煤矿开采对生态环境的影响及对策研究

通过对煤矿开采过程中对水、土地、大气的影响分析的基础上,结合煤矿开采实际,就如何做好煤矿开采区环境保护提出合理的对策.     

Nanoparticles in wastewater from a science-based industrial park - coagulation using polyaluminum chloride

The Hsinchu Science-based Industrial Park (HSIP) is the hi-tech manufacturing hub of Taiwan. Wastewater from the HSIP contains numerous nano-sized silicate particles whose size distributions peak at 2 and 90 nm. A 3-5 mg l(-1) as Al dose of polyaluminum chloride (PACl) was used in the field to coagulate these particles, but the removal efficiency was low. Laboratory scale tests indicated that although PACl coagulation removed 52% of the turbidity and 48% of the chemical oxygen demand (COD) from water, its effect on nano-particle removal was minimal. About 58% of the soluble COD was associated with colloidal Si particles. A light scattering test and transmission electron microscopy (TEM) demonstrated that the nano-particles agglomerated in approximately linear aggregates of sizes 100-300 nm. Prolonged contact between residual PACl and the nano-particles generated large aggregates with sizes of up to 10 microm and a fractal dimension of 2.24-2.63. The results presented herein should be of interest in the processing of "high-tech" wastewater that contains nanosized silica particles.     

An investigation of changes in water quality throughout the drinking water production/distribution chain using toxicological and fluorescence analyses

Changes in water quality from source water to finished water and tap water at two conventional drinking water treatment plants(DWTPs) were monitored.Beside the routine water quality testing,Caenorhabditis elegans-based toxicity assays and the fluorescence excitation–emission matrices technique were also applied.Both DWTPs supplied drinking water that met government standards.Under current test conditions,both the investigated finished water and tap water samples exhibited stronger lethal,genotox...     

内配燃料垃圾焚烧飞灰烧结无害化处理实验研究

研究了一种垃圾焚烧飞灰烧结无害化处理的工艺,该工艺是将飞灰与不同比例煤粉混合并添加助熔剂进行造粒烧结。通过对试样进行热流和热重测量,分析了飞灰试样在加热过程中热重变化的规律,并利用XRD、扫描电镜、氮吸附分析仪等仪器分析手段对烧结试样的物相、微观形态和孔隙特性等物理化学性质进行了研究。最后采用电感耦合等离子体发射光谱仪对烧结试样重金属浸出性进行了分析。实验结果为飞灰烧结炉的设计和内配燃料烧结工艺运行参数的制定提供了依据。     

Evaluation of the temporal variations of air quality in Taipei City, Taiwan, from 1994 to 2003

Data collected from the five air-quality monitoring stations established by the Taiwan Environmental Protection Administration in Taipei City from 1994 to 2003 are analyzed to assess the temporal variations of air quality. Principal component analysis (PCA) is adopted to convert the original measuring pollutants into fewer independent components through linear combinations while still retaining the majority of the variance of the original data set. Two principal components (PCs) are retained together explaining 82.73% of the total variance. PC1, which represents primary pollutants such as CO, NO(x), and SO(2), shows an obvious decrease over the last 10 years. PC2, which represents secondary pollutants such as ozone, displays a yearly increase over the time period when a reduction of primary pollutants is obvious. In order to track down the control measures put forth by the authorities, 47 days of high PM(10) concentrations caused by transboundary transport have been eliminated in analyzing the long-term trend of PM(10) in Taipei City. The temporal variations over the past 10 years show that the moderate peak in O(3) demonstrates a significant upward trend even when the local primary pollutants have been well under control. Monthly variations of PC scores demonstrate that primary pollution is significant from January to April, while ozone increases from April to August. The results of the yearly variations of PC scores show that PM(10) has gradually shifted from a strong correlation with PC1 during the early years to become more related to PC2 in recent years. This implies that after a reduction of primary pollutants, the proportion of secondary aerosols in PM(10) may increase. Thus, reducing the precursor concentrations of secondary aerosols will be an effective way to lower PM(10) concentrations.     

Overtime work as the antecedent of employee satisfaction,firm productivity,and innovation

Overtime work has been blamed for the deterioration of employee satisfaction and productivity. However, the organization‐level implications of overtime work as a normative expectation remain unclear. In this study, such effects were analyzed through human capital theory and a causal attribution approach. Various organizational outcomes and boundary conditions were explored in explaining these implications. The analysis of time lagged data from 273 firms affirmed that a firm's overtime level was related negatively to employee satisfaction. However, it was positively related to the firm's productivity and curvilinearly (inverted U‐shaped) related to innovation. The effects of the firm's overtime level on firm productivity and innovation were also moderated by organizational trust. This study highlights the costs and benefits of overtime work as tools for utilizing human capital and reveals the critical contingency of organizational trust that enables firms to attenuate the costs of the overtime level and accentuate its potential benefits.     

The influence of sampling protocol on nonmethane hydrocarbon mixing ratios

The effect of sampling protocol on ambient air hydrocarbon mixing ratios was examined on eight sampling days in Los Angeles during 2007 and 2008. Four protocols, which were based on previously published multi-city urban hydrocarbon studies in the United States, were compared and differences were quantified. Whole air canister samples were collected and analyzed for nonmethane hydrocarbons (NMHCs). Differing sampling protocols resulted in large differences in mixing ratios, up to an order of magnitude, for certain NMHCs on the same sampling day. However, the magnitude of the variability between NMHC levels obtained by the four protocols was not consistent throughout the eight sampling days. It was found that sampling time, followed by sampling location, had the greatest influence on the magnitude of the mixing ratio. Ratios between hydrocarbons, often used in urban studies to gain information on emission sources, also varied depending on the protocol used. Comparison of absolute NMHC mixing ratios collected in urban environments using differing sampling protocols should be made with care.     

Estimating and comparing greenhouse gas emissions with their uncertainties using different methods: A case study for an energy supply utility

Energy supply utilities release significant amounts of greenhouse gases (GHGs) into the atmosphere. It is essential to accurately estimate GHG emissions with their uncertainties, for reducing GHG emissions and mitigating climate change. GHG emissions can be calculated by an activity-based method (i.e., fuel consumption) and continuous emission measurement (CEM). In this study, GHG emissions such as CO₂, CH₄, and N₂O are estimated for a heat generation utility, which uses bituminous coal as fuel, by applying both the activity-based method and CEM. CO₂ emissions by the activity-based method are 12–19% less than that by the CEM, while N₂O and CH₄ emissions by the activity-based method are two orders of magnitude and 60% less than those by the CEM, respectively. Comparing GHG emissions (as CO₂ equivalent) from both methods, total GHG emissions by the activity-based methods are 12–27% lower than that by the CEM, as CO₂ and N₂O emissions are lower than those by the CEM. Results from uncertainty estimation show that uncertainties in the GHG emissions by the activity-based methods range from 3.4% to about 20%, from 67% to 900%, and from about 70% to about 200% for CO₂, N₂O, and CH₄, respectively, while uncertainties in the GHG emissions by the CEM range from 4% to 4.5%. For the activity-based methods, an uncertainty in the Intergovernmental Panel on Climate Change (IPCC) default net calorific value (NCV) is the major uncertainty contributor to CO₂ emissions, while an uncertainty in the IPCC default emission factor is the major uncertainty contributor to CH₄ and N₂O emissions. For the CEM, an uncertainty in volumetric flow measurement, especially for the distribution of the volumetric flow rate in a stack, is the major uncertainty contributor to all GHG emissions, while uncertainties in concentration measurements contribute a little to uncertainties in the GHG emissions.

Implications:Energy supply utilities contribute a significant portion of the global greenhouse gas (GHG) emissions. It is important to accurately estimate GHG emissions with their uncertainties for reducing GHG emissions and mitigating climate change. GHG emissions can be estimated by an activity-based method and by continuous emission measurement (CEM), yet little study has been done to calculate GHG emissions with uncertainty analysis. This study estimates GHG emissions and their uncertainties, and also identifies major uncertainty contributors for each method.     

Salinity and nutrient modulate soil bacterial communities in the coastal wetland of the Yellow River Delta,China

The Yellow River Delta is the largest and youngest estuarine and coastal wetland in China and is experiencing the most active interactions of seawater and freshwater in the world. Bacteria played multifaceted influence on soil biogeochemical processes, and it was necessary to investigate the intermodulation between the soil factors and bacterial communities. Soil samples were collected at sites with different salinity degree, vegetations, and interference. The sequences of bacilli were tested using 16S rRNA sequencing method and operational taxonomic units were classified with 97% similarity. The soil was highly salinized and oligotrophic, and the wetland was nitrogen-restricted. Redundancy analysis suggested that factors related with seawater erosion were principal to drive the changes of soil bacterial communities and then the nutrient level and human disturbance. A broader implication was that, in the early succession stages of the coastal ecosystem, seawater erosion was the key driver of the variations of marine oligotrophic bacterial communities, while the increasing nutrient availability may enhance in the abundance of the riverine copiotrophs in the late stages. This study provided new insights on the characteristics of soil bacterial communities in estuarine and coastal wetlands.

     

Experimental determination of sorption in fractured flow systems

Fracture "skins" are alteration zones on fracture surfaces created by a variety of biological, chemical, and physical processes. Skins increase surface area, where sorption occurs, compared to the unaltered rock matrix. This study examines the sorption of organic solutes on altered fracture surfaces in an experimental fracture-flow apparatus. Fracture skins containing abundant metal oxides, clays, and organic material from the Breathitt Formation (Kentucky, USA) were collected in a manner such that skin surface integrity was maintained. The samples were reassembled in the lab in a flow-through apparatus that simulated approximately 2.7 m of a linear fracture "conduit." A dual-tracer injection scheme was utilized with the sorbing or reactive tracer compared to a non-reactive tracer (chloride) injected simultaneously. Sorption was assessed from the ratio of the first temporal moments of the breakthrough curves and from the loss of reactive tracer mass and evaluated as a function of flow velocity and solute type. The breakthrough curves suggest dual-flow regimes in the fracture with both sorbing and non-sorbing flow fields. Significant sorption occurs for the reactive components, and sorption increased with decreasing flow rate and decreasing compound solubility. Based on moment analysis, however, there was little retardation of the center of solute mass. These data suggest that non-equilibrium sorption processes dominate and that slow desorption and boundary layer diffusion cause extensive tailing in the breakthrough curves.