhancement by nutrient amendment (biostimulation), hydrocarbon degrader addition (bioaugmentation) and combined nutrient and degrader amendment, was also explored. The ability of indigenous soil microflora to mineralise ¹⁴C-target hydrocarbons was appreciable; ≥16% mineralised in all soils. Generally, addition of nutrients or degraders increased the rates and extents of mineralisation of ¹⁴C-hydrocarbons. However, the addition of nutrients and degraders in combination had a negative effect upon ¹⁴C-octacosane mineralisation and resulted in lower extents of mineralisation in the three soils. In general, the rates and extents of mineralisation will be dependent upon treatment type, nature of the contamination and adaptation of the ingenious microbial community.     

Pesticide pressure and fish farming in barrage pond in Northeastern France Part I: site characterization and water quality

Purpose

Fish farming in barrage pond is a rearing system commonly used worldwide. Obtaining good water quality is essential to improve sustainability of these ecosystems, both for health of fish consumers and environmental considerations. However, ponds are often located in agricultural landscape, but few study reports impact of pesticide pressure on these ecosystems. This study characterizes five sites in Northeastern France. This work establishes an initial framework for pesticide monitoring with the aim to improve understanding of the fate of pesticides in ponds.

Methods

This framework is based on surveys indicating managements and Geographical Information System (GIS) for five ponds and their watersheds (sites: C-0, C-25, C-45, C-75 and C-85) and completes with some analysis of a large spectrum of pesticide residues in surface waters.

Results

Watersheds show a gradient of crop proportion ranging from 0% to 82% of the watershed area, mainly rapeseed, wheat, barley and maize. Ponds were representative of local Northeastern France management. Many pesticides, and also nutrients, were measured in water with concentrations varying between sites and seasons. The sum of quantified molecules ranged from 0.17 ??g/l for site C-0 (March) to 8.81 ??g/l for site C-25 (October). Concentrations of metaldehyde, quinmerac, isoproturon and bentazon were sometimes above 1 ??g/l.

Conclusions

There is a strong connection between pond and watershed, due to water supply throughout the fish production cycle. Sites with small pond/big watershed are the most exposed to acute contamination a few days after spraying because water discharges are not diluted.     

Source apportionment of urban fine and ultra-fine particle number concentration in a Western Mediterranean city

Extensive measurements on particle number concentration and size distribution (13–800 nm), together with detailed chemical composition of PM_2.5 have constituted the main inputs of the database used for a source apportionment analysis. Data were collected at an urban background site in Barcelona, Western Mediterranean.The source identification analysis helped us to distinguish five emission sources (vehicle exhausts, mineral dust, sea spray, industrial source and fuel-oil combustion) and two atmospheric processes (photochemical induced nucleation and regional/urban background particles derived from coagulation and condensation processes). After that, a multilinear regression analysis was applied in order to quantify the contribution of each factor.This study reveals that vehicle exhausts contribute dominantly to the number concentration in all the particle sizes (52–86%), but especially in the range 30–200 nm. This work also points out the importance of the regional and/or urban formed aerosols (secondary inorganic particles) on the total number concentration (around 25% of the total number), with a higher impact on the accumulation mode. The photo-chemically induced nucleation of aerosols only represents a small proportion of the total number as an annual mean (3%), but is very relevant when considering only the nucleation mode (13–20 nm) fraction (23%). The other sources recognized registered sporadic contributions to the total number, coinciding with specific meteorological scenarios.This study discloses the main sources and features affecting and controlling the fine and ultra-fine aerosols in a typical city in the Western Mediterranean coast. Whereas the road traffic appears to be the most important source of sub-micrometric aerosols, other sources may not be negligible under specific meteorological conditions.     

Vulnerability of community businesses to environmental disasters

Business plays important roles in community functioning. ² However, disaster research has been disproportionately focused on units of analysis such as families, households and government agencies. This paper synthesises the major findings within the business development research field and the disaster research field. It constructs a framework for evaluating business vulnerability to natural disasters. Our theoretical integration of the research conducted to date addresses five major issues. First, it defines the ways in which businesses are subject to the impacts of natural disasters. Second, it identifies the factors that determine the magnitude of business impacts after a disaster. Third, it identifies how and when businesses return to their pre-disaster level in the disaster stricken community. Fourth, it describes measures that can be taken by individual firms and community planners to reduce the impacts of environmental disasters. Fifth, it identifies needs for public policy and future research to reduce business vulnerability to environmental disasters.     

Climate change in Algeria and its impact on durum wheat

According to IPCC reports, the Mediterranean basin and particularly the North African area are amongst the most vulnerable regions to climate change. However, the information concerning the North African zone is very limited, and studies on climate change have never been conducted in Algeria up to now. This paper aims at bridging this information gap and initiates a first research on the impact of climate change on durum wheat cropping, the most strategic commodity in the food system and in the national economy of Algeria. Climate projections for the distant future (2071–2100), obtained from the ARPEGE-Climate model of Météo-France run under the medium A1B SRES scenario, are introduced into a simple agrometeorological crop model previously validated with field data. Two options for the sowing date are assessed: a dynamical date, chosen within the traditional sowing window by means of a rainfall criterion, or a prescribed date with supplemental irrigation on the same day. Crop development is modelled using thermal time, and maximum yield is determined from the accumulation of solar radiation. A water stress index is inferred from a daily water balance model, and actual yield is estimated from potential yield corrected by the water stress index. The model also takes into account the occurrence of dry periods during the growing season, which can induce partial or total failure of the crop cycle. Two stations, representative of two of the three agroclimatic areas where durum wheat is grown, were chosen: Algiers in the central northern region and Bordj Bou Arreridj in the eastern high plains. Climate change is not similar for both areas, but a tendency towards aridity is clear especially in spring. Future temperature and potential evapotranspiration increase in both regions with a maximum in spring and summer. In Algiers, rainfall will decrease throughout the year and mainly in spring and summer. Conversely, summer precipitation in Bordj Bou Arreridj will increase significantly. In both regions, the autumn rains will increase in the future climate, the possibilities of early sowing will be improved, crop cycle will be reduced, and harvest will take place earlier. In Algiers, yields tend to decrease in the future climate, whereas in Bordj Bou Arreridj, a dynamical (earlier) sowing will tend to keep yields at their current level.     

Analyzing the hydrologic effects of region-wide land and water development interventions: a case study of the Upper Blue Nile basin

In the drylands of the Upper Blue Nile basin, high climate variability and land degradation are rampant. To enhance adaptive capacity in the region, various soil and water conservation interventions have been implemented. Moreover, water resources development schemes such as the Grand Ethiopian Renaissance Dam should be implemented by 2025. We modeled the effects of these interventions on surface runoff in the basin for both current and future (2025) basin conditions, using the runoff coefficient method in a spatially explicit approach. Under current conditions, we observed high spatial variability of mean annual runoff. The northeastern Blue Nile-1 sub-basin produces the highest mean annual runoff (391 mm or 10 × 10⁹ m³), whereas the northwestern Blue Nile-2 sub-basin produces the lowest mean annual runoff (178 mm or 0.2 × 10⁹ m³). The basin generates a total annual runoff volume of 47.7 × 10⁹ m³, of which about 54 % comes from cultivated land. The strong association between land use and topography masked the direct effect of rainfall on runoff. By 2025, total annual runoff yield could decrease by up to 38 % if appropriate basin-wide soil and water conservation interventions and the Grand Ethiopian Renaissance Dam are implemented. However, the full effects of most physical structures will only last for 1 or 2 years without regular maintenance. The improved understanding of the dynamics of the Upper Blue Nile basin’s hydrology provided by the present study will help planners to design appropriate management scenarios. Developing the basin’s database remains important for a holistic understanding of the impacts of future development interventions.     

Woody climbing plants influence the structure of the mountain forest in the Kahuzi-Biega National Park, DR Congo

In the mountain forests of the Kahuzi-Biega National Park (KBNP), in the Democratic Republic of Congo, where Sericostachys scandens, a woody climbing plant in the Amaranthaceae family, is expanding, trees appear to be negatively affected by this liana. In order to contribute to the understanding of the links between the expansion of the liana and the decline of its hosts, we compared the density and the species richness of the trees of dbh (diameter at breast height) ≥5 cm from the plots invaded by S. scandens with those from parcels that are still free from the invasion. The results of the paired unilateral t test applied to the overall sample showed that the tree density is very low in the plots dominated by the liana (p < 0.01), but that species richness is not affected (p > 0.05). In the class with diameter [10–30 cm], the lowest density of trees corresponds to the plots colonized by S. scandens, compared to the places where the liana is not abundant (p < 0.01). Further, the density of trees is significantly lower (p < 0.05) in the classes with diameters [5–10 cm] and ≥30 cm, in plots dominated by S. scandens. In conclusion, the emergence of the liana S. scandens has a negative effect on the density of the trees in the mountain forest of the KBNP.